Having problems with your Bosch SHU9915UC Dishwasher ?

The above chain exactly describes our dishwasher. I went ahead and got a new brain for it but how do you get the top housing/cover off to access the circuit board?


Answers :

Hello,
\015\012
\015\012Welcome to FixYa.
\015\012
\015\012I can provide you with the complete service manual, it's up to you. You'd need to provide an email address though for me to send the service manual to.
\015\012
\015\012I think the service manual can lay out for you in more detail the procedure to install a new control than I can. I'll watch for your reply.
\015\012
\015\012Regards,
\015\012
\015\012Macmarkus :)
Repair Help & Product Troubleshooting for Bosch SHU9915UC Dishwasher

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

The above chain exactly describes our dishwasher. I went ahead and got a new brain for it but how do you get the top housing/cover off to access the circuit board?


Hello,\015\012\015\012Welcome to FixYa.\015\012\015\012I can provide you with the complete service manual, it's up to you. You'd need to provide an email address though for me to send the service manual to.\ ... Bosch SHU9915UC Dishwasher

F1 error in top drawer even after replacing circuit board in bottom of unit. Please note there was now water in the first place. Model DD603SS Not sure weather to get fixed or just buy different brand? Any help appretiated Gordon.


It would be helpful to know the reason why you changed the circuit board.\015\012\015\012Is the bottom drawer working ok now?\015\012\015\012There are several reasons for F1 to show up including the water flood at base.\ ... Fisher and Paykel 23 in. DD-603SS Built-in Dishwasher

The circuit board on our Miele G646 dishwasher has failed. do we 1) see if we can get another one second hand and in which case what other models have a compatible circuit board 2) try and get the board repaired and who do you recommend 3) bite the bullet and pay an exorbitant amount for a new board or 4) give up and just buy a new machine Thanks


What is the dwasher doing or not doing and how do you know it's the board. More information required please. ... Dishwashers

Dishwasher starts and runs to 2nd rinse cycle, when pump starts to pump water out, all lights on front display flash along with key pab lights blinking. you can turn off and restart, but is does the same. Diswasher will also try to start when in off mode. Replaced circuit board and it does to same. Did I get a bad circuit board or is there another problem. Also when I try water service test, I get a Rinse aid fault.


U REPLACED THE CIRCUIT BOARD IN THE DOOR, THE ONE BEHIND THE CONTROL BUTTONS? THAT IS THE TIMER, IT IS KNOWN AS THE CCU OR CENTRAL CONTROL UNIT, THAT IS WHAT CONTROLS ALL TIMED FUNCTIONS, SO THAT REALLY IS THE ONLY PART THAT CAN CAUSE THIS PROBLEM ... Frigidaire 24 in. FDB1050REC Stainless Steel Built-in Dishwasher

Dd603 no power to top drawer. circuit board in top drawer ckecks ok bottom board and top drawer wiring harnes were burnt. replaced both pieces. Still no power to top drawer. Need some help. Thanks


... Fisher and Paykel Dishwashers

Gaggenau GM 915-710 UC6 dishwasher will not fill and wash. Close the door, turn lever. Empties water from sump. (drain hose was not clamped above disposal outlet nipple, fixed that) Machine empties sump, but will not stop after sump is dry. Will not initiate fill and wash. Manually stop machine. Can't get control board to do the diagnostic to get an F #. Pressing button 1 and 3 at the same time. A couple of the plastic tabs on the circuit boards plastic support housing that link the


... Gaggenau GI936-760 Dishwasher

Having trouble with dishwasher- I feel like dishes are not getting clean- will replacing circuit board on dishwasher help dishing become cleaner?


You may need to clean out the filters that keep food from being pumped up to spray out of the sprayers. This will depend on your make and model as to how to do this. Clogged filters will reduce the amount of water being sprayed. Try opening the do ... Maytag Dishwashers

Bosch DW model SHU53A05UC/17 was working fine until yesterday evening. Went to turn it on and now get nothing. No lights, no power zip. It's on its own 20amp circuit. Checked the fuse and it's not blown. Flip the breaker on/off a few times anyway to make sure. I was installing a floor and used my miter saw on the sump pump circuit (diff from the DW circuit). It blew the fuse a few times. Any chance, on a diff circuit, it spiked and damaged a board in the DW? What part (part #) would


... Dishwashers

Bosch SHU43C Dishwasher. Where to get parts - quick? Needs a new control-board / circuit board. All valves, switches, heater appear to work. Won't run open the water inlet valve. Won't run the self-check program. Has a burnt connection on the control 'mother-board'.


1-800-944-2904 That is Bosch Company. They will send out-- next day. ... Bosch 24 in. SHU43 Built-in Dishwasher

Hobart lx30H Fuse f1 3.2amp 250vac blown, f1 feeds relay board. No booster temp, pump and sump heater active (OK). Can problem be from other devices that are driven from the low power relays on this board or are we looking at a board failure as the only answer. No skinny on door panel, Can't get access to OEM repair manuals anywhere on line Thanks


Possible bad relay coil ... Hobart 24 in. LXIH-3 Built-in Dishwasher

How do I actually get to the circuit board on dishwasher


Hi All,Great web-sitevery useful. To add, my SB907 has same problem - not heating. Found no open/short circuit in heater - found this forum - followed through with removal of circuit board and ... BINGO ! Dirty big black burn mark under rela ... Westinghouse Dishwashers

Kitchenaid kuddo1dppa I own a KitchenAid KUDD01DPPA, 2 drawer dishwasher. I am not a technician, however I have had a lot of experience in repairing various appliances and am savvy with electronics and mechanical technical issues. Here's the problem: I was getting rinse error codes in both drawers, pulled the bottom drawer out, removed the cover to the circuit board and used a dryer to dry up the moisture on the flood switch. Now I am getting Fill Failure error code on both drawers. I have g


