Having problems with your Candy DFI Plan Built-In Dishwasher ?

My candy 1012 dishwasher won't drain fully- someone said that perhaps a filter needs cleaning- I've cleaned out the one in the bottom of the machine -is there another one?


Answers :

CHECK PUMP,DISCHARGE LINE .
I WOULD START BY SEEING IF IT PUMPS OUT IN A LRG BUCKET 1ST.
SOMETIMES IT IS OUTSIDE OF THE D/WASHER.. FRED
Repair Help & Product Troubleshooting for Candy DFI Plan Built-In Dishwasher

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

My candy 1012 dishwasher won't drain fully- someone said that perhaps a filter needs cleaning- I've cleaned out the one in the bottom of the machine -is there another one?


CHECK PUMP,DISCHARGE LINE .I WOULD START BY SEEING IF IT PUMPS OUT IN A LRG BUCKET 1ST.SOMETIMES IT IS OUTSIDE OF THE D/WASHER.. FRED ... Candy DFI Plan Built-In Dishwasher

The hose is leaking and I need another bottle that is Attached to the system.Model # 1210 Coleman Pressure Washer , it is an electric one. ''Clean Machine''


... Coleman Pressure Washer PW0881800

FDB105OREC4 My dishwasher is not cleaning my dishes. I push the start button and water seems to be trickling in then it stops and no sounds protrude from the machine for several minutes. Eventually another loud motor seems to turn on and drain the water out of the machine. The soap dispenser usually opens and the soap block that usually dissolves is setting on the bottom of the machine. It seems the water is plenty hot but the rotating washer arms might not be moving. Please help me find the par


... Frigidaire 24 in. FDB1050REC Stainless Steel Built-in Dishwasher

I have an Ariston LS245 dishwasher, have just had the pump replaced, as it had shorted out, due to water in the bottom tray where the water detection float is, also a new drain hose fitted. Have just run a wash and after running a while, presumably to the end of the rinse, wash and dry cycle, then one of the cycle phase lights, the one for 'soak' blinks constantly. I switched the machine off and had a look to see if a wash had been done, the dishes look clean. In the book it says that if one


... Ariston Technologies Dishwashers

10 year old Kenmore Ultra is leaking early in the washing cycle. Wondering if this is worth fixing or need to bite the wallet and buying a new one. I am worried about affecting the new cabinets even though the dishes seemed to be clean on the two occasions that the dishwasher has leaked. Only need a somewhat simple machine- I'd appreciate any suggestions as to what brands I should research if buy is the conclusion. Thanks.


At 10 years old I wouldn't put much if any money into it. Do check the water connections as it may be something simple that just needs to be tightened or a washer replacement. Replacing the valve is a simple and inexpensive fix but don't bother going ... Kenmore 24 in. 17482 / 17484 / 17489 Built-in Dishwasher

My GE Eterna Series 3 Quiet power is not cleaning our dishes. Mostly the dishes on the top row has lots of stuff found in the glasses and mugs. YUCK!! I ran it for a minute and there is just water in the bottom of the machine- no soap. The bottom and top spayer were spinning but the middle one isnt moving. Any Ideas???


I just took mine apart (bottom turntable, screen, etc.) and I was disgusted by the grime and gum that was clogging everything. I think it was keeping all the water a gritty white, which constantly left residue. I am cur ... Maytag Dishwasher

Asko dishwasher- about 1 year old. Dishes are clean but very wet at the end of cycle. The bottom tub is filled with water (looks clean and warm). The dishwasher is leaking and water on tile kitchen floor. I checked for a float device inside and do not see one. What do you think problem is? How can I check hoses to see if clogged- do I need to pull washer out? Is that hard?


... Asko 24 in. 1895 Built-in Dishwasher

Like sand Not getting the dishes clean it seems like sand and other stuf in the glasses :( cant find any extra filters , have clean the regular ones in the bottom of the machine. Please can someone help me find a solution or find a manual online.


Clean out both top and bottom spray arms\015\012Deep Diver ... Bosch 24 in. SHU5305UC Built-in Dishwasher

I HAVE A MODEL # RUD1000DB2 BUILT IN DISHWASHER AND IT IS NOT CLEANING PROPERLY ALSO I WOULD LIKE TO KNOW WHERE WE CAN PURCHASE ANOTHER ONE OF THESE IF NEEDED IN TORONTO ONTARIO THANKS SHERRY


Hi, \012I have an older dishwasher also and recently mywife also complained about it not cleaning right... so me being the man I amtried in vain to clean the things... Bought new spray arms online and installedthem in minutes...now the thing works li ... Roper 24 in. RUD1000DB Built-in Dishwasher

A screw fell in to the bottom of my dishwasher. In trying to get it out it disappeared. In trying to find it we found another one that looked like it had been there a long time. My dishwasher is old model #DU920GWBD5. Do you think we can run the machine?


