Having problems with your Crosley 24 in. CDC450 Free-standing Dishwasher ?

Unit not cleaning as well as when new;understand that things wear out;is there any kind of filtration system in unit that can be acessed and cleaned to allow bettert water pressures?


Answers :

Sounds like the heater element not heating as well as it did also you may need to put it through a hot cycle (empty) to flush out any gunk away.
Repair Help & Product Troubleshooting for Crosley 24 in. CDC450 Free-standing Dishwasher

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Unit not cleaning as well as when new;understand that things wear out;is there any kind of filtration system in unit that can be acessed and cleaned to allow bettert water pressures?


Sounds like the heater element not heating as well as it did also you may need to put it through a hot cycle (empty) to flush out any gunk away. ... Crosley 24 in. CDC450 Free-standing Dishwasher

Water pressure? I read somewhere that low pressure of the incoming water will make it so that the items on the top drawer will not be as clean. I don't see how this can be the case, as I thought that the way the washer worked was that the washer filled (at whatever speed) and then the machine itself pumped the water through the system at the appropriate pressure. Please clarify.


Mom...not true. The water fills the machine which then uses its own pump to spray the dishes with the water/detergent. If your dishes are not getting clean, use the recommended amount of detergent. Hard water will require a spot treatment like Jet ... KitchenAid KUDR01TJ Dishwasher

I have a Troy-Bilt GCV160 pressure washer. While I was pressure washing the water pressure just decreased. The unit will start and runs fine, but there is no pressure when sqeezing the trigger. I purged the water system with no positive results.


Hi and welcome to FixYa. I am Kelly\015\012\015\012First off let me say that the GCV160 is the engine model number and not the unit model number. \015\012\015\012It appears that your model number is 020415 (2600 PSI) as it is ... Pressure Washers

My Kitchen Aid KUDS01DJSS0 seems to have water going to the upper spray arm (I see water coming out of the unit just beneath the upper rack), but the pressure doesn't seem to be high enough to clean the upper rack. No evidence that water is coming out of the spray arm on the very top. Lower rack dishes seem to clean OK. I have already removed the whole upper spray arm assembly and inspected the flapper valves that the middle sprayer goes into. I suspect that it's not making good enough contac


... KitchenAid Dishwashers

Model MDB5100AWW, sn 10493315YK. Dishes not coming clean, stuck on food, and cloudy. We have installed new Jet Dry, and operated unit in rinse cycle with added vinigar about 4 times with no luck on cleaning. We do NOT have a water softener. Do we have lime deposits that are not allowing water to properly. Are there components that we can remove and clean? Mike


The problem is hard water. www.dishwasherfilter.com has a product to solve this problem once and for all. It filters the water going into your dishwasher and removes the ... Maytag MDB5100 Dishwasher

Honda gas powered pressure washer--runs great and I get pressure throughout the system but nothing comes out of the wand itself. There seems to be no clog throughout the system . I have cleaned all parts. When the unit isn't started I can get flow throughout the system


... Pressure Washers

I have a Karcher K3.48M electric pressure washer which used to shut off when you weren't using the cleaning wand. This no longer happens and there is alot of water running out of the bottom of the unit. (This didn't used ot be the case) I expect a leak somewhere inside the unit, but I'm wondering even more if there is a pressure switch which has failed that cased the leak. In other words, if I find and repair the leak and there is a failed pressure switch, it will likely only break again. I can'


Hi you will have a 8 digit number on a silver plate on the machine with a number like 1.141-470.0\015\012Then go to www.karcher.com then on the left click on Europe, then you ... Karcher PSI Electric Pressure Washer

I have a Miele G570 dishwasher and the spinners don't appear to be turning properly. I have removed and cleaned the incoming water strainer, but still no better. The water supply pressure is the same as always. The unit goes through it's complete cycle but the dishes are still not clean. Can you help please?


Run a nice long hot "Pots and Pans" cycle every now and then.Try calling the Miele Appliance Hotline 1-800-999-1360 when your in front of the machine. ... Miele Dishwashers

KUDS02FRSS4 low wash pressure in unit? Washes dishes but not the normal water pressure in unit, all filters are clean


Tear down the lower spray arm assembly to the deck while noting placement and orientation of each piece. There should be a large screen at the bottom that may be plugged with food and water deposits. Soak this screen in hot water, detergent, and whit ... KitchenAid 24 in. KUDS02FRSS Stainless Steel Built-in Dishwasher

MY DISHWASHER HAS NO WATER GOING IN TO THE UNIT IT HAS HAD THE FILTERS CLEANED AND ALL OF THE SPRAY ARMS CLEANED REALLY GOOD DISCONNECTED THE WATER SUPPLY AND FOUND OUT IT HAS A LOT OF PRESSURE JUST NO FLOW ANY IDEA


Hello thereyes i have a pretty good idea i think your problem is that your water solonoid valve has failed and is shut when these solonoid valves fail they automatically shut resulting in no water flow I recommend that you turn of ... Kenmore Dishwashers

The cleaning liquid has never mixed with the water to pressure water. Do you think the line is clogged and if so, how do I take the unit a part to clear the line?


... Karcher PSI Electric Pressure Washer

The "clean light" on our Kitchenaid KUDIO1FLSS flashes 7 times and I cannot clear the problem to allow the unit to operate. Is there a sequence, using the control buttons, to permit the unit to run a system check? I disconnected the power for 30 minutes but that did not solve the problem.


