Having problems with your Champion International Pressure Washers ?

My CPW 2000 will not work! it switches on but no pressure, it has been in the shed all winter!


Answers :

Repair Help & Product Troubleshooting for Champion International Pressure Washers

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

My CPW 2000 will not work! it switches on but no pressure, it has been in the shed all winter!


... Champion International Pressure Washers

I have a Karcher G2600 OR Pressure Washer, 2600 psi, 2.5 gpm. PN 1.194 506 0. gas engine works fine and water flows fine but pump is not adding pressure to stream. Checked and cleaned inlet water filter.


... Pressure Washers

I have an electric pressure washer, K 3.69 M. Water seems to spray out a plastic body when i pull the trigger and has no pressure. I believe water was in it and sat out all winter in a cold shed.


... Karcher Pressure Washers

What do I have to do to winterize my pressure washer? It will be in an unheated shed all winter.


If you are storing in a cold place (below freezing) you should run automotive antifreeze through the machine mixed at a 50/50 solution with water. You will run it through until it comes out of your hose. By doing this you will prevent water left in ... Northstar Pressure Washer 2800 PSI

I have a mi-t-m pressure washer in the ca-series.The problem is the motor shuts down at times with out any reason. The first time I used it was on a house with a well supplied water. It worked fine,brought it home where I used it with no problem. It was used twice that first year. I then winterized it.The second year brought it out to the same house,I was using it for about a half hour when it just shut off with out any notice. I noticed there was back pressure in the engine when I tried to rest


Mi-t-m pressure washers have a Low Oil shutdown feature that turns off the motor, this is often causing similar problems on this kind of appliance.Have oil checked, if oil is fine , then the sensor that controls oil pressure and activate ... Pressure Washers

I have a RAC 1850 watt high pressure washer and it wouldnt start. it has been in the shed all winter


... Pressure Washers

I left my electric karcher pressure washer it in the shed during the winter and they tell me that the housing and the safety valve need replacing. Can I repair it myself? They want 180.00 to fix it which is the price of the washer. Thanks


This needs new piston housing cover the existing one will have a crack in it. ... Karcher PSI Electric Pressure Washer

Hi, I have a Dewalt pressure washer 3100 psi. I want to know why the pressure washer works okay for 1 hour then it stop working completely. the oil is fine, the spark plugs are okay, and when I tried to start it again it does not work. Can you please tell me what could be the problem? This pressure washer is almost brand new I have used it for only like 30 hours for 2 years that I have it. I used it couple times lately but same problem it works for 1 hour then it does not work any. I will


There are two common issues that will cause what you are describing. What you need to do is run the machine until it dies as you are describing. Then pull the spark plug and check for spark. If you do not have spark you have a failing stater. It is v ... Dewalt DPH3100 Gas Pressure Washer

North star petrol pressure washer. working fine, then no high pressure, checked water feed, water filter , pressure relief valve and gun nosall well work sometimes and keep working, when you release the trigger and try in again the pressure gone again. please help, many thanks, richard


Sounds like the regulator is sticking or is airbound. loosen the water connection and then tighten it back. Could also be that the trigger gun is faulty or needs adjustment. Hope this helped ... Karcher 2500 PSI Pressure Washer

Husky Model HU80833 pressure washer was working, then no pressure. What is wrong? Unit is over two years old. Had been working properly earlier in day. While trying to finish job, it lost pressure and nothing would make it get back up to pressure. Also tried it again later, same result


... Honda Pressure Washers

Kranzle 160t pressure washer works but full pressure drops off I then release the pressure trigger for a while and it will work at full pressure again for half a minute.


... Pressure Washers

No high pressure. has been a consistant problem for a while. Was able to get high pressure to "kick-in" before by removing nozzle, squeezing trigger to "prime" high pressure, then quickly put nozzle back in then it would work. now it doesn't work at all.


