Having problems with your Bosch Dishwashers ?

Does the SHE46c06UC/22 use the 266746 control module? The unit is hanging on 1 and not getting hot enough I don't believe?


Answers :

Repair Help & Product Troubleshooting for Bosch Dishwashers

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Does the SHE46c06UC/22 use the 266746 control module? The unit is hanging on 1 and not getting hot enough I don't believe?


... Bosch Dishwashers

Bosch dishwasher, Model SMU 7056, UC 09, FD 7309. My older unit has operated flawlessly for years. Two days ago it started to "stall" in one cycle and not progress to the next, e.g., stayed in the wash cycle and would not move on to rinse. In addition the heat generated in the machine was way below normal. A repairman told me that if the water doesn't get hot enough, the unit will not move on to the next cycle. I always use the "Regular Wash" option, but tried other options such as 'Economy


... Bosch Dishwashers

When starting wash cycle the dishwasher cda cw447 doesnt appear to be getting enough water in and is making a droning / whirring / electrical ? noise. pipes all connected ok inc aquastop water supply unit, no kinks etc. machine 3 1/2 yrs old, just started making this noise. appears to complete rapid cycle but still making unusual sound. water drains away fine from this cycle, dont believe pipes / hoses are blocked.


Try removing the inlet pipe, and refitting, might fix it, else likely that the \015\012Inlet water soleniod failing/failed or tiny mesh filter (it does come out for cleaning) behind the inlet hose clogged. Temporaily bypass the aquastop water s ... Dishwashers

My unit used to send steam out of the top but no longer gets hot. I'm sure the coil should be replaced. This unit was pricey and is used every 7-10 days over the last 14 or so months. My last unit lasted 15 years. How difficult is it to change the heating coil? How much is the suggested retail price?


Hi,Check your heating element.. \012A bad heating element causes many problems in dishwashers...Dishwasher Problems The Heating Element not W ... Whirlpool GU2400XTP Built-in Dishwasher

My Kenmore Ultra Wash, type 575D does not drain after completing all cycles. I can get it to drain by pressing the cancel/drain button a couple of times. I have checked the filters and they are clean. What could be the problem? I believe the unit is only about 4 years old and it doesn't get over-used. Thanks. Jim Seibert


HiDishwasher not draining issue usually occurs due to kinked drain pipe, clogged drain filter or drain pump. Please check that the drain pipe, pump or filter is not kinked, clogged ... Kenmore Dishwashers

Frigidaire dishwasher 15 months old. just started not washing dishes very well. set it for high temp wash. put plenty of fresh dishwashing liquid in. the unit goes thru a full cycle. you open the door and dishes are still dirty. there is always lots of dishwash liquid in the door. some of it runs down the inside of the door of the unit. just does not use all of it so dishes dont get cleaned. what could it be?


First I would check to see if it is getting enough water. There is a screen in the water inlet valve that tends to pick up debris. Follow the links Di ... Frigidaire Dishwashers

It appears that the dishwasher is not getting enough water. I have made sure that there is nothing blocking the door area so that the soap can dispense and I have reduced the amount of detergent to maybe a 1/2 Tablespoon. Have tried both powder and liquid detergents. Ran a sani clean cycle with the Jet Dry product for dishwasher used in the rural. I also run the hot water in the sink prior to starting the dishwasher to ensure the water is hot when it comes into the dishwasher. The detergent


Hello,Welcome to FixYa.Based on your description you`re experiencing the ... KitchenAid 24 in. KUDP01IL - Multiple Color Built-In Dishwasher

Dishwasher is 16 months old. Recently, it won't get tea stains from spoons or cups and there is a white film on plastics. I have run unit once with vinegar. I tried using less detergent and no change (Cascade Complete). (Neighbors using same detergnet on different machine with no problems so it's not the water.) I always select High water temp and air dry on normanl wash. My hunch is that the motor is going bad and therefore it is not pushing the water with enough force.


