Having problems with your Candy Dishwashers ?
Candy a8001/1 uk
the dishwasher fills and runs for 10 mins then stops. the heating element is heating ok and i have checked the door switch and it seems to be functioning ok but if i open and close the door it will run for a couple of secounds and stop again could you tell me what could be the cause of this?
Repair Help & Product Troubleshooting for Candy Dishwashers
Tips for a great answer:- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.
Suggested Questions/Answers :
Candy a8001/1 uk the dishwasher fills and runs for 10 mins then stops. the heating element is heating ok and i have checked the door switch and it seems to be functioning ok but if i open and close the door it will run for a couple of secounds and stop again could you tell me what could be the cause of this?
... Candy Dishwashers
My whirlpool dishwasher type 280-2 detergent door will not open during wash cycle. Yes the compartment, springs and door are thoroughly clean. Will not open if I just close the door and remains empty. I'm wondering if perhaps I knocked off some random part that makes it open. So please tell me how darn thing opens and perhaps a pic of the parts so I could see if ones missing. Thank you for any help offered for this, its driving me nuts.
Water will not drain out. do not have a drain airGap. when opened dishwasher this afternoon still had water in the bottom of it. Emptied the dishes, closed the door, pushed cancel/drain. the green light came on and i could hear the dishwasher running but not hear the water draining out. Let it run the 2 minute cycle for cancel/drain opened the door and the water is still there.
Hi,Here is a tip that I wrote that will help you with your dishwasher not drainingproblem...Dishwasher Problems - Waterwill not drain out ... KitchenAid 24 in. KUDM01TJ - Multiple Color Built-in Dishwasher
Asko 1585 Dishwasher. Lately the washer has not been completing it's cycle without going into the all lights flashing mode. Usually just opening the door, closing then pushing start gets it going again. Yesterday this happened and it was restarted as described, then it go stuck in what appeared to be a drain mode - all lights flashing, drain motor running. It was in this mode for several hours and could not be stopped by any means. Pushing buttons or opening the door had no effect. Even c
Hi\015\012\015\012\015\012\015\012Thanks for using FixYa. You are right it is related to a bad control board. The\015\012control board has gone faulty and needs a replacement. Please check this recall\015\012information--- ... Asko 24 in. 1585 Built-in Dishwasher
AEG Diswasher Model / Favorit 44080IM PNC 911925601/01 (located in UK) Wash cycle finish light flashes 5 times in sequence then starts again - please advise the meaning of this error signal ? History Machine started running immediately door was closed before any programme selected filled with water and main was motor runs and circulates water Water is not heated and detergent door has not opened Machine will continue to circuluate water until turned off If reset used then
1 blink is machine is having major power supply problem.the power supply board needs replacement.\015\012-----------\015\0122 blink is CCU error.that control board problem.\015\012-----------------\015\0123 blink is the CT error.that is ... Dishwashers
Hello I hope someone can help me. I have a Siemens Hydrosensor Dishwasher that when I start it up in runs for a while and shuts off. I need to open and close the door several times then it may run for a short while, 15 seconds to a couple minutes and then shut down again. Finally, it will run through the rest of the cycle. The issue generally occurs when the digital timer is between 85 and 78. If I just leave it go once it shuts down it does eventually start up and will complete the washing cycl
It sounds like the door switch is at fault, it will cause the symptoms you stated. ... Dishwashers
My wife opened door during cycle. When she closed door it would no longer run. Looking at problems and recomendations on similar models, I replaced the board. Did not fix the problem. I have checked the fuse and the door switches for continuity and all seem ok. The only lights on the panel that come on are: under cycle- Pots & Pans, Light. Under Options - Heated dry. No other lights work and the dishwasher does not operate.
