Having problems with your Bosch SHU33A05UC Stainless Steel Dishwasher ?

Bosch dishwasher shu33a05uc22 keeps running in wash cycle and doees not shut off


Answers :

Repair Help & Product Troubleshooting for Bosch SHU33A05UC Stainless Steel Dishwasher

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Bosch dishwasher shu33a05uc22 keeps running in wash cycle and doees not shut off


... Bosch SHU33A05UC Stainless Steel Dishwasher

When I press the start button, Bosch dishwasher (model SHY56A 05UC) just keep running the motor pumping the water out of dishwasher, irrespective of: 1) the wash cycle it is on, 2) whether the door is closed or open, 3) whether I cancel drain cycle, as told by Bosch Cust Svc in following steps: - "Cancel Drain" by pressing 'Quick Wash' and 'Regular Wash' buttons together for a minute until it shows 0* - Shut power off for a minute and wait for a minute - Restart on Quick Cycle. Paid


What is happenig i believe and has happened to me 2 times is that the water level float that is on the left side of dishwasher is stuck.\015\012\015\012Either remove side panel and flick lever or pull dishwasher out and tap lower portion ... Bosch SHY56A02 / SHY56A06 Built-in Dishwasher

Hello I hope someone can help me. I have a Siemens Hydrosensor Dishwasher that when I start it up in runs for a while and shuts off. I need to open and close the door several times then it may run for a short while, 15 seconds to a couple minutes and then shut down again. Finally, it will run through the rest of the cycle. The issue generally occurs when the digital timer is between 85 and 78. If I just leave it go once it shuts down it does eventually start up and will complete the washing cycl


It sounds like the door switch is at fault, it will cause the symptoms you stated. ... Dishwashers

Have Whirlpool dishwasher Gold Series, Model GU9805CGB1 which stops part way through wash cycle with the led indicator blinks on the normal cycle.....if we ope nthe door and shut ...it continues until part way through rinse cycle...stops again....led indicator blinks again.....we open the door & shut and it continues....but then continues to run through the normal wash cycle continuously.....until we open the door again.....what's wrong???


Sounds like the door is losing contact with the door switch, first thing i would check is the door strike.Metal strike plate located on the tub itself that the door latch catches as it closes. its a spring metal striker, i would try bending it down ... Dishwashers

Dishwasher malfunction MOST OF THE TIME it shuts itself down before fully filling with water - SOMETIMES it doesn't shut down until the minute the wash pump starts - SOMETIMES it washes for 10 or 20 minutes before shutting down - SOMETIMES it will even run a whole cycle, BUT it doesn't open the soap dispenser door - tried doing a diagnostic run but after it turned on all the lights on the panel it started to fill with water and shut itself down......... HELP


Follow this steps and fix it. God bless youFloat Switch\012\012\012The float switch may be hung up and this can cause the dishwasher to be stuck in a cycle. Check the ... Dishwashers

Run cycle dishwasher runs wash cycle over and over...one time 6 hrs! always shuts off but washes 5-6 times


Yep ,, Its your timer it needs replacing.. \015\012\015\012The timer controls tehwash sycle, the problem is it isnt switching off in time so it goes throug cycels until it trips.. What you need to do is to replace it,.\015\012 ... Maytag 24 in. MDB5600A Jetclean II Built-in Dishwasher

Hi I have a problem with my Bosch SHU43CO6UC/22 dishwasher. using "power scrub plus" and "regular" cycles it will continue to fill and overflow the door, after the cycle has run even when the power button is off. I am using the quick wash cycle at the moment .After the cycle has run i open and check if the water has drained or not,If it has it does not continue to fill and flood.If there is water in the bottom after the cycle has finished it will keep rising untill I push the rinse hold button


The bosch dishwashers use a fill valve that is attatched to the inlet hose. yours is stuck in the open position. this usually happens when you have hard water, as the minerals build up on the sealing surface of the water valve. there is no easy ... Dishwashers

