Having problems with your Bosch SHX4AP05UC Dishwasher ?

Bosch model shx57c02uc/21 the upper and lower wash armes do not rotate


Answers :

Repair Help & Product Troubleshooting for Bosch SHX4AP05UC Dishwasher

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Bosch model shx57c02uc/21 the upper and lower wash armes do not rotate


... Bosch SHX4AP05UC Dishwasher

Top level glasses, dishes, etc are covered in gritty substance after wash cycle. Lower level all dishes end cycle sparkling clean. I have removed and rinsed upper water spin arm. Am also using a rinse agent and still have this problem. Bosch model SHE45M06UC/50.


... Bosch 24 in. SHU5305UC Built-in Dishwasher

SHX43M05UC Plastic rotary arm that washes the upper basket does not rotate. The lower one does but the water is shooting out of the upper but it still doesn't rotate. Have removed to make sure not cloged but still is stationary during the wash cycle.


Sorry to read about your problem, I hope this helps you out.either the arm is worn, or you have a loss of pressure to turn the arm, the upper arm need alot more pressure..you may have a clogged pump, or clogged sump area..I tr ... Bosch SHX43M05UC Built-in Dishwasher

Kenmore model#587(Frigidaire) leaks under door. New install. Had machine for a year plus before install. took off front panel- can see water squirting past lower door gasket as wash arms rotate. cause is water running down door during wash cycle piles up in the channels molded into the lower left & right side of the wash tub and pushes out the sides of the lower gasket. looks like a design issue- called SEARS, they just want to sell me a new gasket! go figure. any ideas on a fix?


It does sound like an inner door seal ,however If you get upset at Sears and complain they may help you as they say the squeaky hinge gets the oil..And with Sears the more you squeak the better your chances of results ...Good Luck ... Dishwashers

Model MDB 7600AWQ It is not cleaning dishes well and the bottom water 'slinger' is not rotating. We disassemble the lower assembly and cleaned extensive soap scum and hard water deposits. Lower slinger is still not rotating. Water temp and water level are fine. Pump is getting water to upper slinger and pumping water to drain between wash and rinse and after rinse.


Hi, \012I have an older dishwasher also and recently my wife alsocomplained about it not cleaning right... so me being the man I am tried invain to clean the things... Bought new spray arms online and installed them inminutes...now the thing works li ... Maytag 24 in. MDB7600A Jetclean® II Built-in Dishwasher

I have a frigidaire dishwasher - model number PLDB998AC1. There are two spray arms in this dishwasher - lower and upper. The lower works fine but the upper spray arms are not spinning. There is what I think adequate water pressure coming in from the top but no movement on the upper spray arm. Here is what I know: 1) The water pressure and spray arms alternate between top and bottom. 2) The upper spray arm moves freely when I push it gently. 3) I have removed the pump and cleaned out an


... Frigidaire 24 in. GLD2162RDC Stainless Steel Built-in Dishwasher

Bosch dishwasher lower washer arm not rotating


... Bosch Dishwashers

I have a Bosch dishwasher Model No: SMU7056UC/14. The top rack does not seems to be cleaning good. I took out the filters under the lower wash arm and cleaned out the pump area. Any ideas would be very helpful. Tom


Hi, \012I have an older dishwasher also and recently mywife also complained about it not cleaning right... so me being the man I amtried in vain to clean the things... Bought new spray arms online and installedthem in minutes...now the thing works li ... Bosch 24 in. SMU70 Built-in Dishwasher

The dishwasher is not cleaning the dishes at all, so far I have done the following: Checked both sprayer arms and they move freely and do not appear to be clogged (I ran stiff wire thru holes in each The float is not stuck and moves up/down easily The water leavel in bottom of tub does appear to be low - so I added water filiing tub to heating coil - however this did not help and the water did not spray on lower or upper racks - this is an older model Kenmore Ultra Wash WHAT DO I NEED TO CHECK N


Heating element may have burned out. Check water temp during wash--should read between 130 to 140 F.If not the heating element,you may have to replace pump-motor assembly or wash impeller.Hope this helps. ... Kenmore Dishwashers

I have a Bosch SHE46CO dishwasher that runs too long. It adds an extra 37 min to the normal wash cycle. It counts down correctly until about 50 min then it adds the 37 min. Also when it get to 1 min it continues to run for at least 15 min. I have cleaned the filter and the upper and lower arm.


