Having problems with your Candy Dishwashers ?

Hi my Candy dishwasher model CDI 1012/2 is filling with water then after a few minutes if bleeps and the error code meaning according to the manual is "Longer inlet time. possible cause Faucets is not open" The tap is fully open and the dishwasher is now full of dirty water. Could you please suggest an alternative cause?


Answers :

Repair Help & Product Troubleshooting for Candy Dishwashers

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Hi my Candy dishwasher model CDI 1012/2 is filling with water then after a few minutes if bleeps and the error code meaning according to the manual is "Longer inlet time. possible cause Faucets is not open" The tap is fully open and the dishwasher is now full of dirty water. Could you please suggest an alternative cause?


... Candy Dishwashers

Error Code E1 means longer inlet time. possible causes faucet is not opened, or water intake is restricted, or water pressure is too low, according to the BRADA portable dishwasher model EP9242AWW What does that mean and how do I fix it? I have shut the water faucet off and the error message still shows.


... Dishwashers

After starting my dishwasher ADG 9340/1 (any program) and after pumping evt. (rest)water , the machine won't take fresh water in and gives an acoustic alarm ! After opening the dishwasher , I can see that the "Start"-led is blinking in sequences of six blinks . Can you give me please, a possible cause and/or solution to this problem !


... Dishwashers

I have an ADP6000IX Whirlpool dishwasher which is comming up with a Fault code Err4. The manual indicates overfilled and possible cause "too much inlet water", however there is no water sitting in base of machine, and have unloaded all dishes and Err4 still comes up. I have switched unit on and off at wall but has not re-set. I have disconnected water pipe from tap and reconnected.Is there anything further I can do?


Hi, \015\012\015\012You can solve this by cleaning and de-greasing the filter frame, basket and sensor Also there might be a low threshold for oils/greases/debris of any kind, so you have to rinse and load. By removing outflow tube ... Whirlpool Dishwashers

Whirlpool dishwasher part #3385181. Machine had gone thru wash cycle and was starting to dry. Smelled electrical burning smell, opened washer door and washer was filled with smoke. Turned everything off, cleared smoke, and the washer water dispenser is very hard to turn. Washer has symptoms of burnt up motor that turns water dispenser. Machine is 12 years old. With cost of replacement motor and possible part (pump?) that might have clogged and caused motor freeze up, is it worth fixing or junk


... Dishwashers

Plumbed in new dishwasher wash light and pre wash light flashing nothing happening ! manual says longer inlet time possible cause -faucets not opened?


Hello lozjojo,\015\012Based on your problem description, you either have no water pressure at the inlet valve or the inlet valve isn't operating and allowing water in. Prior to installation, did you make sure you removed ALL the packing materia ... Dishwashers

Hi my Whirlpool ADP6000WH dishwasher is showing an Error 1 code - longer inlet time so its not getting any water. The tap is definately on and nothing has changed since last time it worked ok with no faults. Possible causes? Thank you.


... Dishwashers

Hi All, we have just bought and fitted a Hoover HEDS 668-80 Dishwasher. When we tried to run the first wash, the pre-wash and wash light both light up simultaneously. The instruction manual says this means, "longer inlet time", with the possible causes "Faucets is not opened". Could anyone help? Many Thanks. Lisa. :-)


You do not have enough water pressure,, either change the water supply or check the pressure in your house should ba about 70lbs, to work the unit properly,, you could also increase the water supply from 3/8 to 1/2 inch up to the connection of the un ... LG LDF6810 Built-in Dishwasher

Diswasher TYP NBKH, SERVICE 8546 892 10010 Problem: For all programs except rinse and charge 1/2 for all programs. Pre-rinse and rinse for 50 Bio, 60 and 70 OK. Downloading water to wash causes multiple knocking (on the left side dishwashers) and simultaneous blinking light (relais?). Opening doors and adding water (different amounts - from 0.5 to 2 l) brings the normal work of dishwasher back. Rinse with cold water after washing OK. Final cleaning with hot water causes knocking again. After r


... Dishwashers

Dishwasher continually beeping midcycle. Open washer - dishes wet, water in bottom of dishwasher and water faucet sign illuminated. Can anyone advise what's going on? Just checked the water valve to make sure it was open. Thanks.


