Having problems with your Campbell Hausfeld Pressure Washers ?

Nozzle clogged The nozzle part is clogged


Answers :

Repair Help & Product Troubleshooting for Campbell Hausfeld Pressure Washers

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Nozzle clogged The nozzle part is clogged


... Campbell Hausfeld Pressure Washers

SHU 4300 top arm nozzles getting clogged


... Bosch 24 in. SHU43 Built-in Dishwasher

Maytag dishwasher nozzles clogged on water spray spinning devices


... Jenn-Air JDB9910 Dishwasher

Will not drain, clogged with washed off jar labels and a few metal scrubber parts; Can I pull of the washer arm and drain parts to eliminate the clogged drain? I tried 1/2c. vinegar to rinse out. It just would not drain.


... Frigidaire 24 in. PLD2850 Built-in Dishwasher

Drain Clogged Drain is clogged. Have standing water. I removed the 6 screws holding the top part of the strainer/drain motor on the bottom, but can't figure out what to do next to get to the drain to remove the clog


The strainer should have trapped all the big particles. Are you sure the drain is clogged? More than likely the evac. pump is shot. ... Kenmore 24 in. 17602 / 17604 / 17609 Built-in Dishwasher

My dishwasher spray arms were clogged with calcium buildup so I cleaned one and replaced the other. I also removed the fixed disc-shaped device underneath the lower spray arm and found the particle filter was clogged- so I cleaned it out. The dishwasher ran fine for a few times but then the filter clogged again, and again, and again. Now I need to make a routine of disassembling the parts to get at the filter every week because the filter no longer clears itself during the wash and/or emptying c


You may want to check your hot water tank. It may need drained and cleaned, Or you may have the rod in the tank disintegrating. Also check you water faucet areators to see if they have calcium pieces too. ... Maytag Dishwashers

I have a 2600 Troy bilt pressure washer.When I start the pressure washer,no water comes out the nozzle and the nozzle is not clogged either.I took the nozzle/gun off and there still was'nt any wat


If when you take the High Pressure water hose off the pressure washer pump no water will come out they you may simple have the bypass valve stuck. You may need to just remove the outlet fitting and clean the bypass valve.It would be helpful to kn ... Pressure Washers

I have a Karcher K3.99M when it is turned on and nozzle (trigger) is depressed nothing happens but after playing around with the nozzle trigger it comes on and as along as the trigger is depressed it will run, once you release it will stop and you will have to play with the trigger to get it active again. It sometimes hums even if the trigger is not depressed, please can some address this situation and identify what part is required?


... Alfred Karcher K 5.93 M Electric Pressure Washer

Whirlpool dishwasher part #3385181. Machine had gone thru wash cycle and was starting to dry. Smelled electrical burning smell, opened washer door and washer was filled with smoke. Turned everything off, cleared smoke, and the washer water dispenser is very hard to turn. Washer has symptoms of burnt up motor that turns water dispenser. Machine is 12 years old. With cost of replacement motor and possible part (pump?) that might have clogged and caused motor freeze up, is it worth fixing or junk


... Dishwashers

Kenmore (Whirlpool) 655 1589910 Dishwasher. Fills with water, motor makes horrible noise (buzzing / loud hum). Dishes do not wash and there is no evidence that any water pumped up to the spray arms. Spray arms are not clogged. We have a fully functioning water softener so it is not a hard water issue. Unit does drain normally. Either filter is badly clogged or pump is bad. How do I get to these parts to check them out?


You need to clean/ check the chopper. sounds like you have a bad motor. about 2-300 dollars for the part ... Kenmore 15899 Built-in Dishwasher

I have a Mi T M job pro 3500psi pressure washer that may have a clog in the nozzle, how do I release the pressure in the line? All the pressure fittings are stuck (probably from the pressure in the line), even the one at the nozzle. Is there a pressure release somewhere on the machine?


... Mi T M WP-2700-4MHB Pressure Washer

Dishwasher - Clogged spray nozzles


... Kenmore Dishwashers

Clogged pressure washer nozzle


Some of those adjustable nozzles are made with a removable orifice. If you look close, it is basically a small set-screw with a hole in it (for the spray orifice). I am not sure what size you need, but they are always metric, "allen" ... Briggs & Stratton Briggs Stratton Pressure Washer Adjustable Spray Nozzel And Wand

I have a maytag dishwasher mdb5600awb. it is about 5 years old. it does not clean anything on the top shelf for the most part. i took everything apart and found nothing that was clogged. we tried a rinse agent and that didnt help. for 460 dollars i expected more out of this. i also had the motor replaced 3 years ago. can someone give me an idea why i cant get my dishwasher to wash dishes?


