Having problems with your Briggs & Stratton Prosumer 20324 Gas Pressure Washer ?

Motor will not start I have changed spark plug and air filter


Answers :

Fist check that there is spark.
\015\012if there is spark then it may not be getting fuel.clean carby & fuel lines. make sure fuel tap is on.
Repair Help & Product Troubleshooting for Briggs & Stratton Prosumer 20324 Gas Pressure Washer

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Motor will not start I have changed spark plug and air filter


Fist check that there is spark.\015\012if there is spark then it may not be getting fuel.clean carby & fuel lines. make sure fuel tap is on. ... Briggs & Stratton Prosumer 20324 Gas Pressure Washer

Karcher 2400R I have not used my pressure washer for 6 months. It was left full of gas in the garage. I tried to start it but it would not fire up so I change the gas, oil, and spark plug, took apart the carburator and cleaned it out with carb cleaner. I went ahead and put everything together, pull the cord and wanted to start. While trying to start it after I sprayed starting fluid in the air cleaner I noticed that gas was coming back from the crankcase breather hose into the air filter choking


You have a poor signal to the spark plug usually caused by a rusty fly wheel found underneath the pullcord casing. clean it with releasing ajent such as wd 40. common when not in use for a while. ... Karcher 2500 PSI Pressure Washer

My gas power washer will not start. I filled the gas, checked the oil, set the choke, made sure it was on, changed the spark plug, checked the air filter, and drained any water. When I pull the cord to start I don't even get a putter. Anything else I can try or do I need to take it to a service place.


Will it run if you pour a small amount of gas in the carb? If so, it's a fuel supply problem. Most likely a stuck closed float needle. ... Honda Maxus Pressure Washer MX5222

Wont start I have a North Star pressure washer that has been in storage for three years.It has the Honda motor GX 160 5.5 I put in new gas changed the oil, air filter,and spark plug.But it wont kick over. Im not sure how to work the levers upon starting it.Theres one for gas, choke,idle,and of course an on switch.Please help


Tip a cap full of fuel in top of the carb to start intitially, check for spark as common fault is on/off switch, If no spark, link the 2 wires on on/off switch together. ... Pressure Washers

Troy built 2350 psi 2.0 gpm. pressure washer. starts onne then dies. will not start again. has briggs and straton motor. has been sitting up for the winter. have changed spark pulg. checked air filter that is clean, has oil and gas.


... Pressure Washers

My pressure washer doesnt seem to run properly. i have changed the fuel,air filter,spark plug and the oil. It will start but runs poorly.


Ok the first thing you need to check is if the spark is fireing. To do this you need to remove the plug plug it into the spark plug cap hold it on the cylinder head pull the engine over it will pull easy and see if you have a blueish spark jumping th ... Briggs & Stratton 2200 PSI Gas Pressure Washer

Washer won't start tried everything , I could think of changed spark plug tried new gas , Two things that bother me are . if i take out the spark plug and put my thumb over the spark plug hole theres no pressure and the wire that comes from the coil to shut off the pw it has continunity from the coil to the pin that sticks up to shut off the pw but it also has continuity from the coil to all parts of motor.


... Pressure Washers

Cannot start my pressure washer. Checked the spark plug - ok. Air filter - ok. Gas - ok. Choke - on. On/off switch - on. water - on. Trigger on wand - depressed to release pressure. Still won't start. Ideas?


The Oil Level? ... Pressure Washers

Hi. I have a Briggs & Stratton 2800PSI gas pressure washer. I can get it to start, but after about 5 min, then it quits. I have cleaned the carb, change oil, changed plug, new gas, cleaned/checked air filter. Nothing will keep it running. Wondering if it may be not enough water pressure, but would that cause it to stop like that? When it runs, it does a good job, but it stops just as you get going. Do you have any other suggestions? Thanks!


