Having problems with your Bosch SHU5316UC Dishwasher ?

Is there a reset?

\015 Is there a reset on the SHU5316IC?\015

Answers :

Depress the on/off button, then depress at the same time the SCRUB WASH button and the DELICATE/ECONOMY buttons at the same and hold for approximately 3 seconds. You will see the alphanumeric display progressto end. When the drain pump has stopped and the alphanumeric display is at the end, the cycle is complete and the the dishwasher is reset.
Repair Help & Product Troubleshooting for Bosch SHU5316UC Dishwasher

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Dishwasher PLD 3465 REC I cannot reset the display panel. I took the kickplate off which was supposed to have the code for the reset but it had nothing related to reseting the display panel. It is stuck on 94 min clean time. What is the code to reset? There is nothing in the Use & Care manual that tells you how to reset.


Putting the unit into service mode will reset the the display. Look at the instructions behind the front panel. If the unit fills and does not wash, the wash motor may not be working. ... Frigidaire 24 in. PLD3465REC Stainless Steel Built-in Dishwasher

I have a Kenmore dishwasher, model 665.16039. Over the past month (we were on vacation 8 days over Xmas, but I assume it would have happened then, too) it has required rebooting using the Normal Wash - Heated Dry reset about 4-6 times. It would then do a couple loads okay, then need resetting. Now, however, it's refusing to reset to a point at which the Start buton will work. When I reset it, it flashes all the lights (incl. Start), and it fills, sprays, empties, etc. just as though it works


Make sure there is no water damage. ... Kenmore 24 in. 16039 Built-in Dishwasher

I have a GE Profile Triton Dishwasher and it has worked fine for about 8 years. Suddenly it will not reset. The reset light blinks after reset but you can not choose a normal cycle afterwards. I shut of the machine by pulling the fuse box. I turned it back on but again it will not reset?


Hello, how are you?\015\012It sounds like you have a stuck key on the keypad, preventing you to push any other key.\015\012I've seen this problem many times in the past 4 years.\015\012Good luck.\015\012Ned ... GE 24 in. Profile PDW7800 Built-in Dishwasher

Diplomat ADP8224 The thermostat on my dishwasher (Diplomat ADP8224) has tripped and requires resetting. This has been carried out by an engineer who seems to reset somewhere under the machine. I have tried to locate the reset but with no success. Any ideas where this is and how to carry out reset


... Bosch 24 in. SHU43 Built-in Dishwasher

I cant reset the dish washer is operating in 11 minutes which is rinse only??? I have turned it off, but it doesnt reset. can you please let me know how to reset it?


The reason for the dishwasher to default to Rinse only cycle is likely the heater is faulty. Does this happen with both the drawers?Also make sure the top panel switches are clean. Use a damp clean cloth and wipe the top panel inside drawer. ... Fisher and Paykel DD605SS Stainless Steel Dishwasher

My Bosch SHE45M built-in dishwasher is suddenly taking an extra-long time to go through its cycles. On Regular wash it will countdown from 117 minutes to 31 minutes. When it hits that time it resets to 87 minutes, then counts down to 1 minute and will not stop. I have to hit the cancel-reset buttons for it to drain. I have tried to do a hard reset by cutting the power at the breaker for 20 minutes or more. I'm interested in potential parts and a description of how to fit it! Thanks in advance.


... Bosch SHE45M06UC Built-in Dishwasher

My kenmore elite model # 253.4448370 keeps beeping and won't stop. We try to press reset button because high temp and power failure lights are flashing but when we press reset button it doesn't seem like the button works..it doesn't reset like it use to...does anyone know how to make this beeping stop? It appears that the temps are right for both frig and feezer but beeping won't stop...HELP!!


... Kenmore Dishwashers

Karcher K3.92 M 1750 PSI poweer Washer motor won't start. Followed Reset/Test/Reset sequence with cord plugged directly into outlet. Light on cord near Reset comes on when Reset pressed down but goes off when Reset released (Normal?) Switch ON and trigger pressed releases water stream but no motor action.


They are sensitive to large extention cords. My father in laws pops reset when a small cord is used. If internally shorted- motor will continually pop the reset even plugged direct to outlet. Check voltage at outlet. ... Karcher 2500 PSI Pressure Washer

Kuds30fxss Recently my Kitchen Aid dishwasher, Model No. KUDS30FXSS, began to cease washing and begin draining after only a few minutes of washing. I have been searching for the "reset sequence" as I know that most appliances have a sequence of buttons you can press on their control panel in order to reset any faults in the system, but I have been unsuccessful. Could someone please tell me what the reset sequence is, and if possible, what another solution to my problem may be. I have already


... KitchenAid KUDS30FXSS Builtin Dishwasher

Clean light is blinking, have already killed the power, then called to whirlpool and they walked me through resetting it by pushing buttons, however when i attempted to run it after resetting it, it started to run then went right back to the flashing clean light. i tried resetting it again, and ended up with the same result.