Replace the dock at the back if it is missing a piece. That solved my problem with the top rack not getting clean. ... Maytag 24 in. MDB5600A Jetclean II Built-in Dishwasher

Honda gas powered pressure washer--runs great and I get pressure throughout the system but nothing comes out of the wand itself. There seems to be no clog throughout the system . I have cleaned all parts. When the unit isn't started I can get flow throughout the system


... Pressure Washers

I have had 3 Karcher pressure washers all experience the same problem and so have two of my neighbors. Our area has very hard water and it causes problems with the washer not bringing up the pressure when the trigger is pulled (or surges up and down) and the nozzles clogging, etc. The service repair facilities cannot tell me how to prevent this. Many attempts to contact Karcher for advice have been ignored. I have been thinking that perhaps running the engine for a few seconds with no hoses a


If your water is that hard (and it appears it is) WD40 will NOT solve the problem. You should look into a water softener. However, chances are that a small, inexpensive model will not have the flow capacity required for a pressure washer. You'll like ... Karcher K2.26 Electric Power Washer

I've a Kenmore - Whirlpool dishwasher purchased in 7/2002(665.17574200), which seems clogged. T The ''Accumulator Assembly'' (8268429) filter is clean, and I've stripped the unit down to the plastic components. This has happened once before, and the repair person cleaned some kind of secondary filter, but I can't locate that filter on the parts diagram. I'm guessing it's below the ''Protector inlet'' (8268390). Either I buy a new dishwasher, which seems a waste, or I find out how to clear the


... Kenmore 24 in. 17572 Built-in Dishwasher

Corner screw missing, causes leaking also, the washer arms on top and bottom have clogged holes, where can I get a part to open them up to clean them out?


The wash arms don't come apart you can knock the stuff out of them and clear the holes with some thing small and pointed.\015\012as for the corner screw issue I need more info what corner what screw are you talking about? ... Dishwashers

Maytag model dwu9200aax pieces of plastic and cloth clog some of the rinse holes on the spinning rinse part..how to take apart rinse arm to clean it?


The top spinner part can simply be pulled off by grasping it near its hub and pulling downward. Push it back on and push in the locking clip in the center. \015\012The bottom spinner can be removed, First unscrew the center column. Hold the spinn ... Maytag MDB6650A Built-in Dishwasher

My 1984 Miele G522 dishwasher doesn't fill with water. No clogs in tubes, etc. could it be a broken part and if so, which? thanks


HI. this is a water inlet valve issue. I recommend testing this device. it may be faulty.To access the inlet valve remove the lower panel located beneath the door. The panel is usually held in place with two scre ... Miele Dishwashers

I have an LG dishwasher lds5811ww -- for about 1.5 years. Purchased it at Best Buy. The soap dispenser is not emptying completely anymore. The upper rack is in its uppermost position. I suspect that the top two spray bars are not turning around because they have not changed positions when I suddenly open the dishwasher while in operation. The spray nozzles do not appear clogged. Any suggestions?


If your dishwasher is cleaning poorly, check these:\015\012\015\012Water-inlet valve\015\012Internal filters\015\012Drain valve\015\012Spray arms\015\012Water temperature\015\012Detergent cup\015\012Water-inlet valve Most cleaning problems are ... LG Dishwashers

We recently bought a house with a Kenmore 363.16222100 (?) dishwasher. No manual. Monday night it didn't drain properly and leaked some water on the kitchen floor. The cycle had finished when we saw the water on the floor. We bailed out the excess water. I took off the drain cover and insert. I couldn't see an obvious clog problem, but cleaned it out. Then I tried a short cycle, interrupting it to shorten it. No problem. Water seemed to drain fine. I did find a part that looked like a straw and


HelloWelcome to FixyaMy name is Huum,You can find your model dishwashers manual here at this site. this sitehttp://www.managemyhome.com/mmh/lis_pdf/OWNM/L0801624.pdfI feel you should not invest blindly in someone ... Dishwashers

Not draining my dishwasher is running partly...but stopping b/c theremust be a clog...the bottom is filling up with water and staying.....what tools do i need?


Hi, Tools you might need are, 1/4" & 5/16" nut driver/socket, phillips screw driver & pliers.\015\012I would remove the drain hose from the sink and put the end into a bucket. Start the d/w into spin and see if water releases.\015 ... Hotpoint 24 in. HDA3400G Built-in Dishwasher

I have a GE Triton XL dishwasher that is not spraying water onto the dishes. I just reset the power, and that didn't help. Putting it on the rinse only or wash cycle fills the bottom with water, but it sounds like a trickle vs. the spray. The heating element comes on and the soap door opens, but there's not spraying. I made sure there was nothing clogging the water line or other parts. What do you think is wrong?


... GE Tritonr XL GSD6260JCC Dishwasher

Dishwasher problems I have a counter top dishwasher and it's not cleaning things like it used to i think its clogged but i cant get to the drain because it is in the bottom i tried draino but it didn't work i also tried unscewing the bottom but i cant get that part out i think there is somthing stuck in there.


First thing to check water hose that connect at back of machine. pull the screen out and clean it. use a pliers. I run my under water then use a q-tip if its clog to clean the rest.\015\012\015\012Then pour a cup of vingar in machine and ... Danby 22 in. DDW396 Free-standing Dishwasher
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.0580 seconds