Having problems with your Briggs & Stratton Pressure Washers ?

What kind of oil do you use for a 6.75hp briggs & stratton pressure washer and where is the drain plug at


Answers :

Repair Help & Product Troubleshooting for Briggs & Stratton Pressure Washers

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

What kind of oil do you use for a 6.75hp briggs & stratton pressure washer and where is the drain plug at


... Briggs & Stratton Pressure Washers

Briggs and Stratton pressure washer will not start. I have a 6.75 hp pressure washer that is only a year old. when I pull cord it turns over but does not start. I changed plug and checked it, I have spark when pulling. I have 40-50 psi of compression when pulling also. gas was drained and is brand new. it was working fine last time it was used. I have tried starting it without the water line or spray wand hooked up and no difference. After about 10 or 15 pulls, can smell gas when I am trying to


Hello dave, the problem is compression to low,you need 60 to 130 lbs to run engine,check for blown head gasket,or bad rings,or a stuck open valve,hope this helps,, ... Briggs & Stratton Pressure Washers

I have a Craftsman 2700 psi pressure washer with a Briggs and Stratton 850 engine (80 year anniversary special addition) . It is about 2 years old and used very little and will not start. I filled it with fresh fuel and checked the oil. I also replaced the spark plug and air filter. I checked the fuel line thinking it may not be getting fuel, but there is no obstruction from the tank to the end of the fuel line. I am out of TS options short of taking it to a service center.


Here is the long answer with everything we learned while using a power \015\012washer twice a day for years::\015\012It sounds like could be one of the problems listed below or a \015\012combination of those things.\015\012\015\0121 ... Briggs Stratton 020273 Elite Series Portable Gas Pressure Washer

What type of oil does pressure washer use? - Briggs & Stratton Pressure Washer Projectpro Spray Nozzle


... Briggs & Stratton Pressure Washer Projectpro Spray Nozzle

Cannot figure out how to remove the oil plug to drain the oil. Label points to a spot that looks like it might be a plug, but can't figure out how to remove it. It is a 2500 psi Mdl VR2500 Briggs & Stratton engine Honda Power Washer. Ken from NH


Should take a 3/8" socket extention ... Pressure Washers

Oil plug on troy bilt 020240 pressure washer - Briggs Stratton 020273 Elite Series Portable Gas Pressure Washer


... Briggs Stratton 020273 Elite Series Portable Gas Pressure Washer

Hi. I have a Briggs & Stratton 2800PSI gas pressure washer. I can get it to start, but after about 5 min, then it quits. I have cleaned the carb, change oil, changed plug, new gas, cleaned/checked air filter. Nothing will keep it running. Wondering if it may be not enough water pressure, but would that cause it to stop like that? When it runs, it does a good job, but it stops just as you get going. Do you have any other suggestions? Thanks!


If it wont start, check for spark.how you do that,ok take the spark plug wire out put it close to the sparkplug(use some gloves or something to insulate your self from get electric shot from the spark) find some one who pull the start rope, if you do ... Briggs & Stratton Prosumer 20324 Gas Pressure Washer

What oil do i use to chane oil - Briggs & Stratton 2200 PSI Gas Pressure Washer


For normal usage I would reccomend straight 30 weihgt oil.If you are planning on using it during colder temperaturesI would switch to 10w-30. thanks ... Briggs & Stratton 2200 PSI Gas Pressure Washer

Won start Was using the pressure washer 1st time this year and started on the second pull. Ran out of gas shut-off also noticed it needed oil. Believe, I put too much oil so, I drained some and added gas. At first, there was no resistant in the pull so waited an hour and tried again. This time the resistant was there on the pull but still would not start; no attempt even to turn over. It's been a couple of days...changed the spark plug although, hardware guy said nothing was wrong with it..still


... Briggs Stratton 020273 Elite Series Portable Gas Pressure Washer

I have a Briggs & Stratton Pro 3400 pressure washer that I got new last year and used for maybe 5 hours and it worked great. Have had it stored since then with stabilizer in the gas (I didn't run it dry) and now it won't run for more than a minute or two without dying. A dealer said it was probably bad gas and I now know that even with the stabilizer I should have run it dry last year before storing. Everything is like brand-new including plug and air filter so it must be the gas/carberator gunk


... Briggs & Stratton Prosumer 20324 Gas Pressure Washer

I have a Karcher 2,600 PSI 2.3 GPM Gas Pressure Washer G 2600 VHR that I have used once last summer. I have stored the PW in my basement with no fuel in the gas tank. The PW was never exposed to freezing temps. I cannot get the PW to start. I put new fuel into the tank, the oil is good, I drained the carburetor, and the spark plug works (tested it). I pull the cord and the engine doesn't turn. Fuel value is on, choke is pulled, and the starter switch is turned on. System is practically brand new


Hi I have a similar pressure washer from Kartcher and the same scenario as yours I have owned it for about 2 years and noticed that it was getting harder and harder to start with each time I use it which is months. If your pw has a honda engine on i ... Karcher G 2600 VH Gas Pressure Washer

I have a cratsman 675 series pressure washer, Briggs and Stratton motor. It stopped as I was using it. I tried to restart and feels like the motor is ceased. Oil was low as I found out. What to do?


