Having problems with your Briggs Stratton 020273 Elite Series Portable Gas Pressure Washer ?

What's wrong is it shot?

\015 My lawn mower was ran low on oil and was running than just stopped like it ran out of gas?\015

Answers :

Repair Help & Product Troubleshooting for Briggs Stratton 020273 Elite Series Portable Gas Pressure Washer

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

I bought a troybuilt pressure washer used and i changed the motor oil and ran it maybe 5 minutes. later i checked the oil level again and it shot out the cap and i noticed the pump oil level is also almost to the top of sight glass. Does anyone know whats wrong?

If you left it sit for a while & did not turn the fuel tap off,it may have flooded and therefore the oil level would have risen causing the oil to over flow.\015\012\015\012always turn the fuel tap off when not using your pressure wahser. ... Honda Pressure Washer PSI 3000

I have a kitchen aid dishwasher Model #kudso2frbl1 that the bottom spinning arm doesn't work. Whats wrong?

... KitchenAid Dishwashers

My washer vibrates and has low pressure, whats wrong

Add some oil to the hydrailic pump it may be low. ... Northstar Professional Series Pressure Washer 4000 PSI

I have an americana dishwasher that makes a wearied noise, and I don't know whats wrong with it. do I have do be concerned about it? and what can I do do fix the problem if there is any. thanks

... Dishwashers

Hi, I'm having a problem with my Beko dishwasher, i've had it a yr and now when I turn it on it makes a tapping noise at the base and no water is delivered into the dishwasher. Any ideas whats wrong?

Your floatreloay switch needs to be checked to see if it is moving up and down and check to see that it is not sticking or that the relay is working in float switch ... Dishwashers

E1 flashes on dishwasher whats wrong? - Dishwashers

If you can identify the manufacture and get the model #, go to www.repairclinic.com and you should be able to find the answer to your question along with troubleshooting instru ... Dishwashers

The pressure washer hose blows off when I close the trigger and it is screwed on tight. Whats wrong?

The first thing is that for sure the screw thread on the machine or at the end of the hose is damaged. Now it seems thar when you close the trigger the machine is not stopping due to a spill valve problem or micro switch problem. You are a bit lucky ... Karcher PSI Electric Pressure Washer

I have a aeg 43070 vi dishwasher It keeps tripping the circit breaker on the house fuse box . I have reset the leak cutout by dipping the dishwasher back and stopped the warning sound,but went for about a minute and then trip the electrics again . any ideas whats wrong ?

I assume you are refering to the earth leakage circuit breaker. This trips when a earth leak fault has occured. The normal cause for this could be\015\012A) Water leaking via a pipe at the bottom comming in contact with one of the electric moto ... AEG 23 in. Favorit 44070Vi Built-in Dishwasher

Dishwasher does not work, whats wrong? completely hooked up (water, electrical) seems as if it has no power.

... KitchenAid KUDS40CVSS Builtin Dishwasher

Dishwasher problems theres no water coming into the dishwasher is the hose plugged? whats wrong

The first thought that comes to mind is the valve... are you sure the water valve to the dishwasher is open? \015\012\015\012The next possible cause could be a bad relay switch which opens when the unit calls for water... if it's bad the ... Bosch 23 in. SHU33A Built-In Dishwasher

My dishwasher starts a cycle then near to the end switches the programme to an E3 and turns off whats wrong

Temperature sensor / thermostat problem... ... Kenmore 15762 Dishwasher

SGS46M72AU fails to remove waste water. Whats wrong?

... Bosch Dishwashers

My GE Potscrubber Dishwasher will turn on but when I rotate the dial to "start" it sounds like it is trying to run its cycle BUT nothing happens does anyone know whats wrong and how to fix this??

... GE 24 in. GSD2230Z Built-in Dishwasher

Our clean light flashes 7 times pauses and flashes 7 times again, we can not restart the unit whats could be wrong

Hi,This machine was made by Whirlpool and the flashing clean light is a common error code for them.If\015\012the clean light is the one flashing then your dishwasher could have a\015\012heater circuit problem (depending on the age) or thi ... Whirlpool Dishwashers

My AEG favorit sensorlogic turbo dry dishwasher keeps bleeping and want start. Im not sure whats wrong with it. I have cleaned the filters and put in new salt and it still wont work. The programme lights are working but no water will go in to it????

Hey\015\012I just had the same issue done everything you say above with no joy. i then emptied the water that was in the dishwasher that the filter goes into and its now fine.\015\012good luck ... Dishwashers

I can see water going into drain but suds are coming out around door whats wrong?

... Hobart SR24C-4 Dishwasher

Hi. We have a dishwasher ADP 241 S and on the right side of maschine is blinking green light and its not washing at all. I was trying to find some manual on the internet to know whats wrong but I did not find any. Could you help me with my problem? Thanks

... Dishwashers

My kenmore elite dishwasher won't start. the cancel button and cycle work whats wrong

... Kenmore Dishwashers


Sparkplug needs to be cleaned or replaced. ... Honda 8 HP Engine

My Simpson Riviera 966 wont complete wash cycle,whats wrong with it ?

1) timer- it stays wherever you leave it and does that action.\015\0122) No fill -cold- for rinse\015\0123) No pump out\015\0124) Syphoning- where is your drain hose ?\015\0125) Set to " no spin" drip dry" -- reset control ... Dishwashers

My maytag jetclean dishwasher motor will run but no water will shoot out, whats wrong?

... Maytag Jetclean II MDB8551A Dishwasher

Whirlpool adg 7550 starts cycle then beeps and flashes 6 times whats wrong?

6 flashes indicates water intake fault ie machine is saying it has not filled with water within the required time.\015\012-Check inlet hose not kinked or blocked.\015\012-Next, check inlet valve is OK (check with ohm meter-should read app ... Whirlpool 24 in. ADG7540 Built-in Dishwasher

Wont run I have a Kenmore QuietGaurd2 it will not run at all. It filled up with hot water, then it quit working. It wont even drain the water out or cycle. Nothing is happening, whats wrong with my dishwasher??

... Kenmore 24 in. 15992 Built-in Dishwasher

I have a SMU40E12sk/01. In the display i says E15??? Whats wrong?

... Dishwashers

Starts ok wrench appears heats ok wash cycle pressure strong at first then fades wrench appears -p2 -cleaned screens and checked spray arms .incoming water pressure 20 psi whats wrong ?

Check the spray arm. Machine water pump. After this pump pressurebuilds up to the spray arm. Rubber hosejunction inside the wash tub. This place gets connected to the spray arm system. You can see this when you draw the tray for loa ... Hobart 24 in. LXIH-3 Built-in Dishwasher
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.0168 seconds