You may a a latching issue. d/w not latching properly. How long does it take before the clean light comes on after you reset it. does it fill with water? if so, then your motor may be defective. ... Whirlpool 24 in. DU1100XTP Built-in Dishwasher

Reset code I recently had a problem with my dishwasher that required me to use a reset code on my control panel. I can no longer find the manual that tells me that code. I was wondering if anyone knows it as to save a tech call. The error occurs when the clean light flashes. We have checked the heating element and the tech told us there is no problem there, we just need to reset the machine. The error has occured again, but this time because I tried to run the machine right when we came home fro


I believe the reset sequence is accomplished by pushing the NORMAL WASH then HEATED DRY buttons in that sequence two to three times. The unit will enter diagnostics mode, but can be stopped by pressing the CANCEL button. Let me know if this helps. ... Whirlpool 24 in. DU1050SS Built-in Dishwasher

My Frigidaire FDB956RBC0 has been having trouble resetting on the control panel for a new load. At first I could push several buttons or wait a little bit for it to reset then I could push start. Now I have to open the front panel & pull out a yellow & white plug, then plug it back in to reset the buttons for a new load.


... Frigidaire FDB956RB Built-in Dishwasher

My bosch dishwasher, one month old, has the active light flashing and the reset button won't reset it when I push it. A friend that was over opened the door when it was running because she can with hers, but ever since then, I had to take the water out and the active light is flashing and the wash light is lite. I hold the reset button for 5 seconds and then I shut it off for about 5 minutes, but when I turn it back on, the same things are happening


It sounds like the float is stuck. There is a float that stops the water from coming out when you open the door. It sounds like your friend stoped it in mid cycle and it jammed in the open position. Look on the inside of the machine for a plastic pie ... Bosch Dishwashers

I need to know how to reset the "brain" the start button is flashing and won't stop when I close the door it makes a humming noise and no water is running. I turned off the breaker but it won't reset. Is there like a "hard reset" I can do


I don't think you may need to reset the dishwasher. All that might be happening is the float switch located in the base may be malfunctioning. It could be stuck. Try pushing it down and see if it lifts up by itself. It should only lift when water is ... GE Adora GHDA656LSS Stainless Steel Built-in Dishwasher

Braemar ecostar heater keeps flashing user reset but resetting still won't work


... Dishwashers

I have 2005 model KUDSO1FL and clean light flashes 7 times and won't start . Solutions for reset don't match my buttons. what is the reset? I also have latch problems--machine pops open over


... KitchenAid 24 in. KUDI01FLSS Stainless Steel Built-in Dishwasher

GE Triton XL dishwasher makes high-pitched noise after a power outage and no buttons work. I reset the breaker and pressed the reset tab in top of the door.


... Dishwashers

Is there a reset button to reset bosch 9915 dishwasher cycle?


... Bosch SHU9915UC Dishwasher

Reseting Timer How do I reset the timer for the PDW7800 dish washer?


Press cancel should reset control board.if not unplug for 5 min.there is no button to reset it! if dose not reste may be bad board ... GE 24 in. Profile PDW7800 Built-in Dishwasher

My Maytag MDB8951AWS Dishwasher buttons do not respond, except Auto Clean, Start/Cancel and Delay. Consequently the only way to wash is on auto clean. I have tried disconnecting the power for an extended period to reset it. This hasn't worked is there a key combination to reset? Thnaks


... Dishwashers

Have a NEFF S5453XOGB built in dishwasher - put it on last night and came down this morning and nothing has been cleaned and I have 2 red lines in the time display. HAve tried resetting by holding the 2 buttons down and switching on - it shows the number 23 - as sson as I let go the lights continue to flash and the number 1 appears. I am resetting it correctly?


... Neff 24 in. S5453X1 Built-in Dishwasher

The dishwasher quit during a cycle. I can't get it to start. I have power to all portions of the dishwasher. Do you think the motor stopped due to overload? Is there a way I can reset the motor? If so where is the reset button?


If the Dishwasher cycle does not complete \015\012\015\012Test the ... GE Nautilus 24" Built-in Dishwasher

My dishwasher won't start has flashing lights and won't reset.Can anyone tell me how to reset this in order to reset dishwasher.


... Maytag 24 in. MDC4100A Free-standing Dishwasher

Hi, Had a power cut at my home and my Caple Di455DL Dishwasher was mid cycle on a glasswash program at the time, since power has been regained it will not restart or reset itself, it just lets a pulse of four beeps go once the door is shut and makes a sounds like its trying to pump out water? tried turning off at mains etc but cant get it to reset!


... Dishwashers

Towards end of dishwashing cycle error code comes up and consitently beeps, can not turn off by machine buttons or reset. We have to reset by power plug. Water is left in bottom of macine, dishwashing powder is left on most things. Rinse button then works, it then drains the machine no problem. So I dont think it is the pump.


No response ... Dishwashers
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.0473 seconds