Having problems with your Craftsman 2500 PSI Briggs Stratton Powered Pressure Washer ?

Briggs stratton pressure washer keep stalling after few minutes use

\015 Starts fine runs fine till you start washing then 15 minutes stalls\015

Answers :

Repair Help & Product Troubleshooting for Craftsman 2500 PSI Briggs Stratton Powered Pressure Washer

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Briggs stratton pressure washer keep stalling after few minutes use


... Craftsman 2500 PSI Briggs Stratton Powered Pressure Washer

I have a Briggs & Stratton gas power washer. This is the 1st time this year that I have used it. I put in fresh gas, hooked up the water supply. The engine started and then quickly stopped. I had to release the water pressure in the hose before I could pull start the engine. The only way to keep the engine running is to hold down the spray nozzle trigger. Once that is released the pressure in the hose builds up and the engine stops.


Sounds like the unloader is not working correctly. Try replacing it and see what happens. ... Briggs & Stratton Prosumer 20324 Gas Pressure Washer

I have a Briggs & Stratton Pro 3400 pressure washer that I got new last year and used for maybe 5 hours and it worked great. Have had it stored since then with stabilizer in the gas (I didn't run it dry) and now it won't run for more than a minute or two without dying. A dealer said it was probably bad gas and I now know that even with the stabilizer I should have run it dry last year before storing. Everything is like brand-new including plug and air filter so it must be the gas/carberator gunk


... Briggs & Stratton Prosumer 20324 Gas Pressure Washer

Have a Husky Pressure Washer 2200 psi, HU80931. I don't have an owner manual. It has set for about a year. When I started the washer there was very little pressure. Did some cleaning and it was a little better, but now there is no pressure and I am having trouble keeping it started. Can you help? The washer was purchased at Home Depot and it has Briggs and Stratton the the washer too. Thank You, RJ


Look at eReplacementParts.com and the parts diagrams ... Briggs & Stratton Pressure Washers

What type of oil does pressure washer use? - Briggs & Stratton Pressure Washer Projectpro Spray Nozzle


... Briggs & Stratton Pressure Washer Projectpro Spray Nozzle

Briggs and Stratton pressure washer will not start. I have a 6.75 hp pressure washer that is only a year old. when I pull cord it turns over but does not start. I changed plug and checked it, I have spark when pulling. I have 40-50 psi of compression when pulling also. gas was drained and is brand new. it was working fine last time it was used. I have tried starting it without the water line or spray wand hooked up and no difference. After about 10 or 15 pulls, can smell gas when I am trying to


Hello dave, the problem is compression to low,you need 60 to 130 lbs to run engine,check for blown head gasket,or bad rings,or a stuck open valve,hope this helps,, ... Briggs & Stratton Pressure Washers

2200 psi husky briggs and stratton pressure washer used 2 years never used soap dispenser trying now is not drawing soap no longer have manual to see how to connect adjust can you help?


After a long none use, I tried to wash my driveway and powered on the washer,it did, but when i tried to engage the power washer by pressing the wand lever, it did not engage. What can I do to get the power washer working? ... Briggs & Stratton Gas Pressure Washer 20244

Hi. I have a Briggs & Stratton 2800PSI gas pressure washer. I can get it to start, but after about 5 min, then it quits. I have cleaned the carb, change oil, changed plug, new gas, cleaned/checked air filter. Nothing will keep it running. Wondering if it may be not enough water pressure, but would that cause it to stop like that? When it runs, it does a good job, but it stops just as you get going. Do you have any other suggestions? Thanks!


If it wont start, check for spark.how you do that,ok take the spark plug wire out put it close to the sparkplug(use some gloves or something to insulate your self from get electric shot from the spark) find some one who pull the start rope, if you do ... Briggs & Stratton Prosumer 20324 Gas Pressure Washer

Craftsman power washer stalls under load - Craftsman 2500 PSI Briggs & Stratton Powered Pressure Washer


... Craftsman 2500 PSI Briggs & Stratton Powered Pressure Washer

What kind of oil do you use for a 6.75hp briggs & stratton pressure washer and where is the drain plug at


... Briggs & Stratton Pressure Washers

I have a cratsman 675 series pressure washer, Briggs and Stratton motor. It stopped as I was using it. I tried to restart and feels like the motor is ceased. Oil was low as I found out. What to do?


