Having problems with your Briggs & Stratton Quantum Lawnmower Lawn Mower Pressure Washer Head 691160 ?

I have a Quantum pressure washer and it is smoking right between the motor and the pump after it runs for a couple minutes!? It seems to run fine but I shut irt down when I see the smoke and the smell?


Answers :

Repair Help & Product Troubleshooting for Briggs & Stratton Quantum Lawnmower Lawn Mower Pressure Washer Head 691160

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

I have a Quantum pressure washer and it is smoking right between the motor and the pump after it runs for a couple minutes!? It seems to run fine but I shut irt down when I see the smoke and the smell?


... Briggs & Stratton Quantum Lawnmower Lawn Mower Pressure Washer Head 691160

I have a Craftsman power washer model 580 752020. When I start it up, turn on the switch the electric motor runs fine until I either close the trigger to the spray nozzle or press the trigger for power spray. The electric motor just shuts down, if I take my finger off the pressure and let the water run with no presssure the motor runs fine. My question is this. Is the capasitator on the electric motor the probable cause and is there a way to check out the capasitator to see if it is malfuncti


I doubt that it has anything to do with the capacitor on the motor. i think you are having a problem with the actual Motor Drive circuitry. What is happening is when you close the switch, this tells the Motor to "Ramp Up" to pump the water out, what ... Craftsman Pressure Washers

My pressure washer is bogging out and shutting off. It will run fine for a bit then it starts sputtering and shuts off. I changed the oil right before this started happening and yesterday i changed the sparkplug and it seemed to be working fine until I used it today on the driveway.


SOUND LIKE FLOAT IS STICKING ... Dewalt 3800 PSI Pressure Washer

Terrible smell When I run the dishwasher there is a terrible smell.  It cleans fine.  I run the top one and there is water in the bottom trap that seems to be the source of the problem.  I turkey basted it out.  Ran rinse cycle with baking soda but it still stinks.


Yea disposers are most likely cause of odores backin up into the d/w's you can try running through a cycle with a bowl full of vinegar. the vinegar will flush put of the bowl during wash and get all the nooks and crannies clean ... Fisher and Paykel 23 in. DD-603SS Built-in Dishwasher

Bosch SHE55M06UC dishwasher pump was running beyond the cleaning cycle and produced a burnt rubber/plastic smell. Unit did not work until I tried the diagnostic mode, then it seems to run fine but still smells of burnt components.


... Bosch SHE55M06UC Built-in Dishwasher

I received a second-hand as-is Akso D3530 (model #107353001) dishwasher. It washes perfectly fine, but at the end of the cycle, it keeps running. It does not seem to be the drain that is running, but rather the circulating pump. I have fully emptied the pan of water (there was only a little in it (you couldn't see it until you removed the sieve) using a turkey baster and it keeps running. I also checked the float sensor in the bottom. The float sensor is not tripped, and when I manually trip it,


Hi.The float switch is not a water level switch, but an overfill switch. The control board uses the input from the pressure sensor to decide when to stop the pump.When you open the float switch circuit the machine 'thinks' that ther ... Asko 24 in. D3530FI Built-in Dishwasher

I stopped using my dishwaser because it left crusted on food particals even tho I rinced them well(so I thought) before loading. It was as if they were just being dried crusty. After a couple month I noticed a bad smell. I looked in the dishwasher to find standing water in the bottom. I ran a little CLR through and it cleared out. But a couple weeks later again there was water in the bottom. It seems as if the water from the sink is draining into the washer. If I run it it runs thru just fine, n


Hi, \012I have an older dishwasher also and recently my wife alsocomplained about it not cleaning right... so me being the man I am tried invain to clean the things... Bought new spray arms online and installed them inminutes...now the thing works li ... Estate 24 in. TUD4700KQ / TUD4700KB Built-in Dishwasher

Dishwasher will not fill with water. I've already checked the float assembly, that seems to be working fine. The water just doesn't seem to run into the machine. Little history on an unrelated problem: I want to mentioned that not to long ago my brother tried to put a bunch of celery through the garbage disposal. The sinks and pipes got all clogged up and we had to take them apart to clear up. Immediately afterwards the dishwasher stopped filling with water. I don't see how the two can be r


Hi,\012Here is a tip that will help you to find out why water will not come into the dishwasher... Dishwasher ... GE 24 in. GLD5500L Built-in Dishwasher

Dishwasher smoking Started cycle, everything seemed fine. Opened it to put something in and when I closed it to restart it sounded strange. Then the smoke starting pouring out of it and it smelled like something electrical burning. I immediately turned the wall switch off. It is a Kenmore, not sure of the model at this time. Is this a common occurence like if a specific part went out? Thanks for your time.


... Frigidaire 24 in. FDB1050REC Stainless Steel Built-in Dishwasher

Hello, I bought a kenmore diswasher model # 587-15103800 over a year ago and I have never cleaned the inside. I see a small basket that attaches to the hose arm and if I lift it it seems fine with nio food particles. I need to know if there is a better way to clean for any food cloging as recently the diswashed makes a louder noise while I run the normal cycle. pls advise. thanks Joseph


... Kenmore 24 in. 17332 / 17334 / 17339 Free-standing Dishwasher

I have a 3 year old GLD6200 that gets used once per week While running it this morning I heard a sizzling sound, i turned around just in time to see the control panel flicker and go dark. This was followed by a little smoke & a very distinct motor-burning smell. My first though it that it's toast - suggestions?? In searching for info on line I must admit I am dismayed at the number of negative comments about product quality & customer service after a break-down. Hope thats the exception and not


... GE 24 in. GLD6200L Built-in Dishwasher

Rain? I left a borrowed durabuilt 1300 psi pressure washer outside when I had to stop the job due to rain. I figured it'd be fine as long as it was unplugged but when I tried to run it, i smelled something funny so I shut it off. Did I break it?


