Having problems with your Briggs & Stratton Pressure Washers ?

Sears Craftsman model 580.752011 where is the oil drain plug for the engine?


Answers :

Repair Help & Product Troubleshooting for Briggs & Stratton Pressure Washers

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Sears Craftsman model 580.752011 where is the oil drain plug for the engine?


... Briggs & Stratton Pressure Washers

I have a craftsman Pressure washer Model 580-725400 the unit has ran great until today. I last used the unit 1 week ago with no problems but now I have to run the machine almost full choke to get it it rev up and run smooth. The engine oil is clean and filled to the proper point. The spark plug is new and gapped proper. The air filter is new also. And the gas is 97 Oct and fresh. When it choke it to crank the engione I move the choen to run and the engine struggles to run. When I move the choke


... Craftsman Pressure Washers

I have a power washer, craftsman &.0 horsepower, 2900 psi, 2.3 GPM model number 580.752410. i was starter to wash my car, and stops? i change the spark plug, andput new oil in there. still do not working. some one helme in this problem.


... Craftsman 3000 PSI 27 GPM Briggs Stratton Powered Pressure Washer

Where is the engine oil drain plug for a honda xr2600 power washer


... Honda Pressure Washer PSI 3000

Engine lockup I have a craftsman power washer with a briggs and stratton 850 series engine, craftsman model 580752220, the engine will not turnover unless i remove the spark plug, it has electric start and will turn over with no problem like this but if i put my finger over the plug hole it locks up immediatly


Sounds like the intake or exhaust valve is not opening. ... Craftsman 2700 PSI Briggs Stratton Powered Pressure Washer

I have a sears pressure washer, model 580752300. The pump on the underside vibrated lose and broke a couple screws. It came off and the oil drained out. I replaced the screws and it's ready to go except I can't find out how much replacement oil to put back in. Sears has larger containers but won't tell you how much oil to put in. However, there's a pricey pre-measured container they want to make you buy. Anybody know how much oil goes in that pump?


... FAIP Non Marking Pressure Washer Hose 4000 Psi, 50ft. Length

Cannot figure out how to remove the oil plug to drain the oil. Label points to a spot that looks like it might be a plug, but can't figure out how to remove it. It is a 2500 psi Mdl VR2500 Briggs & Stratton engine Honda Power Washer. Ken from NH


Should take a 3/8" socket extention ... Pressure Washers

I have a troy build pressure washer model number 020337 Do I need to change the oil in the pump, and if yes how do I drain it and what kind of oil. I know how to change the engine oil


The pump requires no maintenance and no oil change. It is lubricated for life. ... Karcher 2500 PSI Pressure Washer

Where do i drain the engine oil briggs model 020228


... Briggs & Stratton Pressure Washers

I have a Baldor 6000W generator with a gx340 11hp engine. I have drained the tank and carb and put new gas and sea foam in it. Also I have replaced the spark plug and fuel filter. The engine will start/run as long a I spray starting fluid in the carb. But it will not continue to run without it. Also I just checked the oil level and that is good. Please help!!!


It sounds like the engine is not getting enough fuel for it to run. First check that you have the fuel tap in the on position. If the fuel tap is on then the carby might be blocked or the needle & seat are not working properly. Turn the ... Honda 8 HP Engine

Engine starts, but when i push in the choke, it kills. i just replaced the spark plug, drained the gas and oil and replace with new gas and oil. Starts fine when choked, but when i push in the choke, it dies.


... Honda 50 W Ar Pump 2500 Psi 25 Gpm Pressure Washer

Where is the drain plug for the engine oil and for the water pump on the HOnda 2400


... Pressure Washers

I have a Karcher 2,600 PSI 2.3 GPM Gas Pressure Washer G 2600 VHR that I have used once last summer. I have stored the PW in my basement with no fuel in the gas tank. The PW was never exposed to freezing temps. I cannot get the PW to start. I put new fuel into the tank, the oil is good, I drained the carburetor, and the spark plug works (tested it). I pull the cord and the engine doesn't turn. Fuel value is on, choke is pulled, and the starter switch is turned on. System is practically brand new


Hi I have a similar pressure washer from Kartcher and the same scenario as yours I have owned it for about 2 years and noticed that it was getting harder and harder to start with each time I use it which is months. If your pw has a honda engine on i ... Karcher G 2600 VH Gas Pressure Washer

I have a Craftsman 2700 psi pressure washer with a Briggs and Stratton 850 engine (80 year anniversary special addition) . It is about 2 years old and used very little and will not start. I filled it with fresh fuel and checked the oil. I also replaced the spark plug and air filter. I checked the fuel line thinking it may not be getting fuel, but there is no obstruction from the tank to the end of the fuel line. I am out of TS options short of taking it to a service center.


Here is the long answer with everything we learned while using a power \015\012washer twice a day for years::\015\012It sounds like could be one of the problems listed below or a \015\012combination of those things.\015\012\015\0121 ... Briggs Stratton 020273 Elite Series Portable Gas Pressure Washer

How to drain oil from engine - Craftsman 3000 PSI 27 GPM Briggs Stratton Powered Pressure Washer


Square socket on the bottom of the engine. I think a 3/8 extension on a ratchet is correct. ... Craftsman 3000 PSI 27 GPM Briggs Stratton Powered Pressure Washer

My Craftsman model 580.752300 high pressure washer, leaks around the pump and when running and not spraying from the wand the engine is under load and at idle will stall wandmanagemylife com sears


... Pressure Washers

Whers the oil drain plug on a troy-bilt 2350 psi


... Pressure Washers

I can't find an oil drain plug on a honda 5.5hp engine.gvc 160.


The engine drain plug is on the main (square) base part of the cylinder block. I think it is 10mm. There is a compression washer to seal it aswell so it might need a bit of extra pressure to start it undoing. This should drain your block almost compl ... Pressure Washers

Dishwasher will not drain. power is ok drain hose is not plugged disconnected hose from drain plug was able to siphon smome water through Start washer, then press cancel, get a noise, probablely motor, but no water. Model MDB7600AWS serial 15416386ce


Hello. There are several possible causes for your problem. Let me briefly go through each one and then you may be able to zero in on your specific issue. I will try to include the fix for each. \015\012\015\012Drain line/air gap\015\012\015\0 ... Maytag Dishwashers

I have a model PW 2200 gas pressure washer. It suddenly lost it's high pressure the other day after working fine for @10 minutes. It's getting plenty of water, but the engine doesn't seem to rev up to give it the high pressure. The operating instructions say to check the oil in the engine, and the PUMP before starting, but I haven't found any place to check for an oil level in the pump????Any ideas, I'm very confused.


... Pressure Washers

Dear experts, i just installed a new disposal and i forgot to knock out the plug for the dishwasher. i ran the dishwasher and of course it didn't drain. i knocked out the plug and i tried it again and it still won't drain. what kind of damage did i do. hopefully there's a safety switch to protect the pump. it's an old unit. the model no. is DW730W. Thank you. jeff


You should see a red button on the bottom it is a system reset\015\012 look at the drain hose ensure it is clear\015\012and has good flow ... Jenn-Air 24 in. DW731 Built-in Dishwasher

How to drain the engine oil of a BM80913 Blackmax pressure washer


... Honda Black Max 2600 PSI Pressure Washer

I have a Bosch dish washer model SHX 43 M 0 ZUC / 48 FD 8709 00169 The dish washer is about 1 1/4 years old and was installed by a plumber as part of a Home Depot kitchen remodel. The problem is draining. The quick wash does not drain at the end of the wash. The regular wash sometimes drain and sometimes does not. The auto wash does drain. The lack of draining does not cause problems with the regular wash cycle. I checked the drain hose re the instruction manual and it is correctly installed.


Usually a brush with a flexible shaft will do the trick...\015\012\015\012Like this venturi tube cleaner (available where gas grills are sold)\015\012\015\012 ... Bosch Dishwashers

Have a PD2800 that has started to leak oil. lowered the oil level slightly but it started to again leak oil after just a minute or two of running from a cold start. Oil seems to be coming either from around the oil drain plug or from underneath the motor mounting plate. any ideas? Richard


Hi,There is a nice Troubleshoot article :-http://www.the-power-washer-advisor.com/pressure-washer-pump-repair.htmlHope i helped you.Thanks for using "Fixya". ... Dewalt Pressure Washers

What of oil is used in pump of a simpson power washer model msv 3100 ,not the engine oil. the pump oil ,it's life time oil


... Pressure Washers
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.1431 seconds