Having problems with your Craftsman 2700 PSI Briggs Stratton Powered Pressure Washer ?

How much pump oil do I put in - Craftsman 2700 PSI Briggs Stratton Powered Pressure Washer


Answers :

Repair Help & Product Troubleshooting for Craftsman 2700 PSI Briggs Stratton Powered Pressure Washer

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

How much pump oil do I put in - Craftsman 2700 PSI Briggs Stratton Powered Pressure Washer


... Craftsman 2700 PSI Briggs Stratton Powered Pressure Washer

Gas in oil in pressure washer - Craftsman 2700 PSI Briggs Stratton Powered Pressure Washer


... Craftsman 2700 PSI Briggs Stratton Powered Pressure Washer

Started by Craftsman 2700 PSI , 2.3 GPM Briggs & Stratton Powered Pressure Washer for first time in 9 months. Added new oil, and gas. started but is smoking from muffler and is dripping what appears to be oil near the exhaust end. I shut it down. What could this be due to?


The first thing I would check would be the oil level, to make sure you didn't put in too much oil. If the oil level is correct, it could be a stuck piston ring, letting oil blow by the piston, and out the exhaust. If this is the case, you are going ... Craftsman 2700 PSI,2.3 GPM Briggs & Stratton Powered Pressure Washer - Ca. Model

My Troy Bilt power washer (using Honda GCV160 engine) has no pressure coming from the pump. I checked the water flow, everything seems fine. I believe the pump needs oil added, however, I can't seem to firgure it out (how to add oil to the pump). I did notice that previously, I used to see drops of oil coming from under the pump. I I have a bad seal, can I add oil and test the pressure before I change the seal? Please advise.


I had a similar problem. Turns out I had left the hose disconnected and some sort of wasp built a paper type nest inside the washer tube that the hose connects to. I had to take the pump off and take apart and then cleaned it out with a screw driver. ... Honda Black Max 2600 PSI Pressure Washer

How to drain oil from engine - Craftsman 3000 PSI 27 GPM Briggs Stratton Powered Pressure Washer


Square socket on the bottom of the engine. I think a 3/8 extension on a ratchet is correct. ... Craftsman 3000 PSI 27 GPM Briggs Stratton Powered Pressure Washer

I have a sears pressure washer, model 580752300. The pump on the underside vibrated lose and broke a couple screws. It came off and the oil drained out. I replaced the screws and it's ready to go except I can't find out how much replacement oil to put back in. Sears has larger containers but won't tell you how much oil to put in. However, there's a pricey pre-measured container they want to make you buy. Anybody know how much oil goes in that pump?


... FAIP Non Marking Pressure Washer Hose 4000 Psi, 50ft. Length

I have two questions and would greatly appreciate some help: - What oil to use in the pressure pump of a Ryobi Pressure Washer RY80030? - How much to put in? The pump model is MTP092150 from FAIP. As per the manufacturer, the oil is not to be changed or topped up by the end-user, I know, I know, but brought to a service center instead - I certainly don't want to do that, and there is none close to my place anyway. The reason I need this is that I had to take the pump apart and a


... FAIP Non Marking Pressure Washer Hose 4000 Psi, 50ft. Length

Craftsman pressure washer model 580.752520 - Craftsman 2500 PSI Briggs & Stratton Powered Pressure Washer


... Craftsman 2500 PSI Briggs & Stratton Powered Pressure Washer

Craftsman power washer stalls under load - Craftsman 2500 PSI Briggs & Stratton Powered Pressure Washer


... Craftsman 2500 PSI Briggs & Stratton Powered Pressure Washer

North star eletric hot 2000 psi 3.5 gal per min oil pump had blown shaft seal. replaced with new pump. put small allen plug in return port. I have oil flow to the pump but none comes out port leading to burner even with shutoff switch removed and pump turning. Installed test gage 0 pressure. Took off bypass line and ran into can. pumps small amount of fuel into can that way but with uneven flow & small bubbles. nomatter what I do I just can't get fuel outlet port to burner. pump # A2VA-7116 pl


... Northstar Pressure Washers

Does pressure washer pumps need oil or not? - Briggs & Stratton Pressure Washers


Yes all of them. its a special type call your local equipment rental facilty, its not readily avail normally ... Briggs & Stratton Pressure Washers

