Having problems with your Bosch Evolution 500 SHE55M06UC 24 in Builtin Dishwasher ?

We did not receive the correct installation manual with this dishwaser... and are having trouble locating where the electrical wiring is.... or the hot water connection, either, for that matter


Answers :

Please download the manual from the below link:
\015\012
\015\012http://www.ziddu.com/download/8684400/9000270906_Eng_only.pdf.html
\015\012
\015\012Hope this allows you to resolve the issue.
Repair Help & Product Troubleshooting for Bosch Evolution 500 SHE55M06UC 24 in Builtin Dishwasher

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

We did not receive the correct installation manual with this dishwaser... and are having trouble locating where the electrical wiring is.... or the hot water connection, either, for that matter


Please download the manual from the below link:\015\012\015\012http://www.ziddu.com/download/8684400/9000270906_Eng_only.pdf.html ... Bosch Evolution 500 SHE55M06UC 24 in Builtin Dishwasher

Dishwasher does not start it seems there's no water coming in the tub. I got a trouble shooting manual from ejunkie.com and tested the coil of the water valve which read 1000 Ohms, which means it's OK. Then I hot wired the coil while connected to the water line and the valve opened and I had water flowing [ in a bucket] I have tried to start the test program [hold power scrub plus and regular switch at same time then start button] and lights start flashing you hear drain pump come in then the un


... Bosch SHV4803 Dishwasher

I installed according to guide, but dishwasher will not fill with water. Pump sounds much too loud to be normal. Wiring was checked three times for correct connections. Water supply was checked twice for water getting through, no leaks and water supply on. Drain hose is connected correctly and is connected to house drain.


You state the water supply is on.\015\012Have you loosened the compression nut at the dishwasher ell to see if you have pressure to the water inlet to the dishwasher?\015\012Remember the dishwasher will always run a little to make sure an ... Whirlpool GU2400XTP Built-in Dishwasher

Fills with water, sounds like it starts to pump water then stops, then start again. It attempts to start pumping water 3 or 4 times them turns off leaving the water in the tub. I have read about the water needing to heat up for the cycle to advance. When I check the water that is left in the tub it is warm but not hot. The heating element is not hot either. I did a continuity test on the heating element and it seems to check out ok. I also did a continuity test on the red wire from the heating e


You have a wash pump problem. can be 1 of 3 things. most likely something is caught in the pump impelor if not the wash pump motor may be faulty or ceized or it could be the capacitor for the wash pump motor is faulty. you can try removing the wash p ... Maytag MDB7100AWB Dishwasher

My Siemens dishwasher SL34A sometimes makes loud vibration noises from the supply line at the water pump connection. I can turn off the water and back on it will quit, but sometimes starts again. And it does not matter how open or closed the supply line valve is either. I'm told it is likely the water pump, but this model has a combination water pump/motor assembly and I do not care to put another $230 into it. thx, TS.


... Siemens 24 in. SL34A006UC Built-in Dishwasher

Have a 15 day old Thermador Dish washer direct wired to the circuit breaker, replacing a DW that was there for 10 years. Wiring is the same age. The unit will not turn on and I took the cover off the electric cover the hot wire had melted the connection. what's going on? model DWHD630gcm


... Thermador DWHD630GCP Dishwasher

We have a Bosch SHU9925UC dishwasher, installed in 2002. In August 2010, the water didn't drain, and a service technician discovered melted wire nuts at the main incoming power junction, presumably due to a loose connection there. He re-wired it. Now it's March 2011 and yesterday we smelled electric fire smoke coming from the dishwahser, opened it up and again found melted wirenuts. So is it really just poor installation, given that now 2 different installers have created the same problem?


... Bosch SHU9925UC Built-in Dishwasher

I am doing the electric connection for the dishwasher and the green wire goes where. I see a green wire located on the bottom of the motor area and was wondering if that whewre it goes.


In the conection box the is a green screw that you should attach the green wire to should be in the front right hand corner ... Dishwashers

I have purchased a Bosch dishwasher SMS50E22au. The manual instructions say cold water connection only yet there is also instructions for a hot water connection . We have solar hot water, and we are unclear as to whether we can connect to solar hot water.


... Bosch SMS69L 24 in. Built-in Dishwasher

New dishwasher installed and heating element is not heating and get no hot water. Hose and electrical are connected.


On the bottom of your dish washer you can check if the heating element is getting power, if not you have few thermostat next to it (they might be disconnected from the instalation) or they might burn. check them when the power is off for continuity.. ... Dishwashers

I have a neff dish washer and the water will not come past the connection at the pipe in the wall where there is a electric type valve block which the wire goes back to the machine which i think must be a safty devise can can i rectify this problem


You have got an Aqua Stop valve fitted with your dishwasher. \015\012\015\012The reason it has triggered and stopped water getting in is that the flood switch in the dishwasher has activated.\015\012\015\012You have a leak ins ... Neff Dishwashers

First 2 weeks ago i put an electric control module into the upper section. what comes on is the green flashing light for clean. in checking connections i found the paper for trouble shouting. i did what they said to do. they said hit the time saver - high temp - time saver - high temp. from there all the lights went on & the wash cycle started and ran. then it just stopped & the green light for clean just flashes. the water is still in the bottom & won't drain.


