Having problems with your Bosch Dishwashers ?

How to remove kickplate on Bosch dishwasher? No power, won't run.


Answers :

Repair Help & Product Troubleshooting for Bosch Dishwashers

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

How to remove kickplate on Bosch dishwasher? No power, won't run.


... Bosch Dishwashers

My sink got clogged and now my bosch dishwasher SHU43C05UC wont fill with water. I read on line that it most likely is the float is stuck and to access the front kickplate needs to be removed. Is there a diagnostic test that I can do that will display on the LED to make sure that this is the problem. How involved is it to unstick the float. Can it be done without moving the dishwasher and just working from the kickplate area?


It is most likely that you need to do the following\015\012\015\012Larger remnants of food that have not been trapped by the filters and have been left in the water can cause a blockage in the pump. The water is no longer pumped out of th ... Bosch 24 in. SHU66C02 / SHU66C06 Built-in Dishwasher

My two year old Bosch dishwasher is not cleaning well and is leaving gritty food on most glasses, cutlery, etc. Worse on the top but also not good on the bottom. I have tried cleaning the removable filter on the bottom and rinsing the two 'wands' - one on top and on the bottom so that the little holes are not blocked. I've tried using the power scrub mode. I've run the dishwasher twice with detergent and no dishes. This has problem has persisted over at least a month. Can you please help me?


Hi, \012I have an older dishwasher also and recently mywife also complained about it not cleaning right... so me being the man I amtried in vain to clean the things... Bought new spray arms online and installedthem in minutes...now the thing works li ... Bosch Dishwashers

Water wont drain, I have removed drain hose from back of machine run cycle and still nothing more than a trickle. I am guessing its plugged but im not sure of the best way to test or clear the plug. its a bosch


Im a old bosch tech and your problemis in the drain pump. remove 1 screw in the bottom of the unit and you will take off the plastic door, spin propeller and remove obstruction that will do it. if this helps send me a 4 thumbs up post thanks ... Bosch 24 in. SHU43 Built-in Dishwasher

I have a Bosch SHX46A05UC14 dishwasher. The dishwasher is in a new home I just purchased. I tried to run the dishwasher on a normal cycle. However, when I push POWER and NORMAL CYCLE it makes a buzzing noise...and that's it. I opened the dishwasher and on the base of the dishwasher there was a screen that could be removed. I noticed that there was still some anti-freeze fluid in there (because the house was winterized). Could there be a simple solution to this problem?


... Bosch 24 in. SHU43 Built-in Dishwasher

Hi I have a problem with my Bosch SHU43CO6UC/22 dishwasher. using "power scrub plus" and "regular" cycles it will continue to fill and overflow the door, after the cycle has run even when the power button is off. I am using the quick wash cycle at the moment .After the cycle has run i open and check if the water has drained or not,If it has it does not continue to fill and flood.If there is water in the bottom after the cycle has finished it will keep rising untill I push the rinse hold button


The bosch dishwashers use a fill valve that is attatched to the inlet hose. yours is stuck in the open position. this usually happens when you have hard water, as the minerals build up on the sealing surface of the water valve. there is no easy ... Dishwashers

Bosch wont Hello i have a Bosch DLX Series dishwasher and i put it outside and covered it while i did my kitchen remodel.. 6 months later kitchen is done and i move the washer back in. It turns on and it sounds like its running but it wont take in water from the hose. which is on and connected. any suggestions thanks very much...Steve


Faulty inlet valve or water in the bottom tray which will activate the float swich and pump out any water. See that this moves up and down freely. Turn electrics off first. ... Bosch 24 in. SHE44C02UC / SHE44C06UC / SHE44C07UC Built-in Dishwasher

I have a Whirlpool GU2275XTVY0 when I start the cycle on normal it will run for about 5 minutes then the power button starts flashing and wont run. It drains fine and starts fine just wont finish the cycle.


It might help if the wash arm had started moving when it shut off.\015\012\015\012Unless it is always exactly 5 minutes I would say perhaps the door switch is out of alignment. It might start ok when you engaged at time of closing door bu ... Whirlpool Gold GU2275XTV Builtin Dishwasher

Wont run I have power to the unit but it wont run i have no lights on the unit


If your dishwasher doesn't work at all, check these:Power from the house ... KitchenAid 24 in. KUDP01IL - Multiple Color Built-In Dishwasher

AFTER A BRIEF POWER OUTAGE DUE TO ELECTRICAL STORM THE F1 CODE FLASHES AND PUMP RUNS CONTINUOUSLY. TURNING POWER OFF ONLY STOPS IT FOR SEVERAL SECONDS. TURNING OFF POWER TO DW AND BACK ON DOES NOT RESET. I HAVE REMOVED THE BOTTOM DRAWER AND CHECKED FOR WATER, BUT UNIT IS DRY. IS THERE ANOTHER WAY TO RESET THE SWITCH?


Hi there,The f1 fault is cased by a leak on the dishwasher.It is activated when water gets to a dangerous level in the base of the appliance near to the PCB.The main reason this happens is putting cups on the drop down s ... Dishwashers

BOSCH DISHWASHER QUIT MID CYCLE NO LIGHTS ON DISPLAY AND ACTS LIKE NO POWER. POWER INCOMING IS GOOD AND POWER TO SWITCH IS GOOD. TRIED NEW SWITCH WITH NO LUCK. MOTOR WILL RUN IF OVERFLOW FLOAT UNDER DISHWASHER IS LIFTED.