When dishwasher is turned on to the cycle mode - it fills with water - heater heats water to the proper temp - pump starts - washer goes through it's complete cycle - even pumping out the wash water and the drying cycle,then shuts down. the problem is that it does not circulate the wash water thru. the spray heads-even though the circ,pump is running.Even though the unit is 8 yrs.old and hasn't run for 6 yrs,my wife&i do our dishes by hand. our unit is a GU1200XTKB0 Serial# FL4617501


The impeller on the wash pump is worn out or the disposer screen is obstructed. Disassemble as needed to investigate the cause. ... Whirlpool 24 in. GU1200XT Built-in Dishwasher

Kenmore Dishwasher Model 665.11643300 Cycle will not run. Normal Wash light blinking Cancel light will also blink (but can be cancelled by holding button down) I tried shutting down the power and resetting at the breaker. I tried other buttons like Air Dry, etc to see if there was some sort of sequence Note* last cycle ran was rinse cycle many months ago - house has been vacant and dishwasher has not been in use.


I will look a bit further in detail about your dishwasher problem. I am assuming you have checked the inlet water tap to the dishwasher is turned on. ... Dishwashers

Shu4302uc I have a Bosch SHU4302UC Dishwasher and the Regular Wash and the Clean indicator lights are always on. It just keeps running and running and does not seem to go through an entire cycle. I can choose any other cycle and it does the same thing---it continuously runs and the clean light is always on.


Hoe can you rate a question about a dishwasher that dose not work inappropriate????\015\012Please think before rating, or no one will give you advice, and you'll just have to pay the repair-man whatever he tells you it costs.\015\012I act ... Bosch 24 in. SHU43 Built-in Dishwasher

I received a second-hand as-is Akso D3530 (model #107353001) dishwasher. It washes perfectly fine, but at the end of the cycle, it keeps running. It does not seem to be the drain that is running, but rather the circulating pump. I have fully emptied the pan of water (there was only a little in it (you couldn't see it until you removed the sieve) using a turkey baster and it keeps running. I also checked the float sensor in the bottom. The float sensor is not tripped, and when I manually trip it,


Hi.The float switch is not a water level switch, but an overfill switch. The control board uses the input from the pressure sensor to decide when to stop the pump.When you open the float switch circuit the machine 'thinks' that ther ... Asko 24 in. D3530FI Built-in Dishwasher

Dishwasher keeps running in wash cycle


I lifted this off the tech sheet for your dishwasher, it explains your problem of long wash times. Heater or temperaturesensor problem:■ Open connection orcomponent in heater ortemperature sensorcircuit(s). ... Whirlpool 24 in. DU1100XTPS Built-in Dishwasher

Dishwasher has been stored. Was working fine-ish for first half dozen washes. Now not starting wash. From troubleshooting in manual I'm holding down first two buttons and it's saying "End", but keeps moving back to SOAK function (17 mins) and not doing anything. Display shows whole soak cycle to run, but on holding down start button it makes no difference - doesn't beep to acknowledge and start cycle.


After bringing the unit from storage did you conduct any service on it? Did you remove any water before storing the unit? when you store a unit like this you need to totally empty the unit from everything including wate ... Smeg 24 in. DWF614SS Stainless Steel Free-standing Dishwasher

Float does not shut off the water when dishwasher is being filled. IWater keeps running, fills up and runs out of the front of the dishwasher. Also it will not pump the water out at end of cycle.


Check the float to make sure it moves freely up and down, and it should click when it moves. Remove float and clean around the float tube-you may need to do this from below, through the access panel. Use white vinegar to scrub the float and ... Maytag MDC4650AW Built-in Dishwasher

My Kenmore Elite dishwasher did not drain the water out of the bottom after the dishes were washed last night. Could I possibly have pushed a wrong button to keep it from draining, or do I have a problem? All the dishes were clean. Should I run it through another wash cycle? I've got water standing in the bottom of my dishwasher.


