Having problems with your Campbell Hausfeld Pressure Washers ?

My Honda GCV160 surges after about 3mins the engine dies off whilst the operation is going and eventually shuts down. To restart it must be cooled off before you attempt to proceed your task

\015 It was purchased in August at PRICESMART La Romain Trinidad & Tobago\015

Answers :

Repair Help & Product Troubleshooting for Campbell Hausfeld Pressure Washers

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

My Honda GCV160 surges after about 3mins the engine dies off whilst the operation is going and eventually shuts down. To restart it must be cooled off before you attempt to proceed your task


... Campbell Hausfeld Pressure Washers

My Honda GCV160 surges after about 3mins the engine dies off whilst the operation is going and eventually shuts down. To restart it must be cooled off before you attempt to proceed your task


... Campbell Hausfeld Pressure Washers

New pressure washer runs starts and runs for 30-45 minutes with no problems then dies and will not restart. Once it cools for a few minutes it will restart but will die again quickly. If it is allowed to sit for 30+ minutes it will run for another half hour but then dies again. Changed oil, gas, checked all obvious areas. Any suggestions?


Try removing the carb bowl and check for dirt/water etc , also if the machine is over heating it may be getting vapour locked ... Honda Pressure Washer PSI 3000

Must wait 30-40 mins to restart engine


Check your manual to see if it call for premium or regular. Premium has less energy per gallon and is designed for higher compression engines. What makes it "premium" is more anti-knock compounds - not better quality or performance. Sounds like a vap ... Briggs & Stratton 3000 PSI Pressure Washer

Bosch ascenta SHE4AP02UC/06 must restart multiple (4-5-6) times to get cycle to run


... Bosch She4ap02uc Ascenta Dishwasher 42 White

The engine starts cold after 2 or three pulls, runs ok initially, but seems to have slightly less power. After a few minutes I can turn off the choke. When teh engine warms up and runs for about 15 minutes, there is a definite power decrease and the motor sounds like it will stall. If I paly with the choke, it does not stall, but has little power to pump water. If the engine does stall or it is turned off, it will not restart until it cools down.


I would first try draining the carb bowl, if you look at where the choke lever is and look below that you should see a clear red tube with a flat head screw below that, if you just turn the screw out the carb will drain. If you still have an issue yo ... Karcher G3025OH Pressure Washer

I have a Whirlpool GU2400XTPQ, it sometimes stalls with the display showing 44, it acts like it is running but when the door is open there is no water and it will not continue with the cycle from this point, you must restart the machine from the beginning of the cycle.


... Dishwashers

My dishwasher stops during the wash cycle with a "uo" error code. I can not restart the load until it cools down and then sometimes it stops again during the cycle with the same error code.


... Frigidaire PLD4555RFC Dishwasher

B & S 4.0 Power Washer 2200 psi, gas powered, runs great for 30 min. (+/-) then abruptly shuts down & won't restart.


... Briggs & Stratton 2200 PSI Gas Pressure Washer

Kenmore dishwasher stopped during cycle. won't restart


... Dishwashers

Dishwasher restarting My dishwasher keeps restarting itself, and occasionally the display flickers. No error codes are displayed. It does not restart at any consistent point, seems very random. Any help appreciated.


... Fisher and Paykel Dishwashers

GSD2200G00WW. When starting washer, part of the time the machine will not start, other times if machine has been running for a while and you open the door and try to restart the machine it will not restart. You can hear the motor humming as if it wants to go but it will only restart if you turn the motor shaft even just a little. I am wondering if the electric motor is dying??


... GE GSD2200G Built-in Dishwasher

My Whirlpool Dishwasher ADP931 has stopped working. It stopped in the middle of the cycle with 2 to 3 inches of water on the floor of the compartment. I mopped out the water and tried to restart the dishwasher. The green "on" light now comes on when I press the start button. but nothing happens (no motor comes on,no water enters).Repeating the above action several times does not help the washer to restart even though the other function lights will come on when the knob is turned. saturn1914


Hi,Whenever you see such symptoms, Time for you to investigate it properly. Check the below guide :-\015\012\015\012\015\012\015\012\015\012Power from the house\015\012\015\012Is\015\012there power getting to the dishwa ... Dishwashers

