Having problems with your Bosch SMS63E Dishwasher ?

Bosch Dishwasher SMS4602eu is not heating up. I have tested the heating element for continuity and this seems to be fine. Any other suggestions would be greatly appreciated?


Answers :

Repair Help & Product Troubleshooting for Bosch SMS63E Dishwasher

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Bosch Dishwasher SMS4602eu is not heating up. I have tested the heating element for continuity and this seems to be fine. Any other suggestions would be greatly appreciated?


... Bosch SMS63E Dishwasher

Dishwasher flooding Hi my Asko D1716 Super Cleaning System Dishwasher has started to have a flooding problem. When the cycle finished last night it seemed fine then in the morning the machine was full of water, I scooped out the water and by this evening the machine had flooded onto the kitchen floor. I tried other solutions I found on this website but they didn't suit my dishwasher as it doesn't have the appropriate buttons. Any suggestions would be appreciated!


When you say that you tried other solutions.. it's hard to know which you've tried and which you haven't so I will suggest some basics first.. ( if you've tried them, then disregard)...\015\012Have you checked or addressed the following:\ ... Asko D1716 Built-in Dishwasher

My DX303 is constantly bringing up error 30. I have had it apart, and there are no water leaks. If I pour water into it, it will drain no worries, however it seems like it wants to continuously drain with this error 30. Sometimes it will come good and go through its complete cycle hassle free, but it's not now. Any suggestions would be appreciated. Thanks.


... Dishwashers

I have the E3 error on my Smeg DWI614 dishwasher which would indicate a heater error, however it is heating the water in the bottom of the machine but it seems to time out. The main issue seems to be that the recirc. pump is not running during the heating phase. I have taken the pump out, checked the connections etc. twice now and everything seems fine (the motor runs when tested). When I have done this (both times) the dishwasher has started again and run for 20+ cycles fine, then the issue com


... Smeg DWI614 Built-in Dishwasher

Hi there, we have had our Bosch Loggixx Auto Option dishwasher for about 5 years now and we seem to have had endless issues with it. However, it now seems to have an error with the timer, which on any wash it seems to get to about 6 minutes and then jumps to 32 minutes and the contents are not being cleaned. Any advise that you would be able to provide would be greatly appreciated. Many thanks


There is way's to fix this problem, first check the amps that is going to the dishwasher, and them repplace the timer.\015\012\015\012can be a electrical problem that is keeps damaging the dishwasher. ... Bosch Dishwashers

My Omega Eurolux Dishwasher (mode: DW211P/1) won't stop cycling, It sems to get stuck during the wash cycle and continues for hours, until I turn it off. If I turn the dial to rinse it rinses fine. It doesn't seem to heat the water at all, there is no steam when I open the door. I have put a new heating element in, but this doesn't seem to be heating up at all. When I open the door mid wash cycle the element is cold to touch.


... Dishwashers

E3 Error Hi My dishwasher is showing error E3, which the user manual states "The appliance is not able to pump out the water.", however, other E3 error states a heating issue. The dishwasher does in fact heat the water but generates the E3 error after 10 minutes or so, then pumps out the water from the dishwasher. I'm a little confused as to what the issue is here and what part I would need to rectify the problem. Any advise you could give would be greatly appreciated. Kind regards


The E3 error is a result of water temperature not getting to a nominal value within a particular time. This could be caused by several factors like heater faulty, wash pump not working well, wash arms not circulating water as required. Need model nu ... Smeg Dishwashers

I have a Bosh Logic dishwasher SGS65L12GB/04 The other day it got to 1 min left and would not stop pumping out water and continued even with the door open. After 5 mins playing around it started working again for a further 2 washes. Now when switched on the pump for pumping out the water works continuously. Reset it time seem to count down but does not do anything reset time goes to 0 and beeps but still the pump runs even with the door open. all buttons seem to work fine but no washing and pu


Hi Jonathan,\015\012\015\012Welcome to FixYa.\015\012\015\012Your float may have got stuck or it's possible that you have water leaking into the bottom of the washer. In the bottom of the wash compartment, next to the drain yo ... Bosch Dishwashers