... Whirlpool Dishwashers

The dishwasher was recently removed for floor refinishing and reinstalled. The bottom rotor works but the top rotor does not. I asked the re-installer, who worked for the moving company, if he had connected everything properly and he said there was just one water line going into the machine and assured me he had connected it properly. Is there something else that needs to be done to make the top rotor operational? Thanks. John M


... Jenn-Air JDB3610 Built-in Dishwasher

I have a Maytag dishwasher quiet series 300. It is one year old. The problem I am having is this. After running a cleaning cycle, there is water in the bottom of the machine. If I push the start button, then cancel a few seconds later it will drain. Any idea? Thanks, Terry Roose


Hi Terry, Welcome to FixYa, I am Kelly. \015\012 A few things can cause this. Most of the time it is drain related with the Air-Gap being the culprit that is restricting drain flow. If the dishwasher drain has a restriction ... Maytag Dishwashers

Maytag quiet series 200 is not washing dishes properly, bottom ones are almost always dirty after running the dishwasher. Is there a filter I need to clean anywhere?


... Maytag Dishwashers

My dishwasher barely cleans my dishes. i basically have to wash them before i place them into the dishwasher. also, once they come out there is usually residue of the dishwashing detergent especially on the top rack. another problem is that the wheels on the bottom are all warped and come off every time i use the machine. we have had this appliance not even for 5 years and it is driving me crazy! any advice/ solutions would be very helpful.


Sounds like the pump or drain is stopped up. is there water in the bottom after the Cycle is done? ... GE 24 in. Profile PDW8280JSS Built-in Dishwasher

I have just bought a house with this dishwasher. The first couple weeks it was fine, now not all of the water will drain. Ive taken it all apart and cleaned it but after washing there is about 2cm of dirty water covering the bottom. It happens with both but usually only one at a time. I have read horrible things about the dish draw, what could the problem be? Help Please


The most common cause of problems on dishwashers installed by the builder are Installation issues. Usually, the drain hose is kinked and food particles accumulates on the hose until it clogs completely.If you are planning to fix it by yo ... Fisher and Paykel 23 in. DD-603SS Built-in Dishwasher

I have a model #587.1526 or 587.1625 it is one the use and care guide book. the cycle goes through and washes but does not drain. The machine does not even make a noise like it is trying to drain. I have cleaned and vacumned out the bottom twice but to no avail. does the pump go out on these things?


... Kenmore 24 in. 16262 Built-in Dishwasher

Removed the bottom filter of a GE Quietpower 3. Cleaned the screen and replaced the unit, now the machine does not drain. I assume the screen and the part under it can go in one way.


Hello, luckyI\012 was trying to help you out here. I am not sure if this well help you? \012But here is a link to about everything you want to know about your \012dishwasher, from repair to trouble shooting on most common dish ... Maytag Dishwasher

Ge m# gsd5560g02ss dosent seem to wash well . Im wandering if there are filters besides the plastic one at the bottom,that need to be changed or cleaned perodicly


... GE Dishwashers

We need to replace the locking ring in the bottom of our Asko 1716 dishwasher.(It's cracked) I can only find one kind of replacement ring for that,but it looks like the right size. I need to know if Asko uses one ring for more than one model of dishwasher?It's a 5" locking ring for the bottom well of the tub. Thanks for your help!


Only 1 size ... Asko D1716 Built-in Dishwasher

How do I clean our dishwasher? It leaves standing water in bottom after a running load.


... Maytag Dishwashers

My KichenAid KUDS011 has functioned well until this morning. When I push any of the buttons on the keypad, nothing happens. I noticed there is still water in the bottom of the dishwasher from the last dish washing. Also, I've heard there is a screen or similar part in the bottom of the dishwasher that needs to be cleaned occasionally. I haven't figured out how to remove the bottom center of the dishwasher to access this for cleaning.


If the drain or screen are clogged, the machine may no operate.Unscrew the the 2 long screws on bottom, remove the basket, there may be a flapper under the basket, For pics, see here: http://www.contractorssolutions.com/dishwashers. ... Dishwashers

Need a service/repair manual for a Bosch SGS0905AU/01. The machine is completely dead (no display) after a burnt smell came from it. On the pump motor is a broken/melted brown attachment with a broken ceramic(?) disc inside which looks like some type of capacitor. I really need to know what this is/was so I can replace it. Also, need to know whether there is another fuse somewhere in the machine as that has most likely blown as well. TIA


Hello,\015\012\015\012Welcome to FixYa.\015\012\015\012While I can provide a overall Bosch service manual if you post an email address, Based on your description I'd say the issue actually with the motor start relay and consiquently the control...as ... Bosch Dishwashers

Machine just started leaving dirty water in bottom of machine. cleaned filters,had machine apart,removed and cleaned waste pipe. pump runs and impeller feels ok.only time i could get any water to drain into bucket was when shook waste pipe very hard?


Check that the pump is clean and not loose. Make sure pump, impeller, and waste pipe are in alignment with each other and are clean. If it works when you shake the pipe, then there is still a clog inside or the pipes aren't aligned correctly and some ... Dishwashers

My manual for the kelvinator extreme clean kd12dds-2 was ruined and i would like to get one because the machine is not cleaning as well as some older machines i have used and i would like to see if there is something i am doing wrong or if it can be cleaned out someway


... Kelvinator Dishwashers

I have a kenmore 665.13719k601, i used the delay switch and now i found water in the bottom of the machine. the cycle most have stopped while i was away. when i returned there was water sitting in the bottom of the machine. The water is clean... I can not drain due to no access to power on the machine. I checked the breaker but it was on, so i reset it anyway... nothing.. any idea's


... Kenmore 13719 / 13712 Built-in Dishwasher
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.1198 seconds