Check the sensor of the liquid at the bottom of the dishwasher. Sometimes that is the cause of the fault. ... Bosch SHU43C05 Stainless Steel Built-in Dishwasher

ASKO 1555 dishwasher won't run. The anti flood device motor won't stop running but we've removed all the water. All the lights on the front panel blink in unison and when we hold down the start/cancel button on the front, nothing resets. We can't run our dishwasher. We've tried disconnecting power and resetting the circuit breaker but the churning motor won't stop.


Hello,Welcome to FixYa.Based on your description " The anti flood device motor won\\'t stop running but we\\'ve removed all the water " It is likely nothing very serious. ... Asko 24 in. 1805 Built-in Dishwasher

Bosch SHX46A02UC-21 Won't Fill and Drain Runs Continually. Original presentation of problem was that it wouldn't drain. Discovered that Garbage Disposal had plugged drain line. After clearing Drain Line, now drains fine but the drain pump runs continuously and it never fills with water. Have done the Cancel, Power Off routine however, even after that, drain pump runs continually.


Float switch is in the flood position and the drain pump is running..\015\012there is water under the dishwasher or that switch is stuck up.. ... Bosch 24 in. SHU43 Built-in Dishwasher

My Bosch SHX46A06UC just runs and runs and wont stop.


The control board is not turning on the water heater due to bad control board, heater or limiting fuse. ... Bosch 24 in. SHU66C02 / SHU66C06 Built-in Dishwasher

Dishwasher wont drain and no power light


Your dryer probably has debris in the little drain pump located near the floor. Once you remove the lower front kick plate you will see where the hose is connected to the pump. Remove the clamp there, pull the hose off the pump and then disconnect ... Bosch 24 in. SHE44C02UC / SHE44C06UC / SHE44C07UC Built-in Dishwasher

Avanti 18" dishwasher gets power but wont run thru cycle,


... Avanti Dishwashers

Ge dishwasher wont run after power outage


... Maytag Dishwasher

How to remove the kickplate bosch dishwasher


... Bosch Dishwashers

Gibson Furnace Hi and thanks for reading my question. I have a Gibson furnace with electronic ignition. When I turn on the power to the furnace it starts running with the batteries removed from the thermostat. It blows but does not produce cool or or stop running. The circuit board has a small red light that is flashing but does not seem to have a pattern. I would appreciate any input that you may have. Also are the relays located ont he circuit board itself?


... Dishwashers

We have a Bosch dishwasher supplied with softened water - does a great job. However, on the most recent run, the soap door didn't open properly and the soap puck (we use those two part liquid/powder that dissolve) was only partially dissolved. Our stainless steel cutlery now has a hazy film all over it, something that handwashing and a subsequent successfully-executed dishwasher run didn't remove. It's expensive cutlery, less than a year old, and a wedding gift from my mother who lives next d


Sounds like the you need to see if your using a proper rinses / drying aget like turbo dry. Fill it up and you should be good for 40 washes. If it continues you may have a bad control unit. ... Dishwashers

Carburator is gummed up I can remove the carburator but after that im lost I removed the screw from the bottom of the cup drained the old gas shot some carb cleaner in there opened the gas line put the screw back in numerous times wont start regapped the spark plug and cleaned it won't start only has been used about five hours my buddy didn,t run the old gas out of it two years ago before winter it's a type 5 manual choke/fixed throttle


... Karcher 2500 PSI Pressure Washer

My power button cover broke on the dishwasher and I figured out the part number I needed, but when I put it back together I got the wires crossed on the board and door switch. Now the control lights up , but the dishwasher will not run a cycle. THe question is does the plug on the door switch have to be a certain way, because there are three wires and you can connect the plug both ways. I did turn the plug, but it still does not run. Did I break the switch? Bosch SHU9956uc/14


The wires do have to be a certain way on the door. Otherwise a door open can tell the board that's it shut and vice versa. The easiest way to do it, is test the switch with an ohmmeter, place the meter on the switch, push button in and see if the rea ... Bosch SHU9956 Built-in Dishwasher

Bosch SHV 4300 Dishwasher stopped in mid cycle Power Lights now don't come on No Power Will not run. Main fuse in electrical box not tripped.


... Bosch Dishwashers

Hobart LX30 Hey I just bought a Hobart Lx30 and we don't have a power source that can handle the 50 amp requirement. We got it at an extremely good price so we are trying to work around it. I was told that disconnecting the water heater would allow it to work in a standard 120 volt outlet. I did that and now I have another issue. The machine wont run unless the water is 160 degrees. How do i disconnect the sensor that restricts the temp so that I can run the machine at a lower temp?


Hopefully you took the suggestion to run the correct 50 amp 208-240 service to the unit.Converting the unit to an LX30C has a couple of pitfalls. The LX30C is connected directly to the incoming water supply, which should run 120-140 degre ... Hobart 24 in. LXIH-3 Built-in Dishwasher

Bosch D/W model # SHU9955UC. The drain motor will not stop running. Ran the reset sequence on the panel. Display reset to "0" minutes. Power cycled the D/W and when powered back on the drain motor started up again. What do I do ?


Hi ....This is a common problem. Remove the kick plate you will see the white base which also is a tray to collect leaks or backups. Reach your fingers over the top of tray and feel for water/wetness,if so safety switch has been activated and pump wi ... Bosch SHU9955UC Built-in Dishwasher
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.1407 seconds