Having problems with your Bosch SHE4AM15UC Dishwasher ?

My Bosch dishwasher runs for a second then goes straight to clean. I have tried each cycle and it does the same for each. Model number she4am15uc


Answers :

Repair Help & Product Troubleshooting for Bosch SHE4AM15UC Dishwasher

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

My Bosch dishwasher runs for a second then goes straight to clean. I have tried each cycle and it does the same for each. Model number she4am15uc


... Bosch SHE4AM15UC Dishwasher

I have a Kenmore Ultra Wash Dishwasher (Model Number 665.15634) that will not fill up properly. When I try to run a cycle (any cycle), the first thing the dishwasher should do is fill up with hot water. But in my case, my dishwasher fills for about 10 seconds, then stops. Then tries to fill again for about 7 seconds, then abruptly stops again. And this process goes on and on and on. The dishwasher never fully fills up nor starts the wash sequence properly. Once the dishwasher fills up, it


... Dishwashers

Dishwasher: Kenmore ultra wash sensor quiet guard plus. I'm in a rental so I don't have the manual or model number. A few days ago it just wouldn't start the wash cycle. When you press normal wash then start the no heat dry and lock lights flash every other second or so but nothing happens. I can hit the cancel button and it will make sounds like its trying to drain, and after about 5 minutes stops. I've done the heated wash/ no heat dry sequence to try to reset but no luck. Also tried turn


... Kenmore Dishwashers

Greetings. I have a Fisher & Paykel dishdrawer - the top drawer appears to have lost power mid cycle and the lid has not retracted - no led display - no response from the buttons. The bottom drawer functions ok. I have tried turning the power off at the wall for 30 seconds and on again. I have tried swapping the top and bottom controllers and the bottom still works but the top does not, so the controllers must be ok Not sure where to find the model number sorry. Any suggestions?


Describethe inside of unit,any wear on it anywhere, the rack the dishes go on is it plastic coated? is it wore with rust comeing though on tips here and there? ... Fisher and Paykel DishDrawer DS605FDSM Stainless Steel 23 in Builtin Dishwasher

I have Whirlpool Quiet Partner III dishwasher, Model number GU2400XTPS3, Serial number FS1820245. I recently had the thermal fuse replaced by an authorized service repair person. My problem is that the dishwasher stops mid-cycle. I noticed that when I try to clean it in the normal cycle, the dishwasher stops with about 46 or 47 minutes remaining, and the green light flashes continuously. I have pressed the Normal and Heated Dry buttons, as well as the Sani Dry and HEated dry buttons to res


... Whirlpool 24 in. ADG7540 Built-in Dishwasher

I have Whirlpool Quiet Partner III dishwasher, Model number GU2400XTPS3, Serial number FS1820245. I recently had the thermal fuse replaced by an authorized service repair person. My problem is that the dishwasher stops mid-cycle. I noticed that when I try to clean it in the normal cycle, the dishwasher stops with about 46 or 47 minutes remaining, and the green light flashes continuously. I have pressed the Normal and Heated Dry buttons, as well as the Sani Dry and HEated dry buttons to reset the


... Whirlpool GU2400XTP Built-in Dishwasher

I have a Kenmore Type 575-0 Dishwasher, model number 665.16033401, Style 16033. It runs trough the cycle, once the cycle is complete the clean mode light is on but most dishes are still dirty. I had someone here to repair this about a year ago. All he did was press alternating two buttons, which I have tried, it resets and lets you start a new cycle. However, the problem remains. Last time there was only button pressing involved, no need to replace anything. So, I would hate to have to pay ag


You need an electronic control and heating element ... Dishwashers

Model KUDS30FXSSO, Unit attempts to start. Blue light on the front of the door comes on indicating the cycle is starting. Pump runs a few seconds as normal. Then the maching sounds like it trying to start the next step three or four times. The blue light goes out. The washing cycle then switches to cancel/drain, ( I opened the door to see which control lights were on.) runs the drain pump then stops. The green light on the front panel does not come on indicating the cycle was completed.