... KitchenAid 24 in. KUDI01FLSS Stainless Steel Built-in Dishwasher

Coleman model APW-120 May have frozen while stored over winter the unit is new but water was not completly removed before storage. Problem motor runs continuosly but there is no water pressure I have cleaned screen & nozzel


Whar has happened is that your unloader / bypass valve is sticking. This is due to minor corrosion and having water in the unit over the winter. Most of the time they will sanp out it if you do the following:\015\012\015\012Add 3 - 4 oz ... Coleman Powermate DuraBuilt 1400 PSI Pressure Washer

Bosch Exxcel model number SGS46E12GB had the check water light on a week ago, checked supply and cleaned filters, all good. light still on, got upset and slammed the door, light off. since then the unit will either wash stuff, or not. didn't seem the arms were spraying very well when I opened the door, so I bypassed the door switch tonight and put it through a pre rinse cycle. (I ran it with the bottom filters removed) upshot is the pressure of water was really poor. also, when I first turned


... Bosch 24 in. SGS47E02 Exxcel Free-standing Dishwasher

We used our LG diswasher to clean our grill grates, which was a bad idea, because now the unit will not clean the dishes. We cleared the washer arms of debris, but the unit still is leaving the dishes on both racks dirty and is leaving the liquid soap dispensed into the unit undissolved on the door of the unit. There are no kinks in the water inlet, and water is getting into the unit, but the dishes are not getting cleaned.


Hi\015\012\015\012\015\012Thanks for using FixYa. Please make sure the dishes are loaded properly or\015\012dishwasher is not overloaded. Also check that the dishwasher is filling\015\012properly. It will fill with water up to ... LG LDF6810ST Stainless Steel Built-in Dishwasher

Removed rear toe-plate to detect leak. Leak caused by broken drain hose. Hose replaced. To do this the unit was tipped forward onto its front door to allow access to the base area. Water allowed to drain out the front base area. Unit re-assembled but now does not switch on. Water connected. Base-plate dry. No water was detected at upper-front control panel. Power is connected and reaching unit ( multi-meter test ). Tipping the unit forward seems to be the cause. Is there any fuse,


The micro switches are frequently replaced on the door handle and they don't need to ever get wet. A lot of amp draw burns those switches up while they are dry. If they were wet and power was applied then they got fried my friend. The good news is th ... Dishwashers

Customer bought house with a Viking Dishwasher already there. He has no user manuals or documentation with the model number listed. None of the stickers on the side of the door have a Viking model number. This unit is a Quiet Clean System with Auto Water Heating and is (he thinks) about two years old. How can I find out what the model # might be or better yet how do I find out the part # to fix the main control board / interface. It just keeps blinking.


Check the back of the unit for a tag.... otherwise - removing the clock... it should have a part number on it.\015\012\015\012Thanks! ... Dishwashers

Power washer - model jcb-pw20tss. TSS=total stop system. seems to be ''stuck'' on my model. Can you suggest method to free up and restore pressure which will allow me to switch on machine again. Mains electric =OK Fuse = OK Connected to water supply =OK


... Pressure Washers

Dishlex global 310 - I've cleaned all filter components and removable parts but still it's like no high pressure water is getting through. How do I check to unblock the inflow at the bottom of the unit?


When the Dishlex starts for the first time, there is a\015\012service mode set up. The service mode allows you to set a 'fill-time'\015\012for the water to reach the right level, depending on the water pressure\015\012and flow... So resetting the ... Electrolux Dishwashers

Karcher K4 Hello, just cleaning my patio been using it for two days and it has stopped pressuring up, water comes through the lance but there is a humming noise coming from the unit when switched on, weather the trigger is pulled or not. Thanks for your time hope you can help. Regards Gareth


It sounds as if you might have an air lock/air bubble in your pump circuit. If you've not already done so, try holding the trigger on your high pressure nozzle for several minutes with the engine OFF. (just your water pressure forcing water through t ... Karcher 2500 PSI Pressure Washer

My Karcher K2.36 stopped working. I had been cleaning the pathways and with no warning, no peculiar noises, etc the unit motor stopped working. The power was connected, the water was still coming from the wand albeit at low pressure. Thanks.


... Karcher Pressure Washers

Water leaks from underneath the unit. Water only leaks when the pump cuts on (pressurizes). It leaks down on to the hose connecting to the water inlet valve on the right hand side of the unit when looking at the door of the unit. When the unit is full of water and the motor / pump is not running the unit does not leak. This unit is a Maytag jetclean dishwasher Model DWU9200BAB about 12 years old


Please change the 'o'rings of drain line and the inlet and also check the drain hose and the inlet if there are any holes in it ... Dishwashers

I am a licensed plumber who installed a frigidaire fdb1o5rem1 dishwasher for a customer about 2 years ago. It has water to the solenoid valve and the screen is clean. I can see water coming in to the unit on left side through the port hole on the inside of the unit. Dishes do not get clean and it doesnt act like water is being distrubuted inside the dishwasher. Soap never gets washed away from door. Dishwasher makes funny sound in mid cycle like the pump is not running in wash cycle. Discharge p


I can see from what you have described (by the way it is a very clear and precise description which is very helpful), there is a problem in the water circulation system. These dishwashers use an alternating water flow method to split the water circul ... Frigidaire Dishwashers

In my bauknecht GSFP Control light blinks and the dishwasher waiting after celin 34591 unit (Water pressure gauge)


... Whirlpool Dishwashers

Maytag MDB 4000 AWB. Not cleaning. not getting water now. pressure was low when i was getting water. . Soap dispenser would not open as well. I replaced the motor on the soap door. cleaned the float switch. Tested continuity and cleaned out water inlet valve. Still not getting any water


... Maytag Dishwashers
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.1918 seconds