I have an Indesit IDL500 dishwasher. It had stopped heating the water up, it looked as if it had short circuited and so i replaced it, i have power going to the element. A couple of forums state that it may be the pcb behind the timer/selector switch. Does this pcb control the program selection and heating of the element? or is there a thermostat that controls the stop and start of the heating element? Any help would be greatly appreciated


Hi\015\012\015\012The unit\015\012has two thermostats and you can test both of them for continuity before\015\012replacing, no continuity replace the thermostat. Hope\015\012this helps...please post back fo ... Indesit 24 in. IDL500 Built-In Dishwasher

Diswasher A couple of days ago my dishwasher would not start, there are lights on the front panel and it starts a washing programme but doesn't actually wash anything. I removed the filter from inside the dishwasher and it is full with water, it seems like there is a blokage somewhere. Would a blockage cause the diswasher not to start. Any help on this problem would be greatly appreciated.


Jhgf ... Whirlpool 24 in. ADP6940 Dishwasher

Bosch dishwasher shx46b02uc has stopped drying. Per online comments, they seem to point to either a corroded wire or a bad heating element. We've replaced the heating element and all the wires looks fine. All other functions work - just not the heat. Open to suggestions.


Hello,Welcome to FixYa.Based on your description ... Bosch 24 in. SHU66C02 / SHU66C06 Built-in Dishwasher

Hello. my dishwasher leaves gunk on the inside of glasses that were wiped clean before washing. It seems like that would mean the drain to the disposal is clogged but the hose is clear and the impellar is free. I blew on the hose and got movement in the disposal. the impellar is clean and new looking. I thought it would be a little dirty? Any help would be greatly appreciated. I will answer any question you have in case i didn't explain it well.


There are many probable causes of failure .A dishwasher's water inlet valve is its most common part to fail. When \015\012your dishes are not being fully cleaned, quite often a faulty water \015\0 ... Dishwashers

Ringsing Can anyone advise me as to how to adjust the AM-15 to rinse properly. It is great that it uses less water but I can not get a good rinsing action. Especially on outside of wares, inside appears to be okay and detergent and rinse amounts are fine. Any help would be greatly appreciated


What do you mean? A longer rinse cycle?I'm a hobart tech. ... Hobart 29 in. AM15-1 Free-Standing Dishwasher

Hi! Our Kenmore Ultra dishwasher is about 11 yrs old. Recently started overflowing onto the floor. Seems to be worse with soap, less when just water. Is this a problem I need to get a repairman or just use less soap? Checked the drain cycle - pump seems to work fine. Any ideas would be appreciated! Thanks AM from Portland


Try a gel and use less soap at first as an experiment they clean better and leave no film I/E electra sol gel ... Asko 24 in. D3250 Built-in Dishwasher

Bosch dishwasher Does not heat up in the washing cycle and does not drain down at the end of the cycle. End of cycle the display sticks at 1 and the drain pump operates until the machine is switched off or reset. Followed the suggestion in another thread to look for a burnt solder joint on the control board. Unfortunately my machine is a later model than the board shown and has no poor joints on the board. It would seem from previous answers that the problem is either the controller, the heating


1) The water must be preheating by heating elements and thermostat see how to do it.\015\0122) Timer , test for defective,clean the contact, repair wires for loose, broken, or burn.\015\012\015\012God bless you.\015\012 ... Dishwashers

Leaking dishwasher My GE dishwasher leaks when running a load of dishes. The leak seems to be coming from about the middle of the tub about halfway back. I can't see exactly where it's coming from, but it appears to be dripping right behind the motor. Could it be a poor connection? I would appreciate any suggestions. Thanks, Bob Engle I do not seem to be able to find the model number


Probably a leak at the motor seal where it enters the tub. Best to remove the motor if you can and inspect the seal. ... Dishwashers

The dishwasher model 665.15872000 seems to be making a lot of noise along with leaving the dishes not completely dry. i check to see how it was draining and that seems ok I have taken it down as far as the chopper and found no obstuctons? any tips would be greatly appreciated. Steven Cinco email [email protected]


... Kenmore Dishwashers

Hello, I would appreciate if you have any suggestions regarding my GE dishwasher. It turns on and seems to want to work but the rinse cycle does not produce any water, it makes noises like the water is coming out and rinsing but when I open the dishwasher the dishes are not wet. I've checked the water valve, turned the control panel off and on, I'm wondering if it is just clogged, any suggestions? Thank you.