... KitchenAid 24 in. KUDP01FL Built-in Dishwasher

Whirlpool model DU960 - from 2001, I think. Stopped running mid-cycle and the cycle lights flash. Won't run. How to fix? If I press 'Cancel/Drain', it flashes that button light. If I press one of the wash cycles again, it turns on the pump for about 1 second, shuts off and the lights flash again. I tried turning off the circuit breaker and turning it back on, but it still won't run. Is this fixable? Do I need to call for service? Or, would I be better off just replacing it?


I have a whilpool du960 the rinse only light is flashing and the light wash light is also flashing. ... Whirlpool Dishwashers

Dishwasher will not start cycle it is locked and will not unlock. door panel suggestion says press and hold energy saver dry pad x3 seconds that is not an option on this model. what can we do.... the numbers 8573025 and the other is 8573030 the numbers on the door we also have additional numbers from our user manual that is part no 8269551


... KitchenAid Dishwashers

I just started a light wash cycle on my Kenmore Ultrawash model 665.1359. The cycle stopped suddenly and now the heated dry button is flashing. I tried pressing it for 10 seconds, but it won't stop. I cannot get the dishwasher to resume its cycle. What do I do??


... Kenmore Dishwashers

I have a Bosch dishwasher model SHU9915 that is 8 years old. It just give a ''hum'' when it tries to go into the wash cycle. It stops humming after a few seconds, like it overheats or overloads, then after a minute or so it tries to start the motor again and ''hums''. It continues this as long as you wish to watch it. Does it sound like the pump has gone out or just a capacitor or something small?


Hi\015\012\015\012 \015\012\015\012 \015\012\015\012Thanks for using FixYa. You are right the issue is with\015\012the motor; don’t think it’s related to a capacitor. The hum ... Bosch Dishwashers

I have a SMEG dishwasher. Can't find the model number on dishwasher or manual. Had two flashing lights and referred to manual - indicates a blocked filter. Cleaned that out, but now when I try to put it on "light" cycle (indicated by wineglass symbol), that light flashes (but no others as would indicate a problem).. All the other cycles work fine. Any ideas? Thank you!


Hi.If only the crystal light is flashing and no other light is on, then that is not an error code. Problem can be a temporary malfunction, or a defective control module or keypad.The delicate (crystal) light flashing with last ... Smeg 24 in. STX2 Built-in Dishwasher

My Maytag dishwasher is 9 years old-- Model number MDB7100AWW, serial number 27754072ZQ It has worked fine until about a month ago, when I began noticing a kind of "scum" on the silverware and some of the dishes after completing a wash cycle. The top rack will squeak and have some resistance when pulled out, whereas before it always came out smoothly. I have always used powdered Cascade. I've tried using less, thinking I might be putting too much in. Then I got a rinse agent. These thin


We had the same problrms, and then the machine wouldn't even clean anything, we took apart the lower spinner and cleaned the plastic filters and now it works like new ... Maytag Dishwashers

I have just moved into a new house with an Asko Dishwasher. It is not working. I program it, the icon for the cycle I have chosen lights up in red, I press start, that lights up in red, the water runs in for about 30 seconds and then nothing more happens. This happens on every wash cycle that I attempt to use. It does not appear to be on time delay as that icon does not light up. Also I have left it for a number of hours after I have tried to start it and still nothing happens. I would appreciat


... Asko Dishwashers

CDA dishwasher (model number CW496) , stops working at the rinse cycle, and does not empty, filter is ok, tried re-setting the programme but unless there is no water being held the programme won't work


My dishwasher starts off with good intentions then a couple of minutes later it starts beeping non stop.I open the door to find it has turned on to the rinse cycle and will not do its job.I continue to start it again and then it repeats the problem a ... Dishwashers

Our dishwasher's lock indicator won't turn off, even after holding down the heated dry button for 3 seconds. We also tried disconnecting the power for 5 minutes and it would not reset. What part do I need? The model number is mdbh965aww.