It can be the software or anly have a much colder water and it needed a longer time to heat for washing and rinsing. also a heater is damaged and the dishwaser runing at the half capacyty. so long! ... Dishwashers

Model Bosch SGS43A52GB/35 dishwasher. Water only coming through upper wash arm. Please help


... Bosch Dishwashers

Upper spray arm is not turning and I don't think water is coming out. Dishes on top are not coming clean. Dishes on bottom are clean (as clean as they get with this dishwasher). How do I remove upper spray arm. Also I'm not sure how to remove lower dish rack to access upper spray arm. Any help appreicated. Kitchenaid model KUDP01FLSS5 Chris


Hi Chris,It sounds to me like a restriction in the pump. I put together some information here on cleaning it out. If you try these please give me some feedback as to if they help or not.Thanks! ... KitchenAid 34 in. KUDP01FLSS Stainless Steel Built-in Dishwasher

I have a Frigidaire dishwasher, FDB-1100RHC, that is not cleaning dishes. My fiance cleaned the trap at the bottom of the washer, removing both the small basket and the larger mesh grid. After replacing both, the washer doesn't seem to have enough water pressure to spin the lower and/or upper arms. If I interrupt a cycle and open the door, water is dribbling out of the upper arms, but they are not rotating and do not move from whatever position you place them in. Both arms are completely uno


Hello :)don't feel bad, I run into this kind of problem at least once a week.\015\012It does sound like the pressure isn't there so you're not getting water to the upper spray arm. What you need to do is take the pump apart, which i ... Frigidaire Dishwashers

Kenmore BuiltIn Dishwasher Stock 17512 Model 17512200 Type 575-0 Serail FM3309375 Probelm: Water sprays out of lower arm weakly, and not out of upper arm at all. Action taken: Unscrewed the 4 screws holding down the item underneath the lower spray arm, and then the small item under that. Found major refuse from years gone by, removed, cleaned. Reassembled, same issue. I suspect I have to get 1 more level down, to the intake for the pump? found 2 screws to remove, but was not suc


... Dishwashers

Upper and lower arms rotate normally. 2nd level (center) arm doesn't rotate at all. Dismantled, checked and cleaned arm. No help. No obstructions in water channel.


No the parts does not wear out in one year.but in some cases it has been noticed with this problem.so the part needs to be replaced.Remove the washarm and check the wash arm support. there is a small white palstic piece on the top of the housin ... Frigidaire PLD4555RFC Dishwasher

Lower spray arm does not spin on my bosch dishwasher model number SHV55M03GB/40. However the top spray arm does spin. I have tried cleaning filters and the actual lower spray arm but found to blockages etc. many help will be greatly appreciated


S.Africa doesnt have same modles as you, but will try and help. Some washers give the operator a choice to run either the top spray arm or the bottom one independently, and/or both together.\015\012Almost certainly, there is a valve that is po ... Bosch 24 in. SHU66C02 / SHU66C06 Built-in Dishwasher

I have a Maytage Model# MDBH940AWW dishwasher. The lower spray arm does not rotate. I changed out the sealkit, but the results are the same. The top spray arms are turning, but not the lower.