... Coleman Powermate DuraBuilt 1400 PSI Pressure Washer

My presuure washer was running fine while we were moving it , it started smoking and shut off now it won't start


If the smoke is black too much fuel from carburetor enter causing it to flood ,remove sparkplug pump out excessive fuel in cylinder re install dried spark-plug and try again be careful not to hole pull-rope handle tight allow it to break free from ha ... Honda Pressure Washers

Dishwasher Stinks Our dishwasher has recently begun to smell like burning rubber when it is running. Still washes the dishes fine, and we pulled it out several times but can find no smoking, smoldering, etc to pinpoint the problem area. Fumes give me a headache. Can anyone help?


Is your dishwasher less than a year old? if so you need to call bosch and have all the gaskets replaced. they tried a new chemical to make the gasket but now have found that after the dry cycle the gaskets put off a strange odor like your discribing. ... Bosch 24 in. SHX99A15UC Stainless Steel Dishwasher

ADB1400 diswasher. Installed, ran for first time using the 1 hour cycle and everything seemed to run fine but the Cancel/drain red light won't stop flashing and it won't shut off.


... Amana Dishwashers

New honda pressure washer maybe had it 2 years and only has about 3 hours on it, I was using it yesterday and it started fine and after running for about 10 min it shut down like i turned the kill switch, it has oil and gas but seems to have lost compression. It is a Honda overhead cam GCV 160, pressure washer is a Troy Built model


... Pressure Washers

I have the E3 error on my Smeg DWI614 dishwasher which would indicate a heater error, however it is heating the water in the bottom of the machine but it seems to time out. The main issue seems to be that the recirc. pump is not running during the heating phase. I have taken the pump out, checked the connections etc. twice now and everything seems fine (the motor runs when tested). When I have done this (both times) the dishwasher has started again and run for 20+ cycles fine, then the issue com


... Smeg DWI614 Built-in Dishwasher

My lower rack will not clean bowls or cups and I have to be very careful how I place plates. The serviceman has been out twice and I have run vinegar through multiple times with no improvement. My top rack is working fine. I have tried running it on different settings and we have verified that the lower wash arm seems to be spinning. The temperature seems to be fine. Even glasses placed on the lower rack that weren't very dirty seem to have a scum in them when finished. Any ideas?


Hi, \012I have an older dishwasher also and recently my wife alsocomplained about it not cleaning right... so me being the man I am tried invain to clean the things... Bought new spray arms online and installed them inminutes...now the thing works li ... Dishwashers

Craftsman power washer model no 580-752800. the powerwasher runs fine but just shuts off for no apparant reason. after a moment i can start again. will run and pump perfectly and then just shuts off.


... Pressure Washers

My dishwasher is a Smeg model STA 6143, and the door won't close. It seems fine until the last few centimeters, then it jams and won't close easily. If you press hard, it'll shut but not latch. Nothing appears to be stuck anywhere. We've tried jiggling the door but it seems somehow to be misaligned, although there's no reason why it should all of a sudden appear to be so. The electronics work fine, the racks fit fine (we also removed them, and the door still won't close), and nothing appear


... Dishwashers

I have an Inglis dishwasher.Serial number-FC3312512,Model number-IBU37002 or it could be IBU37062.I do not know how old the dishwasher is, as I justed moved in to my house this October,and the dishwasher came with the house.Last night I reset the options on the dishwasher,and had the cycle running on heavy duty.About 1 hour after the dishwasher was running this very bad smelling--like smoke- steaming odour was coming out of the door vent of the dishwasher.The smoke alarm went off in my house,and


... Dishwashers

I removed an old dishwasher and replaced it with this GE 24" Profile GSD533ODO1WW unit. It seems to run through the cycles like it should but it doesn't seem to run any water for some reason. I hooked up a new water line to it and turned it on. There where no leaks that I could see. Is there any installation manual that you could send me to make sure that I didn't miss anything or is there anything that you can tell me that I should look for? Thanks, Jesse


... Dishwashers

Appliance had been working fine now all of a sudden no water is running in the dishwasher.The machine appears to run through all of its cycles but without water. The water pressure in the ajoining sink appears a little low though the water pressure in the rest of my home is fine. I see no water leakage anywhere. Do I need to call an appliance tech or should I call a plumber? Thank you.


... GE GSD1000 Dishwasher

One day the diswasher was working fine...the next time it turned it on it ran for about 3 min. then shut off and seemed to have no power. I checked the breaker...it was fine. A few days went by and all of a sudden the lights were blinking on the panel. So I pushed the cancel drain button. The water drained out and I then proceeded to load the dishwasher and turn it on again thinking it was just a fluke when it shut off earlier in the week. It did the same thing...ran for about 3 min and then shu


... Whirlpool GU2200XTSS Built-in Dishwasher

Water seems to be leaking into the dishwasher at the end of the cycle the water appears to be clean, so I am wondering about a seal of some kind on the hot water line leaking or whatever. It is a Bosch Dishwasher SHU series 3200 My problem is the same. Water leaks in to bottom of dishwasher over about a 2-3 day period. The dishwasher runs fine. It does not ever run over. The water seems to stop entering the dishwasher after it reaches a certain level.


You have a bad water valve. When the unit is off, the valve should seal and the water should not flow. Something has gotten in the valve and is keeping the needle up or the diaphram in the valve has deteriorated. replace the water valve and you wil ... Dishwashers
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.1210 seconds