Hi,\015\012\015\012First off, sorry to hear that you replaced the control board for nothing..in hindsight. So if I understand what you're saying is this, You cannot select any cycles and the unit won't start...because the start button is ... Dishwashers
Working on a Whirlpool dishwasher DU915PWSS0 - The soap dispenser won't open automatically. We have replace the wax motor and have installed a new control board. When you pull up on the draw bar manually the dispenser door opens perfectly. I don't have a schematic and I don't have the test sequence so I can't run the diagnostic test. It's a blind assy process so you can't really tell if you have the draw bar over the wax motor and coupled. I need the schematic and or test sequence for the E
Please confirm if this is the model you have.\015\012\015\012I might have some access to th ... Dishwashers
Door wont close. I checked to be sure nothing is in the way. I have tried running thru the cyles to see if i could un hinge the spring but with no luck. the open button is locked iin the open position.
The door latch is broken and can be replaced. Look up the part on searspartsdirect.com and search that part number on ebay for better prices if available.Eric ... Kenmore 16522 Built-in Dishwasher
Bosch SHX46A (6 years old) Selected regular cycle, pressed On and closed door. Cycle did not start normally. Pump runs, but no water is coming into the DW. I confirmed the water supply line is turned on. I opened door, turned off On/Off switch, then poured water into drain. Then turned On/Off switch on. DW began pumping water OUT of the DW. Also, it doesn't matter if the door is open or closed - if you turn the DW on, the pump will run. I suspect a problem with the electrical controls, or perha
From your description, I doubt that the problem is door latch is the cause.\015\012\015\012The first thing that a modern dishwasher does before it begins to fill with water is run the drain pump. It appears that this DW is not progressing ... Bosch Integra® 500 SHX46A0 Dishwasher
Got a Frigidaire model FDB750RCS0. Now it was running for a couple of min then I hear a clicking sound. Thought it might be something hitting the propeller. I opened the door and nothing. Closed it and now it wont even work. Thought the breaker got tripped but not even that. Now when I had it set back to the cancel part, the Clean Light comes on very dim where as before it use to be bright. Any solutions?
... Frigidaire 24 in. FDB750RC Slim-Line Built-In Dishwasher
Smegsa627x dishwasher running through complete cycles but not heating . element showing correct ohms . active side of tst closed , neutral open , could this be the problem ?
It can be the problem of thermostat. ... Dishwashers
My 501HT has stopped draining. It runs through a couple of cycles until the water inside builds up enough to leak out through the door. I have tested the cam switches #3 and #4 and they are opening and closing as the cam turns. How do I test the drain S/V and how do i know if the pump is reversing?
Hello Dabean\015\012Have you sort out your problem yet if not please email me your problems and I try to sort them out for you my email address [email protected] God Bless hav ... Moyer Diebel 24 in. 501HT Built-in Dishwasher
The drum stopped spinning, but could still hera motor running. The door was locked; could not unlock to open. After several attempts of unplugging/replugging door could be open.
Is this a dishwasher or a washing machine that you have a problem with.\015\012\015\012The drum is usually in a washing machine. The motor you hear running is the drain motor. So this is a normal operation of front loading washing machine ... Dishwashers
My soap cap remains in the closed position at all times. The clasp mechanism works fine, if I cycle through with the door open I can see and hear the catch release when it should. But the door remains closed at all times. I leave it open to run, and sometimes it's closed when the wash cycle finishes! Is there an easy way to take the cap off and clean it? Or do I need to WD-40 around it?
