Having problems with your Bosch Dishwashers ?

Bosch she6ap05 dishwasher not heating

\015 Dishwasher is three years old and started leaving dishes dirty. tested inlet water and after starting a cycle I tested the water in the dw tub and it wasn't any hotter than the water from the faucet (the dishes after a full cycle are not as hot as they used to be) so I'm presuming he heater is not working. I've got the control board, heater pump and humidity sensor out of the unit looking for burnt wires/solder joints etc but all look fine. is there a trouble shooting chart I can following to diagnose which part is bad? I've metered the heater loops and they seem to have continuity but they are embedded in circuit boards wrapped around the pump center so it's not obvious to see what's connected to what.\012\012thanks\015

Answers :

If the unit is not heating, it may give an error message (usually e09) the chances are that it is the heat pump (part number 669135). The circulating motor and heater are combined in this one unit. It is also possible that the power board (situated behind the right side panel, bottom right) is at fault, this needs to be replaced by a qualified engineer as the software is booted by a coding program through a specific computer program. The heat pump will be your first check tho, the heating side is the contacts under the larger connection block and should read approx 20-30 ohms. Hope his helps, if you require more info please add a comment.
Repair Help & Product Troubleshooting for Bosch Dishwashers

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Bosch she6ap05 dishwasher not heating


If the unit is not heating, it may give an error message (usually e09) the chances are that it is the heat pump (part number 669135). The circulating motor and heater are combined in this one unit. It is also possible that the power board (sit ... Bosch Dishwashers

Bosch Dishwasher I currently own a Bosch dishwasher. One of the selling points, if I'm remembering right, of the dishwasher was it was supposed to super heat the hot water that is coming in from the tap. I have 3 problems. We have to rinse the dishes by hand before putting them in the dishwasher, Otherwise they won't come out clean. The dishwasher will run for four hours sometimes longer. It doesn't seem like it is heating the water any hotter than what comes out of the tap.


Your control board is bad. ... Bosch 24 in. SHU43 Built-in Dishwasher

My dishwasher does not do a hot wash. Why is this? If I need to replace the heating element, how do i gain access to heating element on my Bosch classixx dishwasher?


Hi, a common problem with these machines is the solder coming away from the heater relay. A simple repair if your lucky. Run a continuity test on the element with a multimeter before replacing it, as it is a massive job to change it. I just changed m ... Bosch SHU9950 Dishwasher

Bosch dishwasher i have dishwasher that seems to progress to fast through cycle and does not heat water leaving dishes dirty. Is it likely to be timer unit or heating element Thanks


I'm probably sounding like a broken record, but id f its got buttons on the front and not a knob, its probably the control board. Unplug the unit or flip the breaker.Take off the outer door and the control panel by removing all those torx screws down ... Bosch 24 in. SGS43C12 Classixx Free-Standing Dishwasher

How do I replace the heating element for a Bosch SHU53 dishwasher


Are you sure its the element, the control boards on them get bad soldering joints and the you get the impression that the element is bad, but its the solder joint that controls the element that goes bad....you can resolder that ... Bosch 24 in. SHU53 Built-in Dishwasher

Installing new heating element in Bosch dishwasher


In order to replace te heater in that unit, it must be remove from cabinet, and taken apart, it is very labor intensive, in order to access the heater, youll need to remove eh lower plastic pan from D/W. in order to get that removed, ... Bosch 24 in. SHU53 Built-in Dishwasher

Bosch dishwasher shx46b02uc has stopped drying. Per online comments, they seem to point to either a corroded wire or a bad heating element. We've replaced the heating element and all the wires looks fine. All other functions work - just not the heat. Open to suggestions.


Hello,Welcome to FixYa.Based on your description ... Bosch 24 in. SHU66C02 / SHU66C06 Built-in Dishwasher

How do you take the control panel out of a Bosch dishwasher model# she44c. I have read other consumers and I have the problem that the solder joint may have come loose. The dishwasher stays on one after cycling. The dishwasher doesn't heat up.


Hello Steve,\015\012\015\012Welcome to FixYa.\015\012\015\012If you email me at [email protected] my windows live account I will send you an o ... Bosch 24 in. SHE44C02UC / SHE44C06UC / SHE44C07UC Built-in Dishwasher

I have a Bosch DLX series dishwasher and no manual. The heat dry doesn't work or at least not well. There is no heat on/off switch. How do I ensure the heat is on so I can stop drying my dishes by hand?