The error indicates that the machine has taken too long to drain the water. Do the following.\015\012 \015\012\015\012Switch off the machine, unplug or disconnect the ma ... Kenmore 16874 Built-in Dishwasher

MY DISHWASHER WILL NOT TURN ON- THE WATER HAS NOT FULLY DRAINED FROM THE LAST WASH-I HAVE CLEANED OUT THE FILTER AND ALL THE WIRES SEEM TO BE CONNECTED. I AM NOT SURE WHERE THE PLUNGER OR PUMP IS LOCATED AND IF IT IS A GOOD IDEA TO OPEN THEM BEFORE I CONSULT AN EXPERT.


If theres no lites at all check power with volt meter at cord in the little box at the bottem panel.if power ther next check door switches then board.you can look at your wiring diagram for you checks.its on the bottem also ... Dishwashers

MY DISH washer electric supply wires are cutdown and water pipe of dishwasher cutoff and i want its diagram input which is help full to connect the circut


Hi .. the electrical input to the dishwasher should be a 3 wire cable, black, white, green/bare. The connection is generally into a small metal box just behind the kick plate on the right side of the front of the washer. The cable gets run thru a cab ... Smeg 24 in. DWF614SS Stainless Steel Free-standing Dishwasher

ASEA CYLINDA 1200 Dish Washer Electric Motor Wiring Connections


A neighbour called around and he popped the right wire in the right place and we were in business. Not sure what he did and he is not sure either. Thankyou Wal. ... Dishwashers

Connecting the hot water line to a new dishwasher.


Use teflon tape on the elbow if you did the back it off put some more on it and stop when its snugged facing the right direction now ive torqued them things pretty tight my self they don't strip that easy ... Dishwashers

We need to connect it back to the built in wires in the dishwasher. We need to know what colours or wires connect to the flat gold metal plates, there is a black plastic case that slips on and then 3 plates underneath and on the top, but not quite sure if that is correct. Then there is still wires that are loose that need connecting. Part NO. C00059727 Copreci - Merloni 1 160010266 TD02 0008


... Dishwashers

My dishwasher DW60 does not complete the program and drain the hotwater leaving hot water in the bottom of the dishwasher however when I run a prewash cold water cycle the water does drain away and the dishwasher program works correctly do you know why it drains cold water okay but not hot water


... Dishwashers

Hello I recentley repaired a broken door latch on chef electronic diswasher the push button type not the rotary switch style. i had to disconnect the circuit board I wrote down the were the wires connected i have discovered that when I reconnected everything i had not got all the wires in the right place is there any way I can get a wiring diagram so I can connect the wires correctly thank you


Unfortunately as i know it is difficult to find a wiring diagram. Better try an authorized service station where they may have similar appliances. ... Dishwashers

Water Connections I have a new house with an Asko 1805. I think it is only connected to the cold water pipe. Can i connect it to hot as well, to reduce its cycle time?? If so, how can I access the connections? The front foot panel doesnt reveal any pipes.


In the US dishwashers are usually connected to the hot water supply. Although the ASKO 1850 I believe has an in line heater. Using hot water supply will reduce electrical useage.\015\012\015\012Interestingly we use to have ASKO washer and ... Asko 24 in. 1805 Built-in Dishwasher

I'm attempting to reuse a Maytag dishwasher motor for a bench grinder. Since this is a reversible motor, I'm not sure how to connect the wiring to a simple switch so that it works in one direction only. The motor has 4 wires: blue, gray, red, yellow. Not sure which to connect to the hot (black), return (white) and ground (bare) wires from the romex and can't find a wiring diagram online for this dishwasher. Any ideas? Thanks.


... Hobart 29 in. AM15-1 Free-Standing Dishwasher

WHAT ARE THE THERMAL FUSE SPECIFICATIONS FOR KENMORE ELITE MODEL 66513122K701SERIAL NUMBER FY1211868 AND WHAT IS THE PART NUMBER FOR A THERMAL FUSE KIT? WE HAVE HAD TWO FUSES BLOW AND THERE DAMAGE TO THE WIRING ON THE LEFT HAND SIDE OF THE CONTROL PANEL THAT CONNECTS O THE SWITCH. THEIR IS DISCOLORATION ON THE PARTS AND WIRING. WE HAVE SEEN EXPERTS STATE THAT IN ORDER TO CORRECT OUR ISSUE WITH THE FUSE BURNING OUT WE NEED A THERMAL FUSE KIT AND WE NEED THE SWITCH AND THE WIRING THAT CONNECTS TO


Http://appliancejunk.com/ge/dishwasher/31-9137.pdf\015\012\015\012A ... Dishwashers

My kitchenaid dishwasher will not complete a washing cycle. the water heating seems to be staying on all the time. could my heating element be shot. the water seems hot when i open the dish washer during the cycle but it is connected to the hot water supply line. thanks


... KitchenAid Dishwashers

Whirlpool Gold Dishwasher - GU2700XTSB The top rack of the dishwasher is not cleaning. The bottom rack dishes clean fine. There are no clogs in either the bottom or top spinner arms, the plastic tube feeding water from the bottom pump to the top rack spinner arm is clean, the spinner arms all rotate freely and do not bind. Water pressure is correct and water temperature is correct. There are no lime or hardwater deposits or clogs. What could be the issue?


Hi,\012\012\012\012\012I\012have an older dishwasher also and recently my wife also complained\012about it not cleaning right... so me being the man I am tried in vain\012to clean the things... Bought new ... Whirlpool GU2700XTSB / GU2700XTSQ / GU2700XTST Built-in Dishwasher

Whirlpool Quiet partner 1dishwasher (model DU1055XTSQ2) that is not filling all the way--water supply is working correctly. Also, the water is not getting hot, the heater coil looks very mottled.


... Whirlpool DU1055XTSQ Built-in Dishwasher
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.1804 seconds