Having problems with your Broaster 1800 Pressure Fryer ?

Looking for someone to service and clean 1800 broaster to resale


Answers :

Repair Help & Product Troubleshooting for Broaster 1800 Pressure Fryer

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Looking for someone to service and clean 1800 broaster to resale


... Broaster 1800 Pressure Fryer

Have a LG model LD-14AW2 dishwasher which has done good service for many years However, it now sems not to have enough water pressure to operate all the rotary sprayers at the one time - thereby not cleaning properly Have purchased a manual and raken the whole machine apart looking for a partial blockage of the water ways - non found - all looks perfect - still no water pressure I would suspect the pump - however, would have thought a pump either gave full service or stopped - not parti


Hi The issue seems to be with the float switch assembly that is bad and should be replaced. Float assembly is found inside the dishwasher's tub, on the bottom. The water that ... Dishwashers

My Kenmore dishwasher, about 5 years old, is not cleaning well any more. Glasses look cloudy,and I assume the bowls and plates are not clean also, but that's harder to detect unless I hold them up to light. I use a rinse agent. What's the problem? Is it worth having a service person look at it or should I just get a new one? It's a Kenmore Elite ultra wash dishwasher.


Although I used my credit card to pay for the live chat, it bounced me out before the service person could respond. So I tried another service and two people who do home repair told me what the problem was and what it would cost to fix it. Since the ... Kenmore Dishwashers

We have a built in GE dishwasher. It has worked fine for about 4 years but now the glasses in the top rack will not come clean. I have cleaned all the holes where the water comes out but I think the sprayer that is beneath the top rack (the one that is attached to the bottom of the top rack) is not rotating. We had someone out to take a look at it and they said it was fine. It isn't fine as it is not cleaning the dishes. Is there a reason that the bottom sprayer is not turning?


Hi,\012\012\012\012\012I\012have an older dishwasher also and recently my wife also complained\012about it not cleaning right... so me being the man I am tried in vain\012to clean the things... Bought new ... Maytag Dishwasher

I need to find a service repair man in NYC for emergency servicing to my Fagor LVC-21W. It has literally blown a fuse or something in the base of it because we heard a pop and then saw sparks. Additionally, the tubes that take in the soap/detergent have detached themselves and nothing in getting clean. The main problem now though is that we cannot even turn it on because of the blown out fuse/part. Can someone help??


... Fagor 18 in. LVC-21W Free-Standing Dishwasher

Have a bosch dishwasher model shu3032uc-14 doesn't clean very well it seems top spinner doesn't always turn, had service look at it and couldn.t find problem recommended to use a water softner, other people have same unit and do not use a softner and theirs works great what else should i look for thank you


... Maytag Dishwashers

My dishwasher will start any program, it drains, fills, empties & beeps continually within a few minutes. The rinse light stays on until the machine is turned off & re-set. Aditonally, the ater heating has been hit & miss for some time! A service guy cleaned the water sensor with hot water fro a ketle + tooth brush, but the problem came back after a couple of weeks. Having removed item he cleaned, it looks fine and appears to switch OK. Not sure if its actually faulty. Is the themperature sensor


... Whirlpool 24 in. ADG7540 Built-in Dishwasher

I had a service tech at my house to repair my refrigerator. He also took a look at my Maytag WU504 dishwaser, which was not cleaning the dishes anymore. He was less familiar with dishwasher diagnosis, but found that the lower spray arm was pumping out water through the jets properly in the cycles, but that the spray arm was not rotating. He seemed stumped and called his supervisor, who suggested it might be the wash impeller. I have looked at the parts diagram on partselectdotcom and taken t


You are absolutely correct!!\015\012\015\012The support retaining nut allows the arm to spin without falling off.\015\012\015\012And it would definately cause dishes not to clean if the arm didnt rotate.\015\012\01 ... Dishwashers

Dishwasher wasn't cleaning, tried cleaning the top spray arm but broke the hook that holds the top spray, looks like a 1/2inch gray plastic nut/bolt with a split prongs at the top. One prong broke so arm will not stay on. Where do i find this nut/bolt/hook. The LG customer service was of zero help.