... Thermador DWHD630GPR Builtin Dishwasher

A GE triton dishwasher causes hammer noise when stops filling. The sink faucet works fine as do all the other faucets in the house. I cleaned all of the traps in the dishwasher. Because the sink works, I don't think it is a sink valve problem. I turned off the water to the house and drained the system, the air chambers should be good. Is there some component of the dishwasher that could be causing the noise? Would cleaning the pump help? If so, how would I do that?


The cause of the hammering noise, (slamming) is due to the water inlet valve on the Dishwasher (DW) shutting off abrutly once the DW reaches the proper amount of water.\015\012\015\012If this is an older DW, you might want to replace the ... GE Dishwashers

Dishwashing machine not fully draining (2 inches of water remain). I have an open problem concerning this problem. I have a new pump. dishwashing machine not fully draining (2 inches of water remain) For this machine.


Following a cycle, a small pool of clean water inside the tub is\015\012typical. Excessive water means the pump isn't pumping water out\015\012properly, the drain hose isn't carrying it to the drain pipe, or the\015\012house's drain lines are backed ... GE 24 in. GLD5860LSS Stainless Still Built-in Dishwasher

We lost electricity very briefly today which caused the dishwasher, washing, drying, clean buttons to blink when the electricity came back on. I opened the door to do a load of dishes hours after the electricity came back on and the basin was filled with water which caused water to spill out of the dishwasher. The basin was empty last night when we used it. It seemed to fill up when it was not running.


It seems unit fill valve is stuck open and water is coming in even when machine is off.fill valve opens up only when u start the unit.2 chks this u can open the door and look at the hole inside from where water comes in.if water is coming in with do ... Frigidaire 24 in. PLD2850 Built-in Dishwasher

We have a Model 587.1440*, 587.1441* Kenmore dishwasher. I had turned the water off to the whole house when we left for vacation and openned one faucet so the water pressure would be off the house while we were gone. Upon our return, I turned the water back on but the dishwasher gets no water. ?? What happened? It was working fine when we left, now no water. ?/


First, have you run it long enough to purge the air from the dishwasher line?\015\012\015\012Secondly, the solenoid valve for the water inlet may be stuck due to no pressure on it while you were gone. Tapping it with something light like ... Dishwashers

The dishwasher takes water in (not to much as when you open the door later, there is hardly water visible) and then it sounds as if it is busy heating the water. Then all of a suddden it will trip the power switch on the distribution board. My impression is that it is not takingin enough water and the heating part causes the trip failure. Your comments and advice to resolve will be aapreciated. Planning to open it up this weekend (machine not that old)


Usually ,there will be a float in the bottom of a dishwasher that shuts down the waterflow when it has received enough water. it works just like the float in a toilet tank (if you are familiar with that) you are definitely on the correct path in thin ... Indesit Dishwashers

My Bosch diswasher is hanging up in the cycle (at 102 mins. in normal cycle and 38 mins in quick cycle). I hear what sounds like a one second pumping of water into the sink area, a pause, and then another one second pumping of water, on and on, but there's no progression beyond this point. One possible cause: a few weeks ago someone turned off the hot water at the heater and another person tried to run the dishwasher. The dishwasher did not function because it could not get hot water. Perhaps


Hi\015\012\015\012 \015\012\015\012Thanks\015\012for using FixYa. To start with check the water inlet valve which is located\015\012behind the lower access panel on the left or right side of the Di ... Bosch 24 in. SHU66C02 / SHU66C06 Built-in Dishwasher

I have a bosch dishwasher SHE43C06UC22 (non-LED version). It's stuck in the drain cycle and continues to run even when opening the door (it should stop, but it doesn't). As a test, I poured a large glass of water in the bottom of the dishwasher and it drained it into the sink as it should, but it continues to run in the drain mode with no water in it. I've heard I either have a float stuck or an emergency drain switch or leak somewhere causing the dishwasher to continue in the drain mode. Ho


