Having problems with your Briggs & Stratton Prosumer 20324 Gas Pressure Washer ?

Craftsmen, power washer, 2800 psi, won't start when hot.


Answers :

When it cuts out check for spark the coil might be bad
Repair Help & Product Troubleshooting for Briggs & Stratton Prosumer 20324 Gas Pressure Washer

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Craftsmen, power washer, 2800 psi, won't start when hot.


When it cuts out check for spark the coil might be bad ... Briggs & Stratton Prosumer 20324 Gas Pressure Washer

I have a Honda GC160 5 horsepower power washer with 2400 psi. When its cold it is easy to start but after it has been running for a while the only way to start it is to have the water shooting out of the wand. Once it is hot and running if i stop the stream of water (release the trigger on the wand) then the machine shuts off. It seems like the only way to keep it running is to constantly have water running through the wand. Please help


... Pressure Washers

My Delonghi Dishwasher keeps turning off. The dishwasher is turned on at the power point. The water is turned on. Okay When I press the POWER botton on the front it wont stay on. I have to keep my finger on the POWER button and then press the START button for washer to work. If I do this it will then pump out any water in the bottom and start to work. ***BUT when you take your finger of the POWER button the washer just turns off and stops working. Do you have any idea what could be the problem p


Yes, the power button is faulty. by pressing the power button forcefully, you are in effect allowing the contacts to close. Replace it. ... Dishwashers

2050 PSI Gas Pressure Washer - 20244: my excell pressure washer wont start. pull start t...


... Briggs & Stratton Gas Pressure Washer 20244

I can't get my home lite 2200 psi power washer too start. I replaced the spark plug and put in fresh gas. Still won't start


... Pressure Washers

My Honda 2600 psi power washer will not pull to start. It was running great then I allowed the neighbor to borrow it. He ran the washer till it was out of gas and proceeded to refuel and at this point it would no longer start. The pull cord is out about 4-6 inches out and I am concerned about taking the casing off myself. Fearing that it may throw more off on the unit. If i take the casing off are there any spring loaded parts that will dismount? What should I do? Spark Plug? Turn


You should be fine to take the recoil off, there shouldn't be anything that shoots out at you. You might want to check the oil level on the engine, many of the Honda engines won't start unless there is enough oil in them. If your oil level is fine, c ... Honda Pressure Washer PSI 3000

I have a Husky 2600 PSI power washer with the Honda GCV160 engine that I can't get to start. It was okay when I purchased it from Home Depot last spring but now I've tried putting new gas in it, spraying carb cleaner, new spark plug, and it still won't start. I only ran it for about 30 minutes when I first purchased it. The guy at the service desk at Home Depot told me that the water hose should be attached and turned on while trying to start. Is this true or would this be starting the motor und


You can eliminate the motor by unbolting the pump from it and then if it will start the problem is with the pump or the unloading valve.If it does not start with the pump removed then you check for spark and get the carb cleaned or have a kit put in ... Karcher 2500 PSI Pressure Washer

I cant start my power washer. the pull start is locked and wont release to start engine.


When the pull start gets locked, you have to release water pressure from the wand. I had the same problem last year. ... Craftsman 2700 PSI Briggs Stratton Powered Pressure Washer

Troy-bilt pressure washer 2350 psi wont start after use


... Pressure Washers

Honda powered gx160 model pressure washer wont start


Did you drain out the fuel before you stock it? If you didn't, you may need to clean the carburetor or replace a new one because the fuel inside has become a kind of stick varnish. You may take a look at following link to see how to change or replace ... Honda 8 HP Engine

The cable in my Husky Gas Power Washer wont pull start


... Honda Pressure Washers

Hondar 2500 pressure washer wont start - Honda 2500 PSI Gas Pressure Washer


... Honda 2500 PSI Gas Pressure Washer

Why wont blackmax power washer 2700 psi honda engine wont stay running once i spray