Yes , If the program controller has hung it would have skipped the drain cycle. So try to redo the cycle and see if the drain works, is not check the program controller and the drain valve/pump.- if there is food particles that have clogged and block ... Kenmore Dishwashers

I have a Diplomat ADP8242 Dishwasher that continues to run during its wash cycle. The machine starts and heats up correctly but will not switch to its rinse cycle and just keeps running with 2 intermitent beeps. I have tried to reset the programe which does pump the water out and resets the control panel, but unfortunatly does not clear the fault. Can you help?


... Dishwashers

All of a sudden, my Kenmore dishwasher (Model 363.1411691) will not cycle. When I lock it shut and try to set it to wash, all I hear is a click--no motor running, no water sounds. As I advance the timer knob, I just get clicks where each cycle should begin. There is standing water in the bottom of the dishwasher which does not drain out. Any advice would be much appreciated, for sure.


Hi.The clicks are simply the relays in the timer board that try switching on. The control module is likely working.The cycle does not start because of a different problem.If no light is coming on, then ensure that wall socket ... Dishwashers

My Amana dishwasher which is an ADB1600AWS1 will go through it's cycles but will just not shut off. It keeps running and running. We have tried to reset but continues to run and run and run. Any thoughts?


Hi\015\012\015\012 \015\012\015\012 \015\012\015\012Thanks for using FixYa. If it won\342\200\231t stop and keeps\015\012on running then the first thing that should be checke ... Amana Dishwashers

Bosch built in dishwasher shu4302uc The dishwasher appears to run through the cycle but the cycle keeps running. I have checked the screens and they were clear. I have a Bosch Dishwasher SHU4302UC and I can't figure out how to cancel the cycle it's in. It keeps running and running. It pumped all the water out and the LED indicator are lit for the rinse/dry.


There is a recall on the control board of many of these models. I have written a guide to help. It is here. Look for the phone number near ... Bosch 24 in. SHU43 Built-in Dishwasher

My maytag legacy dishwasher, series 300 model number mdbh 955aws keeps running for hours. it appears that it is repeating the wash cycle


... Maytag MDBH955AWS Stainless Steel 24 in. Built-in Dishwasher

My dishwasher doesn't seem to fill with water. The heat cycle keeps running and never shuts off. I have discovered that there was some hard water buildup in the drain. I cleaned that out and I still have the same problem. It almost seems like it is not completing a cycle and it won't reset.


Sounds like a bad temperature sensor/thermistor or timer. ... Viking 24 in. Professional Series VUD141 (Ultra-Premium) Built-in Dishwasher

My dishwasher is a Fridigdaire FDB510LCS1, approximately five years old. The timer/knob stops advancing at about 7 o'clock, somewhere in the wash cycle. But the washer keeps running. I marked the place where it stops and, on additional tests, it stops in exactly the same place. I can advance the knob slightly past this location and the washer continues through to the end of the cycle.


Hi\015\012\015\012This is due to a faulty timer on your dishwasher. You would need to replace it to resolve this issue. You can buy the timer for your dishwasher from this link---\015\012\015\012 ... Frigidaire 24 in. FDB510LC Free-standing Dishwasher

I start a wash cycle or rinse cycle and the dishwasher runs for about 1 minute. Water comes into the pan and then the washer shuts off and the control panel goes dark.


... Dacor Epicure ED24 Stainless Steel Builtin Dishwasher

Kenmore Ultra Wash dishwasher model number 665.1374 or 665.1384 I am a technician. This unit does nothing. It has power and ground. I have tested the door switches. They test good. If I unplug the unit and plug it back in then it will run a drain cycle, at least that is what I think it is doing. The motor runs for about 4 minutes. Once it shuts off, there is no further response. No control indicators illuminate. No response from pushing any of the touch buttons.


... Dishwashers

On any of the normal wash cycles, the digital timer only goes down to 42 and then stays there. The cycle just keeps on running until you manually shut it off.


My disewashar work 20 or 30 minits and then displeyd error F3 this is the problam. ... Kenmore Dishwashers
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.2520 seconds