Having problems with your Briggs & Stratton Pressure Washer Projectpro Spray Nozzle ?

Engine will not stay running

\015 I have a B&S 4.5 hp engine on my 2200 psi pressure washer. Will start right up if pump primer bulb but will not stay running. Throttle lever is in correct position. Sat all winter but was started in fall to run Stay-bil through it.\015

Answers :

Repair Help & Product Troubleshooting for Briggs & Stratton Pressure Washer Projectpro Spray Nozzle

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

My pressure washer will not start or stay running unless the trigger is open on the wand. The engine runs good until the trigger is released then the engine stalls instantly. what is worng and how do I fix?


... Briggs & Stratton 2200 PSI Gas Pressure Washer

13 hp honda pressure washer 3000 psi 4gal/min Hard to start and dies out after 20 seconds after the engine gets hot and running after multiple starts the engine will stay running but then dies every 30 minutes


There are a couple of things that can cause this problem. The first thing to check is if you are loosing spark. Dying after it gets hot sounds like to stater is failing in the engine. If you loose spark this is more than likely the issue. If you are ... Honda Landa PG 3500 PSI Pressure Washer

Engine wont stay running unless i put my hand over carb then it stay runnin cleaned carb gas is flowing fine engine is on a morta mixer


Hi and welcome to FixYa. I am Kelly. \015\012When you said you cleaned the carb did your remove the float bowl? Here is what you need to do: \015\012\015\0121. Fuel selector off\015\0122. Remove float bowl mounting s ... Honda 8 HP Engine

I have a problem with my karcher 2500 pressure washer with honda engine it will not start or stay running. I have used starting fluid to start it it starts but won't stay running.


Carb is mostly likely gummed up and should be cleaned. Best option is to dismantle the carb and soak in solvent or equivelant for a couple hours and replace it. Our use Gum Out. Do make sure you have a good spark plug and a strong spark. If you have ... Karcher 2500 PSI Pressure Washer

Engine wont stay running


It is a diaphram carb. Doe's the primer **** straight gas or does it have air bubbles in it? If it has bubbles in it then it is a leak in the fuel line.\015\012If not then Unhook the intake fuel line and pump the bulb until all of the gas is ... Briggs & Stratton Power Products 1539 Pressure Washer

Pressure Washer Engine will not stay running


... Pressure Washers

Pressure Washer Engine will not stay running


Cant get my pressure washer started, replayed spark plug, thanks ... Pressure Washers

I have a Karcher/Honda GC190 6.0 engine starts OK but won't stay running...I had the carb apart and everything looks normal...any thoughts? thanks!


... Pressure Washers

Why wont blackmax power washer 2700 psi honda engine wont stay running once i spray


... Honda Pressure Washers

My 5.5 honda engine on my lawnmower will start but wont stay running already cleaned the carb out didnt help there is no restrictions in the fuel lines im lost please help


It sounds like a fuel problem.\015\012first drian fuel out of tank.\015\012i know you have already cleaned the carby but dis assemble carby and clean with carby cleaner.\015\012re assemble carby & fill tank with fresh fuel.\01 ... Honda Pressure Washers

I have a 5HP Honda engine installed on a Excell pressure washer. While the engine readily starts, it will not continue to run unless I keep the choke setting nearly completely closed. When I activate the pressure gun, it seems to generate adequate pressure, however, when the trigger is released, the engine continues to run at the same rpm instead of the normal variable rpm that most engines operate at during idling periods. The engine will always cease running when I push the choke rod all the w


... Honda Pressure Washers

Unit Runs fine, except when you press the spay gun the engine stalls out. Unit was working fine, ran out of gas, filled tank and started engine. Engine was running fine, triggered spray gun and the engine stalls out.


