Having problems with your Bosch Dishwashers ?

Bosch she43rf5uc/64 does not drain completly. can manually drain by raising red float actuator on bottom left side. no kinks or obstructions

\015 Bosch sherf5uc/64 does not drain completly after last cycle. can manually drain unit by raising float switch actuator on bottom left side (red ) Is there an adjustment? no kinks or plug ups.\015

Answers :

Repair Help & Product Troubleshooting for Bosch Dishwashers

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Bosch she43rf5uc/64 does not drain completly. can manually drain by raising red float actuator on bottom left side. no kinks or obstructions


... Bosch Dishwashers

I have a DU8000XX6 series Kenmore dishwasher that won't drain the water properly. There is about a half inch of water in the tub and the float is raised (not sitting on tub bottom). When I lift up the float a little more I can hear the float switch make. I would assume that when the water is high enough the float switch makes and energizes a solenoid valve in the drain to drain the water, but shouldn't it stay open until all the water drains? Lifting the float while the dishwasher is off wo


... Kenmore 24 in. 15142 Built-in Dishwasher

I have a Bosch dishwasher model no. SHU66C05UC that does not drain properly. After checking for a clear drain tube and finding no problem. I removed the left side panel and found that the red float was not rising in the tube. If I pull up the trigger device to engage the pump switch the machine drains. What causes the float to stay down and what is required to free it? Thanks for any help.


Water in the base. ... Bosch 24 in. SHU66C05 Stainless Steel Built-in Dishwasher

I have a GE Tritonr LX dishwasher it fills and the cycle does not start. I'v taken apart and clean the bottom drain and the float to the left front. I aslo looks like my drain is not draining. Any toughts? thank you Peter


Hello Peter. Part of what the timer does is control the motor and drain valve. If the timer doesn't work properly, the water may not drain and you need to replace the timer. That said, if your machine is more than five years old, I recommend r ... GE Dishwashers

Bosch Model SHV46C03UC/14 Dishwasher won?t drain completely. The drain hose is not kinked or obstructed and it drains into the garbage disposal. If I push the combination of two buttons on the panel, I can pump out residual water, but if I don?t, it stays there. It will become foul smelling within a day if I do not manually remove the water. Bosch technical support won?t talk to me unless I am a service technician, but I can handle this as I do all my appliances. The screens at the bottom o


THE DISHWASHER DO NOIT DRY THE DISH ... Bosch Dishwashers

My dishlex globale 300 has a modle no that is dx300wa*02 the eco light and pump keeps running i have recieved advice to drain/dryout the kidney shapped over flow tray but mine doesn't seem to have one. i've taken off the bottom cover to get a closer look but still can't see it i've also tried tipping the washer on it's left side right side,backside and even upside down to try and drain the extra water but that has made no difference please help


Hi,\015\012Try taking the dishwasher out of its wall space and tipping it back and forth. Apparently the weight of water gathering in some component triggers the 'eco' function. Allow it to evaporate by waiting for few days. ... Dishwashers

My GE Nautilus Portable dishwasher is leaking from the bottom, back left-hand side. Water is still draining from the drain line. Not sure how to disassemble to try to fix. Clogged line? Any advice?


... GE 25 in. Nautilus GSC3400J Free-standing Dishwasher

I have a miele G646 dishwasher whihs has sprung a leak into the bottom tray. Have dried it up and reset float switch but the water seems to be coming from a pipe on the left hand side of the machine. i guess its a seal but which one and how would I replace it?


Hello,It sounds like the leak is coming from the water intake hose.The water intake house is located at the bottom sump of the dishwasher. To get to it the dishwasher has to be taken out and put on its back and the floor plan needs to com ... Miele Incognito G858SCVi Built-in Dishwasher

My chef classic dishwasher is not completely cleaning the dishes. There is no obstruction to the tablet/powder door opening, although there is a small amount of powder left at the end of the cycle. Both top & bottom spray bars are clear & rotate, the water is heating & there appears to be plenty of water getting water into the machine. Drain filters are also clear.


