Having problems with your Bosch Dishwashers ?

I have got a second hand bosch sms 5022 model dishwasher but dont have the manual for it. I just need to identify the symbols in front of the machine e.g. which one shows the salt level etc.


Answers :

Please find the following link to be helpful to help you identifying the fault.
\012
\012click on Bosch Dishwasher support
Repair Help & Product Troubleshooting for Bosch Dishwashers

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

I have got a second hand bosch sms 5022 model dishwasher but dont have the manual for it. I just need to identify the symbols in front of the machine e.g. which one shows the salt level etc.


Please find the following link to be helpful to help you identifying the fault.\012\012click on ... Bosch Dishwashers

I have a Bauknecht dishwasher GS 835 S purchased in 1986. Since moving it while having kitchen refit there are two small leaks. One is from the hose that goes into the bottom of the machine towards the front, and the other is a drip that comes down between the front facia panel and the machine door. Possibly the door seal is slightly perished? I do not want to pay the earth for callout charges etc; if spares are not available. If they are where can I get them, and will they be very costly. I


Hi there,you can get the spare parts for your dishwasher on ... Bauknecht Dishwashers

My zanussi zdf131 has not caused any problems during the last year or so since i purcheased it, but now all the dishes etc come out with a "bloom" of white over everything. I've checked all filters etc, run several cleaning programmes but I've now noticed that the salt level does not seem to be going down. I check it every week & refil but this time the salt has been in the reservoir for several weeks & doesn't seem to have changed - could this cause the problem & if so why is the salt level not


... Zanussi Dishwashers

WONT WASH CLEAN ALWAYS RESIDUE LIKE SAND ON GLASSES ETC. THAT IS ALMOST IMPOSSIBLE TO EVEN REMOVE BY HAND WASH ENOUGH SALT AND RINCE AID ALSO CLEAN FILTER EACH TIME NO OBSTRUCTION IN PUMP FILTER THOUGH HAS AN ORANGE COLOUR SALTLIKE SUBSTANCE INSIDE BRAND NEW MACHINE STARTED WITH BAD WASHING RESULTS AFTER COFFEE PLUNGER WAS NOT CLEANED PROPERLY AND GROUND COFFEE LANDED IN MACHINE ALSO POSSIBLY OUR HOUSECLEANER MIGHT HAVE USED ORDINARY TABLE SALT INSTEAD OF DISHWASHER SAL


Use CLR to remove any build up and then use LEMI-SHINE (walmart in dishsoap aisle) for the cleaning of your dishes. Works great for me as i have the worst well water on the planet. ... Dishwashers

Salt Light Cannot get the salt light to go out. Had some problems with a crystaline Deposit on the left side of machine. we checked the inside of the dishwasher and made sure all was clean etc. After that the light wouldn't go out. Had machine serviced. Turns out we were using too much diswashing powder Only need to use about a Teaspoon (heaped) for a wash not the recptacle full.


The sensor in the salt chamber isn't reading properly. Try descaling the machine with solution and restarting. ... Miele Dishwashers

Not operating my machine starts up as usual then stops and flashes A03 with the add salt symbol. There is more than enough salt in the machine, what do I do???


Yes ... Indesit 18 in. D41 Slim-Line Free-standing Dishwasher

I have an Asko w66 front load washing machine that will only wash one way with a 60 second time delay and washes the same way again instead of reversing. At no time will it wash the other way. At the first spin cycle the water is pumped out but the wash drum will not spin. The pump continues to pump and will not stop while the one way wash continues. The timer stops at this point with the one way wash and pump still pumping continuously.


... Asko Dishwashers

Model Ariston AFA370X - This query is for my daughter who is currently house sitting and can't find any manual for the machine. When switching the dishwasher on there are two red lights next to the on switch. One light indicates salt but it's the other light that is coming on with 2 stars above it and she doesn't know what this light indicates. She has used the machine once before and everything seemed fine but this time this light keeps coming up and the machine will not start. Please a


... Dishwashers

Hello, bought an Hanseatic DW12/BFE in Germany approx. 5 years ago and moved with it to Sweden. Now one of the springs (assisting the front lock opening/closing) did break. I've tried to get a new one via a specialised shop dealing with home machines but withour success. They can only support with spare parts out of their ordinary supply chain. Can you help me? Do you have partners in Sweden or can you send me one or two springs? Thanks in advance for your reply, Petra


... Dishwashers

I have a HJA8630 dishwasher from Howdens. The small grey plastic clip which stops the metal runner at the top from falling out has snapped. it is the one at the rear of the machine not the front one. I need to know where to get this spare part please!!


... Dishwashers

When switch on button in on position, display showing 180 min wash time and saying machine requires salt and rinse aid, but machine was topped up 2 days earlier. Also sounds as though the pump is constantly pumping. All display lights on front of door went out.


... Siemens SE24A230 ExtraKlasse Built-In Dishwasher

Hi, my LG LD2120WH dishwasher stopped working recently because of the detergent container being empty and the salt level too low. After replacing these the machine still doesnt want to start washing. The timer displays fine but doesnt count down either and the machine turns off after a couple of minutes. Please help.