... Pressure Washers

I have a craftsman Pressure washer Model 580-725400 the unit has ran great until today. I last used the unit 1 week ago with no problems but now I have to run the machine almost full choke to get it it rev up and run smooth. The engine oil is clean and filled to the proper point. The spark plug is new and gapped proper. The air filter is new also. And the gas is 97 Oct and fresh. When it choke it to crank the engione I move the choen to run and the engine struggles to run. When I move the choke


... Craftsman Pressure Washers

Washer want stay running. I can pull choke and it


Mr fixit, I have pressure but it just want stay running ... Pressure Washers

The engine starts cold after 2 or three pulls, runs ok initially, but seems to have slightly less power. After a few minutes I can turn off the choke. When teh engine warms up and runs for about 15 minutes, there is a definite power decrease and the motor sounds like it will stall. If I paly with the choke, it does not stall, but has little power to pump water. If the engine does stall or it is turned off, it will not restart until it cools down.


I would first try draining the carb bowl, if you look at where the choke lever is and look below that you should see a clear red tube with a flat head screw below that, if you just turn the screw out the carb will drain. If you still have an issue yo ... Karcher G3025OH Pressure Washer

Honda CU2400 1-MHC has been sitting in my parents garage for about 2 years. It was used once or twice. It looks new. I tried to start it and it wouldn't. I drained the gas and put new premium gas in it and it started but it won't stay running and the pressure is not what it should be. It doesn't clean as well as the electric one I used last time. So, my problem is, it won't stay running and when it is running it doesn't have enough pressure. Any ideas???


After sitting that long, I'd guess the carburetor linkages etc., are partially seized and the governor is not operating as it should to allow proper RPM's when under load. Real good chance carburetor is gummed up good too. I'd get carb serviced, but ... Pressure Washers

I have a pressure washer model 020245 engine wont stay on


... Briggs & Stratton Power Products 1539 Pressure Washer

Water runs out of radiator and out exhaust when engine is running it,s a vs commodore engine


Blown head gasket. compression is forcing water back into cooling system ... Karcher 2500 PSI Pressure Washer

My Honda gx160 5.5 hp engine only runs with full choke on. This has been the case since it was new. The engine runs very smooth, but dies if I open the choke. Thanks


... Karcher 2500 PSI Pressure Washer

For pressure washer Model WP-2402-SWHB, SN 10132043: With Honda engine running, or no engine running, no water will pass through the pump.


Hi If no water is passing through your pump on mains water pressure and not sucking from a barrel then it will be either a blocked nozzle,blocked unloader on the side of the pump or a blocked water filter. ... Pressure Washers

Honda motor wont stay running ,carb not getting enough gas to stay running


As it is gravity fed you would need to remove thfuel line from the carby to check that the fuel is geting to that point,if not removanf clean fuel .bowl and filter . if ok. then a carby service is in order ,they are not difficult but you do need comp ... Pressure Washers

Hello i have a Honda GX160 and the engine will only run on choke if i close it the engine just splutters and thats it. it wont run at the norm i have replaced the carb the tank the air filter and the spark plug and know luck i have no more ideas as to what the problem really is thanks jord


Ii know you must have replaced the fuel filter. Did you replace the fuel line? It is obvious it is not betting enough fuel or it is out of time. Have you tried adjusting the jets on the carb? Have you checked the timing? There is a crankshaft key-way ... Honda Pressure Washer PSI 3000

Engine runs, but when I press pressure washer gun the engine stops


... Annovi Reverberi AR RMW2.2G24 Pressure Washer Pump

My asko dishwasher(1504) keeps running sometimes, The time will run down to 1 min on the disply and stay there and run on and on until I turn it off. Prior to this another problem occured, when the washer does shut off on it's own, the display will read F1(Falt in the heater), I am wondering if one problem has to do with another. The heater problem I can deal with but not the continueous running.


F1 doesn't mean that it's always the heating element itself, often it \015\012can be the control board relay that has shorted and isn't sending power \015\012to the element. If the element is the faulty part, you'd be looking at \015\012about $250 f ... Dishwashers
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.0566 seconds