Having problems with your Bosch Integra 500 SHX45M05UC Stainless Steel 24 in Builtin Dishwasher ?

My shx45mouc will run and run even when the timer hits 1 min it will still run untill i stop it


Answers :

Repair Help & Product Troubleshooting for Bosch Integra 500 SHX45M05UC Stainless Steel 24 in Builtin Dishwasher

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

My shx45mouc will run and run even when the timer hits 1 min it will still run untill i stop it


... Bosch Integra 500 SHX45M05UC Stainless Steel 24 in Builtin Dishwasher

I have a Bosh Logic dishwasher SGS65L12GB/04 The other day it got to 1 min left and would not stop pumping out water and continued even with the door open. After 5 mins playing around it started working again for a further 2 washes. Now when switched on the pump for pumping out the water works continuously. Reset it time seem to count down but does not do anything reset time goes to 0 and beeps but still the pump runs even with the door open. all buttons seem to work fine but no washing and pu


Hi Jonathan,\015\012\015\012Welcome to FixYa.\015\012\015\012Your float may have got stuck or it's possible that you have water leaking into the bottom of the washer. In the bottom of the wash compartment, next to the drain yo ... Bosch Dishwashers

Dishwasher timer stops at 28 min but dishwasher still run and timer does not advance


... Fisher and Paykel 24 in. DD603H W Built-in Dishwasher

Maytag Dishwasher Model MDB4100AWQ When I start the Light Wash Cycle: Washer fills with water, heater comes on (I checked it with a volt meter--120 volts), timer runs, motor never runs, before the timer gets to "rinse" the heating delay light on the door comes on and the timer stops. The heater is still on (120volts) nothing further happens it just boils away on the water in the washer. Note: If I manually forward the timer to "rinse" the motor will kick in and run but does not pump out w


Most common d/w power is 120 volts, check for 120 volts with a  ... Dishwashers

Dishwasher runs for appx 14 min & stops washing half way thru wash cycle. Timer contunies to run. No drain pump out (nothing). Let dishwasher set idle for appx 1 hour and it will re-set. Set timer forward to end of wash cycle and it will complete rinse and final rinse. Then go to dry. Timer works ok.


This sounds like something is stuck in the drain pump. You can remove the inner cover to look for obstructions. You have a dual purpose motor it does the both circulating and draining. The blockage is causing it to overheat and trip the thermal prote ... Whirlpool DU840CWD Dishwasher

Asko dw20 pump keeps running even with door open and turned off... The machine got to the final cycle then the pump just keeps running and the glass icon (L2) keeps flashing. All the water is not evacuated from the washer. When I power off from the front the drain pump still runs (and water is still not draining). When I power cycle from the mains (waiting 10 seconds) the pump engages again and the water level drops a bit and then stops draining. I have done this until all the water is empty an


... Asko Dishwashers

GE Dish Washer GSD 2800 DO3 runs a partial cycle...(even empty) and then beep and gives a message on control panel "washer arm blocked". Even ran without dish rack in washer still got the message. Push reset button and washer starts back runs a couple minutes and then stops and then beep and gives the same message on control panel "washer arm blocked" again. There is "NOTHING BLOCKING" the washer arm!


The rotating arm has a magnet in it to let the controls know if it is turning. Yours is not turning so \012\012\012\012check the jets for blockages... you might have to remove the arm to clean them properly ... Dishwashers

I have a Bosch SHU66C02. I opened the door to stop it from running temporarily, while it was sitting not running, it leaked all of the water out of the bottom right corner of the door, and when I went to start it later it just hummed but the timer didn't go down for over an hour. I tried to put more water in but as soon as I started I could hear the water added to drain. I turned the breaker in the fuze box off to it and let it sit for over an hour, but when I restarted, the timer was still at


... Bosch 24 in. SHU66C02 / SHU66C06 Built-in Dishwasher

I have a SE24T250 and the timer on the auto programme says 188 mins (it is usually around 120 mins) When the prog runs it doesn't finish and shows 1 minute to go and never gets to the drying or end of cycle part of the programme. Have tried the reset but it still shows 188 mins when complete. Any ideas?