These spray arms are designed to shoot high pressure, high temperature water at your dishes. It is possible that the holes of the spray arms, where the water comes out, are blocked with debris, affecting wash quality. You should ins ... Dishwashers

Hi I've inherited a Zanussi DA6142 Dishwasher from a recent house move. It was treated quite poorly by students who I suspect ran it without the filters in place. I've used a dishwasher cleaner and was able to pull out the lower spray arm and rinse out all the crud that was blocking it (small stones, food, plastic, pieces of glass, paper, etc) but I cannot for the life of me work out how to get the upper spray arm out. The PDF manual I've downloaded for this model says DO NOT remove upper spra


... Zanussi Dishwashers

I have a Frigidaire dishwasher and there is not any water coming out of the top wash arm. There is good water pressure coming out of the lower washarm. I pulled out the dishwasher and can see the water going to the top washarm through the tube and it goes up very slowly. I took out the "check ball" below the lower washarm and it worked good. I put the "check ball" back in and ran the machine on "Upper Rack" and it still does not have any water coming out of the upper washarm. It doesn't seem lik


Hi\015\012\015\012 \015\012\015\012 \015\012\015\012Thanks for using FixYa. Please check that there is no gunk or mold\015\012behind the filter screen and under the cover at the bottom. N ... Frigidaire PLDB998A Built-in Dishwasher

GE Triton seems to lack pump pressure to rotate the wash arms.


1)please check the impeller nut is loose.\015\012\015\0122) please check the hose connected to the arm any block.\015\012 ... GE Tritonr XL GSD6260JCC Dishwasher

Dishwasher, nautilus, doesn't spray water out the top arm? I'm haivng to wash dishes 2 times, and still no better results. I've tried opening the door fast during a water cycle to see which is the problem - can only figure it is the upper arm, the lower arm seems to have water coming out, can't tell if the tower raises completely up.


The jets on the arms can sometimes get blocked with food bits that have got past the filter. This reduces the water flow and rotation of the arms.The arms are easy to remove without tools (they are intended to be removed by the user). ... GE Nautilus 24" Built-in Dishwasher

I have a triton xl model @ gsd6200g00bb serial #va790400b. The dishes on the top rack are not getting clean. I have removed the top, and middle, and bottom arms cleaned calcium out of them. Removed the screen below the lower arm cleaned. The top and middle arms are still not spinning during wash cycles. Where do I go next?


Apart from the spray arms themselves there could be other reasons why the water is not getting up to the middle and top arms.\015\012\015\012The distribution circuit from the wash pump that feeds the arms could be blocked or the wash pump ... Dishwashers

Have a dd603 with an issue...took off the arm and the metal silver disk (the ones with holes) to get to the wash impeller-(the thing with blue blades) the wash impeller will not spin-which I think is part of my problem, since i looked at the lower drawer and was able to spin the blue blades easily...was also able to pull it right out. Cant pull out the upper wash impeller!!!! Really want to get this fixed before my husband gets home and I get the lecture about how I purchased a cool looking d


Lol I don't know a lot about dishwashers, just do him good and tell him afterwards, and then hire a mechanic to look at it.Why would you want to pull the propellers off anyway? The top one doesn't pull off because it's screwed on, and the botto ... Fisher and Paykel 23 in. DD-603SS Built-in Dishwasher

Lower spray arm siemens aquastop dishwasher doesn't rotate


Sprayers require water to pass through the jets to provide motion to the arms.Suggestion;Remove the sprayer from the machine and look for blockages. (Removal should be easy, at it is expected that the user will need to clean ... Siemens Dishwashers

Component failure Actually a Kuppersbusch IGV 645.2 Dishwasher There is a plastic conduit which takes water from the base of the machine to the upper spray arm. This now comes adrift from its connection at the base (behind the lower spray arm) on every cycle, resulting in poor or incomplete washing. It can be replaced easily and seems firmly inserted when done but is always adrift again by the end of the next cycle. Anyone any ideas?


Put a bead of silicone on the tube connection and let it set up good before running. If the tube is in good shape and only comes loose this should be an easy fix. ... Whirlpool GU2400XTP Built-in Dishwasher
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.1676 seconds