Hi,\012Here is a tip that will help you to find out why water will not come into thedishwasher... Dishwasher Trouble No Water entering Dishwasher ... Dishwashers

I have a Karcher 3500 hd with a 2.1 head. Machine has always worked well but lately it has been pulsating. High pressure then low... repeat. I have checked valves and they seem fine. Any advise would be great thx.


Sounds like your seals are going , they sell a rebuild kit for it and it is relatively easy to install ... Karcher G3025OH Pressure Washer

My 1998 GE dishwasher leaks. Into the floor, now I see stains on the ceiling below. What to check? Door seal is fine. The dishes get washed. Pressure is good to go. No water out of the front of machine, seems to be coming from below. Take panel off and inspect connections? How about line from sink? Is there a site with illustrations or video repair about this specific problem out there? Any help is greatly appreciated...


Check the water connection at the valve to the dishwasher. If the dishwasher only leaks when used then the motor seal is damaged. If leak is constant the the leak is at the supply to the dishwasher from the water supply at the valve\015\012 ... Dishwashers

I have a bosch SHU6802UC dish washer. Recently the cycles were getting very long (3+ hours) and now when you press power/start, the unit turns on and you can hear the rather loud hum (pump?) of the cycle starting but it does not do anything else, just continues the loud hum. No cycle, does not fill with water, nothing. I ran the diaognostic and it immediately came up "7" on the display. Any thoughts or direction would be greatly appreciated. FYI, I did thuroughly clean it which made no di


There are a few possibities...if you remove the lid and take the two t20 screw off the left side panel at the front you could check the pressure chamber and its hose are not blocked. Use the link and go to page 4, part 263834 and 361113. You ca ... Dishwashers

I have the GLD 4560 NSS and it is no longer draining. The tub stays completely full. When you start it, the water in the tub is reused then it does not drain. No noise or anything when the draining or filling should actually be taking place. Hoses are not kinked, no leaks, no air vent, it drains directly to the disposal. Everything seems OK but it is full of water. Any help would be greatly appreciated.


... GE GLD4560NSS Stainless Steel Built-in Dishwasher

I have a SGS53E72AU and it isn't draining away. I have cleaned the filters, checked to see that the pump isn't blocked by removing the cover and also checked for kinked hose. It is 2 and a half years old. Any suggestions would be greatly appreciated thanks Sally


First of all you must set the machine to a soft/quick wash and let the cycle run. During the process of the program check the voltage on the pump during the drain cycle. It is important that the controller unit supplies voltage to the pump. If power ... Bosch SHU4006 Dishwasher

Hi, I have a westinghouse dishwasher 921 model. When i start the dishwasher (on eco normal), it counts down from 39mins to 36 and then starts flashing "FL". Nothing seems to happen (ie dishes aren't washed) Are you able to help over email. I have checked the filter (thinking "FL" means filter, but the filter is completely clear. Any suggestions or help you can offer would be appreciated. Kind regards Donella. p.a, I don't have a manual.


Check to see if you have something stuck under the float it is the mushrrom looking thing at the front bottom left hand side ... Dishwashers

Whirlpool DU1145XTPPB7 Whirlpool DU1145XTPB7 model. Normal cycle light started blinking sometime during end of wash cycle. It will not do anything. Things I have already tried and not worked: 1. Unpluged and pluged unit back in. 2. System reset w/ heat-dry button, etc. Any help would be greatly appreciated


These dishwashers normally have a "Control Lock" mode.  It's in the manual.  It is provided for child safety.  It's often controlled by holding the "No Heat Dry" button for 4 seconds or more -- same procedure turns it on or off. ... Whirlpool 24 in. DU1100XTP Built-in Dishwasher
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.0874 seconds