Hi,\012That is not that hard to fix and you can easily buy the parts yourselfonline...Here is a tip that will help you with the online buying...How to Buy ... LG LDF6810 Built-in Dishwasher

Dishwasher have a dishwasher that does not clean the dishes properly. It leaves stuff that looks almost like sand on the top of all the dishes on the top rack. I have tried everything I can think of. can someone help me figure this one out


Most dishwashers have a little filter basket in the bottom. Depending on the brand, you can slide out the bottom rack, and in the bottom underneath the sprayer (the propeller thing) there should be some sort of basket that can be removed and cleaned. ... Baumatic 24 in. BFD60SS Free-standing Dishwasher

I've got a whirlpool quiet partner II that the clean light just keeps flashing. what do I do with it? Can it be reset or do I need to have someone come look at it?


Hi,To reset the control use this key dance within 5 seconds press:HEATED\015\012 DRY, NORMAL, HEATED DRY, NORMALThe clean light blinks as it ran a cycle and the water did not heat properly. I have put together a pa ... Whirlpool Dishwashers

I have a GE Triton XL dishwasher that all of the sudden stopped cleaning well. I now find food residue on the dishes, and the detergent cup does not empty completely. I use the gel detergent, and I just see the gel dripping down the door after the cycle is complete. This machine is about 5 years old, and I'm looking to see if it can be easily fix. I rather not have to call someone to tell me that I have to get a new one, or pay more to fix it that what it is worth. Thanks


Hi If you are noticing that the dishes are not clean, then there are a few things to check for. Check the soap powder if it's kept in a dry environment. Also try replacing the powder with something like a gel or liqu ... GE Tritonr XL GSD6260JCC Dishwasher

My Bosch dishwasher has had a problem since we had it installed. It smells like garbage after sitting for a few hours. This problem is there whether it has been run or not. Water is always standing in the large drain tube under the "filter" and it doesn't look clean. I contacted Bosch by phone as soon as this was discovered - in a matter of days after purchase - and was told by a rather haughty service person to leave the dishwasher door open. Not a practical suggestion even if it didn't sm


Was the drain tube that hooks into the sink drain passed over the partition between the sink area and washer area or through a low-level hole. If through a low-level hole, try rerouting the tube over the partition. This forms a 'trap area' to isolate ... Bosch 24 in. SHU43 Built-in Dishwasher

The dishwasher is not cleaning the dishes properly. where can I fins someone to service mashine in GRabouw near cape town


Hi, \012 \012I have an older dishwasher also and recently my wife also complained about it not cleaning right... so me being the man I am tried in vain to clean the things... Bought new spray arms onli ... Whirlpool GU2400XTP Built-in Dishwasher

Our LG 6810 dishwasher has stopped cleaning. After the cycle the dishes are wet and covered in greasy clumps. We ran the test cycle and got the following: 3H/U3 11 22 33 44 55 66 04-2 32 33 0 (inlet valve) 35 36 37 38 23 (Thermistor) 3A 3A (beeped twice and showed 3A) 3A (beeped twice and showed 3A) Any advice you could give me would be appreciated. I have the service manual but have never done any type of dishwasher repair. I'd like to not have to replace this dis


1.) Take racks out of unit.2.) put both of the spray arms in the 12 o'clock position3.) Run the washer,once the washer has started wash cycle,open the door and ensure the spray arms have moved off of the 12 o'clock position. Write down re ... LG LDF6810 Built-in Dishwasher

Dish-washer My dishwasher is not draining all of the water out of the dishwasher after it washes. I got someone to look at the drain pipes and he cleaned out the stuff and they still will not drain all of the water. I would like to know what I could do to get all of the water out of the dishwasher so that the water will come out of the bottom of the machine. Wanda


The problem is most likely that the pump empeller had been damage by pieces from a broken dish or a small piece of siverware. The only way to fix this is to take the dishwasher apart and replace the empeller. If you choose to do this yourself, you sh ... Whirlpool Gold 24 in. Built-In Dishwasher Dishwasher