... Dishwashers

Hi I have a Bosch dish washing machine. The glasses come out cloady and white when washed. It was perfect in the beginning but it is getting worde. The salt is full, the rinsing liquid is full and set right. I used to use the 3 in one capsules, but now I am trying the seperate salt, powder and liquid but nothin gis working. I have also cleaned the washer with that plastic holder filled with liquid a few times, but it doess/t make a difference. Please help. Melani


First thing to try is to use the capsules and see if they work. Try reducing the detergent a little. ... Bosch Dishwashers

I have a whirlpool for Ikea dishwasher that is built in and I put it on the normal 30 minute cycle before I went to bed and 8 hours later it was still going. I opened the door and machine was full of suds. It is like it gets stuck and can't move on to the next part of the cycle. I have checked the filter in the bottom of the machine and checked the salt and rinse aid levels.


It could be waiting for the temperature to reach the required level.\012\012Sounds like the heater element has died. ... Whirlpool Dishwashers

Hoover hed6612 1 80 salt level light remains on all the time even after correct salt is added. machine is just a few months old no problems untill recently. please help : mike.....


Ascertain from the devices manual user guide on the espectation once in operationalities. For example, devices may remain on once powered on until were unplugged from power outsource unless were malfunctioning. Also ascertain from the devices user gu ... Dishwashers

We have an LG dishwasher LD14AT1 P/No 3850ED3005R. It kept signalling an error to do with a leak- all hoses etc were checked, one relaced but no fault was found, so we had a repair man come out and he repalced the electronic board at a cost of $200.00. The error still kept signalling (by the dinging sound). It was then discovered that the appliance had rusted and there was in fact a leak in the base of the machine, not a fault in the electronics. The machine has just remained idle since. I belie


I agree that it should not leak like it is dowing. Is it really rusted/corroded? Or is there a whole?The tech should have seen the leak with ease. Replacing the PCB was uncalled for.Regarding the leak, I would gather the pr ... LG Dishwashers

Hi My Siemens dishwasher doesn't always drain and the dishes taste salty all the time - the salt light is on all the time, even when I fill it up with salt. I have had this machine for a while - is it time to get a new one? Thanks a lot


... Siemens 24 in. SL34A006UC Built-in Dishwasher

Liverpool area Tap symbol lit on cycle display and machine wont start. a level of water is present in machine base.


... Bosch 24 in. SHV55M03GB Built-In Dishwasher

I temporarily misplaced (not lost for good) the owners manual for my honda pressure washer : engine and pump. I do not want to run my machine again until I verify the pump oil content/level. On the pump itself, at the top, there is a black, unscrewable oil cap, with blue-ish oil in it, BUT NO DIP STICK! How do I check the level? What kind of oil, specs etc? Thanks!


Http://www.ultimatewasher.com/download/honda-engines/gc160.pdf ... Karcher 2500 PSI Pressure Washer

I'm having trouble starting my ge profile dishwasher; the machine locks but then when I push the start button one of three things happen: 1) I get error C3 and I do not have a user manual) 2) nothing happens 3 I get the screen indicating that the machineis a sensing soil level, washing' but in fact nothing happens - I do not hear the motor starting and no water runs, thank you!


... GE 24 in. Profile PDW7800 Built-in Dishwasher

Our Classic H750 is not filling via a pump, only by mains water pressure. Also it is not heating up to the correct temp. One of the relays is badly burnt onthe contacts. I would like a diagram to see what this relay does, From the front of the machine it is the 5th relay along. Thx Ian


... Dishwashers

My dishwasher leaves a 'gritty' deposit on most items, mainly mugs and glasses. I have changed detergent, checked the salt and finish levels and put a cleaner through the machine but no improvment.


... Indesit 24 in. DI67 Free-standing Dishwasher

Just will not start like it has no power to it. Checked breaker box and made sure everything was plugged in under machine. There was one white wire that was not slid on in front. Plugged it back on ,still does not start


A voltmeter is very handy with a problem like this. If you have proof of power available at the junction box under the machine, then the next likely place to look is within the latch mechanism inside the door. There is usually a microswitch which act ... Admiral Dishwashers

Hygena dishwasher water will not enter machine when turned on , replaced solenoid only works in one position is there a water level switch/indicator/ thats would prevent the programmer from sending 240 volts to solenoid


There is a pressure stat but these are reliable. a common fault is the wiring loom broken where it goes round the corner at the bottom of the door. take outer door panel off and inspect the wiring loom for breakage ... Dishwashers

Strange behaviour! Hi. Our machine has been unused and plumbed in since we moved into the property (18mths ago) and not required its services until recently. After filling with appropriate rinse aid, salt etc.. We choose the appropriate cycle [1. Intensive or 2. Normal], turn on and after approx. 10 seconds the cycle stalls and we hear a continuous ticking sound..!?  We open the door and everything is bone dry! Has any body experienced the same problem? Many thanks


I think it has to do with a faulty program disc. it can't switch to the next program phase. try turning it a bit. ... Indesit 24 in. D61 Free-standing Dishwasher
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.0715 seconds