Having problems with your Craftsman 2700 PSI,2.3 GPM Briggs & Stratton Powered Pressure Washer - Ca. Model ?

Engine seized power washer

\015 Engine seized\015

Answers :

Repair Help & Product Troubleshooting for Craftsman 2700 PSI,2.3 GPM Briggs & Stratton Powered Pressure Washer - Ca. Model

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

So I found this power washer for sale. The seller claims that the washer generates a good stream of water, not just full power. He also mentions that after a few minutes the engine starts to bog down like it is working extra hard. Does this sound like a pump issue? Could something be clogged or would the pump need to be replaced? Or should I avoid this power washer?


Don't buy a power that doesn't work.There are many expensive parts on a power washer. If it was cheap and simple to fix, the seller would fix it and the washer would not be for sale.Would you buy a car that doesn't work? Especially ... Pressure Washers

I have a Honda ,gas powered power washer and when I squeeze the handle the water pump kills the motor. I've let the engine run until warm and it still can't take the water pump engaging. It's a three year old washer.


... Pressure Washers

I have a B&S 3.75, model 98902,type 014301,code 96032254 gas engine which powers a 1500PSI Clean Master power washer. The engine will start if primed but will not continue to run unless fuel is sprayed down the throat of the carburator.Apparently a gumedup/dirty carb. what is the best way to proceed to clean it? Where is best place to get a rebuild kit and/or replacement carb if needed? What are other possibilities if not a dirty carb?


... Pressure Washers

I have a Briggs & Stratton gas power washer. This is the 1st time this year that I have used it. I put in fresh gas, hooked up the water supply. The engine started and then quickly stopped. I had to release the water pressure in the hose before I could pull start the engine. The only way to keep the engine running is to hold down the spray nozzle trigger. Once that is released the pressure in the hose builds up and the engine stops.


Sounds like the unloader is not working correctly. Try replacing it and see what happens. ... Briggs & Stratton Prosumer 20324 Gas Pressure Washer

Hard starting 6hp Briggs and Stratton power washer engine. I poured a teaspoon of gas into the cylinder; reinserted the spark plug and with one pull in ran fine. This is a choke start engine and it may take 12 to 15 pulls to start on a cold engine. The unit is clean. The air cleaner is new. The spark plug is new. The unit is 2 years old with very little use.


Hello. I have this same machine. Go to the auto parts store and get an aerosol can of starter fluid. Have a helper squirt some into the air intake while you start it. Then continue to squirt a little starter fluid as it runs for the first two mi ... Campbell Hausfeld Pressure Washers

Engine lockup I have a craftsman power washer with a briggs and stratton 850 series engine, craftsman model 580752220, the engine will not turnover unless i remove the spark plug, it has electric start and will turn over with no problem like this but if i put my finger over the plug hole it locks up immediatly


Sounds like the intake or exhaust valve is not opening. ... Craftsman 2700 PSI Briggs Stratton Powered Pressure Washer

Need Engine Manual for All Power America 2200 PSI 4 HP OHV Gas Powered Pressure Washer


... Pressure Washers

Rebuilt honda GC160 5hp engine for a power washer and only got the engine to start once. Just took apart and saw that the cylinder and piston was all scored up again.


... Honda Pressure Washers

Honda Power Washer VR 2522 Engine Manual - Pressure Washers


... Pressure Washers

Simpson pressure washer winterize - Simpson PS3200 Powershot 3200 Psi Direct Drive Cold Water Gas Powered Pressure Washer W/ Honda Engine


... Simpson PS3200 Powershot 3200 Psi Direct Drive Cold Water Gas Powered Pressure Washer W/ Honda Engine

Have a Power washer with Honda 390X engine. Engine intermittently stops and has to be manually restarted. It only stopped once in 10 hours yesterday, but already several times today.


... Honda Pressure Washers

Very little water flow from washer . Once water is connected to the intake side of washer very little is coming from the out site to power nozzle when engine is started it still does not boost water preasure


... Pressure Washers

What type of engine oil do i use for my power washer ? I have a Mi T M 3000 psi choremaster 208 series gas engine


... Pressure Washers

Campbell Hausfield Pressure washer model 1549. After a few years of storage, I cannot prevent the powerful spray leaking from the connection between the Gun and the Lance. I replaced the O-Ring, and tried other means unsuccessfully. Spray from the joint is almost as powerful as spray from the lance nozzle. The Briggs and Stratton engine has been cleaned and operates well. The pump operates well. But the lance connection refuses to seal.


Hello,Most likely, the housing has split and seal is not being made. There is a chance that the hose is leaking where the fitting is crimped on (my experience, but different pressure washer). Are you able to see a leak when turned off b ... Campbell Hausfeld Pressure Washers

I have a 6.75 hp engine on a Briggs and Stratton power washer. I need the torque setting for the engine bolts.


... Briggs & Stratton Pressure Washers

I just bought a used and broken Power Washer which I plan to repair and use, hopefully. I can't seem to locate operators/parts manual. NorthStar Pressure Washer ? 2400 PSI, 2 GPM Item#: 157472A Serial #: 1106 4728 Bar Code: 157472A11064720 Engine: 6 HP Tecumseh Pump: Comet VRX with brass manifold and stainless steel plungers Drive: Direct Thanks for your help.


... Northstar Pressure Washers

Have a Craftsman 2550 MAX PSI, 2.3 MAX GPM, Briggs & Stratton Powered Pressure Washer seems like the engine is ceased how can I fix it? need a copy of the manual with exploded pic of engine


... Craftsman 2500 PSI Briggs Stratton Powered Pressure Washer

What type of oil is used in a simpson power washer,the pump not the engine


... Simpson Pressure Washers

Husky power washer 2200 how to change engine oil


... Pressure Washers

My gas powered pressure washer runs great. But within 25sec. of spraying the water, the engine gets very hot and quits. Any ideas what to do??


... Briggs & Stratton Pressure Washers

Need owners manual for husky power washer 2.3 GPM 2600 PSI with Honda GVC 160 engine Model HU80722


... Pressure Washers

Power washer Craftsman B&S engine model 20228 - carb not working


... Craftsman Pressure Washers

Where is the engine oil drain plug for a honda xr2600 power washer


... Honda Pressure Washer PSI 3000

My Troy Built 2500 psi power washer with Honda engine GCV has been stored for 2 years. I changed the gas and could not get it to start. Which is the start position for the valve on the gas line - Horizontal or Vertical? Thanks, Bill Gray Melbourne Beach FL


... Pressure Washers
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.0599 seconds