Having problems with your Craftsman 2600 PSI Honda Powered Pressure Washer ?

What is the best way to save fuel in power washer


Answers :

Do not use regular gas on it, you will damage the engine.
Repair Help & Product Troubleshooting for Craftsman 2600 PSI Honda Powered Pressure Washer

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

What is the best way to save fuel in power washer


Do not use regular gas on it, you will damage the engine. ... Craftsman 2600 PSI Honda Powered Pressure Washer

I have a B&S 3.75, model 98902,type 014301,code 96032254 gas engine which powers a 1500PSI Clean Master power washer. The engine will start if primed but will not continue to run unless fuel is sprayed down the throat of the carburator.Apparently a gumedup/dirty carb. what is the best way to proceed to clean it? Where is best place to get a rebuild kit and/or replacement carb if needed? What are other possibilities if not a dirty carb?


... Pressure Washers

My Scout 135 Extra pressure washer worked fine and 20 min. later the burner will not start. The fuel nozzle sprays fuel but the ignitor will not spark. How do I check the transformer to determine if it has power and if it is sending power to the ignitor?


... Northstar Pressure Washers

I have a go kart with a honda power washer motor that I just purchased.It lacks power at start and stalls alot.Put new pull in,sprayed carb cleaner,adjusted carb,new air filter,need to know if it need a fuel pump and were to get one


Hondas are gravity feed no pump needed .You might need to clean the card though. ... Karcher 2500 PSI Pressure Washer

I have a Honda GC160 5 horsepower power washer with 2400 psi. When its cold it is easy to start but after it has been running for a while the only way to start it is to have the water shooting out of the wand. Once it is hot and running if i stop the stream of water (release the trigger on the wand) then the machine shuts off. It seems like the only way to keep it running is to constantly have water running through the wand. Please help


... Pressure Washers

I have a troy built power washer powered by honda. It runs for 10 - 15 minutes and then dies. I have replacced the ignition coil, spark plug, rebuilt the carburetor, checked fuel flow and placed the unloader valve and it still dies. Once it dies and the pressure is released it repeats the problem. Any suggestions?


... Honda Pressure Washer PSI 3000

Need fuel cap for ridgid power washer - Ridgid Rd80702 3300 Psi 3.0 Gpm 7 Hp Subaru Ex21fi Ohc Gas Powered


... Ridgid Rd80702 3300 Psi 3.0 Gpm 7 Hp Subaru Ex21fi Ohc Gas Powered

I have a Craftsman power washer model 580 752020. When I start it up, turn on the switch the electric motor runs fine until I either close the trigger to the spray nozzle or press the trigger for power spray. The electric motor just shuts down, if I take my finger off the pressure and let the water run with no presssure the motor runs fine. My question is this. Is the capasitator on the electric motor the probable cause and is there a way to check out the capasitator to see if it is malfuncti


I doubt that it has anything to do with the capacitor on the motor. i think you are having a problem with the actual Motor Drive circuitry. What is happening is when you close the switch, this tells the Motor to "Ramp Up" to pump the water out, what ... Craftsman Pressure Washers

I have a Snap On 2000 PSI electric power washer 110 Volt, is there any way to change to 220 volt without rewinding it ?


... Ace Hardware Pressure Washers

Rx2600 Honda Power Washer Fuel


... Honda Pressure Washers

I have a Briggs & Stratton gas power washer. This is the 1st time this year that I have used it. I put in fresh gas, hooked up the water supply. The engine started and then quickly stopped. I had to release the water pressure in the hose before I could pull start the engine. The only way to keep the engine running is to hold down the spray nozzle trigger. Once that is released the pressure in the hose builds up and the engine stops.


Sounds like the unloader is not working correctly. Try replacing it and see what happens. ... Briggs & Stratton Prosumer 20324 Gas Pressure Washer

Hi I have a brand new Honda Power washer GC 160,2600 psi 2.3 GPM my husband taught me how to use it last night and I think I have followed all of steps: 1. hose free of kinks 2. connected to machine 3. purged pw handle of air and made sure water from house coming through 4. pulled out choke 5. turned red button to "ON" position 5. pulled T handle enging starter and it sounds like it will start but doesnt what am I doing wrong??? yes it does have gas in the fuel tank.


... Karcher 2500 PSI Pressure Washer

BDW45.1 starts as normal you can hear water running then about 30 seconds into cycle everything stops and then you can hear a buzzing noise (best way to describe it is it's like the noise you hear when a motor has power but won't turn)


... Baumatic 23 in. BDW5 Built-in Dishwasher

What type of oil is best for the 3000psi Honda power washer?


