Having problems with your Bosch Dishwashers ?

My bosch dishwasher model shu5306 uc/u12 counts down to one minute left then just keeps running


Answers :

Your d/w has a faulty control board... only solution is to replace it.
Repair Help & Product Troubleshooting for Bosch Dishwashers

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

My bosch dishwasher model shu5306 uc/u12 counts down to one minute left then just keeps running


Your d/w has a faulty control board... only solution is to replace it. ... Bosch Dishwashers

My Bosch dishwasher stops with one minute left on the timer but keeps running most time the soap dispencer door has not opened


Ok The soap dispenser is controlled by a wax plunger. This is mounted in the door on the back of the dispenser. Remove the door panel and gain access to the wax motor. Two wires connected to a brown colored small rectangular box about 1 inch long.You ... Dishwashers

#8575290 Reg wash and start button keep blinking, it runs and stops after one minute. soapy water left in bottom of dishwasher.


... Kenmore Dishwashers

I have a Bosch dishwasher Model SHE58C05. This model has two displays, one on the front where you can see and one with the hidden controls that you can't see when the dishwasher is closed. The display in the front all of a sudden stopped working today. Top still works but I can't tell how many minutes are left while its during the cylcle. I did have to cancel a cycle this morning because I picked the wrong one. Is it possible I hit a strange sequence and somehow cancelled this display (wishf


If you check your user manual there is a section that will guide you through turning off/on the display screen. I have tried to include the link for Bosch manual downloader but their site is down at the moment. If you do not have your manual and ther ... Dishwashers

My dishwasher SL34A015UC / 29 does not complete it's cycle. The cycle will stop with 1 minute left in the rince cycle and continue to run for hours, showing just one minute left. The dishes are not geting clean and there is a unplesent odor inside. I can hear the water draining during the cycle. The drain line is clear and there is plenty of water in the dishwasher. Any thoughts?


... Siemens SL5A70UC 24 in. Built-in Dishwasher

My Bosch dishwasher, model SHX46A05UC/30 has been working fine. I ran it once today on the Power Scrub Plus cycle (always use this one). Shortly after unloading the dishwasher I needed to run it again with more dishes. Within a few minutes of running the dishwasher I heard loud, almost grinding noises. Nothing appears to be stuck. Any ideas on what to do? This dishwasher has always been quiet up until today.


... Bosch 24 in. SHX36L05UC Stainless Steel Built-in Dishwasher

When I press the start button, Bosch dishwasher (model SHY56A 05UC) just keep running the motor pumping the water out of dishwasher, irrespective of: 1) the wash cycle it is on, 2) whether the door is closed or open, 3) whether I cancel drain cycle, as told by Bosch Cust Svc in following steps: - "Cancel Drain" by pressing 'Quick Wash' and 'Regular Wash' buttons together for a minute until it shows 0* - Shut power off for a minute and wait for a minute - Restart on Quick Cycle. Paid


What is happenig i believe and has happened to me 2 times is that the water level float that is on the left side of dishwasher is stuck.\015\012\015\012Either remove side panel and flick lever or pull dishwasher out and tap lower portion ... Bosch SHY56A02 / SHY56A06 Built-in Dishwasher

We have a Whirlpool dishwasher model ADG7550. It runs ok for a few minutes then it switches to the rinse setting (i.e. the furthermost left light of the temperature lights, i.e. lights from the left, 'rinse', '40degs', '50degs', '65degs', '70degs'. We may set it to start at e.g. 65degs, it does so ok for a few minutes then it switches to the 'rinse' light and starts to beep every few seconds. There are 11 beeps.


