Having problems with your Craftsman Pressure Washers ?

Which way does the oil filter go on a lt 2500 craftsman tractor


Answers :

Repair Help & Product Troubleshooting for Craftsman Pressure Washers

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Which way does the oil filter go on a lt 2500 craftsman tractor


... Craftsman Pressure Washers

I have a 7 hp B&G craftsman Pressure washer , if I place an air filter on it ,it wound't start or run , if I remove the air filter it would run like a champ, but after 10 mints , oil would shoot out off the carb like a running faucet , why is it not running with the filter on,.Now am not so sure if the air filter is the correct size , because when I put it on it seem to be a bit on the taller size rather than a perfect fit, thanks for your help , in Hollywood , Reinaldo Roman .


First,It sounds like the air filter is full of dirt preventing air from flowing through, starving the engine of air.As for the oil shooting through, are you certain the oil is coming from teh carb?. Makes no sense the engine w ... Briggs & Stratton Pressure Washer Projectpro Spray Nozzle

North star eletric hot 2000 psi 3.5 gal per min oil pump had blown shaft seal. replaced with new pump. put small allen plug in return port. I have oil flow to the pump but none comes out port leading to burner even with shutoff switch removed and pump turning. Installed test gage 0 pressure. Took off bypass line and ran into can. pumps small amount of fuel into can that way but with uneven flow & small bubbles. nomatter what I do I just can't get fuel outlet port to burner. pump # A2VA-7116 pl


... Northstar Pressure Washers

I HAVE A NEW CRAFTSMAN PRESSURE WASHER WITH KEY START. I HAVE USED IT ONCE AND WHEN I TRIED TO START IT IT WAS HARD TO START HAD TO PULL START IT. NOW IT WONT START. LET PRESSURE OUT HAVE HOSE OH AND RUNNING, NEW SPARK PLUG HAS OIL, GAS FILTER FINE.HAS GOOD COMPRESSION, BUT WILL NOT FIRE GET SOME RECOIL. GETTING GAS TO SPARK PLUG AND GETTING SPARK. IM LOST PLEASE HELP.


... Pressure Washers

I have a power washer, craftsman &.0 horsepower, 2900 psi, 2.3 GPM model number 580.752410. i was starter to wash my car, and stops? i change the spark plug, andput new oil in there. still do not working. some one helme in this problem.


... Craftsman 3000 PSI 27 GPM Briggs Stratton Powered Pressure Washer

I have a Craftsman 2700 psi pressure washer with a Briggs and Stratton 850 engine (80 year anniversary special addition) . It is about 2 years old and used very little and will not start. I filled it with fresh fuel and checked the oil. I also replaced the spark plug and air filter. I checked the fuel line thinking it may not be getting fuel, but there is no obstruction from the tank to the end of the fuel line. I am out of TS options short of taking it to a service center.


Here is the long answer with everything we learned while using a power \015\012washer twice a day for years::\015\012It sounds like could be one of the problems listed below or a \015\012combination of those things.\015\012\015\0121 ... Briggs Stratton 020273 Elite Series Portable Gas Pressure Washer

I have a craftsman Pressure washer Model 580-725400 the unit has ran great until today. I last used the unit 1 week ago with no problems but now I have to run the machine almost full choke to get it it rev up and run smooth. The engine oil is clean and filled to the proper point. The spark plug is new and gapped proper. The air filter is new also. And the gas is 97 Oct and fresh. When it choke it to crank the engione I move the choen to run and the engine struggles to run. When I move the choke


... Craftsman Pressure Washers

I borrowed my nieghbors power washer. It worked the first day all day. In the morning i filled the gas with a fuel stabiler, and 30 oil. I may have over filled it. Upon turning it on the oil started leaking from the air filetr compartment. It starts, but then smokes starts to fume and all the oil leaks. Did I break it or is it a easy fix. I cleaned the filter housing. Also the filter was soaked with oil. should i get a new filter and install it or what is the solution. need help.


You will need to get a new filter, and drain some of the oil out of the machine. If you over fill these this will happen. 90% of the time nothing is broken. ... Karcher 2500 PSI Pressure Washer

I think I added too much oil to my pressure washer. It lost pressure after about 20 minutes, then smoke came our where the exhaust area is. I immediately turned it off. Then I noticed oil dripping from the oil filter. What do you might have happened and what should I do?


Drain the oil until the proper level is reached....let the unit sit for awhile until cool and then remove spark plug and clean it....i think it should be just fine....good luck ... Briggs & Stratton Pressure Washer Projectpro Spray Nozzle

My BE Honda 5.0 2900 psi pressure washer has oil in air filter. I believe it is because my buddy left it tilted to the side in th ecar when he borrowed it. How can I fix it? It is probably low on oil as now due to this. How much oil does it take? As there is no dip stick to check the level, Do I need to empty it all out and refill it


Hi there ibharti sounds like gx 160 honda ohv engine \015\012\015\012replace the air filter if it has been wet with oil, , remove the float bowl and check for oil in the carb, blow the jets out, top up the oil to the point o ... Honda Pressure Washer PSI 3000

Grinding The situation: I have had my Whirlpool DU915PWPB1 for 2 1/2 years, it isn't the greatest dishwasher but does the job good enough. Recently, the water will fill, the washing cycle will run but then when that part stops it goes into a whirring that seems like a motor is going but nothing is moving. I have removed the Filter Modual in an attempt to find out what the grinding would be. There doesn't seem to have anything in the way or under the filter. I have ascertained that the grin


Noise probably not from there when reassembled the plate will not be direct contact with screen noise is probably from wash motor itself..suggest checking owners manual for warranty info ... Dishwashers

I ran my pressure washer today in an effort to run some "stabilized" gas through it for the winter. For some reason the pump began to push oil out the top relief hole. If thats not clear, it's a feature that looks like a priming pump but is rigid. By the way, the oil appeared a bit nourish gray. Not sure if that means anything. Any ideas?