... Bosch Dishwashers

4 year old Bosch SRS43C12GB/14 dishwasher running a full cycle but not heating water


... Dishwashers

Bosch dishwasher no heat


... Bosch Dishwashers

Bosch dishwasher stops mid-cycle and does not heat water


... Bosch 24 in. SGS47E02 Exxcel Free-standing Dishwasher

Bosch Dishwasher Water Not Heating


Depends on if it is the controller board (easy, just behind the door and requires a torx 20 screw driver) or if it is the heating element. The latter is easy, but time consuming, as it requires you to pull the dishwasher out, detach the bottom, tilt ... Bosch Dishwashers

Dishwasher does not heat water - Bosch 24 in. SGS43C12 Classixx Free-Standing Dishwasher


Is this a Bosch DW? If so read this link:\015\012http://www.squidoo.com/Bosch_Dishwasher_Drainage_Problem_Fixes ... Bosch 24 in. SGS43C12 Classixx Free-Standing Dishwasher

Bosch sg14305au/12... NO HEAT - Bosch Dishwashers


... Bosch Dishwashers

Bosch dishwasher Does not heat up in the washing cycle and does not drain down at the end of the cycle. End of cycle the display sticks at 1 and the drain pump operates until the machine is switched off or reset. Followed the suggestion in another thread to look for a burnt solder joint on the control board. Unfortunately my machine is a later model than the board shown and has no poor joints on the board. It would seem from previous answers that the problem is either the controller, the heating


1) The water must be preheating by heating elements and thermostat see how to do it.\015\0122) Timer , test for defective,clean the contact, repair wires for loose, broken, or burn.\015\012\015\012God bless you.\015\012 ... Dishwashers

Bosch Dishwasher, model SGS6312GB/07. The water does not heat up so the dishwasher does not complete its cycle and remains in wash mode. The water has to be scooped out


Press cancel/drain sequence to get water out-check owners manual.\015\0122 possible solutions to your problem discussed here:\015\012 ... Dishwashers

Bosch dishwasher heating element will not heat up


... Bosch Dishwashers

Bosch SGS5312GB/12 Dishwasher I had a control board. Worked fine except didn't heat the water. Got it repaired (new PCB). Now the only thing it does is drain. Clicks every 20 secs and carries on draining. Got a new board. Does everything (including heat the water) except it does not drain before, between, or at the end of cycles. It does drain when while filling, and if the flood detection rod is raised manually (also drains if the inlet pipe beyond the pressure sensor is blocked - found


... Bosch Dishwashers

I have a bosch she44c05uc dishwasher that get stuck on 1 and won't finish. The water will pump out when I cancel. The water will pump in but won't heat up. The final heating doesn't seem to work also. I have removed the circuit board and there appears to be NO solder issues. What else can it be?


... Bosch 24 in. SHE44C05UC Stainless Steel Built-in Dishwasher

Water wont heat in my Bosch dishwasher - Dishwashers


The heater is not designed to heat wter from cpold to hot. it is only designed to maintain the hot waterb temperature. your problemis that the initial water going in is probably cold. you have to run faucet until it gets hot then start the machine. ... Dishwashers

Bosch Classixx dishwasher: Initially no water feed and 'water check' light came on. Removed side panel, emptied water from base. Ran OK for a week or so. The problem then repeated so side panel removed, float switch operation checked (OK) drained water from sump below polystyrene float. Ran OK but contents came out dirty and cold - no heat. Side panels off again, water in base but no obvious leak when watched during cycle - still no heat. Help please.


Http://www.repairclinic.com/Dishwasher-Repair-Help\015\012\015\012\015\012\015\012 ... Dishwashers

Hiya, I have a Bosch Dishwasher SGV4313GB that wont heat the water, it gets stuck with cold water continually washing (pre wash??) the delf. Its a built in and I have opened the inside metal panel and exposed the control unit (PCB) there is no blackened/loose soldered joint to be resoldered. I am at a loss as to what else in the heating circuit to look for. Can you point me in the direction of what I should look for next? Kind regards Mark


... Bosch Dishwashers

Bosch Dishwasher SMS4602eu is not heating up. I have tested the heating element for continuity and this seems to be fine. Any other suggestions would be greatly appreciated?


... Bosch SMS63E Dishwasher

Bosch skt 50 dishwasher not heating


... Dishwashers
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.1246 seconds