Having problems with your Cma Dishmachines CMA-180UC Dishwasher ?

Does this particular model use a pumped waste discharge or is it gravity for discharge


Answers :

Repair Help & Product Troubleshooting for Cma Dishmachines CMA-180UC Dishwasher

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Does this particular model use a pumped waste discharge or is it gravity for discharge


... Cma Dishmachines CMA-180UC Dishwasher

Have a NEW 3 weeks old dishwasher model no SMS69L12GB. Almost a pint of clouded water being retained in waste water pump area all the time after use. CHECKED area and it is spotlesss and no bkockag or kink in waste water hoseor no "E's being displayed on panel. Dont like the idea of stagnant water being in the DW. looking forward to hearing from you asap Annabeth


... Bosch Dishwashers

I have the two drawer model dish-drawer system. In the past the top seal leaked and since has been replaced with a new seal. Worked well for several years after but then the top drawer quit running. So we started to use the bottom drawer. That was fine for awhile althought it would pump waste water into the top drawer. Now neither drawer will work. The bottom drawer starts up and shuts down. I pulled the lower drawer and it is dry.


If your model has got an LCD display are you able to record what shows up on the display when the bottom drawer shuts down. If no display then are you able to note down the LEDs which are on inside the top of the drawer lid. It is likely there is no ... Fisher and Paykel 23 in. DD-603SS Built-in Dishwasher

We have and older Jackson model 10 AB at church, used 10 to 20 times per year. The pump motor quit this summer and was replaced by a local appliance service company. About $700 job. Upon using it recently, the first time since the new pump was installed, the RINSE cycle seems very anemic, that is, low volume and low spin rate. The dishes were not completely rinsed. Temperature was correct, 185 degrees. The service person came back to look with no improvement and now the Heaters will not co


Sounds like a wiring problem but it is controled by a thermo to make sure you get to the proper tempt . so ck the connections and mke sure the thermo is good . . and the element is good . ..hope this helps mm . ... Jackson 10A Free-standing Dishwasher

Troy-Bilt 2550 20293 pressure washer not producing pressure. Worked when last used 2 months ago. Pump pistons are moving up and down when engine is pulled through. Inlet water is flowing through pump but no pressure when engine is started. I have the same problem. Water flows thru the pump when not running, but no flow or goes in by-pass mode when I start the pump. The pump being Troy Bilt Model 020296-01. I replaced unloader valve even. Anything else I can do?


You replaced the unloaded valve. Are you positive you have the unloader screwed to pressure and not turned the opposite way? You will have no pressure if it is adjusted wrong. One other thing I have encountered is that the unloader has a ball bearing ... Pressure Washers

We recently purchased a new pump for our frigidaire gld4355rf dishwasher. The old one started making grinding noises. When we moved the dishwasher it had leaked due to a failure of an interior seal. Our new pump is now making the same grinding noise but it is not constant. When my husband adjusted the pump by using his hand when he got into a certain position the noise stops. We keep the screens clean. Is there an issue with the pump in this model?


... Frigidaire GLD4355RF Dishwasher

KUDK01ILBS5), SN: FR2702809. Have used this machine 6 years and just recently experienced noise that I eventually traced down to a bad recirculation pump bearing that failed due to a small leak in the shaft seal. Installed a new pump on Friday, 4/21/10 and that particular noise is now quieted. While the bearing noise was gone, there remains a pumped water noise that is quieted by manually adding about 1/2 gallon of water within the machine. So I now believe the water level is low, possib


The water level in the machine should be slightly under the heat element. The float you refer to is only for overfill and should not be activated if the machine is filling properly (the water level should be lower than the float switch activation poi ... Dishwashers

I have an 18 Inch dishwasher, model #FDR251RJSO. Lately it does not rinse all of the dishes evenly. In particular the stainless, but also some of the glassware comes out filmy and cloudy as if the detergent did not rinse off properly. The detergent I use is Cascade Advanced Power. I have thouroughly cleaned the inside removing any collected debri. I have given the machine a vinegar bath twice, as well as a commercial cleaning product wash. I tried using liquid rinse, which hasn't been used for a


Hi Maggie and welcome to FixYa, I am Kelly \015\012 The dishes being cloudy and spotty stainless is a symptom of believe it or not in most cases a drain restriction external to the dishwasher. The drain is most lik ... Frigidaire Dishwashers

My tappan dishwasher is only 1 1/2 yr old and its not getting at least 1/2 of dishes clean. We have tried everything from changing to liquid soap, increasing water pressure at meter, not using while washing clothes. We used a dishwasher cleaner to remove calcium, and run hot water in sink before using. We know the wand, pump and drain are working. It is model TDB210RFB5 with 1.1A motor. Is the motor too small to clean dishes? I wish I could get my money back or exchange for an upgrade. Thanks!


... Electrolux Dishwashers

Our GE model GSD4320Z00B is having a problem with the drain system. I've run the unit in the test mode and it does pump the dishwasher down. The problem is the unit does NOT pump down during a normal wash cycle. The fact that the unit works in test tells me it is not the pump. I've checked all the hoses and drain paths and there are no obstructions, again verified by the fact it works in test mode. Any test that can be used to determine the problem besides replacing parts one by one?