It looks as if moisture/water has contaminated the oil. Check the level of oil from the glass window. It must be high. Drain out the oil & check if water is present, if so then replace the entire oil. ... Dewalt DPD3100 Gas Pressure Washer

The dishwasher is stopping half way through the cycle and water remains in the filter. iv cleaned the filter out and it says error 2 ?


... Whirlpool Dishwashers

Hi - I have tried all the usual tricks of running an empty load with vinegar, and the food particle filter seems to be the kind that isn't removable. Whenever I run a load, there is enough left over particles on the dishes - especially the top shelf, that I either have to wash all the glasses by hand, or run at least one more cycle. I have a standard size hotpoint built-in dishwasher. Please let me know if there is a way to clean the filter, or an alternative method so that the dishes are a


The best but not the fastest way is to remove the pump and motor assy and visuall inspect for fooreign items in the pump assy and also inspect for damage to the pump inpeller at the same time. Sorry not a fast fix but the best way ... Dishwashers

Throttle problems Homelite pressure washer model UT80709A. bought it 10 months ago with no problems and stored it for last 9 months. Before doing so, drained gas, oil. Brought out of storage a few days ago, filled with fresh gas, oil, cleaned air filter. Starts great first try but after about 30 seconds the throttle starts visibly revving the motor a litlle at first then gradually faster and faster until it seems to flood and die. Then you cant start for about an hour and its the same story. Hav


... Homelite Pressure Washers

I'm using a Dewalt 2800 power washer and someone set it on its side. And now it will not start. The air cleaner is full of oil. I think there is oil in the carb. I took the air filter off and almost get it to start. Any help?


Take the air filter off and wash in petrol.allow to dry,and put back on. then take the fuel bowl off and clean.turn fuel tap on and drain fuel from carby for a few seconds.turn fuel tap off.put fuel bowl back on.then take spark plug out and turn moto ... Dewalt 3800 PSI Pressure Washer

The dishwasher is not cleanining properly. Cannot lift off the 4-way hydro sweep (with jet spray) (it seems stuck) to clean the removable filter. Kitchenaid Model KUDB220T. I have done this before - but this time cannot remove the 4 - way hydro sweep. found a half ring of metal in bottom of dishwasher - please help


I would suggest you look at diagrams 4 and 5 in the attached assembly drawings. You will have to remove bolt ... KitchenAid Dishwashers

My pressure washer leaks oil out the air filter. I have removed the filter and it still pours out. it only happens when i engage thw hose.


Hi and welcome to FixYa, I am Kelly. \015\012 [ First check and make sure someone did not over service the engine oil level. ] #1 Cause of oil blow by that happens out of the blue. \015\012\015\012This is happening ... Karcher 2500 PSI Pressure Washer

Intake/Drain light is on. First flashed F13. Cleaned the water intake filter;cleaned the triple filter and drain pump.Light continues to stay on-it seems as if no water in coming in the dishwasher. Water supply is on all the way.


Hi\015\012\015\012 \015\012\015\012 \015\012\015\012Thanks for using FixYa. F13 is a\015\012flow meter error; unfortunately there is no way to reset it so you’ll have to\015\012get ... Miele Dishwashers

My Karcher 2400 PSI pressure washer is not starting after about 5 years. What type of spark plug and gap should I change the old out with and what kind of oil do you recommend. I don't think I have ever changed the oil but way less that 50 hours on the machine. Thanks


... Karcher 2500 PSI Pressure Washer

Need to clean Jenn-Air dishwasher JDB-5 filter, how do you take filter out? Wash arm is in the way.


... Dishwashers

Fills ok wash ok at 156 degrees goes into rinse cycle dont seem to have much water comming out shows 0 degrees rinse temp. screen is out so thats not clogged have separate free standing electric heater piped in has been working fine for 5 years that way dont understand 0 degree water temp. on display any help would be great thanks for your time joe


... Hobart AM14-253 Free-standing Dishwasher

Started by Craftsman 2700 PSI , 2.3 GPM Briggs & Stratton Powered Pressure Washer for first time in 9 months. Added new oil, and gas. started but is smoking from muffler and is dripping what appears to be oil near the exhaust end. I shut it down. What could this be due to?


The first thing I would check would be the oil level, to make sure you didn't put in too much oil. If the oil level is correct, it could be a stuck piston ring, letting oil blow by the piston, and out the exhaust. If this is the case, you are going ... Craftsman 2700 PSI,2.3 GPM Briggs & Stratton Powered Pressure Washer - Ca. Model

My pressure washer craftsman 580767300 where do you check the oil or add oil in the pump not the motor I HAVE A manuel it does not show


... Pressure Washers

Whirlpool 8575637 dishwasher, My dishwasher will not drain all the way. I suspect there is a clogged filter somewhere I can't find. I have removed the round filter and cleaned it, but still have the problem. Any suggestions?


... Whirlpool GU2400XTP Built-in Dishwasher
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.0734 seconds