Having problems with your Briggs & Stratton Pressure Washer Projectpro Spray Nozzle ?

No detergent flow to nozzle

\015 Cannot get detergent to flow from the container to the nozzle\015

Answers :

Repair Help & Product Troubleshooting for Briggs & Stratton Pressure Washer Projectpro Spray Nozzle

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

I have a Campbell Hausfeld RBPW1810 pressure washer, It has two detergent tanks. I cann't get either to work. I just purchased the unit in June if this year and this is the frist time I am useing the unit. I followed the instructions (low pressure position on the nozzle) and the detergent came on for two second then stopped (only water then). What am I doing Wrong??? Rich From Alqonquin, Ill


Sometimes thinning the solution will help, but in any case make sure the line from detergent tank to pump is sealed, otherwise it just sucks air. I use a small hose clamp at pump. let us know ... Campbell Hausfeld 1800 PSI Electric Pressure Washer

How do I get the nozzle to spray detergent out of it? The high pressure works great but I can't get the detergent part to work. I lost the owners manual and now I'm confused about it. Any help will be appreciated. Thank You , Mad Max


Go to this LINK and find the part/diagram that can help you. ... Karcher FactoryReconditioned K240R 1400 PSI 13 GPM Electric Pressure Was

My TroyBilt Pressure Washer 2500 PSI 2.3 max gpm will not pull detergent through the tube. I have the correct tip on the nozzle and the tube connected to the pressure washer and in the bottle of detergent but I'm getting nothing. Any ideas? Thanks! -Carson


If you follow the chemical hose back to the pump it will be attached to a barbed nipple, behind the nipple there should be an o-ring, spring and a ball.A lot of the time if you are using the proper nozzle in the low pressure setting and still c ... Briggs & Stratton Pressure Washers

B302 - unable to start detergent flowing - How should it work?


It will only pick up detergent if you use a low pressure detergent nozzle - or no nozzle at all. It also takes a while for the detergent to get to the nozzle. ... Karcher 2500 PSI Pressure Washer

DeLime light and detergents not flowing into dishwasher


Make sure the probs are clean inside of unit.Lime build up and calcium deposits may have occurred. ... Dishwashers

Have k3.99 electric. have water flowing through coming out nozzle but has no pressure. Powwer is there. Have no idea where to look or what needs to happen ?


... Karcher K2.26 Electric Power Washer

Have a Karcher kb4040 that continues to run constantly even when the trigger isnt pressed. Also water flows out of the detergant hose when im not pressing the trigger. Pressure seems down slighlty, not much. This happened after i ran water out of trigger gun with no lance attached, machine switched on. Seems to leak from trigger handle aswell. Many thanks in advance


This is two things. One is the back flow check valve to the soap line is leaking. The other is the pressure switch on the output side of the pump. ... Pressure Washers

I have a G2500VH pressure washer that has started to pulse when the trigger is squeezed. This happens if I use the 0,25, and 40 degree nozzles BUT if I use the one for low pressure(detergent use) it will hold pressure fine. I have changed the unloader valve, checked all the valves and seals ad they seem to be fine. What could be the problem?


Do you mean pressure on and off with the hp tips and smooth and steady with chemical tip? ... Pressure Washers

I have a McCulloch FHH18A power washer. When plug it in without the water turned on, the pump will start. As soon as I turn the water on to the unit, the GFCI power cord trips. Water does flow through the unit as I have water at the wand nozzle when not plugged in. Any suggestions?


I would guess there is a leak somewhere inside the unit that is spraying water on some electrical component and causing a ground fault. ... McCulloch FHH18A Electric Pressure Washer

I have a B&D PW 2100 SPB washer but cant get the soap to flow into the nozzle


Click on the links to help you solve your problem,\015\012\015\012Using the correct nozzle for detergent injection\015\012\015\012 ... Black & Decker Pressure Washers

My Karcher K3.48M pressure washer remains in the low pressure mode even when I return the pressure nozzle to the high pressure position. How can this be corrected. The pump seems to build up the pressure because when I release the handle the pump motor stops. This is a fairly new pump which was purchased in the latter part of last year(2010). Could this have been caused by the detergent I have been using which is an automotive shampoo? Please help I love this washer and for the times that I u


... Karcher PSI Electric Pressure Washer

I have a Honda GCV160 5.5 HP engine, CV-2400-1MHC, 2400psi, 2 GPM Chore Master MI-T-M gas pressure washer, about 5 years old (the manual is dated 2005). I am the second owner and the first owner told me he did not use it very much. I just bought it in July 2010. When I adjust the nozzle the only setting that will clean my timber deck is the high pressure with the narrowest flow. At this setting it will take forever to clean the deck. The setting with a broader coverage and high pres


... Honda Pressure Washers

Can get no water flowing to the spray nozzle


Most likly the sliding nozzle valve is not fully down or up. I have found after the nozzle lay about for some time they get stuck from water scale. It took two persons pulling and pushing on the valve to get my to operate again. It worked for me. ... Briggs & Stratton Adjustable Spray Nozzle And Wand #6044

Very little water flow from washer . Once water is connected to the intake side of washer very little is coming from the out site to power nozzle when engine is started it still does not boost water preasure


... Pressure Washers

Home lite 3100 psi pressure washer detergent wont flow


... Karcher 2500 PSI Pressure Washer

I have a gas powered husky 2600 psi, hook up everything 3/4 hose line about 10 ft long, let water flow through w/o nozzle added, fire up the engine and when I pull the handle, engine stalls out . Any help would be great, mike


Choke off? \015\012Fuel quality, meaning no water, is essential of course.\015\012If its brand new and this is the first starting, I would call Husky. Check oil..\015\012The engine has a governor on it, so it should be sounding lik ... Pressure Washers

My dishwaher is leaving detergent film (some clumps) on my dishes but especially the silverware. Checked the nozzles and did not see any obstructions. Thank you for any advice!


Its not detergent it is hard water causing the problem. go to www.dishwasherfilter.com and get their filter. ... Bosch 24 in. SHE56C05UC Stainless Steel Built-in Dishwasher

Can't move nozzle to low pressure


... Campbell Hausfeld Pressure Washers

Does not give a continous high pressure flow cuts in and out


Hi. Water flow may be restricted to the pressure washer. Check that all hoses are free of kinks, leaks, or blockage. Make certain all hoses and fittings are connected properly. Make sure to open the faucet/spigot ... Karcher K2.26 Electric Power Washer

Water keeps flowing into dishwasher


... ikea-usa.com Dishwashers

I have a frigidaire FDB1050REC0 dishwasher that is working fine most of the time. Sometimes about 40 percent of the time, when we open the main door after it is finished with a normal cycle, we find a big clump of detergent left in the main detergent compartment and the detergent door is open. It is like the detergent is getting wet with the detergent door closed and then when it is supposed to open, the detergent is wet and clumps. We switched to liquid detergent and the same thing is happening


... Frigidaire Dishwashers

Dublin Dispenser broken nozzle


... Godinger Dublin Beverage Dispenser

Karcher pressure washer does not suck detergent up


... Karcher K2.26 Electric Power Washer

Detergent trouble After each wash, there is detergent (gel) left on my dish/dishes that are driectly in front of the detergent cups (once the door is closed). The detergent cup that closes still has detergent all over it. Ideas?


Hi there,\015\012\015\012sounds like the detergent dispenser is not working properly.\015\012\015\012are the rest of your dishes clean? in other words, is there any food residue on them?\015\012\015\012check the d ... Frigidaire 24 in. FDB1050REC Stainless Steel Built-in Dishwasher
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.0274 seconds