Having problems with your Briggs & Stratton 2200 PSI Gas Pressure Washer ?

What oil do i use to chane oil - Briggs & Stratton 2200 PSI Gas Pressure Washer


Answers :

For normal usage I would reccomend straight 30 weihgt oil.If you are planning on using it during colder temperaturesI would switch to 10w-30. thanks
Repair Help & Product Troubleshooting for Briggs & Stratton 2200 PSI Gas Pressure Washer

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

What oil do i use to chane oil - Briggs & Stratton 2200 PSI Gas Pressure Washer


For normal usage I would reccomend straight 30 weihgt oil.If you are planning on using it during colder temperaturesI would switch to 10w-30. thanks ... Briggs & Stratton 2200 PSI Gas Pressure Washer

Briggs and Stratton pressure washer will not start. I have a 6.75 hp pressure washer that is only a year old. when I pull cord it turns over but does not start. I changed plug and checked it, I have spark when pulling. I have 40-50 psi of compression when pulling also. gas was drained and is brand new. it was working fine last time it was used. I have tried starting it without the water line or spray wand hooked up and no difference. After about 10 or 15 pulls, can smell gas when I am trying to


Hello dave, the problem is compression to low,you need 60 to 130 lbs to run engine,check for blown head gasket,or bad rings,or a stuck open valve,hope this helps,, ... Briggs & Stratton Pressure Washers

Gas in oil in pressure washer - Craftsman 2700 PSI Briggs Stratton Powered Pressure Washer


... Craftsman 2700 PSI Briggs Stratton Powered Pressure Washer

Started by Craftsman 2700 PSI , 2.3 GPM Briggs & Stratton Powered Pressure Washer for first time in 9 months. Added new oil, and gas. started but is smoking from muffler and is dripping what appears to be oil near the exhaust end. I shut it down. What could this be due to?


The first thing I would check would be the oil level, to make sure you didn't put in too much oil. If the oil level is correct, it could be a stuck piston ring, letting oil blow by the piston, and out the exhaust. If this is the case, you are going ... Craftsman 2700 PSI,2.3 GPM Briggs & Stratton Powered Pressure Washer - Ca. Model

I have a 2550 psi pressure washer with a 6.75 hp briggs and stratton engine with ready start. i wont start. has gas and oil plug looks good. any solutions?


... Briggs Stratton 020273 Elite Series Portable Gas Pressure Washer

I have a Craftsman 2700 psi pressure washer with a Briggs and Stratton 850 engine (80 year anniversary special addition) . It is about 2 years old and used very little and will not start. I filled it with fresh fuel and checked the oil. I also replaced the spark plug and air filter. I checked the fuel line thinking it may not be getting fuel, but there is no obstruction from the tank to the end of the fuel line. I am out of TS options short of taking it to a service center.


Here is the long answer with everything we learned while using a power \015\012washer twice a day for years::\015\012It sounds like could be one of the problems listed below or a \015\012combination of those things.\015\012\015\0121 ... Briggs Stratton 020273 Elite Series Portable Gas Pressure Washer

Oil I have a Briggs and Stratton 2200 psi pressure washer. It doesn't specify an oil ~ other than to show a photo of synthetic pressure washer oil manufactured by them. I can't find that specific brand anywhere, what can I substitute it with? Ace hardware was stumped.


Remember when your searching for something you can't find the internet is always your best bet. You should also use a good search engine; www.bing.com is one of the best search engines I have ever used. I searched some stores that have the oil your l ... Briggs & Stratton Briggs Stratton 2000 Psi Pressure Washer Freeshp

The power washer is not taking in the soap. - Briggs & Stratton Briggs Stratton Vanguard OHV 3000 PSI Gas Pressure Washer


... Briggs & Stratton Briggs Stratton Vanguard OHV 3000 PSI Gas Pressure Washer

I have a Briggs & Stratton gas power washer. This is the 1st time this year that I have used it. I put in fresh gas, hooked up the water supply. The engine started and then quickly stopped. I had to release the water pressure in the hose before I could pull start the engine. The only way to keep the engine running is to hold down the spray nozzle trigger. Once that is released the pressure in the hose builds up and the engine stops.