... Briggs & Stratton Pressure Washer Projectpro Spray Nozzle

I have a 2550 psi pressure washer with a 6.75 hp briggs and stratton engine with ready start. i wont start. has gas and oil plug looks good. any solutions?


... Briggs Stratton 020273 Elite Series Portable Gas Pressure Washer

How to drain oil from engine - Craftsman 3000 PSI 27 GPM Briggs Stratton Powered Pressure Washer


Square socket on the bottom of the engine. I think a 3/8 extension on a ratchet is correct. ... Craftsman 3000 PSI 27 GPM Briggs Stratton Powered Pressure Washer

Hi, I have a Dewalt pressure washer 3100 psi. I want to know why the pressure washer works okay for 1 hour then it stop working completely. the oil is fine, the spark plugs are okay, and when I tried to start it again it does not work. Can you please tell me what could be the problem? This pressure washer is almost brand new I have used it for only like 30 hours for 2 years that I have it. I used it couple times lately but same problem it works for 1 hour then it does not work any. I will


There are two common issues that will cause what you are describing. What you need to do is run the machine until it dies as you are describing. Then pull the spark plug and check for spark. If you do not have spark you have a failing stater. It is v ... Dewalt DPH3100 Gas Pressure Washer

Oil I have a Briggs and Stratton 2200 psi pressure washer. It doesn't specify an oil ~ other than to show a photo of synthetic pressure washer oil manufactured by them. I can't find that specific brand anywhere, what can I substitute it with? Ace hardware was stumped.


Remember when your searching for something you can't find the internet is always your best bet. You should also use a good search engine; www.bing.com is one of the best search engines I have ever used. I searched some stores that have the oil your l ... Briggs & Stratton Briggs Stratton 2000 Psi Pressure Washer Freeshp

I got the pressure washer started - lots of smoke etc after not having used 3 years. I then poured in wrong oil to top it off - my brother's chain saw bar oil. DARN. After 3-4 minutes it started rattling and stopped. Can't pull the chord to get started. Did it seize the engine? I have drained all oil. Can I try using a cleaner, light weight oil to try to unlock it?


Nope! you have blown the seals and most likely the cylinder is full of water. You will need to take it to the repairer to have it cleaned checked and new seals fitted. $200 ... Karcher 1750 psi Electric Pressure Washer

What is the gap on spark plug for vr2500 - Briggs & Stratton Briggs Stratton Pressure Washer Repair Manual B3277gs


... Briggs & Stratton Briggs Stratton Pressure Washer Repair Manual B3277gs

Gas in oil in pressure washer - Craftsman 2700 PSI Briggs Stratton Powered Pressure Washer


... Craftsman 2700 PSI Briggs Stratton Powered Pressure Washer

I HAVE A NEW CRAFTSMAN PRESSURE WASHER WITH KEY START. I HAVE USED IT ONCE AND WHEN I TRIED TO START IT IT WAS HARD TO START HAD TO PULL START IT. NOW IT WONT START. LET PRESSURE OUT HAVE HOSE OH AND RUNNING, NEW SPARK PLUG HAS OIL, GAS FILTER FINE.HAS GOOD COMPRESSION, BUT WILL NOT FIRE GET SOME RECOIL. GETTING GAS TO SPARK PLUG AND GETTING SPARK. IM LOST PLEASE HELP.


... Pressure Washers

Briggs and stratton 020228 spark plug gap - Briggs & Stratton Pressure Washers


... Briggs & Stratton Pressure Washers

Does pressure washer pumps need oil or not? - Briggs & Stratton Pressure Washers


Yes all of them. its a special type call your local equipment rental facilty, its not readily avail normally ... Briggs & Stratton Pressure Washers

I have a Pressure Washer VR2500 , 6.5 horsepower / 2500 PSI number on side 123K12-0134-E Residential - Excell. I do not know which is the oil drain plug for the Pump on the bottom. There is an Allens Wrench plug on the side. However when removed nothing comes out. There is also an Alans Wrench like plug towards the back, that does not want to come out. Which one is the correct plug and do you have a picture as I could not order an Owners Manual on-line? Please Advise!


Hi and welcome to FixYa, I am Kelly \015\012First here is the owders manual: \015\012http://www.excellpressurewasher.com/documents/p ... Comet GXD2527G Pressure Washer Pump

I have a Briggs & Stratton gas power washer. This is the 1st time this year that I have used it. I put in fresh gas, hooked up the water supply. The engine started and then quickly stopped. I had to release the water pressure in the hose before I could pull start the engine. The only way to keep the engine running is to hold down the spray nozzle trigger. Once that is released the pressure in the hose builds up and the engine stops.


Sounds like the unloader is not working correctly. Try replacing it and see what happens. ... Briggs & Stratton Prosumer 20324 Gas Pressure Washer

Started by Craftsman 2700 PSI , 2.3 GPM Briggs & Stratton Powered Pressure Washer for first time in 9 months. Added new oil, and gas. started but is smoking from muffler and is dripping what appears to be oil near the exhaust end. I shut it down. What could this be due to?


The first thing I would check would be the oil level, to make sure you didn't put in too much oil. If the oil level is correct, it could be a stuck piston ring, letting oil blow by the piston, and out the exhaust. If this is the case, you are going ... Craftsman 2700 PSI,2.3 GPM Briggs & Stratton Powered Pressure Washer - Ca. Model
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.1670 seconds