Having problems with your Briggs & Stratton Gas Pressure Washer 20244 ?

2300 psi Quantum pressure washer won't start. It is about 4 yrs old. If i change the spark plug does it have to be gapped,If so what is the gap size?


Answers :

Repair Help & Product Troubleshooting for Briggs & Stratton Gas Pressure Washer 20244

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

2300 psi Quantum pressure washer won't start. It is about 4 yrs old. If i change the spark plug does it have to be gapped,If so what is the gap size?


... Briggs & Stratton Gas Pressure Washer 20244

My Karcher 2400 PSI pressure washer is not starting after about 5 years. What type of spark plug and gap should I change the old out with and what kind of oil do you recommend. I don't think I have ever changed the oil but way less that 50 hours on the machine. Thanks


... Karcher 2500 PSI Pressure Washer

Briggs and Stratton pressure washer will not start. I have a 6.75 hp pressure washer that is only a year old. when I pull cord it turns over but does not start. I changed plug and checked it, I have spark when pulling. I have 40-50 psi of compression when pulling also. gas was drained and is brand new. it was working fine last time it was used. I have tried starting it without the water line or spray wand hooked up and no difference. After about 10 or 15 pulls, can smell gas when I am trying to


Hello dave, the problem is compression to low,you need 60 to 130 lbs to run engine,check for blown head gasket,or bad rings,or a stuck open valve,hope this helps,, ... Briggs & Stratton Pressure Washers

Washer won't start tried everything , I could think of changed spark plug tried new gas , Two things that bother me are . if i take out the spark plug and put my thumb over the spark plug hole theres no pressure and the wire that comes from the coil to shut off the pw it has continunity from the coil to the pin that sticks up to shut off the pw but it also has continuity from the coil to all parts of motor.


... Pressure Washers

11 hp honda pressure washer engine won't start. No spark at the pkug, bought a new coil and still no spark. This sysem only has a coil off the fly wheel and the spark plug. I even changed spark plug. Use the unit the other day, shut it down and on restart it won't start. Also, I disconnected the kill switch and the il lvel sensor so nothing was going to ground.


If you replaced the coil,check the wire and boot,check with meter for continuity.could be loose connection to spark plug ... Honda Pressure Washer PSI 3000

Honda GC190 no start. Unit has been sitting for 2 years. Drained old gas, cleaned the carb. No go. New plug gapped to 0.030in. Still nothing. spark seems good. Cleaned the fuel strainer and there IS a bit of vacuum at the fuel pump when cranking. Poured a dab of gas into combustion chamber.. Still won't "talk to me" AT ALL. Removed valve cover and checked the valves.. within specs and nothing sticking or hanging up. Timing belt and cam looks good. Took a peak at the coil.. air gap in specs. 1ohm


... Karcher 2500 PSI Pressure Washer

Troy built pressure washer won't start. It has a Honda 160 CVG motor. I used it for about a year and then it stopped working. I've replaced fuel and spark plug. Spark plug is soaked every


... Karcher 2500 PSI Pressure Washer

I have Craftsman 6.75 horsepower pressure washer model no. 580.7527000 I starts and then shuts off.have change spark plug. still runs a short time and dies.


Replace the gas, check the air filter is not clean. ... Craftsman 2500 PSI Briggs Stratton Powered Pressure Washer

What is the Spark Plug Gap for workforce wf80911 pressure washer


... Pressure Washers

My pressure washer doesnt seem to run properly. i have changed the fuel,air filter,spark plug and the oil. It will start but runs poorly.


Ok the first thing you need to check is if the spark is fireing. To do this you need to remove the plug plug it into the spark plug cap hold it on the cylinder head pull the engine over it will pull easy and see if you have a blueish spark jumping th ... Briggs & Stratton 2200 PSI Gas Pressure Washer

Spark plug gap - Global Industrial 2700 Psi Pressure Washer With 6 Hp Honda Engine


... Global Industrial 2700 Psi Pressure Washer With 6 Hp Honda Engine

I have a Craftsman 2700 psi pressure washer with a Briggs and Stratton 850 engine (80 year anniversary special addition) . It is about 2 years old and used very little and will not start. I filled it with fresh fuel and checked the oil. I also replaced the spark plug and air filter. I checked the fuel line thinking it may not be getting fuel, but there is no obstruction from the tank to the end of the fuel line. I am out of TS options short of taking it to a service center.