Test this steps and fix it. God bless you\012 \012 Water Inlet Valve\012 \012 \012 \012 \012 \012 \012 \012 \012 ... Dishwashers

Ld-1416T I have an LG LD-1416T dishwasher and the lower spray arm does not turn. The top arm turns and the top rack is washed well. I pulled everyting out and cleaned all the filters (which weren't that dirty) but still no luck. I could only get so much stuff out to clean before it looked like to go any further, I would need to gain access through the bottom. Are there more filters in the motor area which might need cleaning? I read that it could be the vario motor. Can I test this? and if s


If you have one spray bar working then there is enough pressure. There is only one pump. So you should check the spray bar to see if it is plugged. Also check the seals to see if they are bad. ... LG Dishwashers

Karcher 620M, how do I get access to cable termination in order to fit new power cable ? I have so removed many housing screws but am still unable to get to terminal block which is partly under yellow top housing/cover


Gday mate just did one split yellow case sealed lead pullsout pry out with screwdriver nowive just to find where to buy one ... Karcher Pressure Washers

I have the above dishwasher shv57c03uc just less than 5 years old. The door latch does not engage solidly. when i pust start button left side lights on indicator right does not come on and i have to push on button twice for washer to come on. When it does come on the cycle is real short and it does not complete a full cycle. I an asuming the circuit board is defective!! does this sound right? if so how can i replace the board?where can i get troubleshoooting instructions?


Hi\015\012\015\012You are right it is the ... Bosch 24 in. SHV57C03UC Built-in Dishwasher

Unit does not power up. checked power to unit ok checked power to latch switch - ok appears circuit board is bad. Traced 120v to board. Any other checks before getting new dishwasher?


Hi mgray770,\015\012It sound like you have done a good job already, but just a couple thoughts before you go buy a new one. If the board does nothing then it could be locked, check your owners manual or whirlpool.com for the exact unlock inst ... Whirlpool Dishwashers

My bosch sgs45 tripped the electrics out, now the machine washes the dishes, but does not get hot and stays washing on 1 indefinatley,i have checked the pipe under the kick board which was blocked,also the circuit board for shorts /dodgey solder joints all seem ok, any ideas


And have you checked the heater element for continuity? also check to where the wires are connected to the element as well sounds like a short to me Thanks Rick ... Bosch 24 in. SGS45E02 / SGS45E08 Exxcel Free-standing Dishwasher

Even after ensuring that really hot water is coming from the faucet and placing the unit on the Delicate/Econo setting we consistently get a 2 HR reading. We have also had it where the unit gets stuck on Cycle 1 and we have to reset to go to CL and clear the system of its waste water. Is this a mechanical issue or a circuit board issue.


Did you discover the source of the 2HR reading? Mine's doing the same thing, except the drain pump keeps running and running as well...\015\012Any ideas?\015\012I can't imagine it's anything but the circuit board (for the third time in t ... Bosch SHU5316UC Dishwasher

Need to replace the latch assembly on Maytag dishwasher model # MDB5600AWW. How do I gain access to the area where I need to replace the part? I removed the 5 screws at the top, but can't seem to get the upper front panel off. I'm afraid of pulling on it to hard.


Remove all the screws on the inner door panel and lift it up it will be easyer ... Dishwashers

My Kenmore ULTRA WASH dishwasher model #1603* does not respond to any command. When I select a desired washing I only get a blinking light on my selection and nothing else. If I select ''Cancel/Drain'' it blinks as well. I receive no response at all if I select ''Start/Resume''. To stop the blinking I must turn off the circuit breaker. When I restore the power, the control board is not lit, however, selecting any of the wash cycles and the blinking starts once again. The manual refers to a blink


Replace timer/program module\015\012Vitally ... Kenmore Dishwashers

Kitchen Aid model KUDS01FLSS3, water gets pumped into bottom of dishwasher but when the cycle needs to change to shoot the water over the dishes nothing happens. When the cancel button is pushed all the water will drain.I have cleaned out the bottom drain compartment that was jammed with calcium build up and guck. Would this be a pump /motor problem or electrical circuit board problem?


... KitchenAid Dishwashers

Rinse agent light stays on the machine keeps running countsdown to 1 doesnt get hot i replaced the circuit board


... Bosch SHI6805 Dishwasher

I was using my Karcher 350M pressure washer working fine but it just stopped having tripped the power boards circuit breaker. The breaker now trips each time I switch on the washer. There is no smell of burnt motor and the electric did not get wet when last in use. Appreciate any suggestions or tests that can be made. I have a decent multimeter. Thanks.


... Karcher 1750 Psi Elec Pressure Washer

An electrical panel breaker switch was replaced after the microwave and dishwasher both lost power. The microwave works after replacing the main panel breaker. However the dishwasher will not show any power. Checked the internal circuit board, no burned areas, cannot find an internal GFI reset, what can I do to get power restored to the main control panel or even the unit itself? Rick C


1)check any fuse in the circut board.(blown off)\015\0122)check any loose connection of neutral (or)phase wire to the machine(or)in the switch. ... Kenmore 24 in. 17482 / 17484 / 17489 Built-in Dishwasher

Where could i get a replacement plug (connector) for wires that go into the main circuit board? the plug on the wire side is damaged??


These are available, at an auto shop, or hardware, electrical, store, they are a compression spade connectors. They come in a few sizes so it is best to take, an old one, to compare. They are "Crimped On with a special tool, you can also get these, ... LG 24 in. LDF7810 Built-in Dishwasher
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.1125 seconds