... Siemens Dishwashers

Hi, I have an ASKO D3250 dishwasher and it keeps stopping during the wash cycle and flashing the heavy pots and pots symbol simultaneously. I tried cleaning the filter basket and found a little plastic part floating in there that has printed on it PP-T20. I don't know where this piece goes or if it's even the culprit. There is a little bit of water not draining from the filter area when I unscrew the outer filter basket, I cleaned it out, but when I re-run it, it still stops and gives the dual f


The part is a cap for the drain pump. You can put it back into position by removing the filters and placing it to the left of where the circular filter would be positioned. The part goes in with the part numbers on the bottom facing down. When posit ... Asko 24 in. D3530FI Built-in Dishwasher

Whirlpool ADG7540 approx 4 years old (maybe a bit older) I have ran diagnositic check and the start light flashes 4 times stops briefly then flashes 4 times again over and over along with a continuous bleeping. When I put the dishwasher on any program I can hear the pump running but after a few mins the same flashing and beeping occurs although it sounds as if the pump is still running. I have taken off the pump checked for blockages and also checked the outlet hoses and spiggot, there are non.


Yikes, we have just identified this exact same problem tonight. If you've had any success with fixing it, we would sure appreciate hearing how. Best of luck with your machine ... Whirlpool 24 in. ADG7540 Built-in Dishwasher

I have a Beko DE 6340 dishwasher. it was blocked in the pipe so stopped running, i cleared the blockage so that the water pumped out but now it still wont go even tho the lights are on and it still makes a noise as tho its going.


... Dishwashers

Got a Frigidaire model FDB750RCS0. Now it was running for a couple of min then I hear a clicking sound. Thought it might be something hitting the propeller. I opened the door and nothing. Closed it and now it wont even work. Thought the breaker got tripped but not even that. Now when I had it set back to the cancel part, the Clean Light comes on very dim where as before it use to be bright. Any solutions?


... Frigidaire 24 in. FDB750RC Slim-Line Built-In Dishwasher

When I start the top drawer it defaults to 5 minutes (with the lights Heavy, Fast, Rinse highlighted) runs for a couple minutes, then stops and the LED starts randomly cycling through all kinds of codes very quickly. There is water in the tub that has not drained after completing the couple minutes of operation. This cycle repeats itself if I hit the power button again after the LED starts freaking out. The 5 min cycle shows in the LED, sometimes with the no circulation error, sometimes with the


Here is the solution: \015\012http://applianceguru.com/forum1/24814.html ... Fisher and Paykel 23 in. DD-603SS Built-in Dishwasher

Kitchenaid kudio f6ss6 stops running after 10 min and green lite blinks I reset but still happensnks


Most likely the heater circuit is faulty. ... Fisher and Paykel 23 in. DD-603SS Built-in Dishwasher

Miele Diamante G 2150 SCU Dishwasher problem ----The program cycle indicators "Rinse", "Drying" and "End" flash at the same time. The drain pump is running when the door is open. I have reset the power and cleaned the drain pump and non return valve and Spun the propeller several times in both directions to check for obstructions. Still has the same problem. Water is being drained continuously even with power switch on dishwasher turned off.. Had to shut the breaker off to get it to stop. A


Hi\015\012\015\012Plugged system or a jammed drain pump can cause these issues, also make sure the drain hose is not blocked. Check the drain hose for any visible clogging, remove if present. If no visible lint is present then remo ... Dishwashers

My Frigidaire Dishwasher keeps going to 99 min even though im just trying to run the quick clean. The dishes that are in the dishwasher are practically clean any way . . . how do i stop this?