If it wont start, check for spark.how you do that,ok take the spark plug wire out put it close to the sparkplug(use some gloves or something to insulate your self from get electric shot from the spark) find some one who pull the start rope, if you do ... Briggs & Stratton Prosumer 20324 Gas Pressure Washer

Troy built pressure washer won't start. It has a Honda 160 CVG motor. I used it for about a year and then it stopped working. I've replaced fuel and spark plug. Spark plug is soaked every


... Karcher 2500 PSI Pressure Washer

I HAVE A NEW CRAFTSMAN PRESSURE WASHER WITH KEY START. I HAVE USED IT ONCE AND WHEN I TRIED TO START IT IT WAS HARD TO START HAD TO PULL START IT. NOW IT WONT START. LET PRESSURE OUT HAVE HOSE OH AND RUNNING, NEW SPARK PLUG HAS OIL, GAS FILTER FINE.HAS GOOD COMPRESSION, BUT WILL NOT FIRE GET SOME RECOIL. GETTING GAS TO SPARK PLUG AND GETTING SPARK. IM LOST PLEASE HELP.


... Pressure Washers

Honda mower is not starting. Changed filter, spark plug, oil, and gas.


... Honda Lawnmower Hrr216 Hrs216 Hrb216 Recoil Starter

Bought unit new last summer. Used it once last summer and once this year. It started fine both times. Today, it will not crank. I have replaced the spark plug, checked the air filter (it is clean), gas tank is full and added oil. Why won't it crank?????


Unable to crank? Do you mean unable to start?If you leave gasoline inside tank over long period of time, that will 'gum-up' and ruin carburetor.To prevent problem, put additive in gasoline or empty gas from tank:: under gas tank sho ... Craftsman Pressure Washers

Crafstman 22hp briggs and straton engine, I've changed spark plugs, air filter...when engine runs it does so unevenly and at times backfires. What can I do to solve the problem?


Don't use the choke, turn the lean all the way to the right and back off 1 and a half turn, its running too rich, usually find this screw under bowl on carb, don't mess with the other screws, take air breather off and let breath without choking, if y ... Briggs Stratton 020273 Elite Series Portable Gas Pressure Washer

I have a Craftsman 2700 psi pressure washer with a Briggs and Stratton 850 engine (80 year anniversary special addition) . It is about 2 years old and used very little and will not start. I filled it with fresh fuel and checked the oil. I also replaced the spark plug and air filter. I checked the fuel line thinking it may not be getting fuel, but there is no obstruction from the tank to the end of the fuel line. I am out of TS options short of taking it to a service center.


Here is the long answer with everything we learned while using a power \015\012washer twice a day for years::\015\012It sounds like could be one of the problems listed below or a \015\012combination of those things.\015\012\015\0121 ... Briggs Stratton 020273 Elite Series Portable Gas Pressure Washer

11 hp honda pressure washer engine won't start. No spark at the pkug, bought a new coil and still no spark. This sysem only has a coil off the fly wheel and the spark plug. I even changed spark plug. Use the unit the other day, shut it down and on restart it won't start. Also, I disconnected the kill switch and the il lvel sensor so nothing was going to ground.


If you replaced the coil,check the wire and boot,check with meter for continuity.could be loose connection to spark plug ... Honda Pressure Washer PSI 3000

Hard starting 6hp Briggs and Stratton power washer engine. I poured a teaspoon of gas into the cylinder; reinserted the spark plug and with one pull in ran fine. This is a choke start engine and it may take 12 to 15 pulls to start on a cold engine. The unit is clean. The air cleaner is new. The spark plug is new. The unit is 2 years old with very little use.


