Having problems with your Briggs & Stratton Pressure Washer Projectpro Spray Nozzle ?

Gas does not shut off in bowl, float is good and needle is ood

\015 Gas does not shut off in bowl, float is good and needle is good is there a gasket where the needle inserts into the gas feed?\015

Answers :

Have you checked the seat where the needle lands in the bore for dirt or varnish that may be keeping the seat partially open and not fully closing?
Repair Help & Product Troubleshooting for Briggs & Stratton Pressure Washer Projectpro Spray Nozzle

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Gas does not shut off in bowl, float is good and needle is ood


Have you checked the seat where the needle lands in the bore for dirt or varnish that may be keeping the seat partially open and not fully closing? ... Briggs & Stratton Pressure Washer Projectpro Spray Nozzle

8 hp honda on cement mixer starts on first pull but shuts down as if it is running out of gas. I put fresh gas in it and cleaned the filter and bowl of the carb.


If it has a fuel filter. check that. change the spark plugs. ... Honda Pressure Washers

Engine does not start. I ran it about two weeks ago and it worked fine. I took the spark plug out and it was dry. I made sure there was gas in it. I tried some starting fluid by spraying into air intake and it start running for a short time until the starting fluid ran out. I removed the carb bowl and there was gas in it. However the inside of the bowl and the float had brown deposits and looks like rust. So I think the main jet has been clogged up with a particle. How do I clear it? Where do I


Try cleaning the carb with gumout spray and a little compressed air, be careful to reassemble the float and needle valve exactly as you found it. ... Northstar Pressure Washer 3000 PSI

Hello, I have a couple year old brigs and strattion upright pressure washer. It has always ran great untill recently. It will run for a acouple minutes before dying, like it is starving for fuel. i give it a couple of minutes, it starts right back up and again dies after a couple minutes of use... I have takin the float bowl and float off and cleand the gas tank and fuel line. everything seems to be in order. Do you have any ideas what it could be? I have not tuched the top side of the carb sinc


Check the oil level in the engine itself. Verify that your oil reservoir is full, then try again.You may also want to refer to the owners manual for other trouble shooting tips. Click this link to go to your manual.http://www. ... Briggs & Stratton Gas Pressure Washer 20244

Honda 13.0 gas leaking from bowl on the bottom of carb. Engine was breathing hard and starting to send white smoke out of muffler prior to stalling. In a carburetor type car i would say the float was stuck open. This is a DeWalt 3300.


That would be the first thing I would look at would be grit in bowl stopping the float from moving freely or a hole in the float. Hope this helps. Thanks ... Dewalt 3800 PSI Pressure Washer

Maytag Model MDB7160AWW S/N 10337613WQ Symptons: Fills with water OK, shuts off water OK, does not start any cycle, or drain. After a power off/power on reset, problem remains. Flashes CLEAN & LIGHT WASH. My understanding is this is an error condition for low motor current, which makes sense as the motor never starts. I know both door switches are good (I checked them with a DVM) and both engage when the door is closed. Tripping the water float switch opens the valve and water fills the tub


... Dishwashers

I have a Honda 5.5 hp pressure washer and it wont keep running I bought it off craigs list they said the last time it ran was almost a year ago I took off the carb and sprayed carb cleaner threwout but didn make a difference I cant seem to see any jets juist the float needle and that was clean if I pour gas in the carb it will run for a for about 5 seconds and but wont stay even if I choike it. does anyone have a answer


Try soaking the carb for 15 minutes in gasoline. If you have a plugged port just sparying may not be enough to clean it ... Honda 2500 PSI Gas Pressure Washer

Model gc190 will only run with choke applied,removed float bowl cover and found gummy **** in it removed jet and blew out with carb cleaner and comperssed air still no good


... Honda Pressure Washers

Gas is coming out of hole in float bowl - Honda Pressure Washers


There shouldnt be a hole in the float..if there is, the float is shot...the gas can never shut off if its filled with gas ... Honda Pressure Washers

Honda GX 240 on woodsplitter stopped running. Tries to fire a couple of times each pull but dies. Found debris in gas tank. Cleaned out the tank and hose to carb. Cleaned out the sediment cup. Cleaned out the rust and debris from the bottom of the float bowl. sounds like debris in carb jets? Is it worthwhile taking the carb apart and cleaning it, or just order a new carb?


Install a new plug, and make sure your gas mixture is not to rich, And you air cleaner is clean ... Honda 8 HP Engine

My lawn mower with a Briggs motor Wont start, has spark fuel is good , the unit is approx 5 years old, but seldom used, worked great last year, drained the fuel, and stored it for the winter.Refueled it and wont start. I can getting started if I pour a little gas down the carb, but naturally it wont run long. I'm thinking needle and seat, any help would be appreciated. Thanks


... Craftsman 2700 PSI Briggs Stratton Powered Pressure Washer

8hp honda engine on log splitter. costantly stalls as governor opens throttle to maintain rpm. engine starts to stumble then stalls. When revved with throttle acts similar. somewhat better when hot, somewhat better at half choke. have pulled carb and checked bowl, float, pulled main jet checked, blew carb out but no better. No dirt or gum in carb, looked new. all gaskets looked good. engine has low hours.