... Frigidaire Dishwashers

Greetings, My Viking disk washer Model # Dfud042 runs 4-5 min then makes several cliking sounds and stops. The program light for the light china is blinking, the soap dispinser still has soap in it, and water remains in bottom of the washer. Regards, James Parker


Hi,\015\012If it is filling and draining ok, then I suggest the problem lies with the main heating element.\015\012Disconnect from the supply and turn off water. Pull forward, to gain access to the element from underneath.\015\012Te ... Viking DFUD042 Built-in Dishwasher

My ASKO D1706 drain pump will not stop running and the system will not advance to the next cycle even though the timer keeps spinning. What's happening here?


Hello,Welcome to FixYa.Based on your description "drain pump will not stop running and the system will not advan ... Asko D1706 Built-in Dishwasher

Bell rings when starting the cycle it runs for about 5-10 mins then the bell rings and stops it looks like pe or 6e on the planel flashing but it still happens on the other cycles what could it be can you help


You have either a water fill or water temperature problem.  Not sure because you couldn't be specific on the error problem.  You will need to call a qualified LG technician to diagnose this properly. ... LG 24 in. LD-12BS6 Stainless Steel Free-standing Dishwasher

We have a +11 year old Bosch SHU3006/UC/U06 that never leaves the wash cycle. We had to stop it during our last test run at 3 hours. Chat advise is suggesting a water temperature problem (I origionall thought the timer), suggesting that the cycle will not advance until it hits a set temperature (170 degrees). We checked and noticed that the water in the machine was only around 90 degrees during a wash cycle. We do not have exploded views or parts drawings, nor electrical schematics. I wou


Check continuity of the heating element to see if it is broken/open.\015\012\015\012The dishwasher prefers that the incoming water (water heater) be 120 degrees (F) ... Bosch SHU3036UC Dishwasher

The wash cycle times seem to vary considerably , but the trouble is it runs even after the timer reaches 0 and when I stop it the dishes aren't very clean . It does this @ every setting


Hi,There could be many Reasons. Few main Reasons are as follows :-\015\012\015\012 \015\012 Water-inlet valve\015\012 \015\012 \015\012 \015\012 \015\012 ... Bosch 24 in. SHE44C02UC / SHE44C06UC / SHE44C07UC Built-in Dishwasher

Dishwasher stop running with about a minute left to go, water still in the bottom. Following lights are blinking; high temp wash, sanitize, and no heat dry. I have check that the garbage disposal is clear, even ran it for a while. The over flow valve does move up and down. Pressing the buttons mentioned above does nothing.


I am assuming this problem has been fixed. If not then please post a comment to confirm which bit is still not resolved. ... Frigidaire Dishwashers

My dishwasher is not quite 2yrs. old and has always worked great until now. Top rack cups and mugs still are dirty inside from coffee, lipstick, etc., glasses have spots and are cloudy, and silverware seems to have streaks and become darker. I always turn hot water on at faucet prior to running dishwasher. I have check the water faucet and it is 120 degrees. After starting the dishwasher I checked and the water is not even 100. After about 20 mins. the water was aprrox. 117 degrees. The


Hello,Welcome to FixYa,Based on your description I`d suspect a plugged wash pump.The place to start for that is to pull the pump filter, spray arm and check for food deposit, broken glass, undesolved detergent and ... KitchenAid 24 in. KUDI02IRBS Stainless Steel Built-in Dishwasher

Regular cycle took 3 hours then would not shut off. Stopped at 1 min. soapy water still filled the bottom, dishes had soap on them. water finally drained almost out but I am afraid too run another cycle. any ideas? thanks


There is a heating element in the dishwasher that heats the water to about 155F at which point a thermostat closes and sends power to the timer to advance. If the water does not reach this temp, the dishwasher will not advance. Often the problem lies ... Bosch 24 in. SHE44C02UC / SHE44C06UC / SHE44C07UC Built-in Dishwasher
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.1489 seconds