There is a little spring in there that flips the door open, just take the screws off of the side of the door, you'll see the broken spring by the door, make sure power is off to dishwasher ... GE Nautilus 24" Built-in Dishwasher
Whirlpool ADG993, door fault: Hi, a few weeks ago soemthing broke on the door to my diswasher and it falls open wide with no stopping half way as usual. That was fine as the machine could still work, but now the door won't close. All seems fine until you get all but closed and then the door raises slightly from the bottom right corner, preventing it from closing. It looks like something may be jammed in there which pushes the door up at the last minute. There's a man coming out on Friday,
... Whirlpool Dishwashers
Close the Maytag dishwasher, cycle starts, but I noticed a leak! Dishwasher door can be opened by putting your fingers on the edge and pulling it open. Tried it again, door clicked, thought it was ok but still could open door with fingers. Emptied the washer, door locked. Put in a few dishes, same problem
Your problem appear to me like it come from your upper basket .\015\012pleas try 1st to ensure the basket goes inside\015\012untill the end it is important..\015\012 thank you ... GE Dishwashers
I just bought this house with this dishwasher built in. I have pushed the door shut, pressed the heat dry button to lock the door and pressed the start button. Nothing happens. Now I can't even get the lights on front to turn off. The lock button flashes as though the door is open, but its not as far as I can tell. I have to press the latch in to open the door. I'd like to use it... any ideas. Its a Kenmore Elite model # 665 17052 402. Thank You
... Kenmore 24 in. 17052 / 17054 / 17059 Built-in Dishwasher
Frigidaire model F71C12PHS0 is not washing, it goes through the cycle and when the door is opened the soap container is open with soap still in it. We have run it with the door open to see if it is spraying and it is. The heat is working because when we open it at the end of cycle it is hot. Yet soap is still there and dishes are not clean. Thanks to anyone who can help me trouble shoot this.
... Frigidaire 18 in. FDR252RB Built-in Dishwasher
I heard metal drop sound when dish easer door was open in down position. Seems that door does not close same way- it there a spring on door to help close that could have broke? Y I have the kitchen aid - kud102frsso. Thanks
... KitchenAid 24 in. KUDI02FR Built-in Dishwasher
Dishwasher model# FGHD2433KBI. washer was purchesed mid July, used 4 times. I just put in some dirty dish's and closed the door. A couple minutes later the washer turned on. No lights were on. After a few minutes I pushed the cancel button. Nothing happened. I opened the door and it sounded like a sucking sound and the pump stopped. No water in unit. I closed the door it started again. I cut the power at the circut box. Waited a few minutes and turned power back on. Power failure light came on.
... Frigidaire 24 in. PLD2850 Built-in Dishwasher
Kitchenaid model kudso3ctblo, Type 577-0 Ser. FU3202943 When the dishwasher is finished, the soap tablet is still inside the dispenser & the door is still closed. We can open the door by hand & see that the soap has not dissolved. We found a tiny spring on the floor last week. Is there a metal spring in the dispenser? Could this have broken off & now keeps the door from opening?
Myy kitchenaid dishwasher model kudi01flss doesn't start even though the lights on the panel light up so I opened up the door to look at the latch and found a broken plastic piece that appears to be part of the latch. Could this be why the machine doesn't start. The funny this is the door still seems to snap closed even with this broken piece but what I'm thinking is that this piece activates some sort of electrical connection that turns the machine on when the door is closed. Any thoughts on th
... KitchenAid KUDC25CH Dishwasher
Maytag model mdbtt70aww. After the end cycle. open the door and found detergent tab on the bottom and the main wash cover is opened. Maytag diswasher model MDBTT70AWW. Put dishes and so forth in the dishwasher. Put detergent tab and jet-dry rinse agent in the pre-wash section. and close the cover. Start wash cycle after done over door and found the detergent tab on the bottom new the heater. The cover to the main wash is opened. Dishes are are clean. Wish someone would tell me
Model no. MDB6100AWW. Just unloaded the dishwasher. Shut the door and immediately heard clicking (regular cadence). All indicator lights (arrow-shaped) for clean, dry, wash and heating delay were blinking. Opened the door, waited a few minutes, closed the door. Now, just the "Clean" and "6 Hour" arrow indicator lights and "Heated Dry" button light indicator are still blinking continuously. Cannot override. What's going on? Dishwasher came with the house when we purchased it 6 years ago. Proba
Hi Thanks for using FixYa. To resolve this you will have to reset the console. Do this by closing the door and press these buttons in sequence...-high temp wash-heated dry ... Maytag 24 in. MDB6100A Built-in Dishwasher