Having problems with your Briggs & Stratton Briggs Stratton 1800 Psi Elec Pressure Washer ?

My briggs and stratton power waher is leaking oil all over the place


Answers :

Repair Help & Product Troubleshooting for Briggs & Stratton Briggs Stratton 1800 Psi Elec Pressure Washer

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

My briggs and stratton power waher is leaking oil all over the place


... Briggs & Stratton Briggs Stratton 1800 Psi Elec Pressure Washer

Looking to change engine oil - Briggs & Stratton Murray 020456 2400 PSI 20 GPM 190cc Briggs Stratton Gas Powered Pressur


... Briggs & Stratton Murray 020456 2400 PSI 20 GPM 190cc Briggs Stratton Gas Powered Pressur

Campbell Hausfield Pressure washer model 1549. After a few years of storage, I cannot prevent the powerful spray leaking from the connection between the Gun and the Lance. I replaced the O-Ring, and tried other means unsuccessfully. Spray from the joint is almost as powerful as spray from the lance nozzle. The Briggs and Stratton engine has been cleaned and operates well. The pump operates well. But the lance connection refuses to seal.


Hello,Most likely, the housing has split and seal is not being made. There is a chance that the hose is leaking where the fitting is crimped on (my experience, but different pressure washer). Are you able to see a leak when turned off b ... Campbell Hausfeld Pressure Washers

Started by Craftsman 2700 PSI , 2.3 GPM Briggs & Stratton Powered Pressure Washer for first time in 9 months. Added new oil, and gas. started but is smoking from muffler and is dripping what appears to be oil near the exhaust end. I shut it down. What could this be due to?


The first thing I would check would be the oil level, to make sure you didn't put in too much oil. If the oil level is correct, it could be a stuck piston ring, letting oil blow by the piston, and out the exhaust. If this is the case, you are going ... Craftsman 2700 PSI,2.3 GPM Briggs & Stratton Powered Pressure Washer - Ca. Model

Cannot figure out how to remove the oil plug to drain the oil. Label points to a spot that looks like it might be a plug, but can't figure out how to remove it. It is a 2500 psi Mdl VR2500 Briggs & Stratton engine Honda Power Washer. Ken from NH


Should take a 3/8" socket extention ... Pressure Washers

Briggs & Stratton engine loses power


Hello herb1007If it is running it would burn any oil off the top of the piston. (that got there when you tipped it). It sounds like you carburetor needs cleaning. There are sprays on the market that sometime help with this. ... Briggs & Stratton Pressure Washers

Oil leak but dipstick says its full i have a briggs &stratton 2200psi q45 seris 2.0 gpm


... Briggs & Stratton Pressure Washers

I have a Brute Briggs and Stratton as power washer. Water leaks from the oriface. How do we fix it?


... Briggs & Stratton Prosumer 20324 Gas Pressure Washer

What oil to use in a 4 cycles Briggs stratton 4 hp on a coleman power pressure 2000 psi


... Pressure Washers

How to drain oil from engine - Craftsman 3000 PSI 27 GPM Briggs Stratton Powered Pressure Washer


Square socket on the bottom of the engine. I think a 3/8 extension on a ratchet is correct. ... Craftsman 3000 PSI 27 GPM Briggs Stratton Powered Pressure Washer

I have a JD 3300 psi 1150 Briggs n Stratton pw. It is leaking from the oil cap/ dipstick seemingly from high pressure. The cap dipstick is about 10 inches long, so this is a real squirt goin on. There is no rubber oring or gasket in the cap. I bought it from a pawn shop new, or at least seemed new as the hose and tips were still factory wrapped. Any ideas?


Either there is compression from cylinder getting into crankcase pushing the oil out or the oil level is too high. ... Briggs & Stratton Pressure Washers

Gas is leaking into the oil tank on a craftsman pressure washer. it will do this while it is running or sitting in storeage. it has a briggs and stratton intek engine.


