Having problems with your Bosch Dishwashers ?

Bosch SGV43A03GB/46 fills up then stops and has a relay clicking in the control panel

\015 Hi I have today been looking at this dishwasher I'm not entirel sure how a dishwasher works but I have checked the drain pump works tested the insulation and continuity of the heating element I wasn't to sure what the terminals on the circulation pump are so I left it alone I suspect that there is a problem with a sensor somewhere but could do with a point in the right direction\015

Answers :

See the diagram attached:if you see the dark lines many contacts are from the timers, if the timer is defective the relais are will NOT close and the motor will not start,In short the timer can be faulty.
Of course clean the contact from dirty, oxide, loose wire, break or burn wires, repair or replace the TIMER see how


6_22_2012_10_04_12_am.gif6_22_2012_10_07_07_am.gif
Repair Help & Product Troubleshooting for Bosch Dishwashers

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Bosch SGV43A03GB/46 fills up then stops and has a relay clicking in the control panel


See the diagram attached:if you see the dark lines many contacts are from the timers, if the timer is defective the relais are will NOT close and the motor will not start,In short the timer can be faulty.Of course clean the contact from dirty, ox ... Bosch Dishwashers

Frigidaire Gallery model control panel flashes and makes clicking noise goes to fast to see code. Now it will not continue it sounds like it keeps staring the cycle and stopping the cycle. Is this the control panel?


... Frigidaire Dishwashers

I have a bosch dishwasher model classxx maxx freedom performance sgs43co2gb/35. the machine when turned on doesnt stop,so i checked the control panel and there was a black ring of soot,before i purchase a new control panel,what would cause this to happen? please help!!!


I think your model was part of the recall and the repair is free to fix call bosch and they will take of ity. they need to know the model asnd serial number to know if it is one of the recall ... Bosch Dishwashers

My Bosch SHX46A06UC/42 stopped working today. I can hear the drain pump constantly pulsing about once every second. I checked the control board and found a relay contacted burned. I re-soldered the relay so it now has a good connection, however the drain pump still just pulses. How do I verify if the drain pump is bad or if the relay failed, or yet another problem?


... Bosch 24 in. SHX46A02 / SHX46A06 Built-in Dishwasher

Bosch dishwasher 9000 104 182 - stopped working, all lights flash and a constant knocking noise from the control panel along the top


... Dishwashers

GE GSD6610GOOB not cycling properly. Our dishwasher is about 6 years old and has been nothing but trouble the past year or so. We've already paid too much money repairing it the first time, (it simply stopped working - the control panel was totally dead) and don't want to pay anymore. Current problem - the machine starts up and fills with water and it sounds like it's running OK, then it will just stop, sometimes for a couple of minutes sometimes longer. Then it will start up again - and


... GE 24 in. GSD6600G Built-In Dishwasher

My maytag dishwasher quiet series 300 stop filling the water, i did choose every cycle on control panel, but i only hear the electrical noise and no water filling. Thanks for any advice!


Check and see if the water is turn on to d/w may have bad full valve ... Maytag MDB9100A Dishwasher

Dish washer 665.13592K600. Will not start. When door is closed you can hear the click of the latch then a relay on the control board. All buttons work except delay and start. You can push the cancel and drain button and the pump will activate. The start and delay buttons have no effect. Not sure if I have a control board or panel problem.


... Kenmore 13599 / 13594 / 13592 Built-in Dishwasher

Control panel will not light up, the dishwasher was running and now it has stopped mid cycle and will not do anything. I just replaced the control panel (black plastic with buttons, not control circuitry). was running the diswasher and it seemed to be working fine, then stopped. water is standing in tub, I checked the float, I don't think the float is the problem. There is power to the outlet, no tripped breakers. But control panel will not light up.


I have a kitchenaid dishwasher model # KUDC10FXBL1 I went to start it and none of the buttons were working. I have checked the breaker and the wiring and everything seems to be in order. ... KitchenAid 34 in. KUDP01FLSS Stainless Steel Built-in Dishwasher

Maytag HDB8600AWW Dishwasher had been making noise (thought might be water valve, like previous DW), eventually stopped draining water, water now in bottom, I've let sit for couple weeks, looked inside, water was gone, I tried running again, it filled with water, but heard humming control panel noises for first time, then shuts itself off. Also, my handle needs replaced. Please let me know as soon as possible. Thanks in advance. David Weaver


Hi David\015\012\015\012The hum and all the noise that you have mentioned in your post states that the issue is with the pump and motor assembly. Please check the drain hose and try to clean the drain pump filter for any clogs, obstructions. Af ... Dishwashers

My bosch dishwasher control panel displays 0H on the time delay. When I start it the OH go to 2H. It then starts running and does not stop. The cycle minutes don't display. It's model number SHU5302UC 14. I do not have a manual and cannot find one online. Thanks


Check to see if your unit has a recall on it because if it does you will get a free control module from bosch.\015\012your problem is the control module. thermador .com is the site to lookup. gaggenau,bosch,thermador they are the same ccompany. ... Bosch 24 in. SHU53 Built-in Dishwasher

Bosch dishwasher shu5300. Replaced control panel. Then replaced drain pump. Will not drain water. Can hear drain pump kick I and drain water for 2 to 3 seconds then stops


Have you checked the water is one, can you hear buzzing from the inlet valve, likes it's calling for water but not getting any?? ... Bosch 24 in. SHU53 Built-in Dishwasher

My Bosch dishwasher model #SHX99A15UC control panel displays a "Delete Errors" code and will not allow me to adjust the Rinse Aid level. The dishwasher stopped drying the dishes when this problem started.