... Honda Pressure Washers

My Troy Built 2500 psi power washer with Honda engine GCV has been stored for 2 years. I changed the gas and could not get it to start. Which is the start position for the valve on the gas line - Horizontal or Vertical? Thanks, Bill Gray Melbourne Beach FL


... Pressure Washers

Honda 11.5hp pressure washer wont start - Honda 2500 PSI Gas Pressure Washer


... Honda 2500 PSI Gas Pressure Washer

Started by Craftsman 2700 PSI , 2.3 GPM Briggs & Stratton Powered Pressure Washer for first time in 9 months. Added new oil, and gas. started but is smoking from muffler and is dripping what appears to be oil near the exhaust end. I shut it down. What could this be due to?


The first thing I would check would be the oil level, to make sure you didn't put in too much oil. If the oil level is correct, it could be a stuck piston ring, letting oil blow by the piston, and out the exhaust. If this is the case, you are going ... Craftsman 2700 PSI,2.3 GPM Briggs & Stratton Powered Pressure Washer - Ca. Model

I have a 2550 psi pressure washer with a 6.75 hp briggs and stratton engine with ready start. i wont start. has gas and oil plug looks good. any solutions?


... Briggs Stratton 020273 Elite Series Portable Gas Pressure Washer

All-Power America All Power 1800 PSI Pressure Washer won't start


... All-Power America All Power 1800 PSI Pressure Washer

I have a Briggs and Stratton power washer Quantumpower 5hp water driver series 1750 PSI 2.0 gal min model # WGV1721 . I got it used and it was always a bit hard to start but always started. Pull cord frayed and broke I bought new cord and a neighbor replaced for me. Now it does not want to do anything when pulled. I can't get top cover off that has screws with round holes instead of phillips or standard slots to get to pull cord winding


Spray well with WD-40 or similar, and take a small chisel, on it's edge, and hit hard enough to allow chisel to dig in to head of screw, making a "V" like slot in the head, then angle chisel slightly and start tapping in direction of loosening(counte ... Briggs & Stratton Pressure Washer Projectpro Spray Nozzle

Husky 500 2200 psi. starts and runs ok, but no pressure through the wand. hooked up garden hose to power washer turned water on and it comes through the hose ok, but start up and put wand on and no pressure.


... Pressure Washers

I have a excell 2500 psi max honda 5.5 ho vr2522 2.2 gpm presser washer and has been stored for about a year, still looks brand new and has only been used twice before, it has oil and was stored with no gas in the tank, i put fresh gas in the tank and blead the fuel bowl until fuel ran out like it should, the washer wont start, ive checked the turn on switch as well and the fuel cut off knob, i spayed gas in the carb and it fired up but stopped running as fast as it began to run, its not getting


... Honda Black Max 2600 PSI Pressure Washer

13 hp honda pressure washer 3000 psi 4gal/min Hard to start and dies out after 20 seconds after the engine gets hot and running after multiple starts the engine will stay running but then dies every 30 minutes


There are a couple of things that can cause this problem. The first thing to check is if you are loosing spark. Dying after it gets hot sounds like to stater is failing in the engine. If you loose spark this is more than likely the issue. If you are ... Honda Landa PG 3500 PSI Pressure Washer

Craftsman 4 hp 2150 psi pressure washer wont start


Go to www.karcher.com ,click on your region and then click international. Enter the model of the machine or the type number . That is is the first 8 digits of the number under the b ... Karcher 2500 PSI Pressure Washer

Gas powered pressure washer wont start


On pressure washers the more you pull the cord the more pressure builds up making it difficult to pull and start. I hold the trigger down as i pull this keeps the pressure down. If this is not the problem then take a look at the Spark plug, Air Filt ... Briggs & Stratton Gas Pressure Washer 20244

Water wont come out of gun of power washer before starting it


... Briggs & Stratton Vox Professional 2500 PSI (Gas/Cold Water) Pressure Washer w/ Honda GX
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.1569 seconds