... Briggs & Stratton Pressure Washer Projectpro Spray Nozzle

Troy- Bilt pressure washer #020209 , 7.25 Briggs & Stratton, AR water pump #SJV 3G27-1. Boggs down an cuts off acts as if motor is getting tight with wand in use or not. After shut down its easily starts up an repeats itself. Removed pump motor runs fine.


... Briggs & Stratton Power Products 1539 Pressure Washer

What oil do i use to chane oil - Briggs & Stratton 2200 PSI Gas Pressure Washer


For normal usage I would reccomend straight 30 weihgt oil.If you are planning on using it during colder temperaturesI would switch to 10w-30. thanks ... Briggs & Stratton 2200 PSI Gas Pressure Washer

I have a Craftsman 2700 psi pressure washer with a Briggs and Stratton 850 engine (80 year anniversary special addition) . It is about 2 years old and used very little and will not start. I filled it with fresh fuel and checked the oil. I also replaced the spark plug and air filter. I checked the fuel line thinking it may not be getting fuel, but there is no obstruction from the tank to the end of the fuel line. I am out of TS options short of taking it to a service center.


Here is the long answer with everything we learned while using a power \015\012washer twice a day for years::\015\012It sounds like could be one of the problems listed below or a \015\012combination of those things.\015\012\015\0121 ... Briggs Stratton 020273 Elite Series Portable Gas Pressure Washer

Briggs and Stratton pressure washer fuel leak


You've hit the nail on the head.The float,needle and seat are stuck wide open.Once the carburetor bowl is full of fuel the float rises up on top which pushes the needle back into the seat shutting of the flow of fuel.As the engine consumes that fuel ... Briggs & Stratton Pressure Washer Projectpro Spray Nozzle

Briggs & Stratton 2500 Power Washer Loses Pressure Time to Time


If by "a few minutes" you mean 180 seconds, I really don't know what to say. But if you mean 5-10 seconds, you probably are experiencing air in the water line or normal engine warm-up behavior when the choke has been set to full lean too soon. ... Briggs & Stratton 020324 3700 PSI Pro Series Pressure Washer

The power washer is not taking in the soap. - Briggs & Stratton Briggs Stratton Vanguard OHV 3000 PSI Gas Pressure Washer


... Briggs & Stratton Briggs Stratton Vanguard OHV 3000 PSI Gas Pressure Washer

Craftsman 2500psi 2.3 gpm briggs and stratton pressure washer wont start


... Craftsman 2500 PSI Briggs & Stratton Powered Pressure Washer

Brute high pressure washer low pressure - Briggs & Stratton Pressure Washers


... Briggs & Stratton Pressure Washers

Hi. I'm scratch building a pressure washer using a Comet BXD2831G pump. If I don't plan on using any type of detergent, is it OK (or manditory) to plug the detergent intake to keep it from sucking air? I would use a short piece of hose over the intake with a screw in the opposite end. Also, is it possible to set the pressure by ear? If so, what should I listen for? Thanks for your help!


No need to plug the injector because under pressure (internal force/pressure) keeps valve shut. It only opens when large nozzle (black tip) is used lowering internal pressure causing siphon effect. Some chemical injectors have a thumbwheel ... Comet GXD2527G Pressure Washer Pump

Craftsman pressure washer wont stay running - Briggs & Stratton Pressure Washers


... Briggs & Stratton Pressure Washers

Briggs and stratton 020228 spark plug gap - Briggs & Stratton Pressure Washers


... Briggs & Stratton Pressure Washers

Oil I have a Briggs and Stratton 2200 psi pressure washer. It doesn't specify an oil ~ other than to show a photo of synthetic pressure washer oil manufactured by them. I can't find that specific brand anywhere, what can I substitute it with? Ace hardware was stumped.


Remember when your searching for something you can't find the internet is always your best bet. You should also use a good search engine; www.bing.com is one of the best search engines I have ever used. I searched some stores that have the oil your l ... Briggs & Stratton Briggs Stratton 2000 Psi Pressure Washer Freeshp

Just bought a new Briggs Stratton 6 75 pressure washer. i put in a half a tank of gas in the tank and it started up. i ran the pressure washer until it was out of gas. put more gas in now it will not start.


Assuming you tried choking it when you tried to start it, verifiy its getting gas,if not tap lightly on the bowl of carburator. if it is getting gas, check for spark ... Briggs Stratton 020273 Elite Series Portable Gas Pressure Washer
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.1322 seconds