Having problems with your Craftsman 2700 Max Psi Pressure Washer 23 Max Gpm ?

How to replace pull cord on a craftsman gas pressure washer


Answers :

Repair Help & Product Troubleshooting for Craftsman 2700 Max Psi Pressure Washer 23 Max Gpm

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

How to replace pull cord on a craftsman gas pressure washer


... Craftsman 2700 Max Psi Pressure Washer 23 Max Gpm

Briggs and Stratton pressure washer will not start. I have a 6.75 hp pressure washer that is only a year old. when I pull cord it turns over but does not start. I changed plug and checked it, I have spark when pulling. I have 40-50 psi of compression when pulling also. gas was drained and is brand new. it was working fine last time it was used. I have tried starting it without the water line or spray wand hooked up and no difference. After about 10 or 15 pulls, can smell gas when I am trying to


Hello dave, the problem is compression to low,you need 60 to 130 lbs to run engine,check for blown head gasket,or bad rings,or a stuck open valve,hope this helps,, ... Briggs & Stratton Pressure Washers

I have a Karcher 2,600 PSI 2.3 GPM Gas Pressure Washer G 2600 VHR that I have used once last summer. I have stored the PW in my basement with no fuel in the gas tank. The PW was never exposed to freezing temps. I cannot get the PW to start. I put new fuel into the tank, the oil is good, I drained the carburetor, and the spark plug works (tested it). I pull the cord and the engine doesn't turn. Fuel value is on, choke is pulled, and the starter switch is turned on. System is practically brand new


Hi I have a similar pressure washer from Kartcher and the same scenario as yours I have owned it for about 2 years and noticed that it was getting harder and harder to start with each time I use it which is months. If your pw has a honda engine on i ... Karcher G 2600 VH Gas Pressure Washer

I HAVE A NEW CRAFTSMAN PRESSURE WASHER WITH KEY START. I HAVE USED IT ONCE AND WHEN I TRIED TO START IT IT WAS HARD TO START HAD TO PULL START IT. NOW IT WONT START. LET PRESSURE OUT HAVE HOSE OH AND RUNNING, NEW SPARK PLUG HAS OIL, GAS FILTER FINE.HAS GOOD COMPRESSION, BUT WILL NOT FIRE GET SOME RECOIL. GETTING GAS TO SPARK PLUG AND GETTING SPARK. IM LOST PLEASE HELP.


... Pressure Washers

Karcher 2400R I have not used my pressure washer for 6 months. It was left full of gas in the garage. I tried to start it but it would not fire up so I change the gas, oil, and spark plug, took apart the carburator and cleaned it out with carb cleaner. I went ahead and put everything together, pull the cord and wanted to start. While trying to start it after I sprayed starting fluid in the air cleaner I noticed that gas was coming back from the crankcase breather hose into the air filter choking


You have a poor signal to the spark plug usually caused by a rusty fly wheel found underneath the pullcord casing. clean it with releasing ajent such as wd 40. common when not in use for a while. ... Karcher 2500 PSI Pressure Washer

Pull cord replacement on a husky pressure washer


... Pressure Washers

The pull cord on gas pressure washer wont allow me to pull it as though it is tangled up, But when i removed the housing, it woorks just fine


Sometimes the housing gets bent slightly. A lot of the housings have little taps or prongs that get slightly bent. I would take the housing off make sure it not bent or warp, to make sure there is nothing to block the free flow of then cord flowing. ... Briggs & Stratton Prosumer 20324 Gas Pressure Washer

Craftsman Pressure Washer 2.7 GPM 3000 PSI. Stopped working, found no oil, added oil now washer will not start, can't even pull the cord. Help


... Pressure Washers

I have a Husky 2600 PSI pressure washer. Started up and used for about 20 minutes - turned off to take around back and now the pull cord is tight and has a clicking sound when trying to pull. Has oil and fresh gas. Suggestions?