Sounds like the unloader is not working correctly. Try replacing it and see what happens. ... Briggs & Stratton Prosumer 20324 Gas Pressure Washer

What type of oil does pressure washer use? - Briggs & Stratton Pressure Washer Projectpro Spray Nozzle


... Briggs & Stratton Pressure Washer Projectpro Spray Nozzle

Pressure washer got wet and will not start - Briggs & Stratton 2200 PSI Gas Pressure Washer


... Briggs & Stratton 2200 PSI Gas Pressure Washer

2800 PSI Troy-Bilt XP pressure washer manual - Briggs & Stratton Prosumer 20324 Gas Pressure Washer


... Briggs & Stratton Prosumer 20324 Gas Pressure Washer

Looking to change engine oil - Briggs & Stratton Murray 020456 2400 PSI 20 GPM 190cc Briggs Stratton Gas Powered Pressur


... Briggs & Stratton Murray 020456 2400 PSI 20 GPM 190cc Briggs Stratton Gas Powered Pressur

Hi. I have a Briggs & Stratton 2800PSI gas pressure washer. I can get it to start, but after about 5 min, then it quits. I have cleaned the carb, change oil, changed plug, new gas, cleaned/checked air filter. Nothing will keep it running. Wondering if it may be not enough water pressure, but would that cause it to stop like that? When it runs, it does a good job, but it stops just as you get going. Do you have any other suggestions? Thanks!


If it wont start, check for spark.how you do that,ok take the spark plug wire out put it close to the sparkplug(use some gloves or something to insulate your self from get electric shot from the spark) find some one who pull the start rope, if you do ... Briggs & Stratton Prosumer 20324 Gas Pressure Washer

Oil plug on troy bilt 020240 pressure washer - Briggs Stratton 020273 Elite Series Portable Gas Pressure Washer


... Briggs Stratton 020273 Elite Series Portable Gas Pressure Washer

I have a Briggs & Stratton Pro 3400 pressure washer that I got new last year and used for maybe 5 hours and it worked great. Have had it stored since then with stabilizer in the gas (I didn't run it dry) and now it won't run for more than a minute or two without dying. A dealer said it was probably bad gas and I now know that even with the stabilizer I should have run it dry last year before storing. Everything is like brand-new including plug and air filter so it must be the gas/carberator gunk


... Briggs & Stratton Prosumer 20324 Gas Pressure Washer

Why is there gas in my oil - Briggs Stratton 020273 Elite Series Portable Gas Pressure Washer


Gas in the oil is usually indicative of a stuck float or needle valve in the carburator float bowl. If the needle valve is stuck open, gas will flow from the float bowl into the cylinder and then the crankcase even if the motor is not running. You ... Briggs Stratton 020273 Elite Series Portable Gas Pressure Washer

2200 psi husky briggs and stratton pressure washer used 2 years never used soap dispenser trying now is not drawing soap no longer have manual to see how to connect adjust can you help?


After a long none use, I tried to wash my driveway and powered on the washer,it did, but when i tried to engage the power washer by pressing the wand lever, it did not engage. What can I do to get the power washer working? ... Briggs & Stratton Gas Pressure Washer 20244

I have a Karcher 2,600 PSI 2.3 GPM Gas Pressure Washer G 2600 VHR that I have used once last summer. I have stored the PW in my basement with no fuel in the gas tank. The PW was never exposed to freezing temps. I cannot get the PW to start. I put new fuel into the tank, the oil is good, I drained the carburetor, and the spark plug works (tested it). I pull the cord and the engine doesn't turn. Fuel value is on, choke is pulled, and the starter switch is turned on. System is practically brand new


Hi I have a similar pressure washer from Kartcher and the same scenario as yours I have owned it for about 2 years and noticed that it was getting harder and harder to start with each time I use it which is months. If your pw has a honda engine on i ... Karcher G 2600 VH Gas Pressure Washer

Gas leak briggs and stratton pressure washer 2400 psi


... Briggs & Stratton Pressure Washers

Engine runs fine but will not spray - Briggs & Stratton 2200 PSI Gas Pressure Washer


Check all of your inlet hoses, one may have a kink or a blocked up filter screen. If nothing is clogged your pump has broken and will need replaced. ... Briggs & Stratton 2200 PSI Gas Pressure Washer

I have a cratsman 675 series pressure washer, Briggs and Stratton motor. It stopped as I was using it. I tried to restart and feels like the motor is ceased. Oil was low as I found out. What to do?


... Briggs & Stratton Pressure Washer Projectpro Spray Nozzle

Location of serial number plack - Briggs & Stratton 2200 PSI Gas Pressure Washer


... Briggs & Stratton 2200 PSI Gas Pressure Washer

I have a Husky 2600 PSI pressure washer. Started up and used for about 20 minutes - turned off to take around back and now the pull cord is tight and has a clicking sound when trying to pull. Has oil and fresh gas. Suggestions?


... Karcher Pressure Washers

Troy built 2350 psi 2.0 gpm. pressure washer. starts onne then dies. will not start again. has briggs and straton motor. has been sitting up for the winter. have changed spark pulg. checked air filter that is clean, has oil and gas.


... Pressure Washers
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.0862 seconds