... GE 24 in. GSD4320Z Built-in Dishwasher

I have two questions and would greatly appreciate some help: - What oil to use in the pressure pump of a Ryobi Pressure Washer RY80030? - How much to put in? The pump model is MTP092150 from FAIP. As per the manufacturer, the oil is not to be changed or topped up by the end-user, I know, I know, but brought to a service center instead - I certainly don't want to do that, and there is none close to my place anyway. The reason I need this is that I had to take the pump apart and a


... FAIP Non Marking Pressure Washer Hose 4000 Psi, 50ft. Length

Looking for info on our churches dishwasher - Toledo Kitchen Machines. Model # TDA27. I can describe it as a single cycle dishwasher. Wondering what type of detergent to use and if there is a manual available. There is a small seal leak between the motor and the pump, other than that everything works. ( this has not been used in 10+ years).I am now in charge of bldg maintenance and am trying to get everything in working order. Any help is appreciated. I am guessing the circa is mid to late 60's


Dishwasher Repair Guide: How To Fix a Dishwasher - ACME HOW TO.com\015\012\015\012\015\012\015\012 ... Dishwashers

My asko dishwasher model 1595 flashers a f-2 code. I checked for a cloged drain. used my shop vac to empty the water in the drip pan then restarted the dishwasher.The pump came on and it continued to fill and pump until went into f-2 again. What is going on?????????


F2\015\012\015\012High water level\015\012\015\012· Plugged/Bad water pump· Defective water inlet valve\015\012\015\012also check that the float switch is not stuck in the up position...\015\012\015 ... Asko 1595 Dishwasher

Model SHU33AO2UC /40 The top rack leaves lots of residue and stuff on glasses. We had a repairman out, he cleaned out the pump intake, and we are careful to clean everything before putting it in the dishwasher. I have made sure all holes in the spinners are clean and don't crowd the glasses. We have also tried different detergents. The dishwasher is 4 yrs old and is used daily. We also use jet dry.


... Bosch Dishwashers

Model #MDB7130AWB Stops mid wash cycle at roughly 60-65 min left, water will not pump out. It sounds like it is about to pump out but doesn't and keeps doing this repeatedly. Using the 8 minute rinse cycle, it drains with no problem...any ideas?


... Maytag MDB7130 Dishwasher

I have a Zanussi dishwasher model DA 6141. For some time now it has not been completely discharging the water at the end of a cycle. But sometime it does completely dicharge.Two days ago it started leaking water from its bottom at the end of a cycle.I tried to locate the leak but was unsucessfuly. All the external plumbing is ok andf there is no leak from the discharge pipe nor water intake pipe. So perhaps its something to do with the water pump?


Hello David,\015\012\015\012Have you removed and cleaned both filters and checked they are inserted correctly? I've uploaded the filter cleaning instructions to Flickr for you:\015\012\015\012 ... Zanussi Dishwashers

Kenmore Dishwasher model # 587 141 4400 doen't seem to be pumping and the wast pump isen't working either


... Kenmore 15899 Built-in Dishwasher

Pump broken and leaking thru crack, looking for used pump for this model


... Pressure Washers

Re: Creaftsman 2700 psi washer, model 580.752100 - I cannot use the detergent cleaning tank. The pump forces water into the tank, and it overflows onto the ground. If I try using the washer with the detergent shut-off value in the off position, the water pressue forces the valve completely out of the housing. Is there a simply fix for this or time for a $ervice call? sw


... Craftsman 2700 Max Psi Pressure Washer 23 Max Gpm

Honda 11 hp, model GX340, Cat pump model 5DX40GL; Low on hydrolic oil need to know what type of hydrolic oil to use.


... Honda Pressure Washer PSI 3000

Hi I have a Troy-Bilt Pressure washer 2200 psi model 20292. I've used it only 4 or 5 times. It ran great for an hour today then it lost pressure. Seems like the pump is not working. The engine runs fine but no pressure. The water runs through the nozzel and I blew air in the lines to make sure there is no blockage and found no blockage even in the pump lines. Any ideas. Tom


... Briggs & Stratton Gas Pressure Washer 20244

We have a Frigidaire dishwasher model #FDB634RF bought new. It was used for a not very long period of time but developed problems due to well water with high lime content. now with good cleaning products available it is ready for use again. The problem is the top spray arm that refuses to rotate. I have taken the arm out and thoroughly cleaned it of deposits checked the supply line from the pump and checked the sump for any obstruction. The arm turns freely by hand but water just pours out the


Hi, \012I have an older dishwasher also and recently mywife also complained about it not cleaning right... so me being the man I amtried in vain to clean the things... Bought new spray arms online and installedthem in minutes...now the thing works li ... Frigidaire 24 in. FDB635RF Built-in Dishwasher

I have a model 5000g. it might have 15 hrs. total running time on it. when i tried to use it last it would not build pressure. i took the pump apart and cleaned and regreased it. everything looked good. ive got good pressure to the pump but just a small spray out the wand. when running there is no real load on the engine. it has always been kept inside in a warm enviorment.


... Karcher Pressure Washers

Hi, When I turn on my dishwasher, it fills as normal with water but is not pumping into the upper spray arm. the spray arms are not clogged, I have checked them. Anyway, I always rinse the dishes under the tap before placing them in the dishwasher. I have to switch the machine on/off several times then the pump starts at full force.Occasionally it goes through a complete cycle without havig to switch on/off. It's a Siemens Lady model, E-NR SN53300GB/08, FD 7201 058479. The dishwasher is used


... Dishwashers

I have a dewalt model 67DX39G1l. Used it fine for a couple of years.Went to used it the other day and the water hose leading to it was getting so hot that it melted it.Found ot the pump gets scolding hot only after you release the trigger.As long as the trigger is pulled it works fine.If anybody can help me with this problem,please let me know.


... Dewalt Pressure Washers
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.1336 seconds