Hello. I have this same machine. Go to the auto parts store and get an aerosol can of starter fluid. Have a helper squirt some into the air intake while you start it. Then continue to squirt a little starter fluid as it runs for the first two mi ... Campbell Hausfeld Pressure Washers

Pressure wsher wont start. added oil to pump resv. its full. changed plug . didnt change gas . been a couple years scince it was started. could it be the little relay or capicitor on side of motor that has wires going to on & off switch


Hi steve_shouse\015\012Make sure you are getting spark at the spark plug, to do this:Remove your spark plug and check to be sure you are getting a bright blue spark at the spark plug.You do this by grounding the plug on the head of the en ... Honda Pressure Washers

I have a Troy Built 2500 PSI pressure washer with Honda 160 CVG motor. It won't start. I've replaced the gas and spark plug. Every time I pull the spark plug out it's soaked. Not sure


... Pressure Washers

Hello I just borrowed a k archer k 2.87 water blaster from a friend and forgot to turn water on before starting motor. Motor stopped after a few seconds and now won't start. Online guide says to change fuse but nz version doesnt have fuse in plug. Do i have to take machine apart?HELP Please!


Most of the time it is the GFCI on the end of the plug that goes bad. If it were me I would cut off the GFCI and wire in a standard 120v plug. If it still doesn't work after that then there is a good chance that something electric internally has gone ... Karcher PSI Electric Pressure Washer

I have a Husky 2600 PSI power washer with the Honda GCV160 engine that I can't get to start. It was okay when I purchased it from Home Depot last spring but now I've tried putting new gas in it, spraying carb cleaner, new spark plug, and it still won't start. I only ran it for about 30 minutes when I first purchased it. The guy at the service desk at Home Depot told me that the water hose should be attached and turned on while trying to start. Is this true or would this be starting the motor und


You can eliminate the motor by unbolting the pump from it and then if it will start the problem is with the pump or the unloading valve.If it does not start with the pump removed then you check for spark and get the carb cleaned or have a kit put in ... Karcher 2500 PSI Pressure Washer

Engine does not start. I ran it about two weeks ago and it worked fine. I took the spark plug out and it was dry. I made sure there was gas in it. I tried some starting fluid by spraying into air intake and it start running for a short time until the starting fluid ran out. I removed the carb bowl and there was gas in it. However the inside of the bowl and the float had brown deposits and looks like rust. So I think the main jet has been clogged up with a particle. How do I clear it? Where do I


Try cleaning the carb with gumout spray and a little compressed air, be careful to reassemble the float and needle valve exactly as you found it. ... Northstar Pressure Washer 3000 PSI

Won start Was using the pressure washer 1st time this year and started on the second pull. Ran out of gas shut-off also noticed it needed oil. Believe, I put too much oil so, I drained some and added gas. At first, there was no resistant in the pull so waited an hour and tried again. This time the resistant was there on the pull but still would not start; no attempt even to turn over. It's been a couple of days...changed the spark plug although, hardware guy said nothing was wrong with it..still


... Briggs Stratton 020273 Elite Series Portable Gas Pressure Washer

Throttle problems Homelite pressure washer model UT80709A. bought it 10 months ago with no problems and stored it for last 9 months. Before doing so, drained gas, oil. Brought out of storage a few days ago, filled with fresh gas, oil, cleaned air filter. Starts great first try but after about 30 seconds the throttle starts visibly revving the motor a litlle at first then gradually faster and faster until it seems to flood and die. Then you cant start for about an hour and its the same story. Hav


... Homelite Pressure Washers

Briggs and Stratton pressure washer will not start. I have a 6.75 hp pressure washer that is only a year old. when I pull cord it turns over but does not start. I changed plug and checked it, I have spark when pulling. I have 40-50 psi of compression when pulling also. gas was drained and is brand new. it was working fine last time it was used. I have tried starting it without the water line or spray wand hooked up and no difference. After about 10 or 15 pulls, can smell gas when I am trying to


Hello dave, the problem is compression to low,you need 60 to 130 lbs to run engine,check for blown head gasket,or bad rings,or a stuck open valve,hope this helps,, ... Briggs & Stratton Pressure Washers
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.1317 seconds