Honda 2500 pressure washer manual - Craftsman 2500 PSI Briggs & Stratton Powered Pressure Washer


... Craftsman 2500 PSI Briggs & Stratton Powered Pressure Washer

How much oil in pump...Craftsman 2200 PSI pressure washer


Hello:Best to use NON DETERGENT 10W30. Be sure you fill the reservoir only 1/3 to less than 1/2 full. ... Briggs & Stratton Pressure Washers

How to change pump oil on craftsman pressure washer #580.767302


... Craftsman Pressure Washers

What type of oil do I put in the high pressure pump and how much? Porter Cable PC2525SP pressure washer.


Regular motor oil ... Pressure Washers

I have a troy built 2450 pressure washer. The engine runs fine but I have no pressure out of the hose. Does the pump require that you put oil in it?


Do you live where it is cold in the winter? And did you winterize the pump this past winter if it is cold? They need to be winterized or pump damage can occur. ... Pressure Washers

What kind of oil do you put into a Excell pressure (exh2425) washer pump? Do you use the same as engine oil (30 w)?


Pressure washer oilI took this picture of my power washer so it's easy to explain the oil.The ... Pressure Washers

Engine lockup I have a craftsman power washer with a briggs and stratton 850 series engine, craftsman model 580752220, the engine will not turnover unless i remove the spark plug, it has electric start and will turn over with no problem like this but if i put my finger over the plug hole it locks up immediatly


Sounds like the intake or exhaust valve is not opening. ... Craftsman 2700 PSI Briggs Stratton Powered Pressure Washer

Campbell Hausfield Pressure washer model 1549. After a few years of storage, I cannot prevent the powerful spray leaking from the connection between the Gun and the Lance. I replaced the O-Ring, and tried other means unsuccessfully. Spray from the joint is almost as powerful as spray from the lance nozzle. The Briggs and Stratton engine has been cleaned and operates well. The pump operates well. But the lance connection refuses to seal.


Hello,Most likely, the housing has split and seal is not being made. There is a chance that the hose is leaking where the fitting is crimped on (my experience, but different pressure washer). Are you able to see a leak when turned off b ... Campbell Hausfeld Pressure Washers

My 1750 huffy power washer was hard to get water pressure for about 10 minutes, once the machine was putting out pressure i noticed it was leaking oil from the bottom of machine need help with the problem


There is sticking valves in the pump ... Pressure Washers

I have a Briggs & Stratton gas power washer. This is the 1st time this year that I have used it. I put in fresh gas, hooked up the water supply. The engine started and then quickly stopped. I had to release the water pressure in the hose before I could pull start the engine. The only way to keep the engine running is to hold down the spray nozzle trigger. Once that is released the pressure in the hose builds up and the engine stops.


Sounds like the unloader is not working correctly. Try replacing it and see what happens. ... Briggs & Stratton Prosumer 20324 Gas Pressure Washer

My pressure washer craftsman 580767300 where do you check the oil or add oil in the pump not the motor I HAVE A manuel it does not show


... Pressure Washers

Briggs & Stratton WAP 9300P pressure washer pump oil brand


... Briggs & Stratton Pressure Washers

WHAT WILL HAPPEN TO A CRAFTSMAN GAS POWERED 2500 PSI PRESSURE WASHER IF SOMEONE RUNS DIESEL THROUGH IT AS A DETERGENT OR DE-GREASER? WILL THIS RUIN THE SEALS IN THE PUMP? OR CAN THIS PROBLEM BE REVERSED WITH A FULL TAKE APART AND CLEAN UP OF ALL PARTS?


If you want to run a very small amount through the engine to help clean carbon deposits I would say that was fine as long as you only used 1-2 ounces to the gallon. But if you want to run diesel through the pump itself I would not recommend this. ... Pressure Washers

WIULL NOT PICK UP SOAP FROM CONTAINER - Craftsman 3000 PSI 27 GPM Briggs Stratton Powered Pressure Washer


There could be a block in the syphon hose going from the soap reservior to the sprayer. Take the hose off and blow through it to make sure the the hose is clear. If the hose has a scrren/filter on it make sur that is clean also. Where the hose att ... Craftsman 3000 PSI 27 GPM Briggs Stratton Powered Pressure Washer
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.1591 seconds