HI, There are two areas of concern here. This will be an issue with either the element, or control sector. I suggest to start with the element inspection. This will requir you use a multimeter, if possible. You will need to varify proepr element func ... Dishwashers

We have a Bosch dishwasher model SHU5315UC/U06. When we ran a "Regular Wash" the dishwasher ran continuously and the timer did not count-down. None of the Delicate or Rinse and Hold buttons responded. The only button that works is the "Scrub Wash", but when we ran it did the same thing. Ran continuously and the timer moved one minute after running about five minutes. I look forward to your solution. Thank you. Jerry


My father-in-law has a Bosch and they had the same problem. The tech guy said it was not heating properly and that caused it to continously run because it won't tick down the timer if it doesn't reach a certain temp, so try turning your faucet as hot ... Dishwashers

Bosch shu43c05uc dishwasher regular and quick cycle run down to one minute and just keep on running . I have re set and turned circuit breaker off ond back on with no luck


... Bosch SHU43C05 Stainless Steel Built-in Dishwasher

My kitchenaid dishwasher model 577-1 keeps shutting off. Will only run for a few minutes.


... KitchenAid 23 in. KUDD01DPPA Stainless Steel Dishwasher

Hi my nearly 9yr old neff S5555 integrated dishwasher has problems on the control panel the program times come up with the completely the wrong times for the wash ie the 150 one comes up saying 32minutes on a quick wash it gets stuck at 1 minute left and keeps going on, also the delay timer timer is not working ( I have been told this could be a problem with the programmer) . Is it cost effective to get the progammer changed plus engineers cost or shall l look for a new dishwasher? Thanks Su


... Dishwashers

Hi my nearly 9yr old neff S5555XOGB/40 integrated dishwasher has problems on the control panel the program times come up with the completely the wrong times for the wash ie the 150 one comes up saying 32minutes on a quick wash it gets stuck at 1 minute left and keeps going on, also the delay timer timer is not working ( I have been told this could be a problem with the programmer) . Is it cost effective to get the progammer changed plus engineers cost or shall l look for a new dishwasher? Th


... Neff 24 in. S5543X2 Built-in Dishwasher

Kenmore 74362 My model# is 665.74362400 this unit is only just over one year old. My problem is it shut down and the quick rinse light started blinking. I have tried some of the button-reset procedures that were on some other responses but to no avell I even left it unplugged for a while. Any impute would be appreciated. I have a Kenmore Dishwasher Model #74362. After we run a cycle for a normal wash and heated dry the dishes are all very dirty and greasy. It is as if they were never washed. Th


I had the same issue and you will never beleive the solution.\015\012Steps to follow:\015\0121) run one full cycle with no dishes or soap\015\0122) run one full cycle with a dishwasher cleaner like Jetdry\015\0123) run one ful ... Dishwashers

Dishwasher keeps running I have a Bosche dishwasher and the water keeps running. As long as we run it and don't stop it, the pump will continue to drain about every 3 minutes. The water just keeps running though. If we open it to empty the dishes, the cycle will stop. But the water keeps running, filling the tub, and then overflows, flooding the kitchen and drains through our wood floors to the basement below. Our ASKO seems to have a similar problem. I started the dishwasher, and the water ke


Open up the door, get out the control unit. Pry open the unit's plastic case and look at the board. Burnt spot? If so, the heater circuit burnt out (happens a lot on Bosches) and the control is waiting for the water temp to rise, but of course it ... Bosch SHU43C05 Stainless Steel Built-in Dishwasher

Our Hotpoint Dishwasher Model HDA200X-73BA has two little white plastic pipe stubs poking out of the bottom of the dishwasher. During one of the cycles--(I don't think it is the drain cycle)-- some water is being released from one of these pipe stubs and then it stops and the other one runs some water. They each only run for a few seconds, but the water is just running on the floor. These little pipe stubs are about one half inch in diameter and project out of the bottom of the dishwasher about


Hello. go to the sears direct website, click on the blue link below, and enter your model number. ou can then access an excellent parts diagram which will show these stubs and what may be missing from them. Joe\015\012\015\012 ... Hotpoint Dishwashers

The dishwasher cycle starts and gets 20-30 minutes in and then stops giving me the - - - like the door was opened, but it was not. If I use extra heated wash, the cycle stops at 63 minutes left. If I use the regular wash cycle, it stops at 43 minutes left. I have to click the resume button to get the dishwasher to complete the wash cycle. This has been happening evey time I use the dishwasher the last 2 weeks. It is Whirlpool dishwasher model GU2700XTSS! and is only 3.5 years old.


