Having problems with your Campbell Hausfeld PW2102 Gas Pressure Washer ?

Gas motor runs but very little pressure comes out of nozzle. The 2200psi washer has only about 10 hrs running.I keep it in a warm garage all winter..thanks..rick


Answers :

Repair Help & Product Troubleshooting for Campbell Hausfeld PW2102 Gas Pressure Washer

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Gas motor runs but very little pressure comes out of nozzle. The 2200psi washer has only about 10 hrs running.I keep it in a warm garage all winter..thanks..rick


... Campbell Hausfeld PW2102 Gas Pressure Washer

I HAVE A MIELE G646 SC DISH WASHER AND IT KEEPS LEAKING WATER INTO THE LOWER TRAY AND CUTTING OUT BECAUSE THE FLOOD SYSTEM KICKS IN.I HAVE THE MACHINE IN THE GARAGE WORKING UP ON TWO WORK MATE WITH THE UNDER TRAY OFF FOR THE FIRST FEW CYCLES THERE WAS NO LEAKING THEN WE FOUND IT LEAKING DOWN THE FILL PIPE.THE WATER IS LEAKING FROM AROUND THE AREA THE FILL PIPE FITS TO THE WATER SOFTNER BUT NOT ALL THE TIME.AN ENGINEER FROM MIELE SUGESTED IT COULD BE THE VENT INSIDE THE SIDE OF THE MACHINE BUT EV


Have you made sure the water sofener filler neck locknut is tight to the bottom of the dishwasher?i have had experience with one machine where spilled salt was not rinsed away after the softener was filled and this corroded a very small pin *** ... Miele 24 in. G646SC Plus Free-Standing Dishwasher

I have a GE PDW8060GSS dishwaser. The washer does not turn on. The "anti bacterail" swith keeps blinking. There is some water standing inside the washer. Tried draining, but water keeps coming back. Not sure what is the issue. Can you help?


If after draining water comes back then you need to check the waste water system for any cloughs. Problem might even be at the dwelling drainage system as any blockages would prevent water from going out from washer. Check the waste hose, filter and ... GE Profile PDW8060GSS Built-in Dishwasher

My Delonghi Dishwasher keeps turning off. The dishwasher is turned on at the power point. The water is turned on. Okay When I press the POWER botton on the front it wont stay on. I have to keep my finger on the POWER button and then press the START button for washer to work. If I do this it will then pump out any water in the bottom and start to work. ***BUT when you take your finger of the POWER button the washer just turns off and stops working. Do you have any idea what could be the problem p


Yes, the power button is faulty. by pressing the power button forcefully, you are in effect allowing the contacts to close. Replace it. ... Dishwashers

Have a Husky Pressure Washer 2200 psi, HU80931. I don't have an owner manual. It has set for about a year. When I started the washer there was very little pressure. Did some cleaning and it was a little better, but now there is no pressure and I am having trouble keeping it started. Can you help? The washer was purchased at Home Depot and it has Briggs and Stratton the the washer too. Thank You, RJ


Look at eReplacementParts.com and the parts diagrams ... Briggs & Stratton Pressure Washers

Hi i have a whirlpool dish washer - model : ADP4731/5 , AAA class . I keep getting a F7 error message and it is not allowing me to turn the washer on , if i hold the start button down it allows the washer to go for 30 seconds before the error comes back up and it stops working again


... Whirlpool Dishwashers

Asko dw20 pump keeps running even with door open and turned off... The machine got to the final cycle then the pump just keeps running and the glass icon (L2) keeps flashing. All the water is not evacuated from the washer. When I power off from the front the drain pump still runs (and water is still not draining). When I power cycle from the mains (waiting 10 seconds) the pump engages again and the water level drops a bit and then stops draining. I have done this until all the water is empty an


... Asko Dishwashers

The spray arm, above the top rack, keeps unscrewing during the wash cycle. Just the arm comes off leaving a round plastic part attached to the top. This can be unscrewed and inside is a white 'washer'. The arm can be clipped back but comes off again in the next wash. The plastic 'washer' has to be turned over to allow re-attachment. Is a washer missing from inside?


Could the arm be mounted upside down and rotating the wrong way? Just an idea... Some of these can fit either way and the retainer will fit either side of the arm. ... Frigidaire 24 in. PLD2850 Built-in Dishwasher

Start light keeps flashing but washer won't operate. Tried to reset by hitting cancel button but start light keeps flashing.


Check whether inlet water is flowing into the machine. ... KitchenAid 24 in. KUDI02IRBS Stainless Steel Built-in Dishwasher

I have a Karcher Pessure Washer K-Series, K 3.96M. When I turn it to ON, the washer keep cutting out of power and I get not water in the handle, even thought we water is on etc....


