Having problems with your Craftsman Pressure Washers ?

I have a Craftmans power washer model 580-767300 with low pressure

\015 It has three place to put oil, but not sure which is for the pump?; not sure which is for the motor?; not sure how much to put in either place?\015

Answers :

Repair Help & Product Troubleshooting for Craftsman Pressure Washers

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

I have a Craftmans power washer model 580-767300 with low pressure


... Craftsman Pressure Washers

Honda pressure washer model # exhp3640-1 3600psi 0=13hp has low water pressure out of triggers motor does not engage for higher pressure


... Pressure Washers

Power washer Briggs & stratton model 2200 from sears. Just pulled out of my shed. Runs fine but water pressure is really low. I cleaned everything that may be blocked. Water pressure from house is ok.. I'm lost Help thank you.


... Pressure Washers

Turn water on then actuate wand trigger. Pressure washer leaks when wand trigger is actuated and has very low pressure/flow output. After releasing trigger the pressure cycles on - off at approx 1 second interval. I suspect that the plasstic oulet tube is leaking causing low pressure leak out of bottom when trigger is actuated and causes pressure switch to cycle when the trigger is released. Any Help? This pressure washer is approx 18 months old!


You gave a very close solution yourself for the problem. But other leakages can cause such symtoms.Forexample a leaking head or a leaking chemical inlet. These can be caused because the spill valve (pressure control valve) is stuck. When this valve s ... Karcher PSI Electric Pressure Washer

Power washer the original clean machine 2400 psi low water pressure


... Comet Pressure Washers

At the beginning the pressure washer was running but there was no power from the nozzle. I stop the gun trigger, remove the nozzle , it works for 1 minute and stop working again Now the washher pressure turns off on its own after 1 minute or less Honda 2400 psi


See attached link:\015\012http://www.wmpcs.com/index.php?main_page=page&id=14\015\012\015\012If you continue to have the problem you m ... Honda Karcher G2400HH-R Pressure Washer

Power washer will only run when sprayer is on low pressure as soon as sprayer switched to high the pressure washer quits


... Earthwise PWO2200 2,000 psi 1.6 gpm Electric Pressure Washer

Hoda power washer low on pressure - Honda Pressure Washers


Caused by either of two things: The pump is worn and needs to be rebuilt or replaced. OR the pressure relief valve ( protects the motor from excessive pressure build up when you turn spray off) , is stuck in the open position thereby not allowing p ... Honda Pressure Washers

Powerate durabuilt power washer model db1303 - Coleman Powermate DuraBuilt 1400 PSI Pressure Washer


... Coleman Powermate DuraBuilt 1400 PSI Pressure Washer

Craftsman pressure washer model 580.752520 - Craftsman 2500 PSI Briggs & Stratton Powered Pressure Washer


... Craftsman 2500 PSI Briggs & Stratton Powered Pressure Washer

Power washer has low pressure - Mi T M Pressure Washers


... Mi T M Pressure Washers

When the washer is at rest with water on and power on the pump runs on and off on its own but when i pull the trigger the washer works fine in low pressure and high pressure


... Pressure Washers

North Star Model 157597 Pressure Washer from Norther Tool calims to have adjustable pressure. There is nothing in the manual about how to adjust the pressure and I have received two statements from them on how to adjust the pressure: 1. Adjust the pressure at the unloader valve 2. Run the motor at reduced speeds. Which, if either is correct?


... Pressure Washers

Hello, I own a Honda Pressure Washer (Porter Cable Model) with a Cat pump 2600psi and 6.5 hp. An Excellent machine for the past 7 years. Last fall I noticed it was not producing the full pressure but still Engine was running strong. This past weekend. started it up and used it for about 1 hour still with minimal pressure at full throttle. Then pressure was totally cut off. I stopped and started the engine the engine and it had minimal pressure again. Same thing happened again. I stopped the engi


... Honda Pressure Washers

Honda powered gx160 model pressure washer wont start


Did you drain out the fuel before you stock it? If you didn't, you may need to clean the carburetor or replace a new one because the fuel inside has become a kind of stick varnish. You may take a look at following link to see how to change or replace ... Honda 8 HP Engine

No high power water pressure coming out of my model #580.768030 pressure washer. The same pressure comes out when the pump is turned off.


You should dismantle and clean the manifold from the pump , it is sticking. Common ... Comet BXD2527 Pressure Washer Pump

I have a G2500VH pressure washer that has started to pulse when the trigger is squeezed. This happens if I use the 0,25, and 40 degree nozzles BUT if I use the one for low pressure(detergent use) it will hold pressure fine. I have changed the unloader valve, checked all the valves and seals ad they seem to be fine. What could be the problem?


Do you mean pressure on and off with the hp tips and smooth and steady with chemical tip? ... Pressure Washers

No pressure to the wand. Motor runs and pressure gauge reads 4000 psi.Feels like no power in the wand Is a Honda pressure washer model #BEEX-2965HWCOMX.


... Honda Pressure Washers

I have a power washer that needs a wand for the high pressure, the low pressure wand is part number PA6630GF. I need the part number and where tp urchase the high pressure wand.


... McCulloch FHH18A Electric Pressure Washer

No pressure for power washer. model FH160G 1600psi


... McCulloch FH160G Pressure Washer

Low or no pressure on EX-Cell XR2600 pressure washer


... Pressure Washers

I started working with the Karcher KB4040 pressure washer and all was well for 1-2mins, then it sputered a bit and all power died. All hoses were still attached properly, it hadn't blown a fuse in my house and the fuse in the plug of the washer is working fine.When I switch it on I get nothing. Do you think the motor has packed in? I borrowed the machine from my neighbour who's away on holiday, so don't know much about age of the machine. Any advice much appreciated.


If the water is in anyway impeded, like kink in hose the unit turns off and goes into protection mode. That it it shuts down for a pewriod of time depending on how hot it may have got.\015\012When its rested try it again ensuring you definitely ... Karcher 1750 psi Electric Pressure Washer

Sears Power Washer Model 580-767300 works great but loss of pressure ocurs after a few minutes or working. If you wait and work the pressure gun it will come back for a while


... Pressure Washers

Do not have book for pressure washer 330'' pleasr help me find a source,i am a widow and can not find istruction to use the power washer T hank you Name of product,Karcher,model number is ''330''


... Pressure Washers

I'm trying to get a Durabuilt pressure washer (model DB1303) to work. After hooking up the water hoses I plug it in and turn on the power. It sounds like it's running but there is no increase in pressure and it runs continuously. I only let it run for about 10 seconds and then turned it off. I tried it a couple of times...no luck.


... Coleman Powermate DuraBuilt 1400 PSI Pressure Washer
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.1634 seconds