Hello,\015\012\015\012Welcome to FixYa.\015\012\015\012I suspect based on your description...\015\012\015\012"stops giving me the - - - like the door was opened, but it was not, I have to click the res ... Whirlpool Dishwashers

My bosch dishwasher control panel displays 0H on the time delay. When I start it the OH go to 2H. It then starts running and does not stop. The cycle minutes don't display. It's model number SHU5302UC 14. I do not have a manual and cannot find one online. Thanks


Check to see if your unit has a recall on it because if it does you will get a free control module from bosch.\015\012your problem is the control module. thermador .com is the site to lookup. gaggenau,bosch,thermador they are the same ccompany. ... Bosch 24 in. SHU53 Built-in Dishwasher

Asko dishwasher D1876 keeps running a 1 minute left and won't stop


... Asko D1876 Dishwasher

Clean light comes on my Kenmore Elite Dishwasher Model # 665.17263. This happened once before and has to do with the heating element. The service guy showed me how to press the buttons in a certain sequence to "unstick" the unit and it worked fine. The Quick Rinse light keeps flashing. When I push a previous sequence recommendation it switched to pots n pans and Quick Rinse and Cancel all started blinking. Then in about 2 minutes went back to Quick rinse. I did one sequence and it started to d


It seems that there is something stucks in your dishwasher...is there any error code? ... Kenmore 24 in. 15079 Built-in Dishwasher

Have a frigidaire dishwasher (model- PLD4375RFC0)about 2 years old. Set to run as we left to go out of town- when we came back all lights flashing including error- found a child's plastic bowl that had fallen to the bottom and had a melted spot as it was next to the heating element. Called support and were told to master restart- shut the power off for 15 minutes. Did and now flashing "27". Cannot find a code for that and neither could support without sending out a repairman. Any advice before


... Frigidaire Dishwashers

Gets to the end of the cycle (1 minute left on countdown) and just keeps running, does not start the "dry" mode. will run until i open it and when i shut it it goes 13 minutes left on the countdown but then gets stuck at 1 minute again. does not drain. has been doing this awhile, but until now it would simply finish the cycle when i opened, closed and reset it. now it just gets stuck again.


Hello,Welcome to FixYa.Based on your description ... Bosch SHU5315UC Dishwasher

Hi, I have a GE dishwasher. The model is GSD2204PWW, (it's a canadian model) I bought it 2 years ago. Lately, the water comes inside the dishwasher during the washing cycle, but it is drain out few minutes later, it completes its cycle and the other ones perfectly. So please, does anyone know how I can fix it? it that one : http://***.geappliances.ca/jsp/ge_Features.jsp?model_id=55511&product_id=23&cmb_Brands=---&cmb_Colours=---&cmb_496=---&cmb_565=---&cmb_PriceMax=---&cmb_PriceMin=---&count=1


Hello, tamaraI\012 was trying to help you out here. I am not sure if this well help you? \012But here is a link to about everything you want to know about your \012dishwasher, from repair to trouble shooting on most common dis ... Maytag Dishwasher

Bsoch dishwasher runs long and displays 1 minute left on timer


Sounds like a bad solder connection on the heater relay of your control unit. more than likely you will need a new control unit. part number 266746 ... Bosch 24 in. SHU53 Built-in Dishwasher

My dishwasher is leaking from underneath, front left as you look at it. If i go underneath it, there appears to be a seal on the outside (it does not appear to be the one that runs along the bottom of the inside of the dishwasher) that has come away at one point. Do you know a) how to get the front panel off (the bit that makes it look built in),b) how can i get another one of these seals. I assume if i get one we can just fit it into place. Many thanks, Robyn J


Hi,\012Here is a tip that I wrote about dishwashers and them leaking.Leaking Dishwasherheatman101\012\012\012p80897 ... Neff 24 in. S5453X1 Built-in Dishwasher
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.2504 seconds