Having problems with your Caterpillar Cat Pump Pressure Washer Pump 3SP30G11 ?

I have an excel pressure washer 11 hp Honda engine. water is leaking into the cat pump 4hp40gl causing the oil to become milky, after the washer sits overnight the oil clears up. Any and all help will be appreciated. Thanks


Answers :

Repair Help & Product Troubleshooting for Caterpillar Cat Pump Pressure Washer Pump 3SP30G11

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

I have an excel pressure washer 11 hp Honda engine. water is leaking into the cat pump 4hp40gl causing the oil to become milky, after the washer sits overnight the oil clears up. Any and all help will be appreciated. Thanks


... Caterpillar Cat Pump Pressure Washer Pump 3SP30G11

Craftsman Pressure Washer 2.7 GPM 3000 PSI. Stopped working, found no oil, added oil now washer will not start, can't even pull the cord. Help


... Pressure Washers

I borrowed my nieghbors power washer. It worked the first day all day. In the morning i filled the gas with a fuel stabiler, and 30 oil. I may have over filled it. Upon turning it on the oil started leaking from the air filetr compartment. It starts, but then smokes starts to fume and all the oil leaks. Did I break it or is it a easy fix. I cleaned the filter housing. Also the filter was soaked with oil. should i get a new filter and install it or what is the solution. need help.


You will need to get a new filter, and drain some of the oil out of the machine. If you over fill these this will happen. 90% of the time nothing is broken. ... Karcher 2500 PSI Pressure Washer

I have two questions and would greatly appreciate some help: - What oil to use in the pressure pump of a Ryobi Pressure Washer RY80030? - How much to put in? The pump model is MTP092150 from FAIP. As per the manufacturer, the oil is not to be changed or topped up by the end-user, I know, I know, but brought to a service center instead - I certainly don't want to do that, and there is none close to my place anyway. The reason I need this is that I had to take the pump apart and a


... FAIP Non Marking Pressure Washer Hose 4000 Psi, 50ft. Length

What type of oil for Karcher Power Washer 2600? I know nothing about engines, and I do not want to use wrong oil. Help Please.


... Karcher 2500 PSI Pressure Washer

My pressure washer runs 4 about 20-25 min then it starts knocking and pinging then shutsdown it has plenty of oil i checked it and replaced it with 5-20 oil it starts hard always has if you let it sit for about an hour it will start back up sound fine and work good untill it happens again any thoughts to what might be happening to it?


Sounds like the engine is overheating either due to restricted air flow over the cylinder and head assembly, or the engine is running very lean due to a plugged fuel filter, dirty carburetor, or plugged muffler. Hope this helps! ... McCulloch FHH25A Gas Pressure Washer

My AR pressure washer pump is not spraying water out the wand. I noticed on the top oil cap is squirting oil out of the tiny hole. Please help


... Pressure Washers

I have a GE Front load HE washer that is on the manufacture?s pedestal. The machine moves excessively during the cycle and becomes no longer balanced tilting to the right front by as much as 3 inches. I have had three service calls, no solutions, recommendations of a) get rid of the riser, b) I should move it from the main floor (sitting on ceramic tile) to the basement on concrete, c) bolt it to the floor, d) remove ceramic tile and have it sitting on a wood platform. What do you recommend?


... GE 15" Laundry Pedestal for Horizontal Axis Washers and Dryers - White-on-White

I have a Karcher g 2500 vh gas pressure washer and I can't find what oil to use when changing the engine oil. It's not in the owner's manual that I down loaded and I'm not able to find this info on the internet... Can you help?


... Pressure Washers

I have gas in the oil fill and oil coming out of the exhaust of my Ridgid pressure washer. I lent it to my father who isnt mechanical at all so anything could have happened while he was using it. He has since passed away so he cant tell me if he did anything wrong to it. Its a Ridgid with a Subaru SP170 OHC Engine. Any help would be appreciated. Scot


Check to see if the oil is overfilled first.If the oil is at a normal level, the engine was probably overheated or ran low on oil.It is also possible that the machine was tipped over and oil ran into the cylinder. ... Pressure Washers

Dishwasher repair Dear Guru, I hope you are well this evening. I have a Whirlpool Quietwash Plus dishwasher (940 Series) that will randomly have water sitting in after running through a washing cycle. In addition, some mornings there will randomly be a couple inches of water sitting in the bottom without every running the washer. Need assistance. Any help will be appreciated. Thank you for your time. J


Without model unablr to look up exact unit, but in genreral, either ther is a blockage/clog in oyour drain line not alowing complete drain of cycle, as far as never really washing, i would look into perhaps a faulty/ sloppy door switch assembly. if f ... Dishwashers

I'm using a Dewalt 2800 power washer and someone set it on its side. And now it will not start. The air cleaner is full of oil. I think there is oil in the carb. I took the air filter off and almost get it to start. Any help?


Take the air filter off and wash in petrol.allow to dry,and put back on. then take the fuel bowl off and clean.turn fuel tap on and drain fuel from carby for a few seconds.turn fuel tap off.put fuel bowl back on.then take spark plug out and turn moto ... Dewalt 3800 PSI Pressure Washer

I have an Excell VR2500 pressure washer with B & S 6.5 HP engine. It was running fine, but then stalled out and now will not start. Has clean gas and full oil. I pulled the spark plug it is producing a sufficient spark when starter cord is pulled. Any ideas what might be causing the problem? Please help.


