Having problems with your Coleman Pressure Washers ?

My father just got a Coleman Mach II Pressure washer. It is powered by a honda horizontal shaft engine. I was wondering if any info was available about it


Answers :

Repair Help & Product Troubleshooting for Coleman Pressure Washers

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

My father just got a Coleman Mach II Pressure washer. It is powered by a honda horizontal shaft engine. I was wondering if any info was available about it


... Coleman Pressure Washers

Rebuilt honda GC160 5hp engine for a power washer and only got the engine to start once. Just took apart and saw that the cylinder and piston was all scored up again.


... Honda Pressure Washers

What kind of oil in honda 11hp gxv 340 - Honda 11 hp Engine GX340 OHV Horizontal Shaft


... Honda 11 hp Engine GX340 OHV Horizontal Shaft

My Troy Built 2500 psi power washer with Honda engine GCV has been stored for 2 years. I changed the gas and could not get it to start. Which is the start position for the valve on the gas line - Horizontal or Vertical? Thanks, Bill Gray Melbourne Beach FL


... Pressure Washers

I have a keihin carb on a honda engine, used on a power washer, that only runs with choke fully engaged. I have taken the carb apart and cleaned it thoroughly to no avail. the part # on the carb can't be found online. I don't know enough about carbs, theory of operation, to continue and can't find a technical ref for the keiwin being used, any suggestions as the only # on the carb yeilds no hit on the web. # stamped on carb is 65bbkf7


... Honda Pressure Washers

I got a devilbiss power washer 2400psi wvrh2421 2.1gpm 5.5 honda engine its not getting gas and where the position for to turn on the gas


... Pressure Washers

The dishwasher only makes the loud rumbling noise during the initial wash cycle, not during the cycle when it is pumping water out of the dishwasher and into the drain. I found some dental floss wrapped around the blade shaft when I cleaned the area out. The noise is now less but it is still there. I am wondering if the blade got twisted or the shaft got bent.


... Maytag 24 in. MDB9750AW Dishwasher

I have a Honda GC160 motor on a powerwasher. The engine stalls when I release the power wand handle, but if i keep the handle squeezed, it works but the engine sounds like it is laboring.


... Honda Pressure Washers

Honda gc190 Engine starts fine but when I try to wash the governor will not apply any power. I can over ride by pressing governor manually and lots of pressure. Wy would the engine governor be restricting engine RPMs.


... Pressure Washers

I have a Honda ,gas powered power washer and when I squeeze the handle the water pump kills the motor. I've let the engine run until warm and it still can't take the water pump engaging. It's a three year old washer.


... Pressure Washers

Have a Power washer with Honda 390X engine. Engine intermittently stops and has to be manually restarted. It only stopped once in 10 hours yesterday, but already several times today.


... Honda Pressure Washers

My pump is gone on my pressure washer. The honda engine is GC 160. The pump is a model VRX2527G. How do I pull the pump off the engine to replace it. I removed the four bolts from the pump housing, but the pump is still tight to the shaft. Please explain the removal process.


Hello,Your pump sits on a keyed shaft, versus a taper fit. This is good, since tapered shafts will require a puller to remove the pump.Since the pump is already bad, you have a few options available to you. 1) W ... Honda Pressure Washers

Dead dishwasher? I have an Prima LXP600 dishwasher that doesn't work - no power light, no beeps, no anything. I've changed the fuse and used different power sockets. Is there anything that I can investigate, or alternatively is it likely to worth calling an engineer? The machine looks almost unused (was in a repossessed house that I bought, so no history), so I'd like to think that it's got some life left in it!


Please find some help from the link below;\012\012\012http://www.repairclinic.com/Dishwasher-Repair-Help ... Dishwashers

Got a Dewalt 3800 PSI Pressure Washer with 4.0 GPM with a Honda GX 390 gas engine. Tipped it up to roll it out to my truck and got a big puddle of water with what looked like Pump oil in the puddle. Can you help???? It is less than a year old with 10-15 hours on it.....


Could very well be. Did you check the oil level and condition of oil? If its too full or if its light brown milky, then water has entered crankcase. Pressure washer pumps cannot stand to ever let run dry. Even a little. Also excessive idling will ov ... Dewalt 3800 PSI Pressure Washer

What does the F2 Error mean? I got that error thsi morning. The engine was buzzing so I turned the power off. I have cleared what appears to be calcium and/or soap build-up in the 3 filters and in the drain. When I turn the power back on I still get the F2 error. How can I restart the machine and turn off the F2 Error?


The F2 error means the tray underneath the unit has filled with water.\015\012You will need to pull out the dishwasher (remove 2 screws at top left/right when door open that prevent tilting).\015\012Unplug and pull out dishwasher.\015\012Remove 4 scr ... Asko D1876 Dishwasher

I changed 2007 honda pilot alternator and serpentine belt, now the engine is making noises kind of like engine knock. I removed the belt and engine is still making same knocking noise.


... Honda 2007 Pilot EX-L 2WD

Need owners manual for husky power washer 2.3 GPM 2600 PSI with Honda GVC 160 engine Model HU80722


... Pressure Washers

Where is the engine oil drain plug for a honda xr2600 power washer


... Honda Pressure Washer PSI 3000

I have a craftsman 2600 psi powered by a honda engine. i have hooked up the water hose and the pressure hose. Turned on the water and went to bleed the air out of the nozzle and nothing comes out.


... Craftsman 2600 PSI Honda Powered Pressure Washer

My Karcher vert shaft Honda powered washer cuts out when your washing kinda like when you release the trigger (except you haven't) like the relife is opening early what's wrong?


They USUALLY don't have aa true relief valve, but instead when pressure is up, it prevents any more water from enetering the pump.\015\012\015\012REBUILD the valve as usually the O-rings in it are worn. ... Karcher 2500 PSI Pressure Washer

Poor pressure karcher g 2500 pressure washer with a 5.5 honda engine. No high pressure, hose pulsates as does water out of the outlet. have removed the unloader valve twice and cleaned it to no avail


I had this same problem on my pressure washer.the pump had some broken parts in it .i found my replacement pump on EBay. ... Karcher 2500 PSI Pressure Washer

I have a older simpson 3000 power washer, 11 hp honda,been a great machine, owned since new, seems like the pressure is building up to a point where it has blown 2 hoses, i turned the throttle down and started to wash, engine quit after about 15 min. it restarted and quit again, tried starting fluid , nothing, what might be the issue


... Honda Pressure Washer PSI 3000

Cannot figure out how to remove the oil plug to drain the oil. Label points to a spot that looks like it might be a plug, but can't figure out how to remove it. It is a 2500 psi Mdl VR2500 Briggs & Stratton engine Honda Power Washer. Ken from NH


Should take a 3/8" socket extention ... Pressure Washers

My Husky pressure washer 2600 psi powered by a gcv 160 Honda. Engine starts no pressure other then from water source and soap is not being dispensed


It sounds like the (RMW 2.2 G24) pump has gone out. Mine had this problem after about 6 hours of use. I was able to order a new pump for around $160.00, and then installed it myself. Go figure it was just out of warranty. I think my next pressure was ... Pressure Washers

I have a Coleman powermate clean machine pressure washer 2500 psi 2.36gpm and has a 6x200 honda 6.5 horse motor. I just bought at a garage sale.It started just fine when I got home and in less that 2 minutes quit. It says the engine will stop automatically when low on oil. what kind of oil should I use and for the pump what kind of oil do you use?


... Coleman Pressure Washer PW0881800
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.1028 seconds