... Karcher 2500 PSI Pressure Washer

Gas in oil in pressure washer - Craftsman 2700 PSI Briggs Stratton Powered Pressure Washer


... Craftsman 2700 PSI Briggs Stratton Powered Pressure Washer

How much pump oil do I put in - Craftsman 2700 PSI Briggs Stratton Powered Pressure Washer


... Craftsman 2700 PSI Briggs Stratton Powered Pressure Washer

Gas leaking from carb on Briggs and Stratton engine


`v already answerd this,are you slow? with oil in the sump you can do no damage by running the engine with abit of smoke,it will clear up very quickly. i find it hard to believe youhave done the things you claim if you dont know what a carby bowl is! ... Coleman Powermate DuraBuilt 1400 PSI Pressure Washer

I borrowed my nieghbors power washer. It worked the first day all day. In the morning i filled the gas with a fuel stabiler, and 30 oil. I may have over filled it. Upon turning it on the oil started leaking from the air filetr compartment. It starts, but then smokes starts to fume and all the oil leaks. Did I break it or is it a easy fix. I cleaned the filter housing. Also the filter was soaked with oil. should i get a new filter and install it or what is the solution. need help.


You will need to get a new filter, and drain some of the oil out of the machine. If you over fill these this will happen. 90% of the time nothing is broken. ... Karcher 2500 PSI Pressure Washer

The power washer is not taking in the soap. - Briggs & Stratton Briggs Stratton Vanguard OHV 3000 PSI Gas Pressure Washer


... Briggs & Stratton Briggs Stratton Vanguard OHV 3000 PSI Gas Pressure Washer

Oil I have a Briggs and Stratton 2200 psi pressure washer. It doesn't specify an oil ~ other than to show a photo of synthetic pressure washer oil manufactured by them. I can't find that specific brand anywhere, what can I substitute it with? Ace hardware was stumped.


Remember when your searching for something you can't find the internet is always your best bet. You should also use a good search engine; www.bing.com is one of the best search engines I have ever used. I searched some stores that have the oil your l ... Briggs & Stratton Briggs Stratton 2000 Psi Pressure Washer Freeshp

Briggs and Stratton pressure washer fuel leak


You've hit the nail on the head.The float,needle and seat are stuck wide open.Once the carburetor bowl is full of fuel the float rises up on top which pushes the needle back into the seat shutting of the flow of fuel.As the engine consumes that fuel ... Briggs & Stratton Pressure Washer Projectpro Spray Nozzle

Stratton 675 series - Brute 7800802 22-Inch 190cc Briggs & Stratton 675 Series Gas Powered FWD Self Propelled Lawn Mower With High Rear Wheels


... Brute 7800802 22-Inch 190cc Briggs & Stratton 675 Series Gas Powered FWD Self Propelled Lawn Mower With High Rear Wheels

What oil do i use to chane oil - Briggs & Stratton 2200 PSI Gas Pressure Washer


For normal usage I would reccomend straight 30 weihgt oil.If you are planning on using it during colder temperaturesI would switch to 10w-30. thanks ... Briggs & Stratton 2200 PSI Gas Pressure Washer

Power washer won't start - Briggs & Stratton Power Products 1539 Pressure Washer


Have you checked for spark? You can remove the plug, touch it against the block and crank it and see if you have any spark (best done in as dark a place as possible). If you don't have spark, start by replacing the plug.\015\012\015\012 ... Briggs & Stratton Power Products 1539 Pressure Washer

Briggs and stratton 125K02-0131-E1 is leaking gas from around the air filter. I have looked at the hoses and they seem to be fine. I seen where to bang on the carborator to undo the foat, have tried that, still leaking and will not fire


Float is either faulty or sticking very bad, manualy take it out and clean it make sure it moves freely ... Pressure Washers

I have a murray lawn mower powered by briggs and stratton, i'm trying to fing a manual on the internet but it says to put my model number, and on my engine it says that my model number is lev100 but nothing on the internet comes up, i need help. it also has a date (1995-1998). i don't know how many horse power it is.


The model numbers on a briggs engine are stamped into the metal cover above the spark plug and are the first 6 digits the rest are engine codes and type. ... Briggs Stratton 020273 Elite Series Portable Gas Pressure Washer

How much oil does it take to change oil in the briggs and statton power washer


... Briggs & Stratton Pressure Washer Projectpro Spray Nozzle
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.1055 seconds