... Honda 8 HP Engine

Dishwasher starts washing before float switch shuts off


That is it , it is the electronic programer circuit board timer. change it.\015\012Vitally ... Dishwashers

My B&S 2050psi, 2.0 GPM, 3.75HP, doesn't want to start. I prime it as per the directions, good gas, spark plug good. I can flood it with gas and it runs until all the gas is used up then stops. I don't know why it's not able to get any gas from the tank on it's own. Once it starts shouldn't there be a vaccum that draws gas from the tank? Any ideas?


... Briggs & Stratton Gas Pressure Washer 20244

Shark pressure washer with honda 5.0hp motor when in use spraying with good pressure it the pressure shuts off and motor sounds like its about to shove a rod through the cases shut it off restart it andd the same thing occurs all fluid levels good pump and motor. water pressure from hose bib good. may b low water pres. for short time due to possible kink in hose reel not sure


What type pump oil to usefor karcher 2400 psi ... Honda Pressure Washers

I replaced the coil set, but that was not the problem. The ignitor will light the gas flame and it will blow for about 2 minutes, then the gas shuts off. Since replacing the coils, I have not tried the dryer with wet clothes inside. Is this gas shut off normal or do I need another part?


The gas flame will cycle on and off in response to the thermostat. Two minutes sounds about right for the dryer to warm up to temperature. The gas will shut off until the temperature cools down and then should cycle on again. Let the dryer run (ei ... Dishwashers

Won't start Fresh gas, good spark, shear pin good, exhaust comes OUT of the carb mixed with gas. I suspect a valve is stuck open inside. Does this sound correct?


Yes your moving in the right direction if over head valve remove the valve cover and check the rocker arms and for bent push rods if a flat head remove the head and check the valves ... Briggs & Stratton Pressure Washers

Honda GC190 no start. Unit has been sitting for 2 years. Drained old gas, cleaned the carb. No go. New plug gapped to 0.030in. Still nothing. spark seems good. Cleaned the fuel strainer and there IS a bit of vacuum at the fuel pump when cranking. Poured a dab of gas into combustion chamber.. Still won't "talk to me" AT ALL. Removed valve cover and checked the valves.. within specs and nothing sticking or hanging up. Timing belt and cam looks good. Took a peak at the coil.. air gap in specs. 1ohm


... Karcher 2500 PSI Pressure Washer

Maytag gas dryer, gas shuts off after the 1st heat cycle.


As long as your ignitor is heating up enogh. The most likely cause is the valves are not opening. you can usually get just the solenoids on the valve which is much cheaper than the whole valve and easier to replace. Please rate my response. ... Dishwashers

Pressure Washer model 580.752352 will not start


... Pressure Washers

I have a excell 2500 psi max honda 5.5 ho vr2522 2.2 gpm presser washer and has been stored for about a year, still looks brand new and has only been used twice before, it has oil and was stored with no gas in the tank, i put fresh gas in the tank and blead the fuel bowl until fuel ran out like it should, the washer wont start, ive checked the turn on switch as well and the fuel cut off knob, i spayed gas in the carb and it fired up but stopped running as fast as it began to run, its not getting


... Honda Black Max 2600 PSI Pressure Washer

My frigidaire dishwasher will not shut off the water being pumped into the dishwasher. It just keeps pumping in even after the required fill time and will not shut off, eventually I have to turn off the shut off so that it doesn't overflow. The float is working ok. Is this a sensor,circuit board?


... Frigidaire Dishwashers

I have a troy built pressure washer leaking gas from the air filter i looked around for advice and hurd bang against the carb and it will realease the float valve i did it and it worked but should i clean out the fuel in the filter area or the filter will it harm it as it is or should it be okay? the filter was soaked in gas dry now and when it happened the gas flowed from the air intake (behind the filter) if i need to clean out in there how do it do it and if i need a new filter


Definetly replace the paper filter and yes Lowes will carry them.if it does not leak now, I would leave it alone or you will be installing a nine dollar kit.The briggs kit # is 294260 is you choose to do it anyway ... Coleman Powermate DuraBuilt 1400 PSI Pressure Washer

Dishwasher does not fill with water, checked float and it is good. so signal at water valve. But i get a good ohm reading on the valve.


Is the valve opening. Since you have a meter set it to the a c voltage range, and check whether you get voltage to solenoid coil where you tested coil resistance. If no voltage reaching check the control board. For a trial fill water manu ... Dishwashers

I have a excell 2600 honda 5hp gc 160.It has not been used for over a year. I empted the old gas out & put in new gas. It will start but when I push the choke in it shuts off.


I have this same Excell 2600 pressure washer and I had the same problem after using old gas and leaving it sit idle for 4 months after using it only once. When you pull out the choke you are dumping raw gas in the engine and bypassing the carburetor ... Honda Pressure Washer PSI 3000
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.0653 seconds