Made funny noise; stopped to investigate; then wouldn't restart; followed directions below from FixYa and restarted. It finished the cycle, apparently correctly, except it left a little water in the tub. Also, continued to make a lot of noise--a loud motor hum/buzz or similar. Did not make this noise during dry cycle. Dishwasher is Kenmore Model 665; stock number 16839. Can you give continued diagnostic instructions? Appears there is a cracked washer under the lower wand assembly; th


The solution was nearly correct. The person who answered only forgot to mention that water level and pressure switch must be tested. This can cause drain pump working longer than necessary and humming, and machine underfilling, which can cause noise ... Dishwashers

Dishwasher has stopped working, Hasn't completely drained water. When you restart it, it makes a humming sound and then stops. The light above the 'on' button, usually blue, turns red. Have removed most of the water ourselves and tried to restart it to no avail. Any assistance would be greatly appreciated.


Hi,Here is a tip that I wrote that will help you with your dishwasher ... Fisher and Paykel DD24SDFTX6 Dishwasher

When the oven is switched off after cooking the cooling fan runs to cool the oven down,it now keeps running all the time when the oven is off,the only way to stop it is to turn off at the ciruit breaker,what is the possible cause for this?????????? no.FFB1601CWW WALL OVEN


Sounds like the thermostat which allows the cooling fan to keep running after oven switched of is faulty may be stuck on or shorted will need to be replaced.let me know how you went. ... Fisher and Paykel 24 in. DS-603 Built-in Dishwasher

Our Bosch and our Electrolux stainless steel dishwashers fail to dry. Dishes must be towel dried and the inside of the dishwasher stays wet and must be towel dried and left open to thoroughly dry. I can't seem to find a setting to dry the dishes. Help Please


Hi,Check your heating element.. \012A bad heating element causes many problems in dishwashers…Dishwasher Problems The Heating Element not Working ... Dishwashers

My last rinse cycle did not completely drain. I have about 1 inch or so of water in the bottom of my dishwasher. I tried to restart the washer, but it will not turn on. I looked for some type of "restart" button, but could not find. My washer is not 4 months old.


... KitchenAid KUDS301V Dishwasher

Maytag 300 series dishwasher growls like a bad bearing and runs a few minutes then pumps the water out having restart the load. finally after several restarts it will run and finish the load growling every now and then.


This is your pump making noise. It could be the impeller is loose or possibly a bearing. The pump is relatively easy to replace if you have the desire... ... Dishwashers

Haier dishwasher CDW300SS beeping 10 times and 4 lights flashing,,, help The dishwasher will work, it fills, it washes and it empties, BUT will not start now, and the 10 beeps and the four lights flashing,, so wont restart and go throught the program... Is there some way of resetting the dishwasher to restart. help thanks. glenn


... Haier Dishwashers

We have a Model smu 4056 UC/14 that is 13 years old. Abount 2 inches of water is standing in the bottom of the stainless steel tank. We cannot make the unit restart. We understand that you have had problems with the pump vlave and the timer switch on this unit. Can yo tell us how to restart the unit.


... Dishwashers

Northstar Hot Water Pressure Washer (model #157322) While using the pressure washer the safety relief valve activated venting steam and hot water from it... I immediately shut it down and let it cool down. After it was cool, I turned on the water supply again and the relief valve was still spewing water from it. My neighbor said it was probably the "unloader" valve was stuck or damaged. I called around my area and it seems as though no one services my pressure washer.. Is there a manu


... Pressure Washers

On a Telefunken TDW-120 dishwasher there is a 1/2 button for a half load (only the top shelf gets washed) must the button be in to enable the half-load or must it be out?


... Dishwashers

My dishwasher was leaking so i pulled on the door, when i tried to restart it the play pause button goes to red and beeps. i think the lid was mid cycle and it wont restart. have tried turning it off at the power but still no joy


Hi.You may have brooken the door switch.Try tripping the circuit breaker. With power off check that there is no water inside the machine, and eventually remove water.Restart the machine with door closed and try starting ... Fisher and Paykel DS605ZW Dishwasher

The clean button keeps blinking, will not go off and i cant restart to wash. i hit the heat dry button for six seconds and it was unlocked but i cant get the washer to restart.


If the clean light flashes 7 times, pauses, then repeats...When the dishwasher doesn't sense a water temperature increase, it will\015\012stop working and lock the functions (clean light flashes 7 times, all\015\012buttons are non respons ... Whirlpool GU2400XTP Built-in Dishwasher
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.0239 seconds