Try holding the button down for longer say 5 seconds. When you push the button and hold it the little green light should blink. I would disconnect the power for longer..try 20 minutes. If that does not work then remove the inner panel and disconnect ... Maytag Dishwashers

Hi My dishwasher stopped mid rinse cycle, with a little water still in it. Lots of beeping later i managed to set it back to start but it wont go, just beeps. The line to sink seems to be clear. There is no gurgle sound when i try to start it. model number SB907WJ*00


Hi,Is there my error code there?If you set the appliance to drain do you hear the pump running?Bail the water out manually and then take the filters out.Bail out the water below the filters.Take off the ... Dishwashers

I have an Electrolux dishwasher model ESF489, and I can't get water to go into it.the water goes as far as the machine then the inlet hose just pressurises up.I know the hose is clear .The machine tries to go through its cycles but because the water will not flow,it just cuts out after a few seconds.????


Assuming the control card is working ok, the most likely problem is the water inlet valve which may have a faulty solenoid. Do you not get any indication of beep or fault lights on the dishwasher.\015\012You can find a possible replacement at ... Electrolux Dishwashers

Hi My Bosh dishwasher is model SMU 7056UC The water is not out of the bottom of the unit, when the cycle is complete it is still cloudy. What do we do? What part number do we need for the door seal as it leeks ? I tried to down load the manual to see the parts and couldn't.


Hi \012either your dishwasher has a blocked filter or a blocked water outlet. Some dishwashers will reset if you can unblock the pump or outlet where it goes to waste. You will need to bail out the water first, then pull out all the filters and ... Bosch Dishwashers

My Whirlpool Quiet Partner IV dishwasher model number GU3600XTRY1 has stopped working. The normal light on the top panel is flashing and one lighted bar is showing in the start touch circle. Upon throwing the breaker in fuse box panel seems cleared but when you try to press any buttons it makes a starting noise for a few seconds then goes quiet and returns to the state above.. Thanks


... Whirlpool 24 in. GU3600XTRY Stainless Steel Built-in Dishwasher

Whirlpool dishwasher, model DU1050XTPQ1, type 575-0; problem: showing no sign of power to unit and bottom of dishwasher is full of water---it apparently stopped during cycle. Is there a reset button? I have tried depressing the front panel "lock" button for five to ten seconds to unlock the system with no luck. The washer is hard wired to the home electrical system. What should be my next course of action? Thanks


... Whirlpool 24 in. DU1050SS Built-in Dishwasher

Ge dishwasher im having a problem with a dishwasher in a  home i just bought....it worked fine at first, now it has basically two cycles, off and wash....it will not try to fill, or pump out, it just washes.....the model number is gsd1100g02ww.  i took out the timer assembly and  found nothing  visibly wrong...but hey, i can fill it  up  myself with water and shop vac  it  out and it works"i tell my wife" i wont  tell u what she told me in return......any help i would appreciate.


Try taking the dishwasher out so u can see the bottom, or if u cant, pull the bottom front plate off, remove the plate, ull see a pump looking peice, small with main water line hooked to it, disconnect it and pull it off, u will need to take it ... GE 25 in. Nautilus GSC3400J Free-standing Dishwasher

Maytag MDBH965AWQ I have a Maytag dishwasher model number MDBH965AWQ. A few weeks ago the clean and sanitized lights would not go off after the door had been left open for over 30 seconds. Then last week, the diswasher would shut off in mid cycle and all lights would turn off with water still in the dishwasher. Today, I noticed that I am able to open the dishwasher door while the dishwasher is running and it will continue to run like the door was never opened. Now it is starting to trip the brea


2 items in need of testing are the door switch - and the main controller board/timer unit.CLIC ... Maytag 24 in. MDBH965AW Built-in Dishwasher

My 6-year-old dishwasher is not getting my dishes clean. glassware feels gritty; flatware looks dirty. I've tried cleaning the interior, and running a potscrubber cycle with the dishwasher empty except for a coffee mug filled with vinegar. What is wrong, and can I fix it? Model number is KUDP01FLBL2.


... KitchenAid Dishwashers
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.1032 seconds