Hello, there are a few thinks to check on the dishwasher. Circulation, drainage - no backflow back into tub, and water temp. If all three are good, then you have hard water. \015\0121. circulation - These MDB models are very good with water circul ... Maytag MDBH985AWB / MDBH985AWS 24 in. Built-in Dishwasher

My dishwasher is Model # 363.15171000. It is not getting glasses and dishes clean. The water is hot enough and we use good dishwashing compound.


Empty the dishwasher and pour in two cups of white vinegar. Close the door and run your longest and hottest cycle to completion. This will clean the dishwasher and sanitize it. You can repeat this cleansing as often as you choose. That said, also ... Kenmore 15121 Built-in Dishwasher

I have a Bosch dishwasher she44c05uc/40 It is 3-4 years old. Recently I noticed that the cycle times have gotten much longer. Since then there is a sewer smell in the washer especially when starting a new cycle it comes out of the disposal. I'm wondering if the pump isn't heating the water hot enough. I've also noticed that the dishes aren't getting near as clean as they were before all this started. Especially stuck on food. It used to clean everything now dishes almost need rinsed.


Hello,Welcome to FixYa ... Bosch 24 in. SHE44C02UC / SHE44C06UC / SHE44C07UC Built-in Dishwasher

We have a model GLD2445RFS0 Frigidaire dishwasher. The water does not appear to be getting hot enough and the dishes do not dry completely even though we use jet dry all the time? Suggestions?


... Frigidaire Dishwashers

Dishes don't get very clean. Especially anything oily or greasy. I don't think the water hot enough or the pressure isn't good. House water pressure is fine. Using gel soap.


If they have a residue or spots the problem is hard water. www.dishwasherfilter.com has a product to solve this problem once and for all. It filters the water going into ... Dishwashers

Our KitchenAid Superba model KUDS01DJss0 ( about 7 years old and has always worked fine) I think is not heating . . the dishes come out wet and don't seem very clean if they had especially if they have a small a bit of something like peanut butter on them when loaded ( so lately I've been dong a pre-wash by hand). Unit doesn't seem to get very "hot" during the wash/dry and steam does not billow out when I open the door soon after the cycle completes like it used to. It does feel warm to the


Hello. The new heating element will come with a new control board. There are no tricks to the change actually, the easiest way to change the heating element is to unhook the plumbing, electrical, and drain hose then pull it out and get to the back ... Dishwashers

I have a Bosch SHU53513UC/U12 dishwasher. My initial problem is that the washer smells bad after a cycle and I've noticed some water sitting in the bottom of the unit. After running a diagnostic test, it results in a "2" heating fault. I followed your advice and used a current coil to and attached it to the GYBK-a1-3 hot wire on the control board. After running the test again, it only gets as high as 1.15A and manual says it should reach 11A. What should I do next?


Hello,Welcome to FixYa. ... Dishwashers

When my dishwasher completes its cycle, there is powdered detergent left in the dispenser and the dishes aren't as clean as they use to be. This started happening after I ran a HI TEMP WASH with a SANI RINSE cycle. I'm thinking that either the detergent dispenser door is opening late or the water is not getting hot enough. To check the dispenser door, I left the door open and just poured powder into the dispenser compartment. This did not improve the cleaning.


Hi\015\012 \015\012Dishwashers use Bi-Metal strip to allow the dispenser to open/close. This strip when heat up causes the soap door spring to open up the dispenser. If this strip is not heated doesn't allo ... Kenmore 16372 / 16374 / 16379 Built-in Dishwasher

Problem I have just purchased a 2008 mobile home that came with a GE dishwasher. However I cannot get the dishes clean. The detergent ends up in the bottom of the unit. And when using a detergent packet it doesn't disolve. We have adjusted the water temperature on the hot water heater and it is now reading between 122-125. HELP!


