Having problems with your Briggs & Stratton Prosumer 20324 Gas Pressure Washer ?

Motor starts fine but only runs about 2-3 minutes than stumbles and shuts down.


Answers :

Insufficient fuel supply,

drain all fuel, disconnect and clean/replace fuel line and fuel filter.

check fuel valve for blockage and clean

check as well tank for presence of rust, if any, clean it out as well.

if this did do not help, you have some problem with carby, it need cleaning then as well, especially fuel chamber. start motor adn while it is runnig use special carby cleaning aerosol. do not overdue and never spray it on non-running carby!

if you find my advice helpful, please do not hesitate to leave comment and give me your vote4, thanx!

Repair Help & Product Troubleshooting for Briggs & Stratton Prosumer 20324 Gas Pressure Washer

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Motor starts fine but only runs about 2-3 minutes than stumbles and shuts down.


Insufficient fuel supply, drain all fuel, disconnect and clean/replace fuel line and fuel filter.check fuel valve for blockage and cleancheck as well tank for presence of rust, if any, clean it out as well. ... Briggs & Stratton Prosumer 20324 Gas Pressure Washer

My pressure washer starts fine, shoots water OK. After running for 5-10 minutes cleaning siding I shut off machine. I go to start it again within a minute or two and the thing feels like it's just about seized. If i wait until the motor is completely cool, it will pull start freely and start right up. I think something is wrong with the pump, not the engine.


Your pressure washer may not have an ez-start valve installed from the factory. Without the ezstart valve, you will need to hold the trigger on the wand open to release the pressure to easily start your engine. This link will show you wh ... Briggs & Stratton Pressure Washers

Pressure washer start fine and idles appropriately trigger is depressed washer runs for about five minutes then just shuts off. Engine restarts fine but when trigger is depressed engine shuts off


Looks like the fuel cap may not be venting try it with the cap loose allowing air into the tank sounds like lack of fuel entering into the carburetor. ... Karcher 2500 PSI Pressure Washer

Dishwasher malfunction MOST OF THE TIME it shuts itself down before fully filling with water - SOMETIMES it doesn't shut down until the minute the wash pump starts - SOMETIMES it washes for 10 or 20 minutes before shutting down - SOMETIMES it will even run a whole cycle, BUT it doesn't open the soap dispenser door - tried doing a diagnostic run but after it turned on all the lights on the panel it started to fill with water and shut itself down......... HELP


Follow this steps and fix it. God bless youFloat Switch\012\012\012The float switch may be hung up and this can cause the dishwasher to be stuck in a cycle. Check the ... Dishwashers

I have a Bosch SHU43 dishwasher, about 6 years old. After starting a cycle, it will run for a while, perhaps 1/2 to 2/3 of the way through the cycle, then shut off. After 10-20 minutes it will start up again, run for a few minutes, then shut off again. It ends up taking about 12 hours for a cycle to finish. The problem started off somewhat intermittent and has gotten worse over the last few weeks. I've checked the electrical box in the front right bottom, and the connection is good. I've even


Hello,\015\012\015\012Welcome to FixYa.\015\012\015\012I`m not sure since you didn`t mention it or perhaps I just interpreted it this way, but is it consistent at the same time or approximately or is ... Bosch 24 in. SHU43 Built-in Dishwasher

Hello I hope someone can help me. I have a Siemens Hydrosensor Dishwasher that when I start it up in runs for a while and shuts off. I need to open and close the door several times then it may run for a short while, 15 seconds to a couple minutes and then shut down again. Finally, it will run through the rest of the cycle. The issue generally occurs when the digital timer is between 85 and 78. If I just leave it go once it shuts down it does eventually start up and will complete the washing cycl


It sounds like the door switch is at fault, it will cause the symptoms you stated. ... Dishwashers

GE quietpower 3 dishwasher repeatedly shuts down after 2 minutes of running.I open the door,shut the door and push the start button,It starts and then shuts down after about 2 minutes of running,every time.


Please provide the full model number of the dishwasher.\015\012Also does the behaviour change if you change the program you are choosing. Try the short cycle like rinse program. Are any of the lights flashing or staying on?\015\012\ ... Dishwashers

I have a Whirlpool GU2275XTVY0 when I start the cycle on normal it will run for about 5 minutes then the power button starts flashing and wont run. It drains fine and starts fine just wont finish the cycle.


It might help if the wash arm had started moving when it shut off.\015\012\015\012Unless it is always exactly 5 minutes I would say perhaps the door switch is out of alignment. It might start ok when you engaged at time of closing door bu ... Whirlpool Gold GU2275XTV Builtin Dishwasher

Engine starts runs good for 2 or 3 min the quites, will start right back up and run for 3 or 3 minutes, then shut off, will restart and run for 4 or 5 min then shut off.,


... Pressure Washers

Craftsman power washer model no 580-752800. the powerwasher runs fine but just shuts off for no apparant reason. after a moment i can start again. will run and pump perfectly and then just shuts off.


... Pressure Washers

My pressure washer is bogging out and shutting off. It will run fine for a bit then it starts sputtering and shuts off. I changed the oil right before this started happening and yesterday i changed the sparkplug and it seemed to be working fine until I used it today on the driveway.


SOUND LIKE FLOAT IS STICKING ... Dewalt 3800 PSI Pressure Washer

Gets to the end of the cycle (1 minute left on countdown) and just keeps running, does not start the "dry" mode. will run until i open it and when i shut it it goes 13 minutes left on the countdown but then gets stuck at 1 minute again. does not drain. has been doing this awhile, but until now it would simply finish the cycle when i opened, closed and reset it. now it just gets stuck again.