I NEED HELP CLEANING OUT MY FILTER ON MY HOTPOINT DISHWASHER..... WHEN WE GO TO RUN IT THE WATER STAY'S IN THE BOTTOM AND WILL NOT DRAIN OUT SO PLEASE HELP ME FIX MY PROBLEM CUZ I CANNOT AFFORD RIGHT NOW SOMEONE COMING OUT TO LOOK AT IT SO IF I CAN FIX IT MYSELF THAT WOULD BE GREAT AND WITH YOUR ALL'S HELP IF YOU WILL THANKS ALICIA


I f you have warranty on this please call them, you have a defective\015\012D/W.Unless there is no charge for repairs ,don't spend a dollar on what\015\012is going to be a on going problem ahead.To explain how to fix this is\015\012what the manufactu ... Hotpoint 24 in. FDW60 Free-standing Dishwasher

I have a dishwasher that does not clean the dishes properly. It leaves stuff that looks almost like sand on the top o*** the dishes on the top rack. I have tried everything I can think of. Can someone help me figure this one out


Dishwasher may not be draining well. It may be dirty water ... Maytag MDB9600A Jetclean II Built-in Dishwasher

I am looking for someone to repair my Karcher high pressure cleaner in or around the Richmond / Hawthorn area. Any ideas? The unit seems to have broken a seal and has lost cleaning pressure and leaks when engaged


... Karcher PSI Electric Pressure Washer

Dishes and the dishwasher look dirty after they run, like it redistributed dirty water. The door is very dirty/filmy except right under the soap dispenser, like someone squirted dirty water on it but wiped right under the soap dispenser. If I run it a second time with vinegar it gets clean, but that is crazy, esp since it takes 2 1/2 hours a load. I have 2 of them and both are doing it. I have changed soaps, added more soap, used less soap, pre-rinsed dishes, put them in filthy, used jet-dry, no


Hi Mike_wend604,\015\012\015\012I am looking for a used Asko #1504, if you would like to sell yours please e-mail me at [email protected] and put "Asko" in the ... Dishwashers

I have a MODEL 577-0 kudk01ILb55 KITCHENAIDE dishwasher. I am trying to remove the inner pplastic bar that goes vertically through the system from top top bottomj so that I can clean out the filter. But I do not see how to remove that bar. I have looked online for a repair manual of some type but have been unsuccessful. Can someone tell me how to remkove the bar so I can get to the filter on the bottom? I have already removed the star shaped rinse sprayer.


... KitchenAid 24 in. KUDS01FLBL Built-in Dishwasher

My kenmore 16482 dishwasher was noisy and not cleaning very well. I removed the large motor underneath and found what looks like the plastic pieces that are on the electric motor shredded and worn and possibly some worn plastic in what im guessing is the pump housing. can these parts be serviced separate from the motor and where can i get them? thanks in advance


... Kenmore 24 in. 16482 / 16484 / 16489 Built-in Dishwasher

Hello. I have a Frigidaire model GLD2250RDS0 that starts a wash cycle normally, then stops mid cycle with the 'washing, drying clean and sanitized' lights all blinking. There is no service sheet behind the panel so I don't have a dianostic to run. I have tried the normal things such as unplugging power and looking for obstructions.


This is going to be a electronic control problem. Part #154540101. art can be purchased online at foxparts.com ... Frigidaire Dishwashers

My dishes lately are not looking clean when washed. They look filmy and the silverware is streaky and looking as though there is still food on them.I am using the same products since the dishwasher was new and even use a rinsing agent,but they still don't look clean. They are loaded correctly. The model is KUDS24SE. Any suggestions?


Check the spray arms for any nozzle block. Check the inlet water for free flow to the machine. Check water pump inside the washer cabinet. If the pump is not developing pressure, this problem can occur. If possible for you clean it and reassemble. ... KitchenAid Dishwashers

Won't clean-looks to run properly


Check the sump area below the pump and clean out any waste food debris,etc. and also the drain check valve,it may be plugged and not draining waste water completely or not closing completely and letting waste water back into the sump and this could b ... Kenmore Dishwashers
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.1145 seconds