Here is the long answer with everything we learned while using a power \015\012washer twice a day for years::\015\012It sounds like could be one of the problems listed below or a \015\012combination of those things.\015\012\015\0121 ... Briggs Stratton 020273 Elite Series Portable Gas Pressure Washer

What is the spark plug gap? - Porter Cable PCH3200 Commercial Pressure Washer


Hi Mike,If you can identify the model of Honda engine on the washer, you can download the service manual from this webpage:http://engines.honda.com ... Porter Cable PCH3200 Commercial Pressure Washer

Karcher 2400R I have not used my pressure washer for 6 months. It was left full of gas in the garage. I tried to start it but it would not fire up so I change the gas, oil, and spark plug, took apart the carburator and cleaned it out with carb cleaner. I went ahead and put everything together, pull the cord and wanted to start. While trying to start it after I sprayed starting fluid in the air cleaner I noticed that gas was coming back from the crankcase breather hose into the air filter choking


You have a poor signal to the spark plug usually caused by a rusty fly wheel found underneath the pullcord casing. clean it with releasing ajent such as wd 40. common when not in use for a while. ... Karcher 2500 PSI Pressure Washer

ENgine runs very rough, replaced spark plug, no change in condition. What's the gap for the magneto?


... Pressure Washers

Hi, I have a problem starting my Craftsman 2450 PSI Pressure Washer, Model 580.752310, could you help? I've changed the spark plug.


... Craftsman 2500 PSI Briggs Stratton Powered Pressure Washer

I have a craftsman Pressure washer Model 580-725400 the unit has ran great until today. I last used the unit 1 week ago with no problems but now I have to run the machine almost full choke to get it it rev up and run smooth. The engine oil is clean and filled to the proper point. The spark plug is new and gapped proper. The air filter is new also. And the gas is 97 Oct and fresh. When it choke it to crank the engione I move the choen to run and the engine struggles to run. When I move the choke


... Craftsman Pressure Washers

Briggs and stratton 020228 spark plug gap - Briggs & Stratton Pressure Washers


... Briggs & Stratton Pressure Washers

Does anyone know what the spark plug gap setting should be for a campbell hausfeld model pw1755v3le pressure washer should be?


Most gas engines will work fine at .030 to .035 sparkplug gap ... Campbell Hausfeld PW2102 Gas Pressure Washer

Pressure washer will not start, cylinder has fuel in it. i think it was filled with diesel. i change the fuel, and the spark plug. still no start. if i spray it with carb or brake cleaner it runs fine.


Pull the fuel hose from the carburetor and let some drain out. Drain the carburetor float bowl. Are there H an L mixture adjustments? Preset each 1-1/2 to 2 turns CCW from CW stop. Get it running with spray if you have to, then adjust the mixtures fo ... Pressure Washers

Spark plug size on Choremaster power washer - Mi T M Mi-T-M CM-1250-0MEH NA Chore Master 1250 PSI Chore Master Pressure Washer CM-1250-0MEH


... Mi T M Mi-T-M CM-1250-0MEH NA Chore Master 1250 PSI Chore Master Pressure Washer CM-1250-0MEH

Motor has been sitting for a while changed out old gas put new in drained carb bowl put new spark plug wont stay running


Here is the long answer with everything we learned while using a power washer twice a week for years::It sounds like could be one of the problems listed below or a combination of those things.1) The exhaust is partially blocked. Che ... Pressure Washers

Can't start the Honda GX160 5.5 HP Electric motor on my Chore Master 2400psi Pressure Washer. Got gas (checked through feed line), new spark plug, switch on, gas, choke ok, throttle a bit funky (about 12 years old on loan from a friend unused for 5+ years, no manuals). Recoil string sounds close to kicking over, but pretty half-heartedly ...


Is there an oil sensor unit if it is going bad it tells the engine the oil low and engine wont start. I had same problem with my pressure washer, i just unplugged the sensor unit and it started fine ever since ... Pressure Washers

What is the gap on spark plug for vr2500 - Briggs & Stratton Briggs Stratton Pressure Washer Repair Manual B3277gs


... Briggs & Stratton Briggs Stratton Pressure Washer Repair Manual B3277gs

Spark plug gap briggs and straton 6.75 hp pressure washer


... Briggs Stratton 020273 Elite Series Portable Gas Pressure Washer
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.1184 seconds