Sounds like it could be just a blocked nozzle in the end of your lance. ... Pressure Washers

Clean light keeps blinking and washer will not function. Cancel runs the pump for 2 minute, but the blinking light keeps going with no functions working.


If the clean light is blinking that mean you dishwasher is having a heater issue. it is an error code. either your control board is bad or the heater or the ntc therm. if you take the bottom panel off you will see or should see a tech sheet that ... KitchenAid Dishwashers

I have a Karcher 330 elec. power washer. The on/off switch will turn the washer on but will not keep it runing


... Karcher Pressure Washers

I was using the pressure washer and it stopped having high pressure and motor keeps doing a varoom--- pause----varoom----pause and does not stop doing this even with the wand off. Does anyone know what to do? it is a karcher 1750 psi electric washer


This problem, where the unit continually switches on and off when the handgun is closed, is quite common. Unfortunately it has at least six different possible causes, only two of which are easily checked. \015\012\015\012The first thing yo ... Karcher PSI Electric Pressure Washer

The washer is very noisey and sounds like the washer hands keep getting stuck. I've checked the bottom and there is nothing stuck.


The noise is definitely in the motion of the arm or the movement of the drive. It is important that you are able to get a first hand view and observe the origin of the sound while trying to turn the drive manually.\012So switch off ... Kenmore Dishwashers

Omega techno wash dish washer leaking from bottom hose from motor to bottom of washer keeps coming off


... Dishwashers

Du1100xtpq7 dish washer keep repeating wash cycle doesn't go past this just keeps washing


Hi\015\012\015\012 \015\012\015\012 \015\012\015\012Thanks for using FixYa. If the\015\012cycle doesn't complete, check these:\015\012\ ... Whirlpool 24 in. DU1100XTPS Built-in Dishwasher

The oil in my gc160 Honda pressure washer is getting water in it some how. Could it be something with the water pump gasket or what? And I can get it started but can't keep it running un less I keep spraying starter fluid in the carbar. Please help ?


... Karcher 2500 PSI Pressure Washer

Whirlpool adp5962 dish washer keep pumping out then the green start button keeps flashing items are not washing can you help where do i start thanks


You may have water in the base due to a leak internally.if you tilt the dishwasher backwards and water runs out.thats the cause of the problem.on all the whirlpool full size dishwashers .access to the base is through two t25 torx screws securing the ... Whirlpool 24 in. ADP5962 Free-standing Dishwasher

Honda pressure washer keeps dying - Pressure Washers


... Pressure Washers

My bosch dishwasher model shu33a keeps running.At first the sanitized light would not light now it just keeps running and when i open the door its not real hot like before..the washer is only 3 years old.


Change the control module. check to see if there is a recall on this module. bosch will tell you if it is.give them model # and serial #. by the way if the modell is arecall you will get a free fix. let me know if this info helps, ... Bosch 23 in. SHU33A Built-In Dishwasher

I have a Honda ,gas powered power washer and when I squeeze the handle the water pump kills the motor. I've let the engine run until warm and it still can't take the water pump engaging. It's a three year old washer.


... Pressure Washers

I HAVE A BRAND NEW TROY-BUILT 2600PSI pressure washer. I have used it twice for about 1/2 hour each time. It worked perfectly. I tried to use it today with everything hooked up perfectly. The Honda engine started perfectly; how ever when I squeezed the wand trigger, the engine instantley died. I let the engine warm up and slowley pushed the choke in. I let it warm up for plenty of time; but everry time I squeezed the trigger it instantly quit- it even backfired once before dying. I changed the g


Sounds like the governor is stuck. My pressure washer speeds up when it has to pump. Don't know if yours uses vacuum to trigger governor or direct linkage. Good Luck. ... Psi Blue Max 2200 High Pressure Gas Power Washer

Water pump I have a porter cable pressure washer model# 2425. I let my presure washer in the garage during the winter(no heat) and now i have a probem with the pump. I start the motor everything is find but when i put the water in the motor stop. Can you help me


... Pressure Washers

It will not take the chemical/soap in the pressure washer? I have checked both ends on the chemical hose and both seemed to fit tight on recievers. Then I checked and did not see where it was pulling air in the hose to keep it from pulling from chemical bottle. This is a brand new washer. Am I doing something wrong?


... Pressure Washers

My dishwasher is a Fridigdaire FDB510LCS1, approximately five years old. The timer/knob stops advancing at about 7 o'clock, somewhere in the wash cycle. But the washer keeps running. I marked the place where it stops and, on additional tests, it stops in exactly the same place. I can advance the knob slightly past this location and the washer continues through to the end of the cycle.


Hi\015\012\015\012This is due to a faulty timer on your dishwasher. You would need to replace it to resolve this issue. You can buy the timer for your dishwasher from this link---\015\012\015\012 ... Frigidaire 24 in. FDB510LC Free-standing Dishwasher
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.0967 seconds