Hello,\015\012\015\012Welcome to FixYa.\015\012\015\012This can be caused by either faulty door switch or indeed the float you mentioned.\015\012\015\012This is where to look for the switch and test it ... Dishwashers

I cant get me dishwasher to start i have tested the overflow switch and its fine i have also tested the water inlet valve and its is fine. but it will not fill the dishwasher with water i have even removed the hose to see if there was any blockage in the line come out from the what inlet valve. the button light up on dishwasher and the cycles work a long with the start button, i have left the door open to see if the door senor could possibly bee an issue and it tested good and function correctly


Hi.If there is no voltage to valve, then parts that can be responsible are only and all the following:Overfill switch or overfill device.Door switch.Electronic control Wiring.If the overfill switc ... Dishwashers

I have a GE dishwasher model GLDL560N10SS. I noticed a burning smell coming from it the other day and then realized that although I can hear water running into the dishwasher when I start it, it never actually runs in the sense that the water is pushed through the various outlets to wash the dishes. I'm assuming that it is because the unit is dry and the heating element is still coming on that it is causing a burning smell. If I open the unit and reset it, it pumps the water back out into the si


The problem sounds like it is in the water inlet selonoid. Pull off the bottom panel and this is the part that the main water line hooks to there is a selonoid and it has a plugg inconnection to it unplugg it and check for power when the unit is supp ... Dishwashers

Bosch shu9915uc dishwasher when turned on sounds like drain pump is running but water will not enter dishwasher. When opened the pump sound stops. I did have a plumber over right before this occurred to replace kitchen sink faucet but he said he did not shut off valve to dishwasher and valve IS open.


Hello, \015\012 \015\012Welcome to FixYa.\015\012 \015\012 ... Bosch SHU9915UC Dishwasher

Whirlpool dishwasher ADG 957. The manual says " Open the door and turn on the water tap". Where is the water tap and what does it look like?


They mean to turn on your water faucet at the kitchen sink and let the water get hot before starting the dishwasher cycle this insures you start the wash with hot water. ... Whirlpool Dishwashers

Hi my teka dishwasher is causing me grief.The water starts but does not stop going all day on extreme hot temperature.I have stopped it as i opened the dishwasher and all the water remains in the bottom which is very dirty.Also it doesnt clean the dishes at all .So im so confused to what to do ..please help me thanks


Might help if you provide the model no. of your Teka dishwasher.\015\012\015\012also have you noticed any flashing lights or lights that come on when the wash is on. ... Dishwashers

I have a portable dishwasher. Where it connects to the faucet it is leaking and spraying water when i turn on the water. It doesnt seem to connect fully to the faucet


... Maytag 24" Tall Tub Portable Dishwasher - Black

Sometimes in my GE nautilus dishwasher I hear the water only dripping like from tap and not the spray and I don't hear the revolver moving its just like for the whole cycle water keeps on dripping like a tap has been opened onto the utensils there is no cleaning or rinsing action happening and the utensils don't come out clean. All during this time there is no leakage


Do you now anything abouth chip instaletion in to IAT? ... GE 24-7/8" Convertible Portable Dishwasher - White-on-White

Good morning! My Whirlpool dishwasher (I'm at work so don't know the precise number) leaves about an inch of water at the bottom after washing. I called a Whirlpool representative soon after my purchase (post Ike devastation of previous dishwasher that drained fully) and was told that this was rather normal for Whirlppol. I live on Galveston Island in Texas, and adding any more sources of water and humiditiy to my household seems counterproductive. Is there anything that I can do to cause


Hi\015\012\015\012 \015\012\015\012 \015\012\015\012Thanks\015\012for using FixYa. Dishwasher not draining properly or not draining at all issues\015\012can arise due to different reasons ... Dishwashers
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.2464 seconds