A 30 weight nondetergent oil is recommended, available at any auto parts store. ... Honda Pressure Washer PSI 3000

My 13 hp honda power washer has a miss when it's not under a load. Is it a fuel or spark problem ?


Most likely fuel / plug. Easy to check. While running unloaded and miss-firing, try applying the choke just a little to increase fuel mixture (make run slightly rich), if clears may need carb kit. If it gets worse with slight choke running rich or p ... Honda Pressure Washers

Coleman Powermate pressure washer. Model PW0751310 A lot of water leaks out in the handle where you squeeze for the unit to work, thus the power spray is weak at best. Took handle/arm apart and didn't see any issues. Possible "O" ring worn out (if i was looking at "O" ring. Any ideas?


There may be orings in gun but usually not available as a repair kit. Replace the gun with a 5000 to 6000 psi. You will get a much longer life by over sizing gun. If you like to tinker, you can by orings at Lowes in the plumbing department. Lube th ... Caterpillar Cat Pump Pressure Washer Pump 3SP30G11

Intermitttent beeping on bottom drawer of dish washer no error code only cycle to work all the way through is rinse cycle. Have turned off power supply over night did not fix problem. When you press pause button restarts for about five minutes then beeps again. No problem with top drawer. All inside cleaned using correct powder and rinse aid.


Panel control board Call Encompass Parts 1-800-638-3328 ... Fisher Dishwashers

I have a Ryobi power washer, model #RY30080. I ran it for a long time yesterday, running it out of fuel. This morning, after refilling the gas, I am unable to start it. The starter rope is very difficult to pull, like it is binding. I followed the correct starting procedure. Can you help me?


It is more likely the pump seized up... or you are experiencing combustion lock.\015\012Remove the sparkplug(s) and pull the cable a few times.\015\012If the motor turns normally - clean the plug or replace it.\015\012If the motor s ... Pressure Washers

I borrowed my nieghbors power washer. It worked the first day all day. In the morning i filled the gas with a fuel stabiler, and 30 oil. I may have over filled it. Upon turning it on the oil started leaking from the air filetr compartment. It starts, but then smokes starts to fume and all the oil leaks. Did I break it or is it a easy fix. I cleaned the filter housing. Also the filter was soaked with oil. should i get a new filter and install it or what is the solution. need help.


You will need to get a new filter, and drain some of the oil out of the machine. If you over fill these this will happen. 90% of the time nothing is broken. ... Karcher 2500 PSI Pressure Washer

I can't find my manual and no longer remember what the fuel mixture is for my workforce 163cc power washer. Can you help me? Thanks much.


Does your pressure washer engine have a place to add and check the oil level? If it does. And it looks like the picture from your question. It is a four stroke engine and the fuel doesnt need added oil.\015\012\015\012Northstar washer ... Northstar Pressure Washer 3000 PSI

The Dishwasher PLD2850RDC2 will not start. The CL flashes, the type of cycle pressed on the key pad does respond, but nothing happens when START is pressed. Steps taken: -Door is clicked shut -Power breaker has been turned off and back on -All dishwasher moving parts have been moved by hand to ensure no obstructions are in the way. Best guess is the key pad is just non responsive. I hope there is an easy solution. Thank you.


... Frigidaire 24 in. PLD2850 Built-in Dishwasher

My power washer fell off the deck onto side and began smoking. Can I save it


Yes. Replace the air filter which probably got loaded with oil when the spill occurred. Also, remove the spark plug and clean it. Joe\012\0124 thumbs up please. ... Honda Pressure Washers

We have a Ryobi RPW2400 Petrol Pressure washer. When we are using it, the motor seems to be struggling for power and nearly stalling. WE have only used one tank of fuel and we were just wordering if there was an adjustment or something that we could do? Bob


... Honda Karcher G2400HH-R Pressure Washer

I have a kenmore elite dishwasher. it is atleast 5 to 8 yrs old. it seems to be running very quiet and the dishsoap is laying in the bottom of the washer after a cycle. i believe the sprayer arms are not working properly. whats best way to clean or replace sprayer arms. thank you


... Kenmore Dishwashers

Hi I have a dish washer problem. it does not drain all the way out. it is brand new just installed. Could it be lack of power? I'm not sure just guessing. thank you Ben


Hi ben,\015\012\015\012I'm Harvey the Master Plumber.\015\012\015\012Your problem is: You have a d/w problem. it does not drain all the way out. it is brand new just installed. Could it be lack of power?\015\012\0 ... Whirlpool Dishwashers
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.1103 seconds