The key things to check are the spark plug, the air filter, the fuel. If those are all new and in good shape then you probably have gum in the carburator. Get a can of starter fluid and a helper. One person squirt the starter fluid into the air in ... Briggs & Stratton Pressure Washers

Troy built 2350 psi 2.0 gpm. pressure washer. starts onne then dies. will not start again. has briggs and straton motor. has been sitting up for the winter. have changed spark pulg. checked air filter that is clean, has oil and gas.


... Pressure Washers

I change oil on my 3700 psi honda motor pressure washer motor and pump and after i done that the tigger rope is to hard to pull looks like some who is pressure some where can some one help me whit this problem .. thank you


Most likely has nothing to do with oil change. Have someone hold the trigger on handle open to relieve pressure on system/pump , this will make engine turn easier when you pull rope. ... Karcher 2500 PSI Pressure Washer

My Kenmore 13743 is 3 years old and was washing perfectly until a couple of months ago. It has become so bad that it won't clean anything on the top rack and barely anything on the bottom rack. In fact, I just pulled a butter knife out of the rack that still had butter on it! Not normal... I do not know how to remove the bottom washer arm to get at the chopper, filter, etc. Please help


Hello,\015\012\015\012Welcome to FixYa,\015\012\015\012You are likely right on, this is very common with these unfortunately. Hopefully this will help.\015\012\015\012**Unplug the unit or turn off the powe ... Kenmore 13743 Staimless Steel Built-in Dishwasher

Oil milky white in pump - Honda Pressure Washer PSI 3000


It may have a slow water leak inside the pump.\012change oil and monitor the new oil.\012if it goes milky the next time you use it then it has a bad leak and the seals will need to be\012replaced,otherwise the bearings will rust &am ... Honda Pressure Washer PSI 3000

Husky Model HU80833 Pressure Washer. Just took it out of the box, starts right up runs about 1-2 minutes washing then dies. I checked the oil, and made sure it has fresh gas. Help


Send it back under warranty ... Pressure Washers

Gas is leaking into the oil tank on a craftsman pressure washer. it will do this while it is running or sitting in storeage. it has a briggs and stratton intek engine.


... Karcher 2500 PSI Pressure Washer

I have a 7 hp B&G craftsman Pressure washer , if I place an air filter on it ,it wound't start or run , if I remove the air filter it would run like a champ, but after 10 mints , oil would shoot out off the carb like a running faucet , why is it not running with the filter on,.Now am not so sure if the air filter is the correct size , because when I put it on it seem to be a bit on the taller size rather than a perfect fit, thanks for your help , in Hollywood , Reinaldo Roman .


First,It sounds like the air filter is full of dirt preventing air from flowing through, starving the engine of air.As for the oil shooting through, are you certain the oil is coming from teh carb?. Makes no sense the engine w ... Briggs & Stratton Pressure Washer Projectpro Spray Nozzle

Wont start I have a North Star pressure washer that has been in storage for three years.It has the Honda motor GX 160 5.5 I put in new gas changed the oil, air filter,and spark plug.But it wont kick over. Im not sure how to work the levers upon starting it.Theres one for gas, choke,idle,and of course an on switch.Please help


Tip a cap full of fuel in top of the carb to start intitially, check for spark as common fault is on/off switch, If no spark, link the 2 wires on on/off switch together. ... Pressure Washers

New pressure washer runs starts and runs for 30-45 minutes with no problems then dies and will not restart. Once it cools for a few minutes it will restart but will die again quickly. If it is allowed to sit for 30+ minutes it will run for another half hour but then dies again. Changed oil, gas, checked all obvious areas. Any suggestions?


Try removing the carb bowl and check for dirt/water etc , also if the machine is over heating it may be getting vapour locked ... Honda Pressure Washer PSI 3000

The oil in my gc160 Honda pressure washer is getting water in it some how. Could it be something with the water pump gasket or what? And I can get it started but can't keep it running un less I keep spraying starter fluid in the carbar. Please help ?


... Karcher 2500 PSI Pressure Washer

Troy Bilt pressure washer model 020209 will not build pressure-have checked all screens and intake in pressure hose and garden hose from house to pump. water leaks at gun handle- took it apart and oiled piston- was ''grabby'' but now snappy but still leaks. Engine starts fine and runs fine. Please help.


A leaking gun will kill all the pressure. You may need to repair or replace the gun ... Briggs & Stratton Pressure Washers

Got a Dewalt 3800 PSI Pressure Washer with 4.0 GPM with a Honda GX 390 gas engine. Tipped it up to roll it out to my truck and got a big puddle of water with what looked like Pump oil in the puddle. Can you help???? It is less than a year old with 10-15 hours on it.....


Could very well be. Did you check the oil level and condition of oil? If its too full or if its light brown milky, then water has entered crankcase. Pressure washer pumps cannot stand to ever let run dry. Even a little. Also excessive idling will ov ... Dewalt 3800 PSI Pressure Washer
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.1277 seconds