Having problems with your Briggs & Stratton 3000 PSI Pressure Washer ?

Briggs & Stratton 3000 psi pressure washer, won't start


Answers :

Repair Help & Product Troubleshooting for Briggs & Stratton 3000 PSI Pressure Washer

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

I have a 2550 psi pressure washer with a 6.75 hp briggs and stratton engine with ready start. i wont start. has gas and oil plug looks good. any solutions?


... Briggs Stratton 020273 Elite Series Portable Gas Pressure Washer

Have a Husky Pressure Washer 2200 psi, HU80931. I don't have an owner manual. It has set for about a year. When I started the washer there was very little pressure. Did some cleaning and it was a little better, but now there is no pressure and I am having trouble keeping it started. Can you help? The washer was purchased at Home Depot and it has Briggs and Stratton the the washer too. Thank You, RJ


Look at eReplacementParts.com and the parts diagrams ... Briggs & Stratton Pressure Washers

Briggs and Stratton pressure washer will not start. I have a 6.75 hp pressure washer that is only a year old. when I pull cord it turns over but does not start. I changed plug and checked it, I have spark when pulling. I have 40-50 psi of compression when pulling also. gas was drained and is brand new. it was working fine last time it was used. I have tried starting it without the water line or spray wand hooked up and no difference. After about 10 or 15 pulls, can smell gas when I am trying to


Hello dave, the problem is compression to low,you need 60 to 130 lbs to run engine,check for blown head gasket,or bad rings,or a stuck open valve,hope this helps,, ... Briggs & Stratton Pressure Washers

Excell pressure washer wont start - Briggs & Stratton Pressure Washer Projectpro Spray Nozzle


Check gas, off/on switch,spark plug and magneto for spark ... Briggs & Stratton Pressure Washer Projectpro Spray Nozzle

Pressure washer got wet and will not start - Briggs & Stratton 2200 PSI Gas Pressure Washer


... Briggs & Stratton 2200 PSI Gas Pressure Washer

Started by Craftsman 2700 PSI , 2.3 GPM Briggs & Stratton Powered Pressure Washer for first time in 9 months. Added new oil, and gas. started but is smoking from muffler and is dripping what appears to be oil near the exhaust end. I shut it down. What could this be due to?


The first thing I would check would be the oil level, to make sure you didn't put in too much oil. If the oil level is correct, it could be a stuck piston ring, letting oil blow by the piston, and out the exhaust. If this is the case, you are going ... Craftsman 2700 PSI,2.3 GPM Briggs & Stratton Powered Pressure Washer - Ca. Model

Craftsman 2500psi 2.3 gpm briggs and stratton pressure washer wont start


... Craftsman 2500 PSI Briggs & Stratton Powered Pressure Washer

2050 PSI Gas Pressure Washer - 20244: my excell pressure washer wont start. pull start t...


... Briggs & Stratton Gas Pressure Washer 20244

Engine wont start. - Briggs & Stratton Pressure Washer Projectpro Spray Nozzle


REMOVE plug and put on to lead and rest plug thread on to a good earth on engine and pull starter cord ,, if spark you have fuel problem ,,If no spark try a nother plug if still no spark remove cowling and Flywheel assy and the spark coil is under t ... Briggs & Stratton Pressure Washer Projectpro Spray Nozzle

Briggs and stratton sprint 3.75 pressure washer wont start and spits oil out exhaust


... Pressure Washers

Briggs & Stratton 3000 psi pressure washer, won't start


... Briggs & Stratton 3000 PSI Pressure Washer

I have a Craftsman 2700 psi pressure washer with a Briggs and Stratton 850 engine (80 year anniversary special addition) . It is about 2 years old and used very little and will not start. I filled it with fresh fuel and checked the oil. I also replaced the spark plug and air filter. I checked the fuel line thinking it may not be getting fuel, but there is no obstruction from the tank to the end of the fuel line. I am out of TS options short of taking it to a service center.


Here is the long answer with everything we learned while using a power \015\012washer twice a day for years::\015\012It sounds like could be one of the problems listed below or a \015\012combination of those things.\015\012\015\0121 ... Briggs Stratton 020273 Elite Series Portable Gas Pressure Washer

Problem with Briggs & Stratton Prosumer 2800 PSI Gas Pressure Washer - 20324 starts but shuts off


... Briggs & Stratton Prosumer 20324 Gas Pressure Washer

Briggs and Stratton 2200 PSI / 5.50 Pressure Washer won't start no spark


... Briggs & Stratton Pressure Washers

Cannot start engine after rebuild - Craftsman 2500 PSI Briggs & Stratton Powered Pressure Washer


... Craftsman 2500 PSI Briggs & Stratton Powered Pressure Washer

Won't start - Craftsman 2700 PSI,2.3 GPM Briggs & Stratton Powered Pressure Washer - Ca. Model


... Craftsman 2700 PSI,2.3 GPM Briggs & Stratton Powered Pressure Washer - Ca. Model

How do you start the engine - Craftsman 2700 PSI Briggs Stratton Powered Pressure Washer


Well without knowing your specific engine I will give you the general steps.\015\012make sure there is fresh fuel in it (everyone has forgotten this sometime)\015\012there is possibly an ON/OFF switch on it somewhere. turn that on \015\012then there ... Craftsman 2700 PSI Briggs Stratton Powered Pressure Washer

Just bought a new Briggs Stratton 6 75 pressure washer. i put in a half a tank of gas in the tank and it started up. i ran the pressure washer until it was out of gas. put more gas in now it will not start.


Assuming you tried choking it when you tried to start it, verifiy its getting gas,if not tap lightly on the bowl of carburator. if it is getting gas, check for spark ... Briggs Stratton 020273 Elite Series Portable Gas Pressure Washer

The power washer is not taking in the soap. - Briggs & Stratton Briggs Stratton Vanguard OHV 3000 PSI Gas Pressure Washer


... Briggs & Stratton Briggs Stratton Vanguard OHV 3000 PSI Gas Pressure Washer

I have a Briggs and Stratton 5.5 hp 2250 PSI pressure washer that lacks PSI. How do I make sure the upload valve is free. It just doesn't appear to be adding pressure to the tank.


... Pressure Washers

Troy bult 2700 pressur washer won't start - Briggs Stratton 198347gs Pump Assembly Kit For Pressure Washers


... Briggs Stratton 198347gs Pump Assembly Kit For Pressure Washers

Craftsman pressure washer model 580.752520 - Craftsman 2500 PSI Briggs & Stratton Powered Pressure Washer


... Craftsman 2500 PSI Briggs & Stratton Powered Pressure Washer

Honda 2500 pressure washer manual - Craftsman 2500 PSI Briggs & Stratton Powered Pressure Washer


... Craftsman 2500 PSI Briggs & Stratton Powered Pressure Washer

2800 PSI Troy-Bilt XP pressure washer manual - Briggs & Stratton Prosumer 20324 Gas Pressure Washer


... Briggs & Stratton Prosumer 20324 Gas Pressure Washer

Hondar 2500 pressure washer wont start - Honda 2500 PSI Gas Pressure Washer


... Honda 2500 PSI Gas Pressure Washer
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.1005 seconds