Having problems with your Champion 26 in. D-HBC Free-Standing Dishwasher ?

Cant keep proper water pressure

\015 Pressure runs 13pounds sometimes motor runs slow i have to turn washer off then back on to rebuid pressure\015

Answers :

Repair Help & Product Troubleshooting for Champion 26 in. D-HBC Free-Standing Dishwasher

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Cant keep proper water pressure


... Champion 26 in. D-HBC Free-Standing Dishwasher

I have a Bosch SHE55C05UC dishwasher and it just started to not wash properly and leave water in the pan below (first time it did not drain at all.. I tried the rinse/hold cycle and got the unit to drain and tried again and it is not working properly and keeps water in the pan. I am on a well and have great water pressure about 70 psi.


I am assuming you have checked the filter and drain sump and there are no obstructions. Have you tried taking the drain pipe out of the sink downpipe and checking if it drains directly into the sink?\015\012\015\012I am also assuming the ... Bosch SHE55C05UC Dishwasher

North star petrol pressure washer. working fine, then no high pressure, checked water feed, water filter , pressure relief valve and gun nosall well work sometimes and keep working, when you release the trigger and try in again the pressure gone again. please help, many thanks, richard


Sounds like the regulator is sticking or is airbound. loosen the water connection and then tighten it back. Could also be that the trigger gun is faulty or needs adjustment. Hope this helped ... Karcher 2500 PSI Pressure Washer

Hi, I have a 3 year old Nemo F&P dishwasher which turns itself on and off for about 3 seconds each on/off continually.Eventually it does get enough water to wash but never goes into the wash cycle properly, ie the water just sits at the bottom. We dont think it's water pressure and it was working fine until recently.Could it be an electrical problem with the signal to fill properly not getting through? Thanks


Hi\015\012\015\012 \015\012\015\012 \015\012\015\012Thanks for using FixYa. If the cycle doesn't\015\012complete, then the first thing ... Fisher and Paykel Dishwashers

Have a LG model LD-14AW2 dishwasher which has done good service for many years However, it now sems not to have enough water pressure to operate all the rotary sprayers at the one time - thereby not cleaning properly Have purchased a manual and raken the whole machine apart looking for a partial blockage of the water ways - non found - all looks perfect - still no water pressure I would suspect the pump - however, would have thought a pump either gave full service or stopped - not parti


Hi The issue seems to be with the float switch assembly that is bad and should be replaced. Float assembly is found inside the dishwasher's tub, on the bottom. The water that ... Dishwashers

I am having trouble attaching 90 degree brass elbow to the plastic water inlet on my new Maytag Dishwasher. Getting leaks. Teflon tape hasn't worked. Cant seem to get the washer to seat properly when everything is tightened down. Wish the water inlet was not made of plastic. It appears it would seat the gasket properly if the water inlet was made of something more durable.


Hi!!\015\012\015\012Have you tried pipe cement, the plastic to metal kind will take care of any leaks. You can find it at any hardware store.\015\012\015\012Good luck! A HELPFUL - 4 THUMBS - rating for this solution would be greatly app ... Maytag MDB8959AWS Builtin Dishwasher

The oil in my gc160 Honda pressure washer is getting water in it some how. Could it be something with the water pump gasket or what? And I can get it started but can't keep it running un less I keep spraying starter fluid in the carbar. Please help ?


... Karcher 2500 PSI Pressure Washer

I just bought a used Kenmore standalone dishwasher and ran it for the first time. The dishes on the top did not get clean and the soap did not come out of the closed soup dish. at one point I took a shower and was wondering if that might have influenced the water pressure enough to cause the problem. Is the soap supposed to open during the wash and could the poor water pressure prevent the top shelf from getting properly washed?


The inlet filter is probably clogged. Try letting it fill up. Open the door to stop it right after it starts to wash Pour a gallon or two of hot water in and see it it works better Stop and do this everytime it goes to fill up. If the door opens ... Dishwashers

Hi have a Karcher 6.91 and I cant get any high water pressure. It has power, I have checked the o-rings, filter and lances but it does not build up high pressure. The water also appears to flow back


... Pressure Washers

Hi have a Karcher 6.91 and I cant get any high water pressure. It has power, I have checked the o-rings, filter and lances but it does not build up high pressure. The water also appears to flow back


... Karcher Pressure Washers

Dishes and glass ware are covered with a light film when done. This problem just started. It appears that there is soap residue left on the contents of the dishwasher. The dishwasher is cycling properly and it sounds as if the water is being pumped and circulated properly and with adequate pressure. All of the water is evacuated between cycles.


Hi,The scum, film and white\012residue problems have started since the reduction of\012phosphates in dishwasher detergents.Here is a tip that\012will help you to solve the problem of films, residue, and scu ... Maytag 24 in. MDB3700 Built-in Dishwasher

Model 01902 2350 psi . engine runs fine , sprays out nozzle but lower pressure and water sprays out plastic elbow on relief valve , that is supose to **** in soap if used , cant hold finger over spray from elbow , high pressure , took apart relief valve and plastic valves all orings are ok , brass pump seals look ok , all back together , still blows out elbow . ?? plastic spools were out by somebody else , not sure if they are in right , cant find picture to compare .