... Bosch Dishwashers

Bosch model shu5316uc 06 stops in the middle of cycle. i swapped out the control panel but problem persists.


It sounds like your touch pad not the board ... Bosch SHU5315UC Dishwasher

FDB520RHS2 Dishwasher Same problem as posted. Dishwasher has power & water - control panel lights are on, when start is pressed the sound of a relay can be heard but nothing else happens - no water fill no cycle. Unit stays in this condition without running.


... Frigidaire FDB520RHS Full Console Dishwasher with 4 Wash Cycles 4 Wash Lev

Contols totally stopped working I replaced the control panel. Now the washer will fill and start wash cycle but will not complete the selected cycle. Also the auto clean cycle will not work.


... Maytag 24 in. MDB8751A Jetclean II Built-in Dishwasher

WP DW Mod # GU1200XTLS0: this unit filled with water and just stopped running. I have power to the unit. The control panel does not light up at all. Its wierd that I have power to the board and all the wires seem to have power! No burnt spots and no burnt smell on the board.Hmmm! Door latch and switches all check ok. Oddly it seems like the line power to DW goes all the way thru the unit and back through the nutural wire. Could the motor windings be burnt out?


Hello , there should be a fuse located by or on the side of the board with 2 wires going to it , one from the latch and one from the board ,it does come off , use an ohm meter to check it , it should ohm out or have low resistance make sure to take t ... Whirlpool GU1200XTLS Stainless Steel Dishwasher

I have a Bosch SGE63E05UC dishwasher that keeps intermittently showing an "E:25" error code. Occasionally it will get all the way through a cycle without going into error, but more often than not it will error and stop. So far the main control module in the front panel and drain pump have been replaced and the problem persists. All hoses have been checked and are clean (unit is only 1 year old) and drains well, when it does drain. Any suggestions?


... Bosch SGE63E05UC 24 in Builtin Dishwasher

Bosch SGS5312GB/12 Dishwasher I had a control board. Worked fine except didn't heat the water. Got it repaired (new PCB). Now the only thing it does is drain. Clicks every 20 secs and carries on draining. Got a new board. Does everything (including heat the water) except it does not drain before, between, or at the end of cycles. It does drain when while filling, and if the flood detection rod is raised manually (also drains if the inlet pipe beyond the pressure sensor is blocked - found


... Bosch Dishwashers

I have a Bosch SHU 3030 dishwasher that made a loud clicking noise and then stopped mid cycle. There was water at the bottom of the washer that I scooped out. I checked the filter and cleaned out any debris. There appears to be no power to the dishwasher. I spin the control dial and nothing happens; no lights, no sounds. The circuit was not flipped.


Pull the bottom kick panel and check the connections on the lower right, where the electric wires come in. Trip the breaker first, to be safe. ... KitchenAid 24 in. KUDI01TJ - Multiple Color Built-in Dishwasher

Kitchenaid kuds01il dishwasher Control panel works and lights comeon. Basin fills with water, but it stops there. Any suggestions?


This would be the main motor, or the control board not telling the main motor to start. If you do not get any flashing lights or error codes and if you press cancel and the water drains out, then it I would say the motor is the culprit. I ... KitchenAid 24 in. KUDS01ILWH Built-in Dishwasher

Bosch aqua stop dishwasher not working- no lights on when press on /off button- was working fine yesterday -except the rinse aid button?sun symbol on control panel was lit up- What would be the prob?


Has the machine got power/is the fuse blown.you are not telling me alot about the problem??? ... Dishwashers

I have a Bosch dishwasher SHX46A06UC/14 that won't drain or cycle. It fills with water. tried changing the main circuit board control panel. That didn't fix it. What next?


... Bosch 24 in. SHX46A02 / SHX46A06 Built-in Dishwasher

I have a whirlpool DU915 built in dishwasher. During the last pre wash cycle after filling with water, it suddenly stopped and the lights on tne control panel went out as it was suddenly unplugged. All connections are still intact, the breaker box to the house has been checked. The shared outlet is still working, as the garbage disposal still operates normally. The latch on the door appears to be functioning. Can you please give me a direction to look?


... Dishwashers

Kenmore Elite Dishwasher- The touchpad (control panel) keeps going ot and stops functioning. The control board is fine but the start button on the touchpad stops working. If I press it multiple times over and over it will finally engage and kick on. This is my second control panel, can the switch membranes be cleaned somehow?


Jodahabo,\015\012\015\012can you post the rest sequence? i would love to try this!\015\012\015\012thanks,\015\012\015\012the_strum_one ... Dishwashers
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.1407 seconds