... Karcher Pressure Washers

I have an Excell VR2500 pressure washer with B & S 6.5 HP engine. It was running fine, but then stalled out and now will not start. Has clean gas and full oil. I pulled the spark plug it is producing a sufficient spark when starter cord is pulled. Any ideas what might be causing the problem? Please help.


The key things to check are the spark plug, the air filter, the fuel. If those are all new and in good shape then you probably have gum in the carburator. Get a can of starter fluid and a helper. One person squirt the starter fluid into the air in ... Briggs & Stratton Pressure Washers

Craftsman pressure washer 580752251 kicks, but won't start


... Pressure Washers

I have Honda pressure washer.Inorder to start the pressure washer you have to pull the cord. THe cord is stuck and I am not able to pull the cord. Why it and what should I do to start the washer.


... Honda 2500 PSI Gas Pressure Washer

Craftsman Pressure Washer Model #how do I adjust the unloader on my craftsman model 580752810 pressure washer, Just replaced it and it has considerably lower pressure than before.


... Pressure Washers

I have a generac pressure washer and the engine will not turn over. Followed the directions to a T and when I pull the cord... nothing. Spark plug? It is brand new out of the box. Filled high with brand new mid octanne gas, filled oil, followed directions to start... nothing.


... Pressure Washers

How do you replace the pull cord on a dewalt 3750 psi pressure washer


... Dewalt 3700 Pressure Washer

Hard to pull cord - Dewalt Heavy-Duty 3100 PSI 6.5 HP Gas-Powered Pressure Washer DP3100


... Dewalt Heavy-Duty 3100 PSI 6.5 HP Gas-Powered Pressure Washer DP3100

Change pull cord on john deere - John Deere 020297 Gas Pressure Washer


... John Deere 020297 Gas Pressure Washer

Pull cord stuck Troy bilt 3000 - Troy-Bilt XP 3000 PSI 2.7 GPM Gas Pressure Washer 020489


... Troy-Bilt XP 3000 PSI 2.7 GPM Gas Pressure Washer 020489

How do i replace a pull cord on a xt7 pressure washer


Try this link:http://www.youtube.com/watch?v=Q3NjVomUQJMThere are others there as well.Best regards, --W/D-- ... Psi Blue Max 2200 High Pressure Gas Power Washer

Cannot start Homelite 7 HP EX21 gas pressure washer. Not sure how to set the primer lever? Forgot to turn on switch. Turned on switch, now cord is tight, will not pull?


... Pressure Washers

Replace pull cord model g23 - Pressure Washers


... Pressure Washers

I have a Troy Built 2500 PSI pressure washer with Honda 160 CVG motor. It won't start. I've replaced the gas and spark plug. Every time I pull the spark plug out it's soaked. Not sure


... Pressure Washers

Craftsman pressure washer


... Pressure Washers

Very Hard to Pull Cord to start engine on Northstar Pressure Washer. When I remove spark-plug it is very easy to pull cord. With plug reinserted it is extremely difficult to pull cord to start engine.


On the Honda motors very hard pull starting with no start ck for broken rocker on exhaust or intake, I've already repaired two with this problem...... ... Northstar Pressure Washer 3000 PSI

I have a Briggs and Stratton power washer Quantumpower 5hp water driver series 1750 PSI 2.0 gal min model # WGV1721 . I got it used and it was always a bit hard to start but always started. Pull cord frayed and broke I bought new cord and a neighbor replaced for me. Now it does not want to do anything when pulled. I can't get top cover off that has screws with round holes instead of phillips or standard slots to get to pull cord winding


Spray well with WD-40 or similar, and take a small chisel, on it's edge, and hit hard enough to allow chisel to dig in to head of screw, making a "V" like slot in the head, then angle chisel slightly and start tapping in direction of loosening(counte ... Briggs & Stratton Pressure Washer Projectpro Spray Nozzle
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.1124 seconds