It sounds as if the non return valve in the elbow is the wrong way around .The o-ring normally goes in first then the ball then the spring. Try it and good luck. ... Pressure Washers

Not cleaning There seems to be a lack of water pressure although the pump seems to work properly. I ahve cleaned the screens. Whem i remove the sprayer arm etc, there seems to plenty of water pressure.


Check spray arm jet holes. Clean the clogging with blower or soft bristles. ... KitchenAid 24 in. KUDI02IR Built-in Dishwasher

I have a Briggs & Stratton gas power washer. This is the 1st time this year that I have used it. I put in fresh gas, hooked up the water supply. The engine started and then quickly stopped. I had to release the water pressure in the hose before I could pull start the engine. The only way to keep the engine running is to hold down the spray nozzle trigger. Once that is released the pressure in the hose builds up and the engine stops.


Sounds like the unloader is not working correctly. Try replacing it and see what happens. ... Briggs & Stratton Prosumer 20324 Gas Pressure Washer

Asko model 1503 upper spray arm is not cleaning dishes properly ,have cleaned spray holes makes no difference it seems that not enough water is there to wash properly have adjusted water pressure to 80 seconds but still no good any suggestions


... Dishwashers

I have a brand new Miele dishwasher which has worked grate since it was installed 2 weeks ago. It keeps shutting itself off & indicates an F13 fault. I looked in the manual, see that water is going in fine & pressure is good. It then says to clean water intake filter. How do I get to that ? I don't have a user maintenance manual. I'm on city water & doubt that the filter is clogged but My wife will kill me if I don't get it fixed today. Can anyone help. Glenn


On my Miele 1220 dishwasher, the inlet filter is inside the inlet hose connector, where it screws onto the water supply. To clean it:\015\012\015\0121. Turn off the stopcock.\015\0122. Unscrew the inlet hose.\015\0123. Remove the black rubber s ... Dishwashers

I have a Miele Dishwasher 2430 Sci. It's been not used for 5 months and when I returned it worked fine for several times (at least 6). NOW the intake/drain light keeps blinking. I have already cleaned out the drain and replaced it properly (there was nothing in there and it was clean). No water is coming into the dishwasher?however I know that the water hook-up is on (the first thing I checked). I turned the water on and off several times and AM SURE it's on now. What else could be


The usual course of events is to check and clean the filter, check and clean the water pump and well, check and clean the waste pipe and any connection to a sink or waste disposal system, then check the inlet warer pressure, then the machine level / ... Miele G2430SCi Dishwasher

I bought a new kelvinator diswasher kd12mm1 - will not start, and shows E1 error. No water? but the connections are all done properly and the water is open. My previous machine had no problem with water pressure. I do not have salt yet... can that be the cause for the machine not starting? Please help


... Kelvinator Dishwashers

I have a kitchen aid dishwasher. The upper spray arm is getting water and getting enough water pressure but wont seem to spin. Ive ran a lot of tests but nothing. ive cleaned out the spray arm and port that gets water to the spray arm. Cant seem to fix it. Any ideas?


Hi,When my wife started complaining about her dishwasher not getting the top rack clean this is what I found and I wrote a tip about it...Dishwasher Spray Arms not Spinning ... KitchenAid 24 in. KUDI02IRBS Stainless Steel Built-in Dishwasher

Water is leaking from inside the pump and i see no damaged plastic from the outside.the motor keeps on even after i release the pressure gun and most of all ther is no or less pressure when i trigger the pressure gun.please can you suggest what parts do i have to change for it to be fixed 10x


Hello. The internal seals need to be replaced. Obtain the Karcher rebuild kit I got from pressureparts.com\015\012 \015\012J. ... Karcher Quick Connect Nozzle Set

Karcher pressure washer keeps running when water stops


... Karcher 1750 psi Electric Pressure Washer

I have a union power petrol pressure washer up1-50 I am having problems with a fine spray of water coming from the 1st brass screw on the end of the pump and keep loosing pressure


I have the same hair line crack so water pushes out the top. Can the part just be replaced ? ... Pressure Washers

Starts but does not keep running. checked oil & its full. do you need water pressure at the pump? I know it has a low oil pressure cut off.


First: check and change the spark plug and do a oil change (OIL IS NOT THE PROBLEM BUT IS GOOD TO DO IT) then do a test with fresh gasoline.\012Second:check all fuel components (LINES,CARB,ETC...)\012Third:if any of this fix the problem ... Dewalt DPD3100 Gas Pressure Washer

The motor keeps cycling on and off (about twice every second) when the pressure trigger is not operated. The unit seems to supply plenty of water pressure when trigger is operated.


The motor is holding pressure in the line.Check the manual. I don't think it is supposed to cycle that much.If it's not designed to do that, then there is a seal or a bearing that is leaking.It's letting water pressure escape ... Karcher K2.26 Electric Power Washer

501ht goes thru wash cycle but cam stops just before rinse cycle clicks in - stays in wash cycle - turned thermostat to booster down in temp -cam then keeps going properly but with no hot water from booster - replaced thermosat still same result - apparently a safety ? no booster water no rinse?


Did you get a solution for this? I am having the same issue. Please email me at [email protected] Thanks -Eric ... Moyer Diebel 24 in. 501HT Built-in Dishwasher
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.1526 seconds