See this link to fix the problem ... Honda Karcher G2400HH-R Pressure Washer

Sears Power Washer Model 580-767300 works great but loss of pressure ocurs after a few minutes or working. If you wait and work the pressure gun it will come back for a while


... Pressure Washers

I have a KARCHER Model K 2401 which onstart up has normal water pressure rather than the high. I can usually get it to work by removing the tip, pressing the trigger and running some water through without the tip on. The i replace tip and it will usually retain the high pressure. If I stop depressing the trigger I have to go through these same steps. It is like it loses prime. It works well once I get it started putting out the high pressure.


... Karcher 2500 PSI Pressure Washer

I have an older Landa Pressure Washer. The burner is not working. Once I get the machine running and water flowing to the pressure washer, with the wand pressed, I flip the burner on switch....and nothing...I have no idea how to work on a pressure washer burner. I have been told it could be the igniter, but I don't know how to fix it if it is. Any help is appreciated.


Check for 12V at the igniter connector with the unit running. If you have 12V and no igniter it may be stuck or bad. Thrun the unit off and read continuity across the DISCONNECTED igniter plug / terminals to the igniter. No resistance = open ignit ... Pressure Washers

Karcher 620m wont work at high pressure


... Karcher Pressure Washers

Pressure gun will not work, you have to disconnect the pressure hose, reconnect it, then it will work as long as you do not release the handle, if you do, you have to start that whole disconnect, reconnect process over again. It wastes time and we will not even mention the aggravation! What do we need to do?


Find a service centre or Local pressure washer co. Get the gun serviced ... Karcher K 2.25 R Electric Pressure Washer

Previous wash cycle worked perfectly. Next morning , dished not washed. Water pressure is insufficient to spray. Checked sprayers and clean. Removed bottom sprayer arm and tested. Water flows barely. Water fills but pressure insufficient to spray. Actually 'bursts' slightly on shutoff. All other functions work perfectly.


... Kenmore 16872 Built-in Dishwasher

My karcher hds 745 is running but just won't build up pressure, this occurred after a really cold few weeks this winter and I hadn't put anti-freeze through the machine to winterize it. There's no water coming from the bottom of the machine when it's running as i've read that if the pump seals are faulty water will escape from the pump etc. The machine motor runs ok but no pressure is acheived on the gauge whatsoever. Any help would be appreciated. Thanks in advance Paul.


... Karcher Pressure Washers

At the beginning the pressure washer was running but there was no power from the nozzle. I stop the gun trigger, remove the nozzle , it works for 1 minute and stop working again Now the washher pressure turns off on its own after 1 minute or less Honda 2400 psi


See attached link:\015\012http://www.wmpcs.com/index.php?main_page=page&id=14\015\012\015\012If you continue to have the problem you m ... Honda Karcher G2400HH-R Pressure Washer

Ryobi Watergun 5000 extra pressure cleaner. On/off switvh and pressure gauge not working, although machine still works. Can't find a reapir agent on Gold Coast


... Pressure Washers

I just got a refurbished pressure washer and after a week of it working i went to use it today and it works there is just no pressure from the knozzle can u help ?


Im not sure you have replaced on the mechine and you say it worked for a weak so it sounds like a new problem . But i owen a few powerwashers and wash houses as part of my bussiness. The most likely things that will stop the pressure are eighter the ... Pressure Washers

Karcher B402 pressure washer Motor runs as soon as power supply connected, on/off switch does not seem to make a difference and no pressure at outlet? Was working fine, stopped for half an hour, came back and wouldn't work. Thanks Bob


Bob I had this happen to my Karcher, the pressure seals have blown. $Au200 for service and replacement from karcher dealer. tyhey would not sell the parts for a DFY ... Pressure Washers

When the patio cleaner is attached,the Karcher 5.68 pressure washer now keeps stopping and starting.It works fine on high pressure lance.It worked fine when bought from new a few days ago. We tried attaching the patio cleaner head to a larger machine with the same results.


... Karcher Pressure Washers

I have a bosch 110 plus pressure washer the problem i have is i turn on washer squeeze trigger and works fine when i release trigger and press again it wont work and trigger seems to have pressure on it


... Bosch AQUATAK 110 Pressure Washer
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.1069 seconds