... GE 24 in. GSD5930 Built-in Dishwasher

I have a GE GSD2000J01WW Dishwasher in a building with low water pressure. The inlet hose is 3/8" OD. The heating coil gets too hot and gives off a bad odor as there is not enough water at start up. Is there a way or a replacement part that can be used to change the timing of the heater and wash cycles, etc.? Thanks


... GE GSD2000J Dishwasher

F&P DD603i Greetings! My mother-in-law went to use her 18-month old Fisher&Paykel DD603 bottom drawer today (Thanksgiving) but it started beeping and showed an error with the motor. From the messages here, it looks like you may have a service manual for this unit? If you do, would you be kind enough to forward it to me also? My mom-in-law would greatly appreciate it, and I could probably get an extra slice of pumpkin pie!! Thanks, Craig [email protected]


Service manuals can be found at http://www.fisherpaykelparts.net ... Fisher and Paykel 23 in. DD-603SS Built-in Dishwasher

Miele 842sc plus. Dishes dont get clean. Water not hot enough. How do I change settings?


... Miele Dishwashers

I have a dewalt model 67DX39G1l. Used it fine for a couple of years.Went to used it the other day and the water hose leading to it was getting so hot that it melted it.Found ot the pump gets scolding hot only after you release the trigger.As long as the trigger is pulled it works fine.If anybody can help me with this problem,please let me know.


... Dewalt Pressure Washers

We used our LG diswasher to clean our grill grates, which was a bad idea, because now the unit will not clean the dishes. We cleared the washer arms of debris, but the unit still is leaving the dishes on both racks dirty and is leaving the liquid soap dispensed into the unit undissolved on the door of the unit. There are no kinks in the water inlet, and water is getting into the unit, but the dishes are not getting cleaned.


Hi\015\012\015\012\015\012Thanks for using FixYa. Please make sure the dishes are loaded properly or\015\012dishwasher is not overloaded. Also check that the dishwasher is filling\015\012properly. It will fill with water up to ... LG LDF6810ST Stainless Steel Built-in Dishwasher

My tappan dishwasher is only 1 1/2 yr old and its not getting at least 1/2 of dishes clean. We have tried everything from changing to liquid soap, increasing water pressure at meter, not using while washing clothes. We used a dishwasher cleaner to remove calcium, and run hot water in sink before using. We know the wand, pump and drain are working. It is model TDB210RFB5 with 1.1A motor. Is the motor too small to clean dishes? I wish I could get my money back or exchange for an upgrade. Thanks!


... Electrolux Dishwashers

Even though I turned up the thermostat on my hot water heater, the water in the dishwasher does not seem to be hot enough. Mold is growing in the food grinder and even though I choose the heat dry option, the dishes are never dry. Yet, when I touched the element, I got burned. The dishes are not getting clean because it doesn't seem to be hot enough to cut the grease.


Hi, \012I have an older dishwasher also and recently my wife alsocomplained about it not cleaning right... so me being the man I am tried invain to clean the things... Bought new spray arms online and installed them inminutes...now the thing works li ... Frigidaire 24 in. FDB1050REC Stainless Steel Built-in Dishwasher

Whats the secret to getting the chopper unit back into the unit. There Tip was to use a small wrench or pair of pliers to compress the spring and align the unit. However , even with it fully compressed , the angle is right and it dosen't want to line up . I know to get it off, they advised to pull up. So it must be the opposite to replace it. I've been trying!!


Its spring loaded,so take a small tool and hold back as you insert back into mount.God bless,tom ... KitchenAid 24 in. KUDI01IL - Multiple Color Free-Standing Dishwasher

Drain Clogged I have a Kenmore Quiet Guard Plus dish washer. The water will not drain from the unti. I believe the drian in the dish washer is pluged. I removed the 8 screws from the pump/strainer unit at the bottom of the unit I removed the top that the screws were holding donw, but can't figre out how to get to the drain to unplug it. The center metal unit is exposed and nut head is exposed. What do I do next to get to the drain hose to unplug it?


You might try pouring liquid plummer in the drain part and jet it set it shouold eat through whatever is in there ... Dishwashers
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.1415 seconds