Hello,Welcome to FixYa.Based on your description ... Bosch SHU5315UC Dishwasher

I have a Craftsman power washer model 580 752020. When I start it up, turn on the switch the electric motor runs fine until I either close the trigger to the spray nozzle or press the trigger for power spray. The electric motor just shuts down, if I take my finger off the pressure and let the water run with no presssure the motor runs fine. My question is this. Is the capasitator on the electric motor the probable cause and is there a way to check out the capasitator to see if it is malfuncti


I doubt that it has anything to do with the capacitor on the motor. i think you are having a problem with the actual Motor Drive circuitry. What is happening is when you close the switch, this tells the Motor to "Ramp Up" to pump the water out, what ... Craftsman Pressure Washers

Amana ADB1400AWW1: Cycle starts, fills and drains, but runs for only about 15 minutes, then shuts off. Doesn't even go to dry cycle, just shuts off after 15 minutes.


... Amana ADB1400AWW Builtin Dishwasher

Dewalt Pressure washer keeps shutting off for no reason. plenty of gas and oil, water running to it. starts fine and as soon as I start spraying it shuts down.


... Dewalt 3800 PSI Pressure Washer

Machine runs until manually shutting down, or until auto-shut down. In either case machine will not start back up for sveral minutes. Can I replace, disable, or remove the auto shut down feature. It's bexcome quite a problem. Please help. Mark


Hi and welcome to FixYa, I am Kelly. \015\012 \015\012I note that your question was 3 months ago. I answered a current post today that had your exact same symptoms. Your post was revealed after I answered the curre ... Dewalt DPD3100 Gas Pressure Washer

Pressure washer will run fine for about 2 minutes then backfire and shut down. I'll wait 5 minutes and get another 2 minutes of use. The oil and gas are both full.


... Dewalt DPH3100 Gas Pressure Washer

I have a craftsman pressure washer. it sat for a year but it did start and it ran fine. then my sister borrowed it and it started but while it was running she tipped it to move it to another location and it just stopped. i've checked all fluid levels, gas, etc. and are ok . i can't start it. is there a safety breaker/fuse that automatically shuts it down and has to be reset?


... Karcher 2500 PSI Pressure Washer

I have a maytag dishwasher. The wash cycle runs for approximately 10 minutes, then shuts off. The timer will say 90 minutes +/- then will go to 1 minute and turn off? There is a grinding noise when the cycle first starts. Any ideas?


... Dishwashers

When I press the start button, Bosch dishwasher (model SHY56A 05UC) just keep running the motor pumping the water out of dishwasher, irrespective of: 1) the wash cycle it is on, 2) whether the door is closed or open, 3) whether I cancel drain cycle, as told by Bosch Cust Svc in following steps: - "Cancel Drain" by pressing 'Quick Wash' and 'Regular Wash' buttons together for a minute until it shows 0* - Shut power off for a minute and wait for a minute - Restart on Quick Cycle. Paid


What is happenig i believe and has happened to me 2 times is that the water level float that is on the left side of dishwasher is stuck.\015\012\015\012Either remove side panel and flick lever or pull dishwasher out and tap lower portion ... Bosch SHY56A02 / SHY56A06 Built-in Dishwasher

I have a Kenmore dishwasher model #17519200. I loaded it last night as usual and closed the door. I pressed the wash cycle I wanted and pressed the start button. I heard it starting to fill with water as usual. After it filled with water it should have gone into the wash cycle mode but it just started making a buzzing noise for about a minute or two then just stopped. I pressed cancel to drain it and it drains fine. I have kept trying to re-run it but it just does the same thing I described.


... Dishwashers

PRESSURE WASHER RUNNING BUT NO WATER COMES OUT WHEN YOU PULL THE TRIGGER??? IT WORKED FINE WHEN I FIRST STARTED IT. I THEN SHUT IT OFF TO MOVE IT. WHEN I STARTED IT BACK UP, IT STOPPED WORKING.


The water admittance valve is stuck. The spring loaded valve lets more water into the pump when the pressure drops when you trigger the wand. Take the valve apart, clean the bore with crocus cloth on a dowel rod. Replace the O Rings and lube with ... Pressure Washers

I have a KUDC101XWHO built in. It has been workinbg fine but tonight it shuts down immediately after starting. After several minutes you can start it again but it immediately shutes down. What gives?


... KitchenAid Dishwashers

Dishwasher issues hotpoint dishwasher model HDA1200 used for a year and put into storage for a year. reinstalled this weekend. dishwasher was fussy about the door latch for a minute...door latch did not want to engage all the way...but went into its cycle. we stopped it and added a few dishes for a test run it started right up and ran about 8 minutes and shut itself down. it will not restart. the power supply is ok. no leakage about the door once latch engaged. what can we do?


It can be the 10A fuse located in the back of the machine. but.... storage is kind of a problem with determining what is wrong with it.\015\012Mouse can have chewed the wires, moisture can have rusted or corroded some components.\015\012C ... Hotpoint 24 in. FDW60 Free-standing Dishwasher

John Deere 3300 PSi pressure washer shutting off while in use.Everything appears fine Oil level,Gal level,Air cleaner ok etc.. May run 2 minutes or 12 minutes then spudders a bit then Bang "Off" as if i turned it off.May or may not restart after a couple of pulls.


John Deere will replace the cap for free; they acknowledge the vendor who supplied Briggs & Stratton gas caps provided faulty caps. Call 1-888-228-3068 then 1 (English), 2, 1 and a technician will ask you for model number and Serial Number ... Dewalt 3800 PSI Pressure Washer
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.1450 seconds