<span style="FONT-FAMILY: 'Trebuchet MS'; FONT-SIZE: 10pt; mso-ansi-language: EN" lang="EN">Hi,<br />Check your heating element.. </span><br />\015\012<span style="FONT-FAMILY: 'Trebuchet MS'; FONT-SIZE: 10pt; mso-ansi-lang ... Magic Chef CDB6100 Built-in Dishwasher

No kinks in the line. Vent at sink is clear. Will pump some water just not all of it. Pulled left side panel off and removed hoses-no blockage. Pulled drain hose off and turned plump on, seemed to have good pressure/volume. Is this a timer issue? or control panel? Model SHU4022UC/U06


Alright, so you have a Slow Filling Dishwasher. In order to keep small particles of dirt and minerals out of the pumps and nozzles of dishwashers, manufacturers install a small screen in the primary inlet water line to trap any contaminants. Over ti ... Dishwashers

Hotpoint dishwasher BFI620 not drained and won't now work: Moved into a new house and acquired a built in dishwasher. First load was fine - or so I thought. Washed and rinsed ok, but large amount of water left in the bottom of the machine which means it now won't work. I've taken out the filter and it appears to be clear, also checked the hose for any kinks, but now I'm stuck. Any ideas?


... Dishwashers

HI dishwasher will not drain if i remove all the water will run thro cycle and stops with a couple of cms of water left have tryed to find filter inside and failed, removed sides and can see a pump on right hand side can turn impeller easily, is this the drain pump? if not how do i get at pump and or filter. is it possible that plastic chamber on left hand side could be blocked assume this transfers heat Robert


... Bosch 18 in. SRS55L02 Logixx Slim-Line Free-standing Dishwasher

Front door leaking at bottom left side


... KitchenAid KUDC25CH Dishwasher

The diswasher will drain completely after the drain cycle is completed. It will then immediately begin to fill again despite no additional cycles being requested. I can hear the fill cycle begin. I can prevent the filling by opening the door slightly or by moving the float plunger up and away from the microswitch that signals to fill the bottom of the washer with water. Is there an adjustment on the float or on the length of the float plunger?


HI, The floater is not the issue here. Your problem will be with the main control assembly. The control assembly routes power to the inlet valve, and drain pump/motor. The floater is merely a regulatory ... Maytag MDB5100A Dishwasher

Bosch Classixx dishwasher: Initially no water feed and 'water check' light came on. Removed side panel, emptied water from base. Ran OK for a week or so. The problem then repeated so side panel removed, float switch operation checked (OK) drained water from sump below polystyrene float. Ran OK but contents came out dirty and cold - no heat. Side panels off again, water in base but no obvious leak when watched during cycle - still no heat. Help please.


Http://www.repairclinic.com/Dishwasher-Repair-Help\015\012\015\012\015\012\015\012 ... Dishwashers

Leaking dishwasher The dishwasher leaks a stream of water at the base -bottom left corner whenever it goes into the final rinse cycle. It does not leak when it is in the wash mode. This leak just seemed to develop suddenly. There was no build up -ie a small stream of water. I just noticed a big puddle on the floor one day after dishwasher had completed its cycle water leak in the left side ,bottom ,husband states a small drip,drip and we do not know what to do or replace. No water standing


I just had this same problem and it was caused by a small plastic seal on the bottom of the door. My friend owns an appliance store and he said this is a common problem for this model of dishwasher. The part was $68 and the labor was $60. I could ... Frigidaire 24 in. PLD2850 Built-in Dishwasher

We have a Maytag "Dependably Quiet" Dishwasher approx. 17 years old. The door doesn't close properly (after I mistakenly lifted and pulled on it at the same time to pull the machine out slightly further). It seems to have dislodged at the bottom somewhat and I don't have any repair manuals that show how it is secured. Both of the springs and plastic hook mechanisms are in place for either side, however, it has dropped slightly down on the left side and binds on the bottom access panel. Any h


It would be helpful if you provided the model number of your dishwasher.\015\012\015\012See below links to service manuals for a few models of Maytag dishwasher, not sure if any of these is yours. I believe the last one might be the Quiet ... Dishwashers

My dishwasher is leaking from front bottom left side when on. have checked the door seal and it is worn about 3" up on left. there is also a rubber seal on the door itself running along the bottom. can this also be replaced and if so where can i get one?


Hi,\015\012Yes, they can both be replaced...this tip will also tell you how to purchase them...\015\012\015\012Here is a tip that I wrote about dishwashers and them leaking. ... Indesit 24 in. IDL500 Built-In Dishwasher

Maytag jetclean dishwasher leaks: Water leaks underneath. I don't see the source of the leak but see water running out on the left side about midway back on the bottom. Could it be related to the little plug inside the unit on the left side halfway up?


... Dishwashers

My dishwasher will not drain after cycling. I have check the drain hose connected to the disposal. All is in good order the hose is not cinked and the air hole is unblocked. I have also checked the screen at the bottom of the dishwasher, there is no debris or blockage here either. I can run the dishwasher on normal, it cycles but I still have stagnat water left beneath the bottom rack. How do I check my pump to see if it is working or could it be a short of some kind? It is a Kenmore Quite


The problem is a solenoid under the unit. It is a small black cylinder that operates a valve to change from the wash cycle to the drain cycle. You can probably order a new one from Kenmore for pretty cheap. ... Kenmore 24 in. 15252 / 15254 / 15259 Built-in Dishwasher

I have a bosch dishwasher SHE43C06UC22 (non-LED version). It's stuck in the drain cycle and continues to run even when opening the door (it should stop, but it doesn't). As a test, I poured a large glass of water in the bottom of the dishwasher and it drained it into the sink as it should, but it continues to run in the drain mode with no water in it. I've heard I either have a float stuck or an emergency drain switch or leak somewhere causing the dishwasher to continue in the drain mode. Ho


Hello,\015\012\015\012Welcome to FixYa.\015\012\015\012This can be caused by either faulty door switch or indeed the float you mentioned.\015\012\015\012This is where to look for the switch and test it ... Dishwashers

Developed a leak at bottom of door. leaks onto floor. drain hose doesn't seem to be stopped up and the dishwasher drains at the end of each cycle. took both drain screens off and couldn't find any obstructions around the drain.


There may trash/ debris in the joint where the seal closes, the seal could also be misaligned or damaged/ worn. ... Kenmore Dishwashers

My dishwashing isn't filling properly. I think there is residue on the float "thingy" (located on the bottom right side close to the door) and it doesn't float like it should, so the dishwasher thinks the water level is correct when it isn't. How can I clean it and get rid of the gunk that is keeping the float from floating?.


It appears you already have someone providing solutions on this posting. Unfortunately I am not able to see the responses.\015\012\015\012It mgiht help if you can provide the full model number of the dishasher.\015\012The float shou ... Westinghouse Dishwashers

We have an Asko 1385 dishwasher. It drains via the same drain into which our kitchen sinks drain. We had a blockage there. When that was fixed we noticed that the dishwasher does not drain properly and does not fill at all yet it seems to go through its cycle. I am wondering if a float switch or some such is stuck but I cannot find one in the bottom of the tub!


It is a plastic circular float in the bottom of the tub.With an exact model # we can point you in the right direction.Thanks!! ... Asko 1385 Dishwasher

Dish washer does not drain after the cycle is complete. The last few months when the dishwasher is done their would be a small amount of water left in the bottom. It didnt create any problems but would smell after a few days. So we would just run the drain cycle and it would empty. Well i got home to and the wife said the it was really full. The water was dirty and when you run the drain cycle it didnt drain. She said the dishes were clean. So i cleaned the vent, and filled the sink with


Check drain hose and drain pump.End of drain hose must be in same level with machine.Try it. ... KitchenAid KUDR01TJ Dishwasher
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.1454 seconds