Having problems with your Briggs & Stratton Pressure Washers ?

Spark plug for 6.75 briggs and stratton intek


Answers :

Repair Help & Product Troubleshooting for Briggs & Stratton Pressure Washers

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Spark plug for 6.75 briggs and stratton intek


... Briggs & Stratton Pressure Washers

Briggs and stratton 020228 spark plug gap - Briggs & Stratton Pressure Washers


... Briggs & Stratton Pressure Washers

Hard starting 6hp Briggs and Stratton power washer engine. I poured a teaspoon of gas into the cylinder; reinserted the spark plug and with one pull in ran fine. This is a choke start engine and it may take 12 to 15 pulls to start on a cold engine. The unit is clean. The air cleaner is new. The spark plug is new. The unit is 2 years old with very little use.


Hello. I have this same machine. Go to the auto parts store and get an aerosol can of starter fluid. Have a helper squirt some into the air intake while you start it. Then continue to squirt a little starter fluid as it runs for the first two mi ... Campbell Hausfeld Pressure Washers

What is the gap on spark plug for vr2500 - Briggs & Stratton Briggs Stratton Pressure Washer Repair Manual B3277gs


... Briggs & Stratton Briggs Stratton Pressure Washer Repair Manual B3277gs

Engine lockup I have a craftsman power washer with a briggs and stratton 850 series engine, craftsman model 580752220, the engine will not turnover unless i remove the spark plug, it has electric start and will turn over with no problem like this but if i put my finger over the plug hole it locks up immediatly


Sounds like the intake or exhaust valve is not opening. ... Craftsman 2700 PSI Briggs Stratton Powered Pressure Washer

Spark plug gap for Briggs and Stratton 6.0 HP


... Craftsman 2500 PSI Briggs & Stratton Powered Pressure Washer

I have a 2500 craftsman power washer with a Briggs and Stratton engine. I used it about a month ago and it worked fine. Took it out yesterday and I could not pull the rope to get it started. I took out the spark plug to release the compression but I still could not pull the rope out it is locked any advice.


It sounds like the pump is seized. Make sure any pressure has been released by pulling the trigger on the gun. Sometimes this will allow you pull the cord. If the pump is seized, a new pump would be in order. ... Briggs & Stratton Pressure Washers

Briggs and Stratton pressure washer will not start. I have a 6.75 hp pressure washer that is only a year old. when I pull cord it turns over but does not start. I changed plug and checked it, I have spark when pulling. I have 40-50 psi of compression when pulling also. gas was drained and is brand new. it was working fine last time it was used. I have tried starting it without the water line or spray wand hooked up and no difference. After about 10 or 15 pulls, can smell gas when I am trying to


Hello dave, the problem is compression to low,you need 60 to 130 lbs to run engine,check for blown head gasket,or bad rings,or a stuck open valve,hope this helps,, ... Briggs & Stratton Pressure Washers

I have a Craftsman 2700 psi pressure washer with a Briggs and Stratton 850 engine (80 year anniversary special addition) . It is about 2 years old and used very little and will not start. I filled it with fresh fuel and checked the oil. I also replaced the spark plug and air filter. I checked the fuel line thinking it may not be getting fuel, but there is no obstruction from the tank to the end of the fuel line. I am out of TS options short of taking it to a service center.


Here is the long answer with everything we learned while using a power \015\012washer twice a day for years::\015\012It sounds like could be one of the problems listed below or a \015\012combination of those things.\015\012\015\0121 ... Briggs Stratton 020273 Elite Series Portable Gas Pressure Washer

How can I repair my Briggs and stratton 6.5 intek


Mine has been having the same issue since new. The needle valve sticks all the time after sitting for a while. You don\\'t have to remove the carb. Just take the breather filter off, drop the carb bowl (it will be dry, no gas) then free up the valve. ... Briggs & Stratton Pressure Washer Projectpro Spray Nozzle

Briggs and stratton 10hp intek pressure washer wont run


... Briggs & Stratton Gas Pressure Washer 20244

Cannot figure out how to remove the oil plug to drain the oil. Label points to a spot that looks like it might be a plug, but can't figure out how to remove it. It is a 2500 psi Mdl VR2500 Briggs & Stratton engine Honda Power Washer. Ken from NH


Should take a 3/8" socket extention ... Pressure Washers

Briggs & Stratton engine loses power


Hello herb1007If it is running it would burn any oil off the top of the piston. (that got there when you tipped it). It sounds like you carburetor needs cleaning. There are sprays on the market that sometime help with this. ... Briggs & Stratton Pressure Washers

Briggs & stratton bpw 2700


Dear gcombs,\015\012One small problem, which might sound silly, is to check that the tap of the fuel is open. There are other reasons why fuel does not come. I think that fuel is not coming, or on the contrary, it could be that too much fuel ... Pressure Washers

Gas leaking from carb on Briggs and Stratton engine


`v already answerd this,are you slow? with oil in the sump you can do no damage by running the engine with abit of smoke,it will clear up very quickly. i find it hard to believe youhave done the things you claim if you dont know what a carby bowl is! ... Coleman Powermate DuraBuilt 1400 PSI Pressure Washer

Briggs and stratton 6.75 wont start carburator working good and getting spark


If all that is working well then check the cylinder compression. ... Pressure Washers

Briggs and stratton 158 cc no spark - Pressure Washers


... Pressure Washers

No spark - Briggs & Stratton Prosumer 20324 Gas Pressure Washer


Check the on/off switch see if wire is broken and grounding out it may just need to be cleaned or you may need to check the coil and check the gap ... Briggs & Stratton Prosumer 20324 Gas Pressure Washer

Oil plug on troy bilt 020240 pressure washer - Briggs Stratton 020273 Elite Series Portable Gas Pressure Washer


... Briggs Stratton 020273 Elite Series Portable Gas Pressure Washer

Gas is leaking into the oil tank on a craftsman pressure washer. it will do this while it is running or sitting in storeage. it has a briggs and stratton intek engine.


... Karcher 2500 PSI Pressure Washer

I have a Briggs & Stratton Pro 3400 pressure washer that I got new last year and used for maybe 5 hours and it worked great. Have had it stored since then with stabilizer in the gas (I didn't run it dry) and now it won't run for more than a minute or two without dying. A dealer said it was probably bad gas and I now know that even with the stabilizer I should have run it dry last year before storing. Everything is like brand-new including plug and air filter so it must be the gas/carberator gunk


... Briggs & Stratton Prosumer 20324 Gas Pressure Washer

Crafstman 22hp briggs and straton engine, I've changed spark plugs, air filter...when engine runs it does so unevenly and at times backfires. What can I do to solve the problem?


Don't use the choke, turn the lean all the way to the right and back off 1 and a half turn, its running too rich, usually find this screw under bowl on carb, don't mess with the other screws, take air breather off and let breath without choking, if y ... Briggs Stratton 020273 Elite Series Portable Gas Pressure Washer

What kind of oil do you use for a 6.75hp briggs & stratton pressure washer and where is the drain plug at


... Briggs & Stratton Pressure Washers

I have a power washer, craftsman &.0 horsepower, 2900 psi, 2.3 GPM model number 580.752410. i was starter to wash my car, and stops? i change the spark plug, andput new oil in there. still do not working. some one helme in this problem.


... Craftsman 3000 PSI 27 GPM Briggs Stratton Powered Pressure Washer

I have a 2550 psi pressure washer with a 6.75 hp briggs and stratton engine with ready start. i wont start. has gas and oil plug looks good. any solutions?


... Briggs Stratton 